Thermochemical electronegativities of the elements.
Ontology highlight
ABSTRACT:
SUBMITTER: Tantardini C
PROVIDER: S-EPMC8027013 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Using static bomb combustion calorimetry, the combustion energy of 1-methylhydantoin was obtained, from which the standard molar enthalpy of formation of the crystalline phase at T = 298.15 K of the compound studied was calculated. Through thermogravimetry, mass loss rates were measured as a function of temperature, from which the enthalpy of vaporization was calculated. Additionally, some properties of fusion were determined by differential scanning calorimetry, such as enthalpy and temperature. Adding the enthalpy of fusion to the enthalpy of vaporization, the enthalpy of sublimation of the compound was obtained at T = 298.15 K. By combining the enthalpy of formation of the compound in crystalline phase with its enthalpy of sublimation, the respective standard molar enthalpy of formation in the gas phase was calculated. On the other hand, the results obtained in the present work were compared with those of other derivatives of hydantoin, with which the effect of the change of some substituents in the base heterocyclic ring was evaluated.
| S-EPMC8777693 | biostudies-literature
Project description:Gas-phase heats of formation for the four butene oxide isomers are reported. They were obtained by measuring the condensed-phase heat of reduction to the corresponding alcohol using reaction calorimetry. Heats of vaporization were determined and allow gas-phase heats of formation to be obtained. The experimental measurements are compared to calculations obtained using a variety of computational methods. Overall, the G3 and CBS-APNO methods agree quite well with the experimental data. The influence of alkyl substituents on epoxide stability is discussed. Comparisons to alkenes, cyclopropanes, aziridines, thiiranes, and phosphiranes are also made. Isodesmic-type reactions were used to determine strain energies of the epoxides and related compounds with various substituents.
| S-EPMC3671579 | biostudies-literature
Project description:Separation and concentration of O2 from gas mixtures is central to several sustainable energy technologies, such as solar-driven synthesis of liquid hydrocarbon fuels from CO2 , H2 O, and concentrated sunlight. We introduce a rationale for designing metal oxide redox materials for oxygen separation through "thermochemical pumping" of O2 against a pO2 gradient with low-grade process heat. Electronic structure calculations show that the activity of O vacancies in metal oxides pinpoints the ideal oxygen exchange capacity of perovskites. Thermogravimetric analysis and high-temperature X-ray diffraction for SrCoO3-? , BaCoO3-? and BaMnO3-? perovskites and Ag2 O and Cu2 O references confirm the predicted performance of SrCoO3-? , which surpasses the performance of state-of-the-art Cu2 O at these conditions with an oxygen exchange capacity of 44?mmol?O?2?mol?SrCoO?3-?(-1) exchanged at 12.1??mol?O?2?min(-1) ?g(-1) at 600-900?K. The redox trends are understood due to lattice expansion and electronic charge transfer.
| S-EPMC4831027 | biostudies-literature
Project description:Graphene and graphene nanoplatelets can be functionalised via a gas-phase thermochemical method; the approach is versatile, readily scalable, and avoids the introduction of additional defects by exploiting existing sites. Direct TEM imaging confirmed covalent modification of single layer graphene, without damaging the connectivity of the lattice, as supported by Raman spectrometry and AFM nano-indentation measurements of mechanical stiffness. The grafting methodology can also be applied to commercially-available bulk graphene nanoplatelets, as illustrated by the preparation of anionic, cationic, and non-ionic derivatives. Successful bulk functionalisation is evidenced by TGA, Raman, and XPS, as well as in dramatic changes in aqueous dispersability. Thermochemical functionalisation thus provides a facile approach to modify both graphene monolayers, and a wide range of graphene-related nanocarbons, using variants of simple CVD equipment.
| S-EPMC5627544 | biostudies-literature
Project description:Ion association is an important process in aqueous dissolution, precipitation, and crystallization of ionic inorganic, organic, and biological materials. Polyoxometalates (POMs) are good model compounds for understanding the complex relationships between lattice energy, ion-pairing in solution, and salt solubility. Here we perform calorimetric measurements to elucidate trends in cluster stability, lattice energy, and ion-pairing behavior studies of simple hexatantalate salts in neat water, parent hydroxide solutions, and molybdate melts, extending previous studies on the isostructural hexaniobates. High temperature calorimetry of alkali salts of hexatantalate reveals that the enthalpies of formation from oxides of the K, Rb, and Cs salts are more similar to each other than they are for their niobate analogues and that the tantalate cluster is energetically less stable than hexaniobate. Aqueous dissolution calorimetry reveals that the cesium salt of hexatantalate has a similar concentration dependence on its dissolution enthalpy to that of hexaniobate. However, unlike rubidium hexaniobate, rubidium hexatantalate also exhibits increased concentration dependence, indicating that hextantalate can undergo increased ion-pairing with alkali salts other than cesium, despite the dilute environments studied. Dissolution enthalpies of POM salts in the parent alkali hydroxides shows that protonation of clusters stabilizes lattices even more than the strongly associating heavy alkali cations do. Additionally, neither weak nor strong lattice ion associations necessarily correlates with respectively high or low aqueous solubility. These studies illuminate the importance of considering ion-pairing among the interrelated processes in the aqueous dissolution of ionic salts that can be extended to serving as a model of cation association to metal oxide surfaces.
