Effect of the Chloro-Substitution on Electrochemical and Optical Properties of New Carbazole Dyes.
Ontology highlight
ABSTRACT:
SUBMITTER: Krawczyk P
PROVIDER: S-EPMC8200205 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:In this work four novel donor-acceptor copolymers, PCDTBTDI-DMO, PCDTBTDI-8, P2F-CDTBTDI-DMO and P2F-CDTBTDI-8, were designed and synthesised via Suzuki polymerisation. The first two copolymers consist of 2,7-carbazole flanked by thienyl moieties as the electron donor unit and benzothiadiazole dicarboxylic imide (BTDI) as electron acceptor units. In the structures of P2F-CDTBTDI-DMO and P2F-CDTBTDI-8 copolymers, two fluorine atoms were incorporated at 3,6-positions of 2,7-carbazole to investigate the impact of fluorine upon the optoelectronic, structural and thermal properties of the resulting polymers. P2F-CDTBTDI-8 possesses the highest number average molecular weight (Mn = 24,200 g mol-1) among all the polymers synthesised. PCDTBTDI-DMO and PCDTBTDI-8 show identical optical band gaps of 1.76 eV. However, the optical band gaps of fluorinated copolymers are slightly higher than non-fluorinated counterparts. All polymers have deep-lying highest occupied molecular orbital (HOMO) levels. Changing the alkyl chain substituents on BTDI moieties from linear n-octyl to branched 3,7-dimethyloctyl groups as well as substituting the two hydrogen atoms at 3,6-positions of carbazole unit by fluorine atoms has negligible impact on the HOMO levels of the polymers. Similarly, the lowest unoccupied molecular orbital (LUMO) energy levels are almost comparable for all polymers. Thermogravimetric analysis (TGA) has shown that all polymers have good thermal stability and also confirmed that the fluorinated copolymers have higher thermal stability relative to those non-fluorinated analogues. Powder X-ray diffraction (XRD) studies proved that all polymers have an amorphous nature in the solid state.
| S-EPMC7761964 | biostudies-literature
Project description:Two novel carbazole-based compounds 7a and 7b were synthesised as potential candidates for application in organic electronics. The materials were fully characterised by NMR spectroscopy, mass spectrometry, FTIR, thermogravimetric analysis, differential scanning calorimetry, cyclic voltammetry, and absorption and emission spectroscopy. Compounds 7a and 7b, both of which were amorphous solids, were stable up to 291 °C and 307 °C, respectively. Compounds 7a and 7b show three distinctive absorption bands: high and mid energy bands due to locally excited (LE) transitions and low energy bands due to intramolecular charge transfer (ICT) transitions. In dichloromethane solutions compounds 7a and 7b gave emission maxima at 561 nm and 482 nm with quantum efficiencies of 5.4% and 97.4% ± 10%, respectively. At positive potential, compounds 7a and 7b gave two different oxidation peaks, respectively: quasi-reversible at 0.55 V and 0.71 V, and reversible at 0.84 V and 0.99 V. At negative potentials, compounds 7a and 7b only exhibited an irreversible reduction peak at -1.86 V and -1.93 V, respectively.
| S-EPMC7277623 | biostudies-literature
Project description:A facile synthesis of 2,4-diaryl-9-chloro-5,6,7,8-tetrahydroacridine derivatives is reported which is based on POCl3-mediated cyclodehydration followed by double Suzuki-Miyaura cross-coupling. The absorption and fluorescence properties of the obtained products were investigated and their HOMO/LUMO energy levels were estimated by cyclic voltammetry measurements. Besides, density functional theory calculations were carried out for further exploration of their electronic properties.
| S-EPMC8474071 | biostudies-literature
Project description:Three asymmetric amino-substituted perylene bisimide dyes with different n-alkyl chain lengths (n = 6, 12, or 18), 1-(N,N-dialkylamino)perylene bisimides (1a-1c), were synthesized under mild condition in high yields and were characterized by ¹H NMR, ¹³C NMR (nuclear magnetic resonance), HRMS (High Resolution Mass Spectrometer), UV-Vis and fluorescence spectra, as well as cyclic voltammetry (CV). These molecules show intense green color in both solution and solid state and are highly soluble in dichloromethane and even in nonpolar solvents, such as hexane. The shapes of the absorption spectra of 1a-1c in solid state and in solution were found to be virtually the same, indicating that the long alkyl chains could efficiently prevent aggregation. They exhibit a unique charge transfer emission in the near-infrared region, of which the peak wavelengths show strong solvatochromism. The dipole moments of the compounds have been estimated using the Lippert-Mataga equation, and upon excitation, they show larger dipole moment changes than that of 1-aminoperylene bisimide (2). Furthermore, all of the compounds exhibit two quasi-reversible one-electron oxidations and two quasi-reversible one-electron reductions in dichloromethane at modest potentials. Complementary density functional theory (DFT) calculations performed on these dyes are reported in order to rationalize their molecular structures and electronic properties.
