Data of a high temperature heat injection test.
Ontology highlight
ABSTRACT:
SUBMITTER: Heldt S
PROVIDER: S-EPMC8082194 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:To better understand the mechanisms that regulate the heat stress response in rice, we conducted a comparative analysis of transcriptome profile in panicles from two rice lines, heat-tolerant line 252 (HTL252) and heat-susceptible line 082 (HSL082) using rice Affymetrix GeneChip. In HTL252 panicles, 1538 differentially expressed genes (DEGs) genes with at least four-fold expression changes compared with the control under heat treatment were considered heat-responsive (HR). Of these DEGs, 522 genes were up-regulated while 1016 genes were repressed. Among DEGs in HSL082, 496 genes were induced and 1707 genes were repressed. Out of the 370 common DEGs found between HTL252 and HSL082, 129 genes were induced and 241 genes were repressed.
2019-06-20 | GSE83542 | GEO
Project description:Near-field radiative heat transfer (NFRHT) management can be achieved using high-temperature superconductors. In this work, we present a theoretical study of the radiative heat transfer between two [Formula: see text] (YBCO) slabs in three different scenarios: Both slabs either in the normal or superconducting state, and only one of them below the superconductor critical temperature [Formula: see text]. The radiative heat transfer is calculated using Rytov's theory of fluctuating electrodynamics, while a two-fluid model describes the dielectric function of the superconducting materials. Our main result is the significant suppression of the NFRHT when one or both of the slabs are superconducting, which is explained in terms of the detailed balance of the charge carriers density together with the sudden reduction of the free electron scattering rate. A critical and unique feature affecting the radiative heat transfer between high-temperature superconductors is the large damping of the mid-infrared carriers which screens the surface plasmon excitation.
| S-EPMC7527961 | biostudies-literature
Project description:Members of the ant tribe Camponotini have coevolved with Blochmannia, an obligate intracellular bacterial mutualist. This endosymbiont lives within host bacteriocyte cells that line the ant midgut, undergoes maternal transmission from host queens to offspring, and contributes to host nutrition via nitrogen recycling and nutrient biosynthesis. While elevated temperature has been shown to disrupt obligate bacterial mutualists of some insects, its impact on the ant-Blochmannia partnership is less clear. Here, we test the effect of heat on the density of Blochmannia in two related Camponotus species in the lab. Transcriptionally active Blochmannia were quantified using RT-qPCR as the ratio of Blochmannia 16S rRNA to ant host elongation factor 1-? transcripts. Our results showed that 4 weeks of heat treatment depleted active Blochmannia by >99 % in minor workers and unmated queens. However, complete elimination of Blochmannia transcripts rarely occurred, even after 16 weeks of heat treatment. Possible mechanisms of observed thermal sensitivity may include extreme AT-richness and related features of Blochmannia genomes, as well as host stress responses. Broadly, the observed depletion of an essential microbial mutualist in heat-treated ants is analogous to the loss of zooanthellae during coral bleaching. While the ecological relevance of Blochmannia's thermal sensitivity is uncertain, our results argue that symbiont dynamics should be part of models predicting how ants and other animals will respond and adapt to a warming climate.
| S-EPMC3905736 | biostudies-literature
Project description:This data article comprises records from five Thermal Response Tests (TRT) of quadratic cross section pile heat exchangers. Pile heat exchangers, typically referred to as energy piles, consist of traditional foundation piles with embedded heat exchanger pipes. The data presented in this article are related to the research article entitled "Comparing heat flow models for interpretation of precast quadratic pile heat exchanger thermal response tests" (Alberdi-Pagola et al., 2018) [1]. The TRT data consists of measured inlet and outlet temperatures, fluid flow and injected heat rate recorded every 10 min. The field dataset is made available to enable model verification studies.
| S-EPMC5996141 | biostudies-literature
Project description:This paper concerns statistical inference for longitudinal data with ultrahigh dimensional covariates. We first study the problem of constructing confidence intervals and hypothesis tests for a low dimensional parameter of interest. The major challenge is how to construct a powerful test statistic in the presence of high-dimensional nuisance parameters and sophisticated within-subject correlation of longitudinal data. To deal with the challenge, we propose a new quadratic decorrelated inference function approach, which simultaneously removes the impact of nuisance parameters and incorporates the correlation to enhance the efficiency of the estimation procedure. When the parameter of interest is of fixed dimension, we prove that the proposed estimator is asymptotically normal and attains the semiparametric information bound, based on which we can construct an optimal Wald test statistic. We further extend this result and establish the limiting distribution of the estimator under the setting with the dimension of the parameter of interest growing with the sample size at a polynomial rate. Finally, we study how to control the false discovery rate (FDR) when a vector of high-dimensional regression parameters is of interest. We prove that applying the Storey (2002)'s procedure to the proposed test statistics for each regression parameter controls FDR asymptotically in longitudinal data. We conduct simulation studies to assess the finite sample performance of the proposed procedures. Our simulation results imply that the newly proposed procedure can control both Type I error for testing a low dimensional parameter of interest and the FDR in the multiple testing problem. We also apply the proposed procedure to a real data example.