| S-EPMC6222682 | biostudies-literature
Project description:Thermochemical cycles that split water into stoichiometric amounts of hydrogen and oxygen below 1,000 °C, and do not involve toxic or corrosive intermediates, are highly desirable because they can convert heat into chemical energy in the form of hydrogen. We report a manganese-based thermochemical cycle with a highest operating temperature of 850 °C that is completely recyclable and does not involve toxic or corrosive components. The thermochemical cycle utilizes redox reactions of Mn(II)/Mn(III) oxides. The shuttling of Na(+) into and out of the manganese oxides in the hydrogen and oxygen evolution steps, respectively, provides the key thermodynamic driving forces and allows for the cycle to be closed at temperatures below 1,000 °C. The production of hydrogen and oxygen is fully reproducible for at least five cycles.
| S-EPMC3386106 | biostudies-literature
Project description:Herein, the pyrolysis of two types of single-use disposable waste (single-use food containers and corrugated fiberboard) was investigated as an approach to cleanly dispose of municipal solid waste, including plastic waste. For the pyrolysis of single-use food containers or corrugated fiberboard, an increase in temperature tended to increase the yield of pyrolytic gas (i.e., non-condensable gases) and decrease the yield of pyrolytic liquid (i.e., a mixture of condensable compounds) and solid residue. The single-use food container-derived pyrolytic product was largely composed of hydrocarbons with a wide range of carbon numbers from C1 to C32, while the corrugated fiberboard-derived pyrolytic product was composed of a variety of chemical groups such as phenolic compounds, polycyclic aromatic compounds, and oxygenates involving alcohols, acids, aldehydes, ketones, acetates, and esters. Changes in the pyrolysis temperature from 500 °C to 900 °C had no significant effect on the selectivity toward each chemical group found in the pyrolytic liquid derived from either the single-use food containers or corrugated fiberboard. The co-pyrolysis of the single-use food containers and corrugated fiberboard led to 6 times higher hydrogen (H2) selectivity than the pyrolysis of the single-use food containers only. Furthermore, the co-pyrolysis did not form phenolic compounds or polycyclic aromatic compounds that are hazardous environmental pollutants (0% selectivity), indicating that the co-pyrolysis process is an eco-friendly method to treat single-use disposable waste.
| S-EPMC8400630 | biostudies-literature
Project description:Thermochemical sulfate reduction experiments with simple amino acid and dilute concentrations of sulfate reveal significant degrees of mass-independent sulfur isotope fractionation. Enrichments of up to 13‰ for (33)S are attributed to a magnetic isotope effect (MIE) associated with the formation of thiol-disulfide, ion-radical pairs. Observed (36)S depletions in products are explained here by classical (mass-dependent) isotope effects and mixing processes. The experimental data contrasts strongly with multiple sulfur isotope trends in Archean samples, which exhibit significant (36)S anomalies. These results support an origin other than thermochemical sulfate reduction for the mass-independent signals observed for early Earth samples.
| S-EPMC3203815 | biostudies-literature
Project description:A thermochemical nonequilibrium analysis was performed under the low enthalpy shock-tunnel flows. A quasi-one-dimensional flow calculation was employed by dividing the flow calculations into two parts, for the shock-tube and the Mach 6 nozzle. To describe the thermochemical nonequilibrium of the low enthalpy shock-tunnel flows, a three-temperature model is proposed. The three-temperature model treats the vibrational nonequilibrium of O2 and NO separately from the single nonequilibrium energy mode of the previous two-temperature model. In the three-temperature model, electron-electronic energies and vibrational energy of N2 are grouped as one energy mode, and vibrational energies of O2, O2+, and NO are grouped as another energy mode. The results for the shock-tunnel flows calculated using the three-temperature model were then compared with existing experimental data and the results obtained from one- and two-temperature models, for various operating conditions of the K1 shock-tunnel facility. The results of the thermochemical nonequilibrium analysis of the low enthalpy shock-tunnel flows suggest that the nonequilibrium characteristics of N2 and O2 need to be treated separately. The vibrational relaxation of O2 is much faster than that of N2 in low enthalpy condition, and the dissociation rate of O2 is manly influenced by the species vibrational temperature of O2. The proposed three-temperature model is able to describe the thermochemical nonequilibrium characteristics of N2 and O2 behind the incident and reflected shock waves, and the rapid vibrational freezing of N2 in nozzle expanding flows.
| S-EPMC7540898 | biostudies-literature
Project description:Despite progress in understanding seafloor accretion at ultraslow spreading ridges, the ultimate driving force is still unknown. Here we use 40Ar/39Ar isotopic dating of mid-ocean ridge basalts recovered at variable distances from the axis of the Gakkel Ridge to provide new constraints on the spatial and temporal distribution of volcanic eruptions at various sections of an ultraslow spreading ridge. Our age data show that magmatic-dominated sections of the Gakkel Ridge spread at a steady rate of ~11.1 ± 0.9 mm/yr whereas amagmatic sections have a more widely distributed melt supply yielding ambiguous spreading rate information. These variations in spreading rate and crustal accretion correlate with locations of hotter thermochemical anomalies in the asthenosphere beneath the ridge. We conclude therefore that seafloor generation in ultra-slow spreading centres broadly reflects the distribution of thermochemical anomalies in the upper mantle.
| S-EPMC8630051 | biostudies-literature