| S-EPMC5456190 | biostudies-other
Project description:Eight novel metal-free organic sensitizers were proposed for dye-sensitized solar cells (DSSCs), theoretically calculated and studied via density functional theory with D-?-A structure. These proposals were formed to study the effect of novel ?-bridges, using carbazole as the donor group and cyanoacrylic acid as the anchorage group. Through the M06/6-31G(d) level of theory, ground state geometry optimization, vibrational frequencies, the highest occupied molecular orbital, the lowest unoccupied molecular orbital, and their energy levels were calculated. Further, chemical reactivity parameters were obtained and analyzed, such as chemical hardness (?), electrophilicity index (?), electroaccepting power (?+) and electrodonating power (?-). Free energy of electron injection (?Ginj) and light-harvesting efficiency (LHE) also were calculated and discussed. On the other hand, absorption wavelengths, oscillator strengths, and electron transitions were calculated through time-dependent density functional theory with the M06-2X/6-31G(d) level of theory. In conclusion, the inclusion of thiophene groups and the Si heteroatom in the ?-bridge improved charge transfer, chemical stability, and other optoelectronic properties of carbazole-based dyes.
| S-EPMC7464466 | biostudies-literature
Project description:Aliovalent substitution of the B component in ABX3 metal halides has often been proposed to modify the band gap and thus the photovoltaic properties, but details about the resulting structure have remained largely unknown. Here, we examine these effects in Bi-substituted CsSnBr3. Powder X-ray diffraction (XRD) and solid-state 119Sn, 133Cs and 209Bi nuclear magnetic resonance (NMR) spectroscopy were carried out to infer how Bi substitution changes the structure of these compounds. The cubic perovskite structure is preserved upon Bi-substitution, but with disorder in the B site occurring at the atomic level. Bi atoms are randomly distributed as they substitute for Sn atoms with no evidence of Bi segregation. The absorption edge in the optical spectra shifts from 1.8 to 1.2 eV upon Bi-substitution, maintaining a direct band gap according to electronic structure calculations. It is shown that Bi-substitution improves resistance to degradation by inhibiting the oxidation of Sn.
| S-EPMC10115781 | biostudies-literature
Project description:The present work reports on the ultrafast nonlinear optical (NLO) properties of a series of D-π-Α and D-A push-pull carbazole-based dyes and establishes a correlation between these properties and their efficiency for potential photonic and optoelectronic applications such as multiphoton lithography (MPL). The ultrafast NLO properties of the studied dyes are determined by two distinct experimental techniques, Z-scan and pump-probe optical Kerr effect (OKE), employing 246 fs laser pulses at 515 nm. The results indicate that chemical functionalization of the carbazole moiety with various strong electron-donating and/or electron-withdrawing groups, such as benzene, styrene, 4-bromostyrene, nitrobenzene, trimethyl isocyanurate, methyl, and indane-1,3-dione, can result in a controlled and significant enhancement of the NLO absorptive and refractive responses. In the context of potential applications, the efficiency of carbazole-based organic materials as photoinitiators (PIs) for MPL applications is demonstrated. The fabricated woodpile microstructure using chemically functionalized carbazole as a PI demonstrates improvements in both feature size and MPL efficiency compared to that using unfunctionalized carbazole as a PI. This is attributed to the efficient charge transfer resulting from chemical functionalization, which leads to a substantial increase (approximately 1 order of magnitude) in the values of the imaginary part of the second-order hyperpolarizability (Imγ) and the two-photon absorption cross section (σ). The achieved feature size of 280 nm is comparable to that obtained with other widely used PIs in MPL applications. Additionally, owing to the strong NLO properties of the studied functionalized carbazole, they could also be promising candidates for further applications in photonics and optoelectronics.
