Dataset Information

Drug Content Uniformity: Quantifying Loratadine in Tablets Using a Created Raman Excipient Spectrum.

ABSTRACT: Raman spectroscopy has proven valuable for determining the composition of manufactured drug products, as well as identifying counterfeit drugs. Here we present a simple method to determine the active pharmaceutical ingredient (API) mass percent in a sample that does not require knowledge of the identities or relative mass percents of the inactive pharmaceutical ingredients (excipients). And further, we demonstrated the ability of the method to pass or fail a manufactured drug product batch based on a calculated acceptance value in accordance with the US Pharmacopeia method for content uniformity. The method was developed by fitting the Raman spectra of 30 Claritin^® tablets with weighted percentages of the Raman spectrum of its API, loratadine, and a composite spectrum of the known excipients. The mean loratadine mass of 9.79 ± 40 mg per 100 mg tablet compared favorably to the 10.21 ± 0.63 mg per 100 mg tablet determined using high-performance liquid chromatography, both of which met the acceptance value to pass the 10 mg API product as labelled. The method was then applied to a generic version of the Claritin product that employed different excipients of unknown mass percents. A Raman spectrum representative of all excipients was created by subtracting the API Raman spectrum from the product spectrum. The Raman spectra of the 30 generic tablets were then fit with weighted percents of the pure loratadine spectrum and the created excipient spectrum, and used to determine a mean API mass for the tablets of 10.12 ± 40 mg, again meeting the acceptance value for the 10 mg API product. The data suggest that this simple method could be used to pass or fail manufactured drug product batches in accordance with the US Pharmacopeia method for content uniformity, without knowledge of the excipients.

SUBMITTER: Farquharson A

PROVIDER: S-EPMC7997337 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Similar Datasets

Project description:Moisture-activated dry granulation (MADG) is an eco-friendly granulation method that uses a small amount of water and insoluble excipients to absorb moisture. MADG is expected to improve productivity and reduce costs. Erythritol, an excipient used for preparing orally disintegrating tablets (ODTs), has poor tabletability and is difficult to form into tablets by conventional methods, such as high-shear granulation (HSG) and direct compression. In this study, we optimized the manufacturing conditions for ODTs to improve the tabletability of erythritol using MADG. The disintegration time of tablets made using the MADG method was approximately one-tenth that of those made using the HSG method, and the hardness was approximately 1.4 times higher. Moreover, MADG could delay disintegration and improve tabletability. We further attempted to optimize the manufacturing conditions using MADG, particularly in terms of the amount of water used. The disintegration time increased as the amount of added water increased. Moreover, water absorption tests revealed that capillary wetting decreased as the amount of water added increased, but the initial wetting did not change. These results suggested that the disintegration time was prolonged because of the increase in granule density and decrease in capillary wetting with the increase in the amount of added water. The hardness of the tablets increased because of the easy deformation of the granules after the addition of up to 3% water; however, when more than 3% water was added, the hardness decreased because of the aggregation of the granules with the excess water. Finally, two-dimensional maps of the effect of the amount of added water and water activity indicated that tablets with a hardness of ≥80 N and a disintegration time of ≤15 s could be produced by adjusting the amount of added water to within the range of 2.2-3.3% and water activity to 0.3-0.53. These results indicate that MADG can improve the tabletability of erythritol and be used for the granulation of ODTs. Tablets with appropriate hardness and disintegration properties can be produced by adjusting the water content to approximately 2.7% and the water activity to approximately 0.4 when producing ODTs with MADG.

Dataset Information

Drug Content Uniformity: Quantifying Loratadine in Tablets Using a Created Raman Excipient Spectrum.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets