Microchemomechanical devices using DNA hybridization.
Ontology highlight
ABSTRACT:
SUBMITTER: Zhu G
PROVIDER: S-EPMC8166185 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:We demonstrate the hybridization-induced fluorescence detection of DNA on an origami-based paper analytical device (oPAD). The paper substrate was patterned by wax printing and controlled heating to construct hydrophilic channels and hydrophobic barriers in a three-dimensional fashion. A competitive assay was developed where the analyte, a single-stranded DNA (ssDNA), and a quencher-labeled ssDNA competed for hybridization with a fluorophore-labeled ssDNA probe. Upon hybridization of the analyte with the fluorophore-labeled ssDNA, a linear response of fluorescence vs analyte concentration was observed with an extrapolated limit of detection <5 nM and a sensitivity relative standard deviation as low as 3%. The oPAD setup was also tested against OR/AND logic gates, proving to be successful in both detection systems.
| S-EPMC3852662 | biostudies-literature
Project description:The most widely used amplification method for microarray analysis of gene expression uses T7 RNA polymerase-driven in vitro transcription (IVT) to produce complementary RNA (cRNA) that can be hybridized to arrays. However, multiple rounds of amplification are required when assaying very small amounts of starting RNA. Moreover, certain cRNA-DNA mismatches are more stable than the analogous cDNA-DNA mismatches and this might increase non-specific hybridization. We sought to determine whether a recently developed linear isothermal amplification method (ribo-SPIA) that produces single stranded cDNA would offer advantages over traditional IVT-based methods for microarray-based analyses of transcript expression.A single round of ribo-SPIA amplification produced sufficient sscDNA for hybridizations when as little as 5 ng of starting total RNA was used. Comparisons of probe set signal intensities obtained from replicate amplifications showed consistently high correlations (r = 0.99). We compared gene expression in two different human RNA samples using ribo-SPIA. Compared with one round IVT, ribo-SPIA had a larger dynamic range and correlated better with quantitative PCR results even though we used 1000-fold less starting RNA. The improved dynamic range was associated with decreases in hybridization to mismatch control probes.The use of amplified sscDNA may offer substantial advantages over IVT-based amplification methods, especially when very limited amounts of starting RNA are available. The use of sscDNA targets instead of cRNA targets appears to improve hybridization specificity.
| S-EPMC1090574 | biostudies-literature
Project description:Reversible control over the functionality of biological systems via external triggers may be used in future medicine to reduce the need for invasive procedures. Additionally, externally regulated biomacromolecules are now considered as particularly attractive tools in nanoscience and the design of smart materials, due to their highly programmable nature and complex functionality. Incorporation of photoswitches into biomolecules, such as peptides, antibiotics, and nucleic acids, has generated exciting results in the past few years. Molecular motors offer the potential for new and more precise methods of photoregulation, due to their multistate switching cycle, unidirectionality of rotation, and helicity inversion during the rotational steps. Aided by computational studies, we designed and synthesized a photoswitchable DNA hairpin, in which a molecular motor serves as the bridgehead unit. After it was determined that motor function was not affected by the rigid arms of the linker, solid-phase synthesis was employed to incorporate the motor into an 8-base-pair self-complementary DNA strand. With the photoswitchable bridgehead in place, hairpin formation was unimpaired, while the motor part of this advanced biohybrid system retains excellent photochemical properties. Rotation of the motor generates large changes in structure, and as a consequence the duplex stability of the oligonucleotide could be regulated by UV light irradiation. Additionally, Molecular Dynamics computations were employed to rationalize the observed behavior of the motor-DNA hybrid. The results presented herein establish molecular motors as powerful multistate switches for application in biological environments.
| S-EPMC5909178 | biostudies-literature
Project description:Modern real-time PCR systems make it easy to monitor fluorescence while temperature is varied for hundreds of samples in parallel, permitting high-throughput studies. We employed such system to investigate melting transitions of ordered nucleic acid structures into disordered random coils. Fluorescent dye and quencher were attached to oligonucleotides in such a way that changes of fluorescence intensity with temperature indicated progression of denaturation. When fluorescence melting data were compared with traditional ultraviolet optical experiments, commonly used dye/quencher combinations, like fluorescein and tetramethylrhodamine, showed substantial discrepancies. We have therefore screened 22 commercially available fluorophores and quenchers for their ability to reliably report annealing and melting transitions. Dependence of fluorescence on temperature and pH was also investigated. The optimal performance was observed using Texas Red or ROX dyes with Iowa Black RQ or Black Hole quenchers. These labels did not alter two-state nature of duplex melting process and provided accurate melting temperatures, free energies, enthalpies, and entropies. We also suggest a new strategy for determination of DNA duplex thermodynamics where concentration of a dye-labeled strand is kept constant and its complementary strand modified with a quencher is added at increasing excess. These methodological improvements will help build predictive models of nucleic acid hybridization.
| S-EPMC3082624 | biostudies-literature
Project description:Sequence analyses of the 16S rDNA gene and DNA-DNA hybridization tests were performed for identification of the species of the probiotic Lactobacillus UFV H2b20 strain. Using these two tests, we concluded that this strain, originally considered Lact. acidophilus, should be classified as Lact. delbrueckii.
| S-EPMC3768445 | biostudies-literature
Project description:Cell-free (cf)DNA signatures are quickly becoming the target of choice for non-invasive screening, diagnosis, treatment and monitoring of human tumors. DNA methylation changes occur early in tumorigenesis and are widespread, making cfDNA methylation an attractive cancer biomarker. Already a proven technology for targeted genome sequencing, hybridization probe capture is emerging as a method for high-throughput targeted methylation profiling suitable to liquid biopsy samples. However, to date there are no reports describing the performance of this approach in terms of reproducibility, scalability, and accuracy. In the current study we performed hybridization probe capture using the myBaits® Custom Methyl-seq kit on 172 plasma samples and standards to evaluate its performance on cfDNA methylation analysis. The myBaits® assay showed high target recovery (>90%), demonstrated excellent reproducibility between captures (R 2 = 0.92 on average), and was unaffected by increasing the number of targets in a capture. Finally, myBaits® accurately replicated 'gold standard' beta values from WGBS (average R 2 = 0.79). The results of this study show that custom targeted methylation sequencing with myBaits® offers a cost-effective, reliable platform to profile DNA methylation at a set of discrete custom regions, with potential applicability to liquid biopsies for cancer monitoring.
| S-EPMC9803870 | biostudies-literature
Project description:It is beneficial to develop systems that reproduce complex reactions of biological systems while maintaining control over specific factors involved in such processes. We demonstrated a DNA device for following the repair of DNA damage produced by a redox-cycling anticancer drug, beta-lapachone (β-lap). These chips supported ß-lap-induced biological redox cycle and tracked subsequent DNA damage repair activity with redox-modified DNA monolayers on gold. We observed drug-specific changes in square wave voltammetry from these chips at therapeutic ß-lap concentrations of high statistical significance over drug-free control. We also demonstrated a high correlation of this change with the specific ß-lap-induced redox cycle using rational controls. The concentration dependence of ß-lap revealed significant signal changes at levels of high clinical significance as well as sensitivity to sub-lethal levels of ß-lap. Catalase, an enzyme decomposing peroxide, was found to suppress DNA damage at a NQO1/catalase ratio found in healthy cells, but was clearly overcome at a higher NQO1/catalase ratio consistent with cancer cells. We found that it was necessary to reproduce key features of the cellular environment to observe this activity. Thus, this chip-based platform enabled tracking of ß-lap-induced DNA damage repair when biological criteria were met, providing a unique synthetic platform for uncovering activity normally confined to inside cells.
| S-EPMC4793915 | biostudies-literature
Project description:Whole genomic DNA-DNA hybridization has been a cornerstone of bacterial species determination but is not widely used because it is not easily implemented. We have developed a method based on random genome fragments and DNA microarray technology that overcomes the disadvantages of whole-genome DNA-DNA hybridization. Reference genomes of four fluorescent Pseudomonas species were fragmented, and 60 to 96 genome fragments of approximately 1 kb from each strain were spotted on microarrays. Genomes from 12 well-characterized fluorescent Pseudomonas strains were labeled with Cy dyes and hybridized to the arrays. Cluster analysis of the hybridization profiles revealed taxonomic relationships between bacterial strains tested at species to strain level resolution, suggesting that this approach is useful for the identification of bacteria as well as determining the genetic distance among bacteria. Since arrays can contain thousands of DNA spots, a single array has the potential for broad identification capacity. In addition, the method does not require laborious cross-hybridizations and can provide an open database of hybridization profiles, avoiding the limitations of traditional DNA-DNA hybridization.
| S-EPMC93071 | biostudies-literature
Project description:The optimal hybridization of photovoltaic (PV) and thermoelectric (TE) devices has long been considered ideal for the efficient harnessing solar energy. Our hybrid approach uses full spectrum solar energy via lossless coupling between PV and TE devices while collecting waste energy from thermalization and transmission losses from PV devices. Achieving lossless coupling makes the power output from the hybrid device equal to the sum of the maximum power outputs produced separately from individual PV and TE devices. TE devices need to have low internal resistances enough to convey photo-generated currents without sacrificing the PV fill factor. Concomitantly, a large number of p-n legs are preferred to drive a high Seebeck voltage in TE. Our simple method of attaching a TE device to a PV device has greatly improved the conversion efficiency and power output of the PV device (~30% at a 15°C temperature gradient across a TE device).
| S-EPMC3699810 | biostudies-other
Project description:Construction of recombinant DNA from multiple fragments is widely required in molecular biology, especially for synthetic biology purposes. Here we describe a new method, successive hybridization assembling (SHA) which can rapidly do this in a single reaction in vitro. In SHA, DNA fragments are prepared to overlap one after another, so after simple denaturation-renaturation treatment they hybridize in a successive manner and thereby assemble into a recombinant molecule. In contrast to traditional methods, SHA eliminates the need for restriction enzymes, DNA ligases and recombinases, and is sequence-independent. We first demonstrated its feasibility by constructing plasmids from 4, 6 and 8 fragments with high efficiencies, and then applied it to constructing a customized vector and two artificial pathways. As SHA is robust, easy to use and can tolerate repeat sequences, we expect it to be a powerful tool in synthetic biology.
| S-EPMC3266897 | biostudies-literature