Dataset Information

Changes in electromyographic activity, mechanical power, and relaxation rates following inspiratory ribcage muscle fatigue.

ABSTRACT: Muscle fatigue is a complex phenomenon enclosing various mechanisms. Despite technological advances, these mechanisms are still not fully understood in vivo. Here, simultaneous measurements of pressure, volume, and ribcage inspiratory muscle activity were performed non-invasively during fatigue (inspiratory threshold valve set at 70% of maximal inspiratory pressure) and recovery to verify if inspiratory ribcage muscle fatigue (1) leads to slowing of contraction and relaxation properties of ribcage muscles and (2) alters median frequency and high-to-low frequency ratio (H/L). During the fatigue protocol, sternocleidomastoid showed the fastest decrease in median frequency and slowest decrease in H/L. Fatigue was also characterized by a reduction in the relative power of the high-frequency and increase of the low-frequency. During recovery, changes in mechanical power were due to changes in shortening velocity with long-lasting reduction in pressure generation, and slowing of relaxation [i.e., tau (τ), half-relaxation time (½RT), and maximum relaxation rate (MRR)] was observed with no significant changes in contractile properties. Recovery of median frequency was faster than H/L, and relaxation rates correlated with shortening velocity and mechanical power of inspiratory ribcage muscles; however, with different time courses. Time constant of the inspiratory ribcage muscles during fatigue and recovery is not uniform (i.e., different inspiratory muscles may have different underlying mechanisms of fatigue), and MRR, ½RT, and τ are not only useful predictors of inspiratory ribcage muscle recovery but may also share common underlying mechanisms with shortening velocity.

SUBMITTER: Sarmento A

PROVIDER: S-EPMC8203654 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Similar Datasets

Project description:The application of rapidly applied length steps to actively contracting muscle is a classic method for synchronizing the response of myosin cross-bridges so that the average response of the ensemble can be measured. Alternatively, electron tomography (ET) is a technique that can report the structure of the individual members of the ensemble. We probed the structure of active myosin motors (cross-bridges) by applying 0.5% changes in length (either a stretch or a release) within 2 ms to isometrically contracting insect flight muscle (IFM) fibers followed after 5-6 ms by rapid freezing against a liquid helium cooled copper mirror. ET of freeze-substituted fibers, embedded and thin-sectioned, provides 3-D cross-bridge images, sorted by multivariate data analysis into ~40 classes, distinct in average structure, population size and lattice distribution. Individual actin subunits are resolved facilitating quasi-atomic modeling of each class average to determine its binding strength (weak or strong) to actin. ~98% of strong-binding acto-myosin attachments present after a length perturbation are confined to "target zones" of only two actin subunits located exactly midway between successive troponin complexes along each long-pitch helical repeat of actin. Significant changes in the types, distribution and structure of actin-myosin attachments occurred in a manner consistent with the mechanical transients. Most dramatic is near disappearance, after either length perturbation, of a class of weak-binding cross-bridges, attached within the target zone, that are highly likely to be precursors of strong-binding cross-bridges. These weak-binding cross-bridges were originally observed in isometrically contracting IFM. Their disappearance following a quick stretch or release can be explained by a recent kinetic model for muscle contraction, as behaviour consistent with their identification as precursors of strong-binding cross-bridges. The results provide a detailed model for contraction in IFM that may be applicable to contraction in other types of muscle.

Project description:BackgroundMechanical power may serve as a valuable parameter for predicting ventilation-induced injury in mechanically ventilated patients. Over time, several equations have been developed to calculate power in both volume control ventilation (VCV) and pressure control ventilation (PCV). Among these equations, the linear model mechanical power equation (MPLM) closely approximates the reference method when applied in PCV. The dynamic mechanical power equation (MPdyn) computes power by utilizing the ventilatory work of breathing parameter (WOBv), which is automatically measured by the mechanical ventilator. In our study, conducted in patients with Covid-19 Acute Respiratory Distress Syndrome (C-ARDS), we calculated mechanical power using both the MPLM and MPdyn equations, employing different inspiratory rise times (Tslope) at intervals of 5%, ranging from 5 to 20% and compared the obtained results.ResultsIn our analysis, we used univariate linear regression at both I:E ratios of 1:2 and 1:1, considering all Tslope values. These analyses revealed that the MPdyn and MPLM equations exhibited strong correlations, with R2 values exceeding 0.96. Furthermore, our Bland-Altman analysis, which compared the power values derived from the MPdyn and MPLM equations for patient averages and all measurements, revealed a mean difference of -0.42 ± 0.41 J/min (equivalent to 2.6% ± 2.3%, p < 0.0001) and -0.39 ± 0.57 J/min (equivalent to 3.6% ± 3.5%, p < 0.0001), respectively. While there was a statistically significant difference between the equations in both absolute value and relative proportion, this difference was not considered clinically relevant. Additionally, we observed that each 5% increase in Tslope time corresponded to a decrease in mechanical power values by approximately 1 J/min.ConclusionsThe differences between mechanical power values calculated using the MPdyn and MPLM equations at various Tslope durations were determined to lack clinical significance. Consequently, for practical and continuous mechanical power estimation in Pressure-Controlled Ventilation (PCV) mode, the MPdyn equation presents itself as a viable option. It is important to note that as Tslope times increased, the calculated mechanical power exhibited a clinically relevant decrease.

Dataset Information

Changes in electromyographic activity, mechanical power, and relaxation rates following inspiratory ribcage muscle fatigue.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets