Estimation of Vibration Characteristics of a Space Manipulator From Air Bearing Supported Test Data.
Ontology highlight
ABSTRACT:
SUBMITTER: Li H
PROVIDER: S-EPMC8155630 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Vibration signal analysis is an important means for bearing fault detection/diagnosis and bearings often operate under time-varying rotational speed conditions. This data article contains vibration datasets collected from bearings with different health conditions under different time-varying speed conditions. The health conditions of the bearing include healthy, faulty with an inner race defect, and faulty with an outer race defect. The operating rotational speed conditions for the dataset include increasing speed, decreasing speed, increasing then decreasing speed, and decreasing then increasing speed. Mendeley Data, http://dx.doi.org/10.17632/v43hmbwxpm.1.
| S-EPMC6249544 | biostudies-literature
Project description:The Fluid Physics Research Rack (FPR) is a research platform employed on-board the Chinese Space Station for conducting microgravity fluid physics experiments. The research platform includes the Microgravity Active Vibration Isolation System (MAVIS) for isolating the FPR from disturbances arising from the space station itself. The MAVIS is a structural platform consisting of a stator and floater that are monitored and controlled with non-contact electromagnetic actuators, high-precision accelerometers, and displacement transducers. The stator is fixed to the FPR, while the floater serves as a vibration isolation platform supporting payloads, and is connected with the stator only with umbilicals that mainly comprise power and data cables. The controller was designed with a correction for the umbilical stiffness to minimize the effect of the umbilicals on the vibration isolation performance of the MAVIS. In-orbit test results of the FPR demonstrate that the MAVIS was able to achieve a microgravity level of 1-30 μg0 (where g0 = 9.80665 m ∙ s-2) in the frequency range of 0.01-125 Hz under the microgravity mode, and disturbances with a frequency greater than 2 Hz are attenuated by more than 10-fold. Under the vibration excitation mode, the MAVIS generated a minimum vibration acceleration of 0.4091 μg0 at a frequency of 0.00995 Hz and a maximum acceleration of 6253 μg0 at a frequency of 9.999 Hz. Therefore, the MAVIS provides a highly stable environment for conducting microgravity experiments, and promotes the development of microgravity fluid physics.
| S-EPMC11372040 | biostudies-literature
Project description:The soft robot manipulator is attracting attention in the surgical fields with its intrinsic softness, lightness in its weight, and safety toward the human organ. However, it cannot be used widely because of its difficulty of control. To control a soft robot manipulator accurately, shape sensing is essential. This paper presents a method of estimating the shape of a soft robot manipulator by using a skin-type stretchable sensor composed of a multiwalled carbon nanotube (MWCNT) and silicone (p7670). The sensor can be easily fabricated and applied by simply attaching it to the surface of the soft manipulator. In its fabrication, MWCNT is sprayed on a teflon sheet, and liquid-state silicone is poured on it. After curing, we turn it over and cover it with another silicone layer. The sensor is fabricated with a sandwich structure to decrease the hysteresis of the sensor. After calibration and determining the relationship between the resistance of the sensor and the strain, three sensors are attached at 120° intervals. Using the obtained data, the curvature of the manipulator is calculated, and the entire shape is reconstructed. To validate its accuracy, the estimated shape is compared with the camera data. We experiment with three, six, and nine sensors attached, and the result of the error of shape estimation is compared. As a result, the minimum tip position error is approximately 8.9 mm, which corresponded to 4.45% of the total length of the manipulator when using nine sensors.
| S-EPMC9494719 | biostudies-literature
Project description:The 2D computational fluid dynamics (CFD) model of transmission conductor is set up to simulate the aerodynamic forces varying with time on the conductor. Taking into account the geometrical nonlinearity of conductor lines, the finite element (FE) models of single span and two-span transmission lines discretized with beam elements are established. By means of the FE models, the aeolian vibrations of the conductor lines excited by the aerodynamic forces under different wind velocities are numerically simulated. The nonlinear resonant characteristics, the amplitude-frequency relations of the conductor lines during aeolian vibration are investigated, and the influences of the span length as well as the initial tension in conductors on the aeolian vibration characteristics are analyzed. Furthermore, a 3D FE model of a conductor segment and the suspension clamp is created to study the stress distributions of the 3D model corresponding to different lines during aeolian vibrations. Finally, based on the stress analysis of the 3D model, the fatigue lives of the transmission conductors during aeolian vibration under different wind velocities are estimated. The jump phenomenon induced by the nonlinear vibration is reflected by the numerical simulation considering the geometric nonlinearity, and it is found that the energy balance principle (EBP) overestimates the vibration amplitudes because it cannot take the influences of the geometrical nonlinearity and span length into account. The obtained results may provide some instructions for the prevention design of aeolian vibration.
| S-EPMC8791497 | biostudies-literature
Project description:We developed scalable radiation dosimeter based on non-coding miR-150 (radiation sensitive) normalized to endogenous miR-23a (radiation insensitive). This nanoString assay revealed the expression of miR-150 and miR-23a in normal healthy volunteers serum blood cell subsets.
2020-07-15 | GSE116880 | GEO
Project description:Acoustic telemetry has helped overcome many of the challenges faced when studying the movement ecology of aquatic species, allowing to obtain unprecedented amounts of data. This has made it into one of the most widely used methods nowadays. Many ways to analyse acoustic telemetry data have been made available and deciding on how to analyse the data requires considering the type of research objectives, relevant properties of the data (e.g., resolution, study design, equipment), habits of the study species, researcher experience, among others. To ease this decision process, here we showcase (1) some of the methods used to estimate pseudo-positions and positions from raw acoustic telemetry data, (2) methods to estimate residency and (3) methods to estimate two-dimensional home and occurrence range using geometric or hull-based methods and density-distribution methods, a network-based approach, and three-dimensional methods. We provide examples of some of these were tested using a sample of real data. With this we intend to provide the necessary background for the selection of the method(s) that better fit specific research objectives when using acoustic telemetry.
| S-EPMC9976422 | biostudies-literature
Project description:Air quality modeling could potentially improve exposure estimates for use in epidemiological studies. We investigated this application of air quality modeling by estimating location-specific (point) and spatially-aggregated (county level) exposure concentrations of particulate matter with an aerodynamic diameter less than or equal to 2.5 μm (PM(2.5)) and ozone (O(3)) for the eastern U.S. in 2002 using the Community Multi-scale Air Quality (CMAQ) modeling system and a traditional approach using ambient monitors. The monitoring approach produced estimates for 370 and 454 counties for PM(2.5) and O(3), respectively. Modeled estimates included 1861 counties, covering 50% more population. The population uncovered by monitors differed from those near monitors (e.g., urbanicity, race, education, age, unemployment, income, modeled pollutant levels). CMAQ overestimated O(3) (annual normalized mean bias=4.30%), while modeled PM(2.5) had an annual normalized mean bias of -2.09%, although bias varied seasonally, from 32% in November to -27% in July. Epidemiology may benefit from air quality modeling, with improved spatial and temporal resolution and the ability to study populations far from monitors that may differ from those near monitors. However, model performance varied by measure of performance, season, and location. Thus, the appropriateness of using such modeled exposures in health studies depends on the pollutant and metric of concern, acceptable level of uncertainty, population of interest, study design, and other factors.
| S-EPMC3543158 | biostudies-literature
Project description:In statistical inference, one has to make sure that the underlying regression model is correctly specified otherwise the resulting estimation may be biased. Model checking is an important method to detect any departure of the regression model from the true one. Missing data are a ubiquitous problem in social and medical studies. If the underlying regression model is correctly specified, recent researches show great popularity of the doubly robust (DR) estimates method for handling missing data because of its robustness to the misspecification of either the missing data model or the conditional mean model, that is, the model for the conditional expectation of true regression model conditioning on the observed quantities. However, little work has been devoted to the goodness of fit test for DR estimates method. In this article, we propose a testing method to assess the reliability of the estimator derived from the DR estimating equation with possibly missing response and always observed auxiliary variables. Numerical studies demonstrate that the proposed test can control type I errors well. Furthermore the proposed method can detect departures from model assumptions in the marginal mean model of interest powerfully. A real dementia data set is used to illustrate the method for the diagnosis of model misspecification in the problem of missing response with an always observed auxiliary variable for cross-sectional data.
| S-EPMC4061274 | biostudies-literature
Project description:Many people living in low and middle-income countries are not covered by civil registration and vital statistics systems. Consequently, a wide variety of other types of data including many household sample surveys are used to estimate health and population indicators. In this paper we combine data from sample surveys and demographic surveillance systems to produce small area estimates of child mortality through time. Small area estimates are necessary to understand geographical heterogeneity in health indicators when full-coverage vital statistics are not available. For this endeavor spatio-temporal smoothing is beneficial to alleviate problems of data sparsity. The use of conventional hierarchical models requires careful thought since the survey weights may need to be considered to alleviate bias due to non-random sampling and non-response. The application that motivated this work is estimation of child mortality rates in five-year time intervals in regions of Tanzania. Data come from Demographic and Health Surveys conducted over the period 1991-2010 and two demographic surveillance system sites. We derive a variance estimator of under five years child mortality that accounts for the complex survey weighting. For our application, the hierarchical models we consider include random effects for area, time and survey and we compare models using a variety of measures including the conditional predictive ordinate (CPO). The method we propose is implemented via the fast and accurate integrated nested Laplace approximation (INLA).
| S-EPMC4959836 | biostudies-literature
Project description:BackgroundA survey of presences and absences of specific species across multiple biogeographic units (or bioregions) are used in a broad area of biological studies from ecology to microbiology. Using binary presence-absence data, we evaluate species co-occurrences that help elucidate relationships among organisms and environments. To summarize similarity between occurrences of species, we routinely use the Jaccard/Tanimoto coefficient, which is the ratio of their intersection to their union. It is natural, then, to identify statistically significant Jaccard/Tanimoto coefficients, which suggest non-random co-occurrences of species. However, statistical hypothesis testing using this similarity coefficient has been seldom used or studied.ResultsWe introduce a hypothesis test for similarity for biological presence-absence data, using the Jaccard/Tanimoto coefficient. Several key improvements are presented including unbiased estimation of expectation and centered Jaccard/Tanimoto coefficients, that account for occurrence probabilities. The exact and asymptotic solutions are derived. To overcome a computational burden due to high-dimensionality, we propose the bootstrap and measurement concentration algorithms to efficiently estimate statistical significance of binary similarity. Comprehensive simulation studies demonstrate that our proposed methods produce accurate p-values and false discovery rates. The proposed estimation methods are orders of magnitude faster than the exact solution, particularly with an increasing dimensionality. We showcase their applications in evaluating co-occurrences of bird species in 28 islands of Vanuatu and fish species in 3347 freshwater habitats in France. The proposed methods are implemented in an open source R package called jaccard (https://cran.r-project.org/package=jaccard).ConclusionWe introduce a suite of statistical methods for the Jaccard/Tanimoto similarity coefficient for binary data, that enable straightforward incorporation of probabilistic measures in analysis for species co-occurrences. Due to their generality, the proposed methods and implementations are applicable to a wide range of binary data arising from genomics, biochemistry, and other areas of science.
| S-EPMC6929325 | biostudies-literature