Piezo-enhanced photocatalytic diclofenac mineralization over ZnO.
Ontology highlight
ABSTRACT:
SUBMITTER: Meroni D
PROVIDER: S-EPMC8193124 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Emerging 2D electronic materials have shown great potential for regulating and controlling optoelectronic processes. A 2D ferroelectric semiconductor coupled with the piezo-phototronic effect may bring unprecedented functional characteristics. Here, a heterojunction photodetector made of p-Si/V-doped-ferroelectric-ZnO 2D nanosheets (FESZ-PD) is fabricated, and the ferroelectricity-enhanced piezo-phototronic effect on the photoresponse behavior of the FESZ-PD is carefully investigated. By introducing the ferroelectricity and the piezo-phototronic effect, improved current rectification performance is achieved and the photoresponse performance of the heterojunction is enhanced in a broad spectral range. The applied voltage bias during measurement naturally causes ferroelectric spontaneous polarizations to align, resulting in a change in band structure near the interface and the local piezo-phototronic effect. The modulated energy band promotes the generation, separation, and transportation efficiency of photogenerated carriers greatly. Compared with the Si/ZnO 2D nanosheets photodetector without ferroelectricity under strain-free conditions, the photoresponsivity R of the FESZ-PD increases by 2.4 times when applying a -0.20‰ compressive strain at +1 V forward bias. These results confirm the feasibility of coupling the ferroelectricity with the piezo-phototronic effect in 2D ferroelectric materials to enhance the photoresponse behavior, which provides a good way to enable the development of high-performance electronic and optoelectronic devices.
| S-EPMC6702758 | biostudies-literature
Project description:We studied the photocatalytic properties of rational designed TiO2-ZnO hybrid nanostructures, which were fabricated by the site-specific deposition of amorphous TiO2 on the tips of ZnO nanorods. Compared with the pure components of ZnO nanorods and amorphous TiO2 nanoparticles, these TiO2-ZnO hybrid nanostructures demonstrated a higher catalytic activity. The strong green emission quenching observed from photoluminescence of TiO2-ZnO hybrid nanostructures implied an enhanced charge transfer/separation process resulting from the novel type II heterostructures with fine interfaces. The catalytic performance of annealing products with different TiO2 phase varied with the annealing temperatures. This is attributed to the combinational changes in Eg of the TiO2 phase, the specific surface area and the quantity of surface hydroxyl groups.
| S-EPMC3933911 | biostudies-other
Project description:SnO2/ZnO hierarchical heterostructures have been successfully synthesized by combining electrospinning technique and hydrothermal method. Various morphologies of the secondary ZnO nanostructures including nanorods (NRs) and nanosheets (NSs) can be tailored by adding surfactants. Photocatalytic performance of the heterostructures was investigated and obvious enhancement was demonstrated in degradation of the organic pollutant, compared to the primary SnO2-based nanofibers (NFs) and bare ZnO. Furthermore, it was found that the H2 evolution from water splitting was achieved by photocatalysis of heterostructured nanocomposites after sulfurization treatment. This synthetic methodology described herein promises to be an effective approach for fabricating variety of nanostructures for enhanced catalytic applications. The heterostructured nanomaterials have considerable potential to address the environmental and energy issues via degradation of pollutant and generation of clean H2 fuel.
| S-EPMC4479871 | biostudies-other
Project description:Photocatalytic water splitting into hydrogen is regarded as one of the key solutions to the deterioration of the global environment and energy. Due to the significantly reduced grain boundaries, ZnO nanorods facilitate a fast electron transfer through their smooth tunnels and are well suited as a photocatalyst. However, the photocatalytic hydrogen evolution performance of pristine ZnO nanorods is still low due to the high recombination rate of photogenerated electron-hole pairs and the less light absorption. Here, a novel structure about black ZnO nanorods (NRs)/TiO2-X mesoporous spheres (MSs) heterojunction has been prepared and the photocatalytic hydrogen evolution performance has been explored. The photocatalytic activity test results showed that ZnO NRs/TiO2-X MSs exhibited higher catalytic activity than ZnO NRs for hydrogen production. Compared to the pure ZnO NRs photoanode, the photocurrent of ZnO NRs/TiO2-X MSs heterojunction photoanode could reach 0.41 mA/cm2 in view of the expanding spectral response region and effective inhibition of e-/h+ recombination at the same condition. Using a relatively integrated experimental investigation and mechanism analysis, we scrutinized that after being treated with NaBH4, TiO2 MSs introduce oxygen vacancies expanding the photocatalytic activity of pure TiO2, and improving conductivity and charge transport capabilities through coating on ZnO NRs. More importantly, the results provide a promising approach in the NRs/MSs composite structure serving as photoanodes for photocatalytic hydrogen production.
| S-EPMC7690575 | biostudies-literature
Project description:The piezo-phototronic effect is about the enhanced separation, transport, and recombination of the photogenerated carriers using the piezoelectric polarization charges present in piezoelectric-semiconductor materials. Here, it is presented that the piezo-phototronic effect can be effectively applied to improve the relative conversion efficiency of a flexible solar cell based on n-ZnO/p-SnS core-shell nanowire array for 37.3% under a moderate vertical pressure. The performance of the solar cell can be effectively enhanced by a gentle bending of the device, showing its potential for application in curly geometries. This study not only adds further understanding about the concept of increasing solar energy conversion efficiency via piezo-phototronic effect, but also demonstrates the great potential of piezo-phototronic effect in the application of large-scale, flexible, and lightweight nanowire array solar cells.