| S-EPMC8277154 | biostudies-literature
Project description:Genome-wide association studies have facilitated the discovery of thousands of loci for hundreds of phenotypes. However, the issue of missing heritability remains unsolved for most complex traits. Locus discovery could be enhanced with both improved power through multi-phenotype analysis (MPA) and use of a wider allele frequency range, including rare variants (RVs). MPA methods for single-variant association have been proposed, but given their low power for RVs, more efficient approaches are required. We propose multi-phenotype analysis of rare variants (MARV), a burden test-based method for RVs extended to the joint analysis of multiple phenotypes through a powerful reverse regression technique. Specifically, MARV models the proportion of RVs at which minor alleles are carried by individuals within a genomic region as a linear combination of multiple phenotypes, which can be both binary and continuous, and the method accommodates directly the genotyped and imputed data. The full model, including all phenotypes, is tested for association for discovery, and a more thorough dissection of the phenotype combinations for any set of RVs is also enabled. We show, via simulations, that the type I error rate is well controlled under various correlations between two continuous phenotypes, and that the method outperforms a univariate burden test in all considered scenarios. Application of MARV to 4876 individuals from the Northern Finland Birth Cohort 1966 for triglycerides, high- and low-density lipoprotein cholesterols highlights known loci with stronger signals of association than those observed in univariate RV analyses and suggests novel RV effects for these lipid traits.
| S-EPMC5513099 | biostudies-literature
Project description:Wheat plants are very sensitive to high temperature stress during grain filling. Effects of heat priming applied to the first generation on tolerance of the successive generation to post-anthesis high temperature stress were investigated. Compared with the progeny of non-heat primed plants (NH), the progeny of heat-primed plants (PH) possessed higher grain yield, leaf photosynthesis and activities of antioxidant enzymes and lower cell membrane damage under high temperature stress. In the transcriptome profile, 1430 probes showed obvious difference in expression between PH and NH. These genes were related to signal transduction, transcription, energy, defense, and protein destination and storage, respectively. The gene encoding the lysine-specific histone demethylase 1 (LSD1) which was involved in histone demethylation related to epigenetic modification was up-regulated in the PH compared with NH. The proteome analysis indicated that the proteins involved in photosynthesis, energy production and protein destination and storage were up-regulated in the PH compared with NH. In short, thermos-tolerance was induced through heritable epigenetic alternation and signaling transduction, both processes further triggered prompt modifications of defense related responses in anti-oxidation, transcription, energy production, and protein destination and storage in the progeny of the primed plants under high temperature stress. It was concluded that trans-generation thermo-tolerance was induced by heat priming in the first generation, and this might be an effective measure to cope with severe high-temperature stresses during key growth stages in wheat production.
| S-EPMC4830833 | biostudies-literature
Project description:In food processes, optimizing processing parameters is crucial to ensure food safety, maximize food quality, and minimize the formation of potentially toxigenic compounds. This research focuses on the simultaneous impacts that severe heat treatments applied to food may have on the formation of harmful chemicals and on microbiological safety. The case studies analysed consider the appearance/synthesis of acrylamide after a sterilization heat treatment for two different foods: pureed potato and prune juice, using Geobacillus stearothermophilus as an indicator. It presents two contradictory situations: on the one hand, the application of a high-temperature treatment to a low acid food with G. stearothermophilus spores causes their inactivation, reaching food safety and stability from a microbiological point of view. On the other hand, high temperatures favour the appearance of acrylamide. In this way, the two objectives (microbiological safety and acrylamide production) are opposed. In this work, we analyse the effects of high-temperature thermal treatments (isothermal conditions between 120 and 135 °C) in food from two perspectives: microbiological safety/stability and acrylamide production. After analysing both objectives simultaneously, it is concluded that, contrary to what is expected, heat treatments at higher temperatures result in lower acrylamide production for the same level of microbial inactivation. This is due to the different dynamics and sensitivities of the processes at high temperatures. These results, as well as the presented methodology, can be a basis of analysis for decision makers to design heat treatments that ensure food safety while minimizing the amount of acrylamide (or other harmful substances) produced.
| S-EPMC8624859 | biostudies-literature
Project description:This article contains the raw data on daily minimum temperature from 1976 to 2015 and energy consumption data from 1997 to 2015 in South Korea. The daily minimum temperature data were obtained from the observed record contained in the Korea Meteorological Administration Database. The monthly heat sales data were obtained from the Korea District Heating Corporation, which is a district heating public corporation. The heating energy sales data were collected from 1997 to 2015. We considered December, February, and December as winter season.
| S-EPMC7118299 | biostudies-literature
Project description:Hourly heat flux for variant boundary conditions of a novel controlled-temperature double skin façade (DSF) building element in a two- dimensional time- dependent study was determined. The building element is subjected to boundary conditions, characterizing different orientations (azimuth 0°, 90°, 180°, 270°) and climatic conditions of the four seasons. This data article provides detailed numerical data on the hourly heat flux, temperatures attained at the exterior and within the building element for six different geometries and for the variant boundary conditions under study. The external boundary conditions were determined with the use of the PVGIS tool, corrected in accordance to the sol-air temperature equation. The numerical simulation studies were performed with the use of the computational fluid dynamics (CFD) tool Comsol Multiphysics [2].
| S-EPMC8257991 | biostudies-literature