On the permittivity of titanium dioxide.
Ontology highlight
ABSTRACT:
SUBMITTER: Bonkerud J
PROVIDER: S-EPMC8203734 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Realising engineering ceramics to serve as substrate materials in high-performance terahertz(THz) that are low-cost, have low dielectric loss and near-dispersionless broadband, high permittivity, is exceedingly demanding. Such substrates are deployed in, for example, integrated circuits for synthesizing and converting nonplanar and 3D structures into planar forms. The Rutile form of titanium dioxide (TiO2) has been widely accepted as commercially economical candidate substrate that meets demands for both low-loss and high permittivities at sub-THz bands. However, the relationship between its mechanisms of dielectric response to the microstructure have never been systematically investigated in order to engineer ultra-low dielectric-loss and high value, dispersionless permittivities. Here we show TiO2 THz dielectrics with high permittivity (ca. 102.30) and ultra-low loss (ca. 0.0042). These were prepared by insight gleaned from a broad use of materials characterisation methods to successfully engineer porosities, second phase, crystallography shear-planes and oxygen vacancies during sintering. The dielectric loss achieved here is not only with negligible dispersion over 0.2-0.8 THz, but also has the lowest value measured for known high-permittivity dielectrics. We expect the insight afforded by this study will underpin the development of subwavelength-scale, planar integrated circuits, compact high Q-resonators and broadband, slow-light devices in the THz band.
| S-EPMC5529529 | biostudies-literature
Project description:This project utilized oligonucleotide microarrays to examine gene expression patterns in adult male fathead minnows (Pimephales promelas) exposed to a common nanomaterial, titanium dioxide (TiO2, stearate-coated particles, MT-100TV®). We exposed adult male fathead minnows for 96 hr to three doses (0, 1, and 10 mg/L nominal) of TiO2 under static renewal conditions. TiO2 is stearate coated, 15 nm particle size.
2010-12-22 | GSE17902 | GEO
Project description:This project utilized oligonucleotide microarrays to examine gene expression patterns in adult male fathead minnows (Pimephales promelas) exposed to a common nanomaterial, titanium dioxide (TiO2, stearate-coated particles, MT-100TV®). We exposed adult male fathead minnows for 96 hr to three doses (0, 1, and 10 mg/L nominal) of TiO2 under static renewal conditions. TiO2 is stearate coated, 15 nm particle size. Three-condition experiment: high dose, controls (untreated, low dose). Three tissues: liver, gill, brain. Biological replicates: 4 control replicates, 4 low dose, 4 high dose for gill and liver. One array for brain control and low dose; and 2 arrays for brain high dose. Contributor: Johnson & Johnson Worldwide Envrionmental
2010-12-22 | E-GEOD-17902 | biostudies-arrayexpress
Project description:Exposure to titanium dioxide (TiO2) food additive by ingestion increased over the years. TiO2 is used in food to give a brighter, fresher colour to sweets, cookies, salad dressing under the name E171. New studies on E171 showed that after ingestion in a colorectal cancer mouse model, a significant increased number of colorectal tumours were found. In addition, short-term exposure to E171 induces gene expression changes in relation to oxidative stress responses, an impairment of the immune system, activation of signalling and cancer-related genes. Furthermore, dysregulation of the immune system was also observed after ingestion of E171 in rats. E171 comprises nanoparticles (NPs) and microparticles (MPs). Previous in vitro studies showed the capacity of E171, TiO2 NPs and MPs to induce oxidative stress, DNA damage, and induction of the micronuclei. The aim of our study was to investigate the relative contribution of the NPs and MPs fractions to the effects of E171 at the molecular level. This investigation was performed using in vitro exposure of Caco-2 cells to E171 as well as the NPs and MPs fractions of TiO2 and assessing effects with genome wide gene expression analysis. Results showed that the E171, TiO2 NPs and MPs induce gene expression changes in signalling, inflammation, immune system, transport, and cancer. Contribution of NPs was observed on genes involved in TLR cascade, MHC class I and II presentation, late cornified envelope, potassium channels, and cell cycle. MPs contribution was observed with changes in gene expression on a target to Hedgehog family, α-defensins, cadherin and cholinergic receptors. The gene expression changes associated with the immune system and inflammation induced by E171, MPs, and NPs suggest the creation of a favourable environment for cancer development.
2019-11-22 | GSE110410 | GEO
Project description:Interventions: This study is a cross-over design, including only healthy volunteers. A cross-over design was chosen because it is the most appropriate design for this study: it will reduce the individual differences by allowing every subject to be his own control.
This study will be done in 4 weeks and include 2 periods. The volunteers will be randomized in two groups: one group will start with the intervention period and the other one will start with the control period. After, these 2 weeks of intervention or control periods, the volunteers will start the control period and intervention period respectively for another 2 weeks.
The time of exposure is 2 weeks. Indeed, it takes 5 to 7 days for the turnover of the epithelial cells in the gut. This will ensure the exposure of all the cells of the luminal surface of the colon.
The control period, is meant to reduce to a minimum the ingestion of E171 in order to have all the volunteers to start the same level of E171. During this period the volunteers will receive a list of products to avoid like cookies, chewing gum, certain toothpaste that are known to contain a significant amount of E171.
The intervention period, is meant to control the amount of E171 that the volunteers will ingest. A concentration, 0.82 mg/kg bw/day, corresponding to a normal daily consumption will be given to the volunteers. The quantity will be adjusted to the body weight and dispersed in yoghurt that will be eaten at breakfast, lunch and dinner.
In order to verify the compliance of the subjects, once in every period the subjects will prepare a package that include exactly what they ate and drank all day. This food package will be mixed and tested for TiO2 content.
Primary outcome(s): The primary outcome parameters are differences in transcriptomic markers after consumption of food additive E171. These outcomes in humans will shed light on the relevance of markers identified in preclinical studies, and how the animal data on the risk of facilitation of tumour growth can be extrapolated to humans
Study Design: Randomized controlled trial, Single blinded (masking used), N/A , unknown, Crossover
| 20119 | ecrin-mdr-crc
Project description:In photocatalytic water splitting, fluidization is known to minimize the adverse effects of mass-transfer, poor radiation distribution, parasitic back-reactions and photocatalyst handling difficulties, which limit the scalability of immobilized-film and suspended slurry photocatalysts. Fluidization of one-dimensional TiO2 photocatalyst particles, such as nanorods, -wires and -ribbons, is highly desired as it further enhances the efficiency of photocatalytic reaction, due to their peculiar photo-electrochemical characteristics that result in more effective separation of photo-generated charges and absorption of photons. However, the harsh physical environment of a fluidized bed reactor does not readily allow for nanostructured TiO2 photocatalysts, as the fine features would be quickly removed from the particle surface. Here, we propose a scalable method for fabrication of rutile TiO2 nanorods on porous glass beads as a 3D protective substrate to reduce the attrition rate caused by fluidization. The quality of the synthesized nanorod films was optimized through controlling a growth quality factor, R q, allowing for good quality films to be grown in different batch amounts and different hydrothermal reactor sizes. The utilization of porous glass beads substrate has reduced the attrition rate, and the protective features of the particles reduced the rate of attrition by an order of magnitude, compared