Browse
Submit Data
Databases
API
Help

Dataset Information

24 Views

0 Connections

0 Citations

0 Reanalyses

0 Downloads

Omics score: 0

Switchable Assembly and Guidance of Colloidal Particles on an All-Dielectric One-Dimensional Photonic Crystal.

ABSTRACT: Dielectric multilayer photonic-band-gap structures, called one-dimensional photonic crystals (1DPCs), have drawn considerable attention in the fields of physics, chemistry, and biophotonics. Here, experimental results verify the feasibility of a 1DPC working as a substrate for switchable manipulations of colloidal microparticles. The optically induced thermal convective force on a 1DPC can assemble colloidal particles that are dispersed in a water solution, while the photonic scattering force on the same 1DPC caused by propagating evanescent waves can guide these particles. Additionally, in the 1DPC, one internal mode can be excited that has seldom been noticed previously. This mode shows an ability to assemble particles over large areas even when the incident power is low. The assembly and guidance of colloidal particles on the 1DPC are switchable just through tuning the polarization and angle of the incident laser beam. Numerical simulations are carried out, which are consistent with these experimental observations.

SUBMITTER: Lu F

PROVIDER: S-EPMC8189027 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Json Xml

Similar Datasets

Two-Dimensional Layered Nanomaterial-Based One-Dimensional Photonic Crystal Refractive Index Sensor.

Project description:One-dimensional photonic crystal (1DPC) sensors have emerged as contenders for traditional surface plasmon resonance sensors, owing to their potential for the detection of bigger molecules and particles due to their higher interaction volume in the sensing medium. Two-dimensional layered nanomaterials, most notably graphene and dichalcogenides (e.g., MoS?, MoSe?, WS?, and WSe?), have shown higher refractive index sensitivity because of their absorption as well as adsorption property. The proposed configuration of 1DPC presented consists of alternate layers of the aforementioned nanomaterials and silicon. The performance parameters, namely the sensitivity, resolution, quality factor, and the evanescent field penetration depth, are calculated and compared with 1DPC having poly methyl methacrylate (PMMA) in place of silicon. Increased shift in resonance angle and quality factor are observed by replacing PMMA with silicon, but at the cost of decreased resolution. Further, our results show that although the sensitivity and quality factor of the 1DPC sensor is less than that of the conventional surface plasmon resonance sensor (SPR) with a gold thin film, it has much higher resolution and penetration depth to make it suitable for large molecules.

| S-EPMC5877326 | biostudies-literature

Straightening of light in a one dimensional dilute photonic crystal.

Project description:Light transport in a dilute photonic crystal is considered. The analytical expression for the transmission coefficient is derived. Straightening of light under certain conditions in a one-dimensional photonic crystal is predicted. Such behavior is caused by the formation of a localized state in transversal motion. The main contribution to the central diffracted wave transmission coefficient is due to states, that either close to the conductance band's bottom or deeply localized in the forbidden gap. Both these states suppress mobility in the transverse direction and force light to be straightened. Straightening of light in the optical region along with small reflection make these systems very promising for use in solar cells.

| S-EPMC6773682 | biostudies-literature

Polymer-loaded propagating modes on a one-dimensional photonic crystal.

Project description:We numerically and experimentally demonstrate that a polymer film-coated one-dimensional photonic crystal (1DPC) can sustain transverse electric (TE) polarized modes without the limit of guided layer's thickness. Our results indicate that two propagating modes are existing inside the polymer film, the first one is the TE polarized Bloch surface wave, and the second one is the TE polarized guided mode. Here in, the evolution of these two modes with change in the polymer film thickness is presented. Our numerical simulation results are in well-agreement with the experimental data obtained using back focal plane imaging.

| S-EPMC3977745 | biostudies-literature

Dynamic Colloidal Photonic Crystal Hydrogels with Self-Recovery and Injectability.

Project description:Simulation of self-recovery and diversity of natural photonic crystal (PC) structures remain great challenges for artificial PC materials. Motivated by the dynamic characteristics of PC nanostructures, here, we present a new strategy for the design of hydrogel-based artificial PC materials with reversible interactions in the periodic nanostructures. The dynamic PC hydrogels, derived from self-assembled microgel colloidal crystals, were tactfully constructed by reversible crosslinking of adjacent microgels in the ordered structure via phenylboronate covalent chemistry. As proof of concept, three types of dynamic colloidal PC hydrogels with different structural colors were prepared. All the hydrogels showed perfect self-healing ability against physical damage. Moreover, dynamic crosslinking within the microgel crystals enabled shear-thinning injection of the PC hydrogels through a syringe (indicating injectability or printability), followed by rapid recovery of the structural colors. In short, in addition to the great significance in biomimicry of self-healing function of natural PC materials, our work provides a facile strategy for the construction of diversified artificial PC materials for different applications such as chem-/biosensing, counterfeit prevention, optical display, and energy conversion.

| S-EPMC8028842 | biostudies-literature

A fluorescent one-dimensional photonic crystal for label-free biosensing based on BLOCH surface waves.

Project description:A one-dimensional photonic crystal (1DPC) based on a planar stack of dielectric layers is used as an optical transducer for biosensing, upon the coupling of TE-polarized Bloch Surface Waves (BSW). The structure is tailored with a polymeric layer providing a chemical functionality facilitating the covalent binding of orienting proteins needed for a subsequent grafting of antibodies in an immunoassay detection scheme. The polymeric layer is impregnated with Cy3 dye, in such a way that the photonic structure can exhibit an emissive behavior. The BSW-coupled fluorescence shift is used as a means for detecting refractive index variations occurring at the 1DPC surface, according to a label-free concept. The proposed working principle is successfully demonstrated in real-time tracking of protein G covalent binding on the 1DPC surface within a fluidic cell.

| S-EPMC3649429 | biostudies-literature

Leveraging Hierarchical Self-Assembly Pathways for Realizing Colloidal Photonic Crystals.

Project description:Colloidal open crystals are attractive materials, especially for their photonic applications. Self-assembly appeals as a bottom-up route for structure fabrication, but self-assembly of colloidal open crystals has proven to be elusive for their mechanical instability due to being low-coordinated. For such a bottom-up route to yield a desired colloidal open crystal, the target structure is required to be thermodynamically favored for designer building blocks and also kinetically accessible via self-assembly pathways in preference to metastable structures. Additionally, the selection of a particular polymorph poses a challenge for certain much sought-after colloidal open crystals for their applications as photonic crystals. Here, we devise hierarchical self-assembly pathways, which, starting from designer triblock patchy particles, yield in a cascade of well-separated associations first tetrahedral clusters and then tetrastack crystals. The designed pathways avoid trapping into an amorphous phase. Our analysis reveals how such a two-stage self-assembly pathway via tetrahedral clusters promotes crystallization by suppressing five- and seven-membered rings that hinder the emergence of the ordered structure. We also find that slow annealing promotes a bias toward the cubic polymorph relative to the hexagonal counterpart. Finally, we calculate the photonic band structures, showing that the cubic polymorph exhibits a complete photonic band gap for the dielectric filling fraction directly realizable from the designer triblock patchy particles. Unexpectedly, we find that the hexagonal polymorph also supports a complete photonic band gap, albeit only for an increased filling fraction, which can be realized via postassembly processing.

| S-EPMC7304928 | biostudies-literature

Assembly of reconfigurable one-dimensional colloidal superlattices due to a synergy of fundamental nanoscale forces.

Project description:We report that triangular gold nanoprisms in the presence of attractive depletion forces and repulsive electrostatic forces assemble into equilibrium one-dimensional lamellar crystals in solution with interparticle spacings greater than four times the thickness of the nanoprisms. Experimental and theoretical studies reveal that the anomalously large d spacings of the lamellar superlattices are due to a balance between depletion and electrostatic interactions, both of which arise from the surfactant cetyltrimethylammonium bromide. The effects of surfactant concentration, temperature, ionic strength of the solution, and prism edge length on the lattice parameters have been investigated and provide a variety of tools for in situ modulation of these colloidal superstructures. Additionally, we demonstrate a purification procedure based on our observations that can be used to efficiently separate triangular nanoprisms from spherical nanoparticles formed concomitantly during their synthesis.

| S-EPMC3289355 | biostudies-literature

Electric field induced structural colour tuning of a silver/titanium dioxide nanoparticle one-dimensional photonic crystal.

Project description:An electric field is employed for the active tuning of the structural colour in photonic crystals, which acts as an effective external stimulus with an impact on light transmission manipulation. In this work, we demonstrate structural colour in a photonic crystal device comprised of alternating layers of silver nanoparticles and titanium dioxide nanoparticles, exhibiting spectral shifts of around 10 nm for an applied voltage of only 10 V. The accumulation of charge at the metal/dielectric interface with an applied electric field leads to an effective increase of the charges contributing to the plasma frequency in silver. This initiates a blue shift of the silver plasmon band with a simultaneous blue shift of the photonic band gap as a result of the change in the silver dielectric function (i.e. decrease of the effective refractive index). These results are the first demonstration of active colour tuning in silver/titanium dioxide nanoparticle-based photonic crystals and open the route to metal/dielectric-based photonic crystals as electro-optic switches.

| S-EPMC5082530 | biostudies-literature

Dependence of Photonic Crystal Nanocomposite Elasticity on Crystalline Colloidal Array Particle Size.

Project description: Not available

| S-EPMC2764406 | biostudies-literature

Assembly of multi-flavored two-dimensional colloidal crystals.

Project description:We systematically investigate the assembly of binary multi-flavored colloidal mixtures in two dimensions. In these mixtures all pairwise interactions between species may be tuned independently. This introduces an additional degree of freedom over more traditional binary mixtures with fixed mixing rules, which is anticipated to open new avenues for directed self-assembly. At present, colloidal self-assembly into non-trivial lattices tends to require either high pressures for isotropically interacting particles, or the introduction of directionally anisotropic interactions. Here we demonstrate tunable assembly into a plethora of structures which requires neither of these conditions. We develop a minimal model that defines a three-dimensional phase space containing one dimension for each pairwise interaction, then employ various computational techniques to map out regions of this phase space in which the system self-assembles into these different morphologies. We then present a mean-field model that is capable of reproducing these results for size-symmetric mixtures, which reveals how to target different structures by tuning pairwise interactions, solution stoichiometry, or both. Concerning particle size asymmetry, we find that domains in this model's phase space, corresponding to different morphologies, tend to undergo a continuous "rotation" whose magnitude is proportional to the size asymmetry. Such continuity enables one to estimate the relative stability of different lattices for arbitrary size asymmetries. Owing to its simplicity and accuracy, we expect this model to serve as a valuable design tool for engineering binary colloidal crystals from multi-flavored components.

| S-EPMC5828173 | biostudies-literature

OmicsDI is part of the ELIXIR infrastructure

OmicsDI is an Elixir interoperability service. Learn more ›

Tweets

OmicsDI Databases

PRIDE
PeptideAtlas
MassIVE
JPOST Repository
Physiome Model Repository

EGA
EVA
ENA
LINCS
PAXDB
Cell Collective

MetaboLights
Metabolomics Workbench
MetabolomeExpress
GNPS
BioModels
FAIRDOMHub

ArrayExpress
dbGaP
ExpressionAtlas
GEO
NODE

Information

Databases
Help
API
Contact us
Code on GitHub
Terms of use
Submit Data