Orbital Tuning of Tunnel Coupling in InAs/InP Nanowire Quantum Dots.
Ontology highlight
ABSTRACT:
SUBMITTER: Sadre Momtaz Z
PROVIDER: S-EPMC7997631 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:With downscaling of electronic circuits, components based on semiconductor quantum dots are assuming increasing relevance for future technologies. Their response under external stimuli intrinsically depend on their quantum properties. Here we investigate single-electron tunneling in hard-wall InAs/InP nanowires in the presence of an off-resonant microwave drive. Our heterostructured nanowires include InAs quantum dots (QDs) and exhibit different tunnel-current regimes. In particular, for source-drain bias up to few mV Coulomb diamonds spread with increasing contrast as a function of microwave power and present multiple current polarity reversals. This behavior can be modelled in terms of voltage fluctuations induced by the microwave field and presents features that depend on the interplay of the discrete energy levels that contribute to the tunneling process.
| S-EPMC6925118 | biostudies-literature
Project description:We study experimentally and theoretically the in-plane magnetic field dependence of the coupling between dots forming a vertically stacked double dot molecule. The InAsP molecule is grown epitaxially in an InP nanowire and interrogated optically at millikelvin temperatures. The strength of interdot tunneling, leading to the formation of the bonding-antibonding pair of molecular orbitals, is investigated by adjusting the sample geometry. For specific geometries, we show that the interdot coupling can be controlled in-situ using a magnetic field-mediated redistribution of interdot coupling strengths. This is an important milestone in the development of qubits required in future quantum information technologies.
| S-EPMC8948226 | biostudies-literature
Project description:We present a detailed atomic-resolution study of morphology and substrate etching mechanism in InAs/InP droplet epitaxy quantum dots (QDs) grown by metal-organic vapor phase epitaxy via cross-sectional scanning tunneling microscopy (X-STM). Two different etching processes are observed depending on the crystallization temperature: local drilling and long-range etching. In local drilling occurring at temperatures of ≤500 °C, the In droplet locally liquefies the InP underneath and the P atoms can easily diffuse out of the droplet to the edges. During crystallization, the As atoms diffuse into the droplet and crystallize at the solid-liquid interface, forming an InAs etch pit underneath the QD. In long-range etching, occurring at higher temperatures of >500 °C, the InP layer is destabilized and the In atoms from the surroundings migrate toward the droplet. The P atoms can easily escape from the surface into the vacuum, forming trenches around the QD. We show for the first time the formation of trenches and long-range etching in InAs/InP QDs with atomic resolution. Both etching processes can be suppressed by growing a thin layer of InGaAs prior to the droplet deposition. The QD composition is estimated by finite element modeling in combination with X-STM. The change in the morphology of QDs due to etching can strongly influence the fine structure splitting. Therefore, the current atomic-resolution study sheds light on the morphology and etching behavior as a function of crystallization temperature and provides a valuable insight into the formation of InAs/InP droplet epitaxy QDs which have potential applications in quantum information technologies.
| S-EPMC9237823 | biostudies-literature
Project description:Tunneling Field-Effect Transistors (TFET) are one of the most promising candidates for future low-power CMOS applications including mobile and Internet of Things (IoT) products. A vertical gate-all-around (VGAA) architecture with a core shell (C-S) structure is the leading contender to meet CMOS footprint requirements while simultaneously delivering high current drive for high performance specifications and subthreshold swing below the Boltzmann limit for low power operation. In this work, VGAA nanowire GaSb/InAs C-S TFETs are demonstrated experimentally for the first time with key device properties of subthreshold swing S = 40 mV/dec (Vd = 10 mV) and current drive up to 40 μA/wire (Vd = 0.3 V, diameter d = 50 nm) while dimensions including core diameter d, shell thickness and gate length are scaled towards CMOS requirements. The experimental data in conjunction with TCAD modeling reveal interface trap density requirements to reach industry standard off-current specifications.
| S-EPMC6336843 | biostudies-literature
Project description:InP and InZnP colloidal quantum dots (QDs) are promising materials for application in light-emitting devices, transistors, photovoltaics, and photocatalytic cells. In addition to possessing an appropriate bandgap, high absorption coefficient, and high bulk carrier mobilities, the intrinsic toxicity of InP and InZnP is much lower than for competing QDs that contain Cd or Pb-providing a potentially safer commercial product. However, compared to other colloidal QDs, InP QDs remain sparsely used in devices and their electronic transport properties are largely unexplored. Here, we use time-resolved microwave conductivity measurements to study charge transport in films of InP and InZnP colloidal quantum dots capped with a variety of short ligands. We find that transport in InP QDs is dominated by trapping effects, which are mitigated in InZnP QDs. We improve charge carrier mobilities with a range of ligand-exchange treatments and for the best treatments reach mobilities and lifetimes on par with those of PbS QD films used in efficient solar cells. To demonstrate the device-grade quality of these films, we construct solar cells based on InP & InZnP QDs with power conversion efficiencies of 0.65 and 1.2%, respectively. This represents a large step forward in developing Cd- and Pb-free next-generation optoelectronic devices.