| S-EPMC11348418 | biostudies-literature
Project description:The optical properties of light-absorbing materials in optical shutter devices are critical to the use of such platforms for optical applications. We demonstrate switchable optical properties of dyes and nanoparticles in liquid-based electrowetting-on-dielectric (EWOD) devices. Our work uses narrow-band-absorbing dyes and nanoparticles, which are appealing for spectral-filtering applications targeting specific wavelengths while maintaining device transparency at other wavelengths. Low-voltage actuation of boron dipyromethene (BODIPY) dyes and nanoparticles (Ag and CdSe) was demonstrated without degradation of the light-absorbing materials. Three BODIPY dyes were used, namely Abs 503 nm, 535 nm and 560 nm for dye 1 (BODIPY-core), 2 (I2BODIPY) and 3 (BODIPY-TMS), respectively. Reversible and low-voltage (≤20 V) switching of dye optical properties was observed as a function of device pixel dimensions (300 × 900, 200 × 600 and 150 × 450 µm). Low-voltage and reversible switching was also demonstrated for plasmonic and semiconductor nanoparticles, such as CdSe nanotetrapods (abs 508 nm), CdSe nanoplatelets (Abs 461 and 432 nm) and Ag nanoparticles (Abs 430 nm). Nanoparticle-based devices showed minimal hysteresis as well as faster relaxation times. The study presented can thus be extended to a variety of nanomaterials and dyes having the desired optical properties.
| S-EPMC10821281 | biostudies-literature
Project description:The (D-π)2-type fluorescent dye OTT-2 with two (diphenylamino)carbazole-thiophene units as D (electron-donating group)-π (π-conjugated bridge) moiety and the (D-π)2Ph-type fluorescent dye OTK-2 with the two D-π moieties connected through a phenyl ring were derived by oxidative homocoupling of a stannyl D-π unit and Stille coupling of a stannyl D-π unit with 1,3-diiodobenzene, respectively. Their optical and electrochemical properties were investigated by photoabsorption and fluorescence spectroscopy, time-resolved fluorescence spectroscopy, cyclic voltammetry (CV) and molecular orbital (MO) calculations. In toluene the photoabsorption and fluorescence maximum wavelengths (λmax,abs and λmax,fl) of OTT-2 appear in a longer wavelength region than those of OTK-2. The fluorescence quantum yield (Φfl) of OTT-2 is 0.41, which is higher than that (Φfl = 0.36) of OTK-2. In the solid state OTT-2 shows relatively intense fluorescence properties (Φfl-solid = 0.24 nm), compared with OTK-2 (Φfl-solid = 0.15 nm). CV results demonstrated that OTT-2 and OTK-2 exhibit a reversible oxidation wave. Based on photoabsorption, fluorescence spectroscopy and CV for the two dyes, it was found that the lowest unoccupied molecular orbital (LUMO) energy level of OTT-2 is lower than that of OTK-2, but OTT-2 and OTK-2 have comparable highest occupied molecular orbital (HOMO) energy levels. Consequently, this work reveals that compared to the (D-π)2Ph-type structure, the (D-π)2-type structure exhibits not only a bathochromic shift of the photoabsorption band, but also intense fluorescence emission both in solution and the solid state.
| S-EPMC9443425 | biostudies-literature
Project description:The seven N-phthalimide derivatives substituted with the amine group at the 3-C position in the phenylene ring were synthesized. The effect of N-substituent chemical structure was investigated. The thermal, electrochemical and optical studies were performed and supported by the density functional theory calculations (DFT). The electrochemical investigations of the synthesized low-molecular phthalimides revealed the one oxidation and reduction process with the HOMO energy level under - 5.81 eV and energy-band gap below 3 eV. The N-phthalimide derivatives were emitted light in a blue spectral region in solutions (in polar and non-polar) with the quantum yield between 2 and 68%, dependent on the substituent at the nitrogen atom, solvent and concentration. The N-phthalimide derivatives were emissive also in a solid state as a thin film and powder. They were tested as a component of the active layer with PVK:PBD matrix and as an independent active layer in the organic light-emitting diodes. The registered electroluminescence spectra exhibited the maximum emission band in the 469-505 nm range, confirming the possibility of using N-phthalimides with PVK:PBD matrix as the blue emitters.
| S-EPMC10643544 | biostudies-literature