| S-EPMC5238743 | biostudies-literature
Project description:Herein, we prepared a novel photocatalytic ZnO-TiO2 loaded carbon nanofibers composites (ZnO-TiO2-CNFs) via electrospinning technique followed by a hydrothermal process. At first, the electrospun TiO2 NP-embedded carbon nanofibers (TiO2-CNFs) were achieved using electrospinning and a carbonization process. Next, the ZnO particles were grown into the TiO2-CNFs via hydrothermal treatment. The morphology, structure, and chemical compositions were studied using state-of-the-art techniques. The photocatalytic performance of the ZnO-TiO2-CNFs composite was studied using degrading methylene blue (MB) under UV-light irradiation for three successive cycles. It was noticed that the ZnO-TiO2-CNFs nanocomposite showed better MB removal properties than that of other formulations, which might be due to the synergistic effects of carbon nanofibers and utilized metal oxides (ZnO and TiO2). The adsorption characteristic of carbon fibers and matched band potentials of ZnO and TiO2 combinedly help to boost the overall photocatalytic performance of the ZnO-TiO2-CNFs composite. The obtained results from this study indicated that it can be an economical and environmentally friendly photocatalyst.
| S-EPMC7600166 | biostudies-literature
Project description:In this study, we fabricated a hybrid plasmonic/semiconductor material by combining the chemical bath deposition of zinc oxide nanowires (ZnONWs) with the physical vapor deposition of aluminum nanostructures (AlNSs) under controlled temperature and atmosphere. The morphological and the optical properties of the ZnONWs/AlNSs hybrid material fabricated at different temperatures (250, 350, and 450 °C) and thicknesses (5, 7, and 9 nm) of Al layers were investigated. By adjusting the deposition and annealing parameters, it was possible to tune the size distribution of the AlNSs. The resonant coupling between the plasmonic AlNSs and ZnONWs leads to an enhanced photoluminescence response. The photocatalytic activity was studied through photodegradation under UV-light irradiation of methylene blue (MB) adsorbed at the surface of ZnO. The MB photodegradation experiment reveals that the ZnONWs covered with 7 nm aluminum film and annealed at 450 °C exhibit the highest degradation efficiency. The comparison between ZnONws and ZnONws/AlNSs shows a photoluminescence enhancement factor of 1.7 and an increase in the kinetics constant of photodegradation with a factor of 4.
| S-EPMC9182769 | biostudies-literature
Project description:Our study was focused on the synthesis of photocatalytic materials for the degradation of organic dyes based on the valorization of biomass resources. The biochar resulted from pyrolysis process of cherry pits wastes was activated by CO2 flow. Activated and inactivated carbon was used to obtain carbon-based photocatalysts impregnated with different zinc salt precursors. The activation of carbon had no significant influence on the photodegradation process. The doping procedure used Li2CO3 and Zn(CH3COO)2 of different concentrations to impregnate the biochar. The carbon-ZnO-Li2O based nanomaterials were analysed by TEM and SEM, while the presence of hexagonal wurtzite ZnO was investigated by XRD. The solid samples were analysed by PL at 360 nm excitation fixed wavelength to correlate their morphology with the optical and photocatalytic properties. The presence of Li atoms led to photocatalytic activities of the doped ZnO similar to the undoped ZnO obtained at higher concentrations of zinc acetate precursor.
| S-EPMC6856305 | biostudies-literature
Project description:Removal of nitrogen oxide pollution has attracted much attention, and photocatalysis is considered as an effective method to treat polluted gas. Currently, modified semiconductors with approximate band gap are used as visible-light-driven photocatalysts. Herein, this is the first investigation of photocatalytic removal of NO under visible light over Cr-doped ZnO nanoparticles (Cr-ZnO NPs). Furthermore, the trapping species experiment and electron spin resonance measurement were conducted to identify the primary reactive factor of the photocatalytic reaction. In this study, Cr-ZnO NPs were synthesized by the sol-gel method with a narrow band gap, enhanced NO photocatalytic degradation performance, low NO2 conversion yield, and high stability under visible light.
| S-EPMC6690566 | biostudies-literature
Project description:Photocatalytic technology aiming to eliminate organic pollutants in water has been rapidly developed. In this work, we successfully synthesized CuWO4/ZnO photocatalysts with different weight ratios of CuWO4 through facile hydrothermal treatment. Crystal structures, forms, and optical properties of these as-prepared materials were investigated and analyzed. 3% CuWO4/ZnO showed the optimum photodegradation efficiency toward methylene blue under the irradiation of simulated sunlight for 120 min, the degradation rate of which was 98.9%. The pseudo-first-order rate constant of 3% CuWO4/ZnO was ?11.3 and ?3.5 times bigger than that of pristine CuWO4 and ZnO, respectively. Furthermore, the material exhibited high stability and reusability after five consecutive photocatalytic tests. In addition, free radical capture experiments were conducted and the possible mechanism proposed explained that the synergistic effect between CuWO4 and ZnO accelerates the photodegradation reaction. This work provides a feasible technical background for the efficient and sustainable utilization of photocatalysts in wastewater control.
| S-EPMC7288558 | biostudies-literature