| S-EPMC6259048 | biostudies-literature
Project description:For InP-based QDs, the current technology does not outperform CdSe-based QDs in many respects, one of which is stability. The optical stability of QDs is closely related to their surface properties, so QDs often use organic ligands for surface protection. These organic ligands are dynamically attached and detached on the QD surface; during detachment, their surfaces are easily damaged and oxidized, thereby deteriorating their optical characteristics. Therefore, we have synthesized a ligand 1,2-hexadecanedithiol with a bidentate form, inducing one ligand to bind to the QD surface strongly through the chelate effect, as a good way to improve the stability of the QDs; thus, the PL stability of the green-light-emitting InP-based QDs was greatly increased. To confirm the existence of the dithiol ligand, we used thermogravimetric analysis/simultaneous thermal analysis-mass spectroscopy (TGA/STA-MS). After that, we applied the ligand to blue-light-emitting ZnSe QDs and red-light-emitting InP QDs, and for those two types of QD we also confirmed that the stability was increased. Additionally, we tested dithiol exchanged QDs at a high temperature of 150 °C, and the increase of stability was effective even in a high temperature condition.
| S-EPMC9050508 | biostudies-literature
Project description:This paper describes coinage-metal-doped InP quantum dots (QDs) as a platform for enhanced electron transfer to molecular acceptors relative to undoped QDs. A synthetic strategy is developed to prepare doped InP/ZnSe QDs. First-principles DFT calculations show that Ag+ and Cu+ dopants localize photoexcited holes while leaving electrons delocalized. This charge carrier wave function modulation is leveraged to enhance electron transfer to molecular acceptors by up to an order of magnitude. Examination of photoluminescence quenching data suggests that larger electron acceptors, such as anthraquinone and methyl viologen, bind to the QD surface in two ways: by direct adsorption to the surface and by adsorption following displacement of a weakly bound surface cation-ligand complex. Reactions with larger acceptors show the greatest increases in electron transfer between doped and undoped quantum dots, while smaller acceptors show smaller enhancements. Specifically, benzoquinone shows the smallest, followed by naphthoquinone and then methyl viologen and anthraquinone. These results demonstrate the benefits of dopant-induced excited-state carrier localization on photoinduced charge transfer and highlight design principles for improved implementation of quantum dots in photoredox catalysis.
| S-EPMC10740119 | biostudies-literature
Project description:Photocatalytic hydrogen evolution is a promising technique for the direct conversion of solar energy into chemical fuels. Colloidal quantum dots with tunable band gap and versatile surface properties remain among the most prominent targets in photocatalysis despite their frequent toxicity, which is detrimental for environmentally friendly technological implementations. In the present work, all-inorganic sulfide-capped InP and InP/ZnS quantum dots are introduced as competitive and far less toxic alternatives for photocatalytic hydrogen evolution in aqueous solution, reaching turnover numbers up to 128,000 based on quantum dots with a maximum internal quantum yield of 31%. In addition to the favorable band gap of InP quantum dots, in-depth studies show that the high efficiency also arises from successful ligand engineering with sulfide ions. Due to their small size and outstanding hole capture properties, sulfide ions effectively extract holes from quantum dots for exciton separation and decrease the physical and electrical barriers for charge transfer.
| S-EPMC6167351 | biostudies-literature
Project description:Self-assembled quantum dots grown by molecular beam epitaxy have been a hotbed for various fundamental research and device applications over the past decades. Among them, InAs/GaAs quantum dots have shown great potential for applications in quantum information, quantum computing, infrared photodetection, etc. Though intensively studied, some of the optical nonlinear properties of InAs/GaAs quantum dots, specifically the associated two-photon absorption of the wetting and barrier layers, have not been investigated yet. Here we report a study of the photoluminescence of these dots by using direct two-photon excitation. The quadratic power law dependence of the photoluminescence intensity, together with the ground-state resonant peak of quantum dots appearing in the photoluminescence excitation spectrum, unambiguously confirms the occurrence of the direct two-photon absorption in the dots. A three-level rate equation model is proposed to describe the photogenerated carrier dynamics in the quantum dot-wetting layer-GaAs system. Moreover, higher-order power law dependence of photoluminescence intensity is observed on both the GaAs substrate and the wetting layer by two-photon excitation, which is accounted for by a model involving the third-harmonic generation at the sample interface. Our results open a door for understanding the optical nonlinear effects associated with this fundamentally and technologically important platform.
| S-EPMC7331710 | biostudies-literature
Project description:Graphene double quantum dots (DQDs) open to use charge or spin degrees of freedom for storing and manipulating quantum information in this new electronic material. However, impurities and edge disorders in etched graphene nano-structures hinder the ability to control the inter-dot tunnel coupling, tC, the most important property of the artificial molecule. Here we report measurements of tC in an all-metal-side-gated graphene DQD. We find that tC can be controlled continuously about a factor of four by employing a single gate. Furthermore, tC, can be changed monotonically about another factor of four as electrons are gate-pumped into the dot one by one. The results suggest that the strength of tunnel coupling in etched graphene DQDs can be varied in a rather broad range and in a controllable manner, which improves the outlook to use graphene as a base material for qubit applications.
| S-EPMC3822378 | biostudies-literature