Dataset Information

Food Waste-Assisted Metal Extraction from Printed Circuit Boards: The Aspergillus niger Route.

ABSTRACT: A low-energy paradigm was adopted for sustainable, affordable, and effective urban waste valorization. Here a new, eco-designed, solid-state fermentation process is presented to obtain some useful bio-products by recycling of different wastes. Urban food waste and scraps from trimmings were used as a substrate for the production of citric acid (CA) by solid state fermentation of Aspergillus niger NRRL 334, with a yield of 20.50 mg of CA per gram of substrate. The acid solution was used to extract metals from waste printed circuit boards (WPCBs), one of the most common electronic waste. The leaching activity of the biological solution is comparable to a commercial CA one. Sn and Fe were the most leached metals (404.09 and 67.99 mg/L, respectively), followed by Ni and Zn (4.55 and 1.92 mg/L) without any pre-treatments as usually performed. Commercial CA extracted Fe more efficiently than the organic one (123.46 vs. 67.99 mg/L); vice versa, biological organic CA recovered Ni better than commercial CA (4.55 vs. 1.54 mg/L). This is the first approach that allows the extraction of metals from WPCBs through CA produced by A. niger directly grown on waste material without any sugar supplement. This "green" process could be an alternative for the recovery of valuable metals such as Fe, Pb, and Ni from electronic waste.

SUBMITTER: Alias C

PROVIDER: S-EPMC8143491 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Similar Datasets

Project description:Deep eutectic solvents (DESs) are an emerging class of ionic liquids that offer a solution to reclaiming technology critical metals (TCMs) from electronic waste, with potential for improved life cycle analysis. The high viscosities typical of DESs, however, impose mass transport limitations such that passive TCM removal generally requires immersion over extended durations, in some cases in the order of hours. It is postulated that, through the targeted application of power ultrasound, delamination of key structures in electronic components immersed in DESs can be significantly accelerated, thereby enabling rapid recovery of TCMs. In this paper, we fully characterise cavitation in a Choline Chloride-Ethylene Glycol DES as a function of sonotrode input power, by the acoustic detection of the bubble collapse shockwave content generated during sonications at more than 20 input powers over the available range. This justifies the selection of two powers for a detailed study of ultrasonically enhanced TCM-delamination from printed circuit boards (PCBs). Dual-perspective high-speed imaging is employed, which facilitates simultaneous observation of TCM removal, and the cavitation evolution and interaction with the PCB surface. Bubble jetting is identified as a key contributor to initial pitting of the TCM layers, exposing the larger underlying copper layer, with the contributions of additional inertial cavitation-mediated phenomena such as bubble-collapse shockwaves also demonstrated as important for delamination. Optimal cavitation activity throughout the sonication then promotes etching of the copper base layer of the PCB structure targeted by the DES, liberating the overlaying TCMs in sections as large as 0.79 mm2. We report a thirtyfold improvement in processing time compared to passive delamination, with sonications at the lower power outperforming those at the higher power. The results demonstrate the potential for industrially scalable recovery of TCMs from the growing quantities of global e-waste, using combined power ultrasonics and DESs.

Dataset Information

Food Waste-Assisted Metal Extraction from Printed Circuit Boards: The Aspergillus niger Route.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets