Norovirus Extraction from Frozen Raspberries Using Magnetic Silica Beads.
Ontology highlight
ABSTRACT:
SUBMITTER: Raymond P
PROVIDER: S-EPMC8116234 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Norovirus outbreaks occur frequently in Denmark and it can be difficult to establish whether apparently independent outbreaks have the same origin. Here we report on six outbreaks linked to frozen raspberries, investigated separately over a period of 3 months. Norovirus from stools were sequence-typed; including extended sequencing of 1138 bp encompassing the hypervariable P2 region of the capsid gene. Norovirus was detected in 27 stool samples. Genotyping showed genotype GI.Pb_GI.6 (polymerase/capsid) with 100% identical sequences. Samples from five outbreaks were furthermore identical over the variable capsid P2 region. In one outbreak at a hospital canteen, frozen raspberries was associated with illness by cohort investigation (relative risk 6·1, 95% confidence interval 3·2-11). Bags of raspberries suspected to be the source were positive for genogroup I and II noroviruses, one typable virus was genotype GI.6 (capsid). These molecular investigations showed that the apparently independent outbreaks were the result of one contamination event of frozen raspberries. The contaminated raspberries originated from a single producer in Serbia and were originally not considered to belong to the same batch. The outbreaks led to consultations and mutual visits between producers, investigators and authorities. Further, Danish legislation was changed to make heat-treatment of frozen raspberries compulsory in professional catering establishments.
| S-EPMC9150961 | biostudies-literature
Project description:The complex and lengthy protocol of current viral nucleic acid extraction processes limits their use outside laboratory settings. Here, we describe a rapid and reliable method for extracting nucleic acids from viral samples using a rotating blade and magnetic beads. The viral membrane can be instantly lysed using a high-speed rotating blade, and nucleic acids can be immediately isolated using a silica magnetic surface. The process was completed within 60 s by this method. Routine washing and eluting processes were subsequently conducted within 5 min. The results achieved by this method were comparable to those of a commercially available method. When the blade-based lysis and magnetic bead adsorption processes were performed separately, the RNA recovery rate was very low, and the Ct value was delayed compared to simultaneous lysis and RNA adsorption. Overall, this method not only dramatically shortens the conventional extraction time but also allows for its convenient use outside the laboratory, such as at remote field sites and for point-of-care testing.
| S-EPMC9407373 | biostudies-literature
Project description:Current extraction methods often extract DNA and RNA separately, and few methods are capable of co-extracting DNA and RNA from sputum. We established a nucleic acid co-extraction method from sputum based on magnetic beads and optimized the method by evaluating influencing factors, such as the guanidinium thiocyanate (GTC) and dithiothreitol (DTT) concentrations, magnetic bead amount, incubation temperature, lysis buffer pH and RNA carrier type. The feasibility of the simultaneous nucleic acid co-extraction method was evaluated by amplifying DNA and RNA viruses from a single clinical specimen with a multiplex RT-qPCR method. Both DNA and RNA were most efficiently extracted when the GTC and DTT concentrations were 2.0 M and 80 mM, respectively, 20 μl magnetic beads were added, the incubation temperature was 80 °C, the pH was 8 or 9, and RNA carrier A was used. Therefore, we established a simple method to extract nucleic acids from two important respiratory viruses compared with other commercial kits. This magnetic beads-based co-extraction method for sputum followed by a multiplex RT-qPCR can rapidly and precisely detect DNA and RNA viruses from a single clinical specimen and has many advantages, such as decreased time, low cost, and a lack of harmful chemicals.
| S-EPMC5362898 | biostudies-literature
Project description:Filamentous fungi identification by Matrix-assisted laser desorption ionization time-of-flight mass spectrometry (MALDI-TOF MS) has been challenging due to the lack of simple and rapid protein extraction methods and insufficient species coverage in the database. In this study, we created two rapid protein extraction methods for filamentous fungi: a one-step zirconia-silica beads method (ZSB) and a focused-ultrasonication method (FUS). The identification accuracy of two methods were evaluated with the VITEK MS, as well as number of spectra peaks and signal-to-noise ratio (S/N) with M-Discover 100 MALDI-TOF MS compared to the routine method. The better method was applied to build a filamentous fungi in-house spectra library for the M-Discover 100 MS, and then another one and routine method were performed in parallel to verify the accuracy and commonality of the in-house library. Using the two optimized methods, the dedicated operating time before MALDI-TOF MS analysis was reduced from 30 min to 7 (ZSB) or 5 (FUS) min per sample, with only a few seconds added for each additional strain. And both two methods identified isolates from most mold types equal to or better than the routine method, and the total correct identification rate using VITEK MS was 79.67, 76.42, and 76.42%, respectively. On the other hand, the two rapid methods generally achieved higher maximum and minimum S/N ratios with these isolates tested as compared to the routine method. Besides, the ZSB method produced overall mean of maximum and minimum S/N ratio higher than that by FUS. An in-house library of M-Discover MS was successfully built from 135 isolates from 42 species belonging to 18 genera using the ZSB method. Analysis of 467 isolates resulted in 97.22% correctly identified isolates to the species level by the ZSB method versus 95.50% by the routine method. The two novel methods are time- and cost-effective and allow efficient identification of filamentous fungi while providing a simplified procedure to build an in-house library. Thus, more clinical laboratories may consider adopting MALDI-TOF MS for filamentous fungi identification in the future.
| S-EPMC8290857 | biostudies-literature
Project description:Rapid large-scale testing is essential for controlling the ongoing pandemic of severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2). The standard diagnostic pipeline for testing SARS-CoV-2 presence in patients with an ongoing infection is predominantly based on pharyngeal swabs, from which the viral RNA is extracted using commercial kits, followed by reverse transcription and quantitative PCR detection. As a result of the large demand for testing, commercial RNA extraction kits may be limited and, alternatively, non-commercial protocols are needed. Here, we provide a magnetic bead RNA extraction protocol that is predominantly based on in-house made reagents and is performed in 96-well plates supporting large-scale testing. Magnetic bead RNA extraction was benchmarked against the commercial QIAcube extraction platform. Comparable viral RNA detection sensitivity and specificity were obtained by fluorescent and colorimetric reverse transcription loop-mediated isothermal amplification (RT-LAMP) using a primer set targeting the N gene, as well as RT-qPCR using a primer set targeting the E gene, showing that the RNA extraction protocol presented here can be combined with a variety of detection methods at high throughput. Importantly, the presented diagnostic workflow can be quickly set up in a laboratory without access to an automated pipetting robot.
| S-EPMC7472728 | biostudies-literature
Project description:ObjectiveThis study constructed a model for the early diagnosis of gastric cancer by comparing the serum peptides profiles of patients with advanced gastric cancer and healthy people. And that model may be the potential to be applied for the efficacy evaluation and recurrence monitoring in gastric cancer.MethodsSerums of 30 healthy people and 30 advanced gastric cancer patients were matched by age and gender were collected. The serum peptide spectrum was obtained by MB-WCX concentration and MALDI-TOF MS analysis. Based on the analysis of the efficiency of differential peptides in the diagnosis of gastric cancer, we first established a model for the diagnosis of gastric cancer based on differential peptides and then carried out external verification. The diagnostic reliability of this model was further tested by compared with carcinoembryonic antigen (CEA) and carbohydrate antigen 19-9 (CA19-9).ResultsIn this present study, we found the expression of two peptide peaks with a molecular weight of 2863 Da and 2953 Da were significantly increased in gastric cancer serum, while the expression of two peptide peaks with a molecular weight of 1945 Da and 2082 Da were significantly decreased. Depending on the characteristics of peptide expression, we constructed a diagnostic model, we compared the sensitivity and specificity of the model established by 2953 Da/1945 Da, and found this model is significantly higher than CEA and CA19-9.ConclusionThere were some differences in serum peptides profiles between patients with advanced gastric cancer and healthy people. The serum peptide diagnostic models based on 2953 Da and 1945 Da have high diagnostic efficiency for advanced gastric cancer. Our result indicated that this model was well worth further validation for clinical diagnosis.
| S-EPMC7426759 | biostudies-literature
Project description:Beta-cyclodextrin (β-CD) was covalently immobilized on glass surface. Functionalized glass surface was characterized by X-ray photoelectron spectroscopy (XPS) and elemental analysis. Glass surface functionalized with β-CD was used to remove cholesterol from ghee (clarified butter fat). 78.8 % cholesterol was reduced in 2 h at 25 °C and 170 rpm. Same surface was used repeatedly for 10 cycles and no reduction in cholesterol removal efficiency was observed. Modified glass surface showed almost no degradation in repeated use in cholesterol reduction experiments.
| S-EPMC4325052 | biostudies-literature
Project description:Current molecular biology laboratories rely heavily on the purification and manipulation of nucleic acids. Yet, commonly used centrifuge- and column-based protocols require specialised equipment, often use toxic reagents, and are not economically scalable or practical to use in a high-throughput manner. Although it has been known for some time that magnetic beads can provide an elegant answer to these issues, the development of open-source protocols based on beads has been limited. In this article, we provide step-by-step instructions for an easy synthesis of functionalised magnetic beads, and detailed protocols for their use in the high-throughput purification of plasmids, genomic DNA, RNA and total nucleic acid (TNA) from a range of bacterial, animal, plant, environmental and synthetic sources. We also provide a bead-based protocol for bisulfite conversion and size selection of DNA and RNA fragments. Comparison to other methods highlights the capability, versatility, and extreme cost-effectiveness of using magnetic beads. These open-source protocols and the associated webpage (https://bomb.bio) can serve as a platform for further protocol customisation and community engagement.
| S-EPMC6343928 | biostudies-literature
Project description:Due to the complexity of bioactive ingredients in biological samples, the screening of target proteins is a complex process. Herein, a feasible strategy for directing protein immobilization on silica magnetic beads for ligand fishing based on SpyTag/SpyCatcher (ST/SC)-mediated anchoring is presented. Carboxyl functional groups on the surface of silica-coated magnetic beads (SMBs) were coupled with SC using the 1-ethyl-3-(3-dimethylaminopropyl) carbodiimide hydrochloride/N-hydroxysulfosuccinimide method, named SC-SMBs. The green fluorescent protein (GFP), as the capturing protein model, was ST-labeled and anchored at a specific orientation onto the surface of SC-SMBs directly from relevant cell lysates via ST/SC self-ligation. The characteristics of the SC-SMBs were studied via electron microscopy, energy dispersive spectroscopy, and Fourier transform infrared spectroscopy. The spontaneity and site-specificity of this unique reaction were confirmed via electrophoresis and fluorescence analyses. Although the alkaline stability of ST-GFP-ligated SC-SMBs was not ideal, the formed isopeptide bond was unbreakable under acidic conditions (0.05 M glycine-HCl buffer, pH 1-6) for 2 h, under 20% ethanol solution within 7 days, and at most temperatures. We, therefore, present a simple and universal strategy for the preparation of diverse protein-functionalized SMBs for ligand fishing, prompting its usage on drug screening and target finding.
| S-EPMC9257657 | biostudies-literature
Project description:Nucleic acid (NA) extraction is an essential step in molecular testing for a wide range of applications. Conventional extraction protocols usually suffer from time consuming removal of non-nucleic acid impurities. In this study, a new magnetic nanoparticle (MNP) is presented to simplify the NA extraction. A core-shell design, comprising of a ferromagnetic core coated with mesoporous silica, forms the basis of the functional nanoparticle. Chemical functionalization of the silica coating includes a multistep synthesis, in which an activated nanoparticle is coupled with a triethylene glycol spaced glycosyl imidazole. The molecular design aims for charge interactions between the imidazolium-based positive nanoparticle surface and nucleic acids, with specific hydrogen bonding between the surface bonded carbohydrate and nucleic acid targets to ensure nucleic acid selectivity and avoid protein contamination. Two different carbohydrates, differing in molecular size, were selected to compare the efficiency in terms of NA extraction. A triethylene glycol spacer provides sufficient flexibility to remove particle surface constraints for the interaction. The Brunauer-Emmett-Teller (BET) analysis shows a significantly larger surface area for the disaccharide-based particles NpFeSiImMalt (∼181 m2 g-1) compared to the monosaccharide analogue NpFeSiImGlc (∼116 m2 g-1) at small particles sizes (range ∼ 15 nm) and sufficient magnetization (29 emu g-1) for easy isolation by an external magnetic field. The particles enabled a high DNA particle loading ratio of 30-45 wt% (MNP/DNA ratio), reflecting an efficient extraction process. A high desorption rate (7 min) with more than 86% of unchanged DNA loading was recorded, indicating low damage to the target extract.
| S-EPMC9069700 | biostudies-literature