Hydrophilic Character of Single-Layer MoS2 Grown on Ag(111).
Ontology highlight
ABSTRACT:
SUBMITTER: Tumino F
PROVIDER: S-EPMC8154856 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:A controllable approach that combines surface plasmon resonance and two-dimensional (2D) graphene/MoS2 heterojunction has not been implemented despite its potential for efficient photoelectrochemical (PEC) water splitting. In this study, plasmonic Ag-decorated 2D MoS2 nanosheets were vertically grown on graphene substrates in a practical large-scale manner through metalorganic chemical vapor deposition of MoS2 and thermal evaporation of Ag. The plasmonic Ag-decorated MoS2 nanosheets on graphene yielded up to 10 times higher photo-to-dark current ratio than MoS2 nanosheets on indium tin oxide. The significantly enhanced PEC activity could be attributed to the synergetic effects of SPR and favorable graphene/2D MoS2 heterojunction. Plasmonic Ag nanoparticles not only increased visible-light and near-infrared absorption of 2D MoS2, but also induced highly amplified local electric field intensity in 2D MoS2. In addition, the vertically aligned 2D MoS2 on graphene acted as a desirable heterostructure for efficient separation and transportation of photo-generated carriers. This study provides a promising path for exploiting the full potential of 2D MoS2 for practical large-scale and efficient PEC water-splitting applications.
| S-EPMC7770824 | biostudies-literature
Project description:The exceptional electronic and photonic properties of the monolayers of transition metal dichalcogenides including the spin-orbit splitting of the valence and conduction bands at the K points of the Brillouin zone make them promising for novel applications in electronics, photonics and optoelectronics. Scalable growth of these materials and understanding of their interaction with the substrate is crucial for these applications. Here we report the growth of MoS2 and MoSe2 monolayers on Au(111) by chemical vapor deposition at ambient pressure as well as the analysis of their structural and electronic properties down to the atomic scale. To this aim, we apply ultrahigh vacuum surface sensitive techniques including scanning tunneling microscopy and spectroscopy, low-energy electron diffraction, X-ray and angle-resolved ultraviolet photoelectron spectroscopy in combination with Raman spectroscopy at ambient conditions. We demonstrate the growth of high-quality epitaxial single crystalline MoS2 and MoSe2 monolayers on Au(111) and show the impact of annealing on the monolayer/substrate interaction. Thus, as-grown and moderately annealed (<100 °C) MoSe2 monolayers are decoupled from the substrate by excess Se atoms, whereas annealing at higher temperatures (>250 °C) results in their strong coupling with the substrate caused by desorption of the excess Se. The MoS2 monolayers are strongly coupled to the substrate and the interaction remains almost unchanged even after annealing up to 450 °C.
| S-EPMC10729873 | biostudies-literature
Project description:The potential for tuning the electronic structure of materials to control reactivity and selectivity in heterogenous catalysis has driven interest in ultrathin metal films which may differ from their bulk form. Herein, a 1-atomic layer Ag film on Pd(111) (Ag/Pd(111)) is demonstrated to have dramatically different reactivity towards formic acid compared to bulk Ag. Formic acid decomposition is of interest as a source of H2 for fuel cell applications and modification of Pd by Ag reduces poisoning by CO and increases the selectivity for H2 formation. Formic acid reacts below room temperature on the 1-atomic layer Ag film, whereas no reaction occurs on pristine bulk Ag. Notably, 2 monolayer films of Ag again become unreactive towards formic acid, indicating a reversion to bulk behavior. A combination of infrared reflection absorption spectroscopy (IRRAS), X-ray photoelectron spectroscopy (XPS) and density functional theory (DFT) was used to establish that the Ag monolayer is continuous and electronically modified compared to bulk Ag. The work establishes a demonstration of the altered electronic structure of Ag monolayers on Pd(111) and an associated change in reactivity. The effect on reactivity only persists for the first layer, demonstrating the need for precise control of materials to exploit the modification in electronic properties.
| S-EPMC8159282 | biostudies-literature
Project description:Inspired by the unique properties of graphene, research efforts have broadened to investigations of various other two-dimensional materials with the aim of exploring their properties for future applications. Our combined experimental and theoretical study confirms the existence of a binary honeycomb structure formed by Ag and Te on Ag(111). Low-energy electron diffraction shows sharp spots which provide evidence of an undistorted AgTe layer. Band structure data obtained by angle-resolved photoelectron spectroscopy are closely reproduced by first-principles calculations, using density functional theory (DFT). This confirms the formation of a honeycomb structure with one Ag and one Te atom in the unit cell. In addition, the theoretical band structure reproduces also the finer details of the experimental bands, such as a split of one of the AgTe bands.
| S-EPMC7343276 | biostudies-literature
Project description:The 2D semiconductor of MoS2 has great potential for advanced electronics technologies beyond silicon. So far, high-quality monolayer MoS2 wafers have been available and various demonstrations from individual transistors to integrated circuits have also been shown. In addition to the monolayer, multilayers have narrower band gaps but improved carrier mobilities and current capacities over the monolayer. However, achieving high-quality multi-layer MoS2 wafers remains a challenge. Here we report the growth of high-quality multi-layer MoS2 4-inch wafers via the layer-by-layer epitaxy process. The epitaxy leads to well-defined stacking orders between adjacent epitaxial layers and offers a delicate control of layer numbers up to six. Systematic evaluations on the atomic structures and electronic properties were carried out for achieved wafers with different layer numbers. Significant improvements in device performances were found in thicker-layer field-effect transistors (FETs), as expected. For example, the average field-effect mobility (μ FE) at room temperature (RT) can increase from ∼80 cm2·V-1·s-1 for monolayers to ∼110/145 cm2·V-1·s-1 for bilayer/trilayer devices. The highest RT μ FE of 234.7 cm2·V-1·s-1 and record-high on-current densities of 1.70 mA·μm-1 at V ds = 2 V were also achieved in trilayer MoS2 FETs with a high on/off ratio of >107. Our work hence moves a step closer to practical applications of 2D MoS2 in electronics.
| S-EPMC9232293 | biostudies-literature
Project description:Monolayer molybdenum disulfide (MoS2), an emergent two-dimensional (2D) semiconductor, holds great promise for transcending the fundamental limits of silicon electronics and continue the downscaling of field-effect transistors. To realize its full potential and high-end applications, controlled synthesis of wafer-scale monolayer MoS2 single crystals on general commercial substrates is highly desired yet challenging. Here, we demonstrate the successful epitaxial growth of 2-inch single-crystal MoS2 monolayers on industry-compatible substrates of c-plane sapphire by engineering the formation of a specific interfacial reconstructed layer through the S/MoO3 precursor ratio control. The unidirectional alignment and seamless stitching of MoS2 domains across the entire wafer are demonstrated through cross-dimensional characterizations ranging from atomic- to centimeter-scale. The epitaxial monolayer MoS2 single crystal shows good wafer-scale uniformity and state-of-the-art quality, as evidenced from the ~100% phonon circular dichroism, exciton valley polarization of ~70%, room-temperature mobility of ~140 cm2v-1s-1, and on/off ratio of ~109. Our work provides a simple strategy to produce wafer-scale single-crystal 2D semiconductors on commercial insulator substrates, paving the way towards the further extension of Moore's law and industrial applications of 2D electronic circuits.
| S-EPMC10901795 | biostudies-literature
Project description:Two-dimensional materials have the potential to be applied in flexible and transparent electronics. In this study, single-layer MoS2 field-effect transistors (FETs) with Au/Ti-graphene heteroelectrodes were fabricated to examine the effect of the electrodes on the electrical properties of the MoS2 FETs. The contact barrier potential was tuned using an electric field. Asymmetrical gate behavior was observed owing to the difference between the MoS2 FETs, specifically between the MoS2 FETs with Au/Ti electrodes and those with graphene electrodes. The contact barrier of the MoS2 FETs with Au/Ti electrodes did not change with the electric field. However, the contact barrier at the MoS2-graphene interface could be modulated. The MoS2 FETs with Au/Ti-graphene electrodes exhibited enhanced on/off ratios (~102 times) and electron mobility (~2.5 times) compared to the MoS2 FETs with Au/Ti electrodes. These results could improve the understanding of desirable contact formation for high-performance MoS2 FETs and provide a facile route for viable electronic applications.
| S-EPMC9458018 | biostudies-literature
Project description:Sensing ultra-low levels of toxic chemicals such as H2S is crucial for many technological applications. In this report, employing density functional theory (DFT) calculations, we shed light on the underlying physical phenomena involved in the adsorption and sensing of the H2S molecule on both pristine and strained single-layer molybdenum disulfide (SL-MoS2) substrates. We demonstrate that the H2S molecule is physisorbed on SL-MoS2 for all values of strain, i.e. from -8% to +8%, with a modest electron transfer, ranging from 0.023e- to 0.062e-, from the molecule to the SL-MoS2. According to our calculations, the electron-donating behaviour of the H2S molecule is halved under compressive strains. Moreover, we calculate the optical properties upon H2S adsorption and reveal the electron energy loss (EEL) spectra for various concentrations of the H2S molecule which may serve as potential probes for detecting H2S molecules in prospective sensing applications based on SL-MoS2.
| S-EPMC9419238 | biostudies-literature
Project description:Integrating different dimentional materials on vertically stacked p-n hetero-junctions have facinated a considerable scrunity and can open up excellent feasibility with various functionalities in opto-electronic devices. Here, we demonstrate that vertically stacked p-GaN/SiO2/n-MoS2/Graphene heterostructures enable to exhibit prominent dual opto-electronic characteristics, including efficient photo-detection and light emission, which represents the emergence of a new class of devices. The photoresponsivity was found to achieve as high as ~10.4 AW-1 and the detectivity and external quantum efficiency were estimated to be 1.1 × 1010 Jones and ~30%, respectively. These values are superier than most reported hererojunction devices. In addition, this device exhibits as a self-powered photodetector, showing a high responsivity and fast response speed. Moreover, the device demonstrates the light emission with low turn-on voltage (~1.0 V) which can be realized by electron injection from graphene electrode and holes from GaN film into monolayer MoS2 layer. These results indicate that with a suitable choice of band alignment, the vertical stacking of materials with different dimentionalities could be significant potential for integration of highly efficient heterostructures and open up feasible pathways towards integrated nanoscale multi-functional optoelectronic devices for a variety of applications.
| S-EPMC5577265 | biostudies-literature
Project description:Accurately modeling heterogeneous catalysis requires accurate descriptions of rate-controlling elementary reactions of molecules on metal surfaces, but standard density functionals (DFs) are not accurate enough for this. The problem can be solved with the specific reaction parameter approach to density functional theory (SRP-DFT), but the transferability of SRP DFs among chemically related systems is limited. We combine the MS-PBEl, MS-B86bl, and MS-RPBEl semilocal made simple (MS) meta-generalized gradient approximation (GGA) (mGGA) DFs with rVV10 nonlocal correlation, and we evaluate their performance for the hydrogen (H2) + Cu(111), deuterium (D2) + Ag(111), H2 + Au(111), and D2 + Pt(111) gas-surface systems. The three MS mGGA DFs that have been combined with rVV10 nonlocal correlation were not fitted to reproduce particular experiments, nor has the b parameter present in rVV10 been reoptimized. Of the three DFs obtained the MS-PBEl-rVV10 DF yields an excellent description of van der Waals well geometries. The three original MS mGGA DFs gave a highly accurate description of the metals, which was comparable in quality to that obtained with the PBEsol DF. Here, we find that combining the three original MS mGGA DFs with rVV10 nonlocal correlation comes at the cost of a slightly less accurate description of the metal. However, the description of the metal obtained in this way is still better than the descriptions obtained with SRP DFs specifically optimized for individual systems. Using the Born-Oppenheimer static surface (BOSS) model, simulations of molecular beam dissociative chemisorption experiments yield chemical accuracy for the D2 + Ag(111) and D2 + Pt(111) systems. A comparison between calculated and measured E 1/2(ν, J) parameters describing associative desorption suggests chemical accuracy for the associative desorption of H2 from Au(111) as well. Our results suggest that ascending Jacob's ladder to the mGGA rung yields increasingly more accurate results for gas-surface reactions of H2 (D2) interacting with late transition metals.
| S-EPMC8162760 | biostudies-literature