Chemosensitive Thin Films Active to Ammonia Vapours.
Ontology highlight
ABSTRACT:
SUBMITTER: Brochocka A
PROVIDER: S-EPMC8122796 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Halogenated metal phthalocyanines are promising materials for the manufacture of active layers of chemiresistive sensors for the detection of various gases. Despite the high interest in such sensors, there are few systematic studies of the position of halogen substituents in phthalocyanine macroring on the chemiresistive response of their films to gases. In this work, we prepared and studied films of novel tetrachlorosubstituted vanadyl phthalocyanine derivatives with Cl substituents in the peripheral (VOPcCl4-p) and nonperipheral (VOPcCl4-np) positions of the phthalocyanine ring as active layers of chemiresistive sensors to reveal the effect of the position of substituents on their structure and sensor response to low concentrations of NH3. It was shown that the films of VOPcCl4-p exhibited a noticeably higher sensor response to NH3 than the VOPcCl4-np ones. The limit of detection of NH3 was 0.7 ppm. The sensing layers demonstrated a reversible sensor response at room temperature with fairly low response/recovery times. It was also demonstrated that NH3 can be detected in the presence of various interfering gases (CO2 and H2) and some volatile organic vapors, as well as in a mixture of gases with a composition close to exhaled air.
| S-EPMC10534441 | biostudies-literature
Project description:Titanium dioxide photoanodes for hydrogen generation suffer from a profound mismatch between the optical absorption of TiO2 and the solar spectrum. To solve the problem of low solar-to-chemical efficiency, optically active materials are proposed. In this work, TiO2 thin films containing erbium were deposited by radio frequency RF magnetron sputtering under ultrahigh vacuum conditions UHV. Morphology, structural, optical and electronic properties were studied. TiO2:Er thin films are homogenous, with uniform distribution of Er ions and high transparency over the visible VIS range of the light spectrum. However, a profound 0.4 eV blue shift of the fundamental absorption edge with respect to undoped TiO2 was observed, which can be attributed either to the size effect due to amorphization of TiO2 host or to the onset of precipitation of Er2Ti2O7 nanocrystals. Near-infrared NIR to VIS up-conversion is demonstrated upon excitation at 980 nm, while strong green photoluminescence at 525 and 550 nm occurs upon photon absorption at 488 nm.
| S-EPMC8348420 | biostudies-literature
Project description:Open porous and transparent microcolumnar structures of TiO₂ prepared by physical vapour deposition in glancing angle configuration (GLAD-PVD) have been used as host matrices for two different fluorescent cationic porphyrins, 5-(N-methyl 4-pyridyl)-10,15,20-triphenyl porphine chloride (MMPyP) and meso-tetra (N-methyl 4-pyridyl) porphine tetrachloride (TMPyP). The porphyrins have been anchored by electrostatic interactions to the microcolumns by self-assembly through the dip-coating method. These porphyrin/TiO₂ composites have been used as gas sensors for ammonia and amines through previous protonation of the porphyrin with HCl followed by subsequent exposure to the basic analyte. UV-vis absorption, emission, and time-resolved spectroscopies have been used to confirm the protonation-deprotonation of the two porphyrins and to follow their spectral changes in the presence of the analytes. The monocationic porphyrin has been found to be more sensible (up to 10 times) than its tetracationic counterpart. This result has been attributed to the different anchoring arrangements of the two porphyrins to the TiO₂ surface and their different states of aggregation within the film. Finally, there was an observed decrease of the emission fluorescence intensity in consecutive cycles of exposure and recovery due to the formation of ammonium chloride inside the film.
| S-EPMC5298597 | biostudies-literature
Project description:Intercalated metal-organic framework (iMOF) type electrochemically active aromatic metal carboxylates are intriguing material candidates for various energy storage devices and microelectronics. In this work, we grow in situ crystalline thin films of such materials through atomic/molecular layer deposition (ALD/MLD); the remarkable benefit of this approach is the possibility to evaluate their electrochemical properties in a simple cell configuration without any additives. Five organic linkers are investigated in combination with lithium: terephthalic acid (TPA), 3,5-pyridinedicarboxylic acid (PDC), 2,6-naphthalenedicarboxylic acid (NDC), 4,4'-biphenyldicarboxylic acid (BPDC), and 4,4'-azobenzenedicarboxylic acid (AZO). In particular, the electrochemical activity of Li-PDC and the crystal structure of Li-AZO are addressed here for the first time. We believe that the in situ gas-phase thin-film deposition is a crucial requirement to benefit from the iMOF-type electrode materials in, e.g., microelectronics and wearable devices.
| S-EPMC7503526 | biostudies-literature
Project description:Recent progress in tissue engineering has made it possible to build contractile bio-hybrid materials that undergo conformational changes by growing a layer of cardiac muscle on elastic polymeric membranes. Further development of such muscular thin films for building actuators and powering devices requires exploring several design parameters, which include the alignment of the cardiac myocytes and the thickness/Young's modulus of elastomeric film. To more efficiently explore these design parameters, we propose a 3-D phenomenological constitutive model, which accounts for both the passive deformation including pre-stretch and the active behavior of the cardiomyocytes. The proposed 3-D constitutive model is implemented within a finite element framework, and can be used to improve the current design of bio-hybrid thin films and help developing bio-hybrid constructs capable of complex conformational changes.
| S-EPMC3294204 | biostudies-literature
Project description:Unambiguous and selective standoff (non-contact) infield detection of nitro-containing explosives and taggants is an important goal but difficult to achieve with standard analytical techniques. Oxidative fluorescence quenching is emerging as a high sensitivity method for detecting such materials but is prone to false positives—everyday items such as perfumes elicit similar responses. Here we report thin films of light-emitting dendrimers that detect vapours of explosives and taggants selectively—fluorescence quenching is not observed for a range of common interferents. Using a combination of neutron reflectometry, quartz crystal microbalance and photophysical measurements we show that the origin of the selectivity is primarily electronic and not the diffusion kinetics of the analyte or its distribution in the film. The results are a major advance in the development of sensing materials for the standoff detection of nitro-based explosive vapours, and deliver significant insights into the physical processes that govern the sensing efficacy.
| S-EPMC4579782 | biostudies-literature
Project description:Taking our current environmental situation in the world into consideration, people should face growing problems of air and water pollution. Heterogeneous photocatalysis is a highly promising tool to improve both air and water quality through decomposition/mineralization of contaminants directly into harmless CO2 and H2O under ambient conditions. In this contribution, we focused on the synthesis of self-assembly WO3 thin films via an electrochemical approach in the aqueous electrolyte containing fluoride ions toward air purification. The effect of preparation conditions such as applied potential (10-50 V), anodization time (15-120 min), concentration of H2SO4 (0.5-1.5 M) and NaF (0.1-1.0 wt.%) on the morphology, photocurrent response, and photocatalytic activity addressed to removal of air pollutant in the presence of as-prepared WO3 samples were thoroughly examined and presented. The results revealed the growth of nanoplatelets and their gradual transformation into flower-like structures. The oxide layers and platelet thickness of the WO3 samples were found to be proportionally related with the synthesis conditions. The photocatalytic ability toward air purification was evaluated by degradation of toluene from air mixture using low-powered LEDs as an irradiation source (λmax = 415 nm). The highest photoactivity was achieved in presence of the sample which possessed a well-ordered, regular shape and repeatable distribution of flower buds (100% of degradation). The results have confirmed that the oxide layer thickness of the anodic WO3 significantly affected the photocatalytic activity, which increased with the increasing thickness of WO3 (to 1.05 μm) and then had a downward trend. The photocurrent response evidenced that the well-organized sample had the highest ability in photocurrent generation under UV-Vis and Vis irradiation. Finally, a possible growth mechanism of WO3 NFs was also discussed.
| S-EPMC7475911 | biostudies-literature
Project description:On length scales from nanometres to metres, partial adhesion of thin films with substrates generates a fascinating variety of patterns, such as 'telephone cord' buckles, wrinkles, and labyrinth domains. Although these patterns are part of everyday experience and are important in industry, they are not completely understood. Here, we report simulation studies of a previously-overlooked phenomenon in which pairs of wrinkles form avoiding pairs, focusing on the case of graphene over patterned substrates. By nucleating and growing wrinkles in a controlled way, we characterize how their morphology is determined by stress fields in the sheet and friction with the substrate. Our simulations uncover the generic behaviour of avoiding wrinkle pairs that should be valid at all scales.
| S-EPMC4355740 | biostudies-literature
Project description:We present the fabrication of nanoscale electroactive thin films that can be engineered to undergo remotely controlled dissolution in the presence of a small applied voltage (+1.25 V) to release precise quantities of chemical agents. These films, which are assembled by using a nontoxic, FDA-approved, electroactive material known as Prussian Blue, are stable enough to release a fraction of their contents after the application of a voltage and then to restabilize upon its removal. As a result, it is possible to externally trigger agent release, exert control over the relative quantity of agents released from a film, and release multiple doses from one or more films in a single solution. These electroactive systems may be rapidly and conformally coated onto a wide range of substrates without regard to size, shape, or chemical composition, and as such they may find use in a host of new applications in drug delivery as well as the related fields of tissue engineering, medical diagnostics, and chemical detection.
| S-EPMC2268127 | biostudies-literature
Project description:Intrinsically conducting polymers (ICPs) have been widely utilized in organic electronics, actuators, electrochromic devices, and sensors. Many potential applications demand the formation of thin polymer films, which can be generated by electrochemical polymerization. Electrochemical methods are quite powerful and versatile and can be utilized for investigation of ICPs, both for educational purposes and materials chemistry research. In this study, we show that potentiodynamic and potentiostatic techniques can be utilized for generating and characterizing thin polymer films under the context of educational chemistry research and state-of-the-art polymer research. First, two well-known bifunctional monomers (with only two linking sites)-aniline and bithiophene-and their respective ICPs-polyaniline (PANI) and polybithiophene (PBTh)-were electrochemically generated and characterized. Tests with simple electrochromic devices based on PANI and PBTh were carried out at different doping levels, where changes in the UV-VIS absorption spectra and color were ascribed to changes in the polymer structures. These experiments may attract students' interest in the electrochemical polymerization of ICPs as doping/dedoping processes can be easily understood from observable color changes to the naked eye, as shown for the two polymers. Second, two new carbazole-based multifunctional monomers (with three or more linking sites)-tris(4-(carbazol-9-yl)phenyl)silanol (TPTCzSiOH) and tris(3,5-di(carbazol-9-yl)phenyl)silanol (TPHxCzSiOH)-were synthesized to produce thin films of cross-linked polymer networks by electropolymerization. These thin polymer films were characterized by electrochemical quartz crystal microbalance (EQCM) experiments and nitrogen sorption, and the results showed a microporous nature with high specific surface areas up to 930 m2g-1. PTPHxCzSiOH-modified glassy carbon electrodes showed an enhanced electrochemical response to nitrobenzene as prototypical nitroaromatic compound compared to unmodified glassy carbon electrodes.
| S-EPMC6723103 | biostudies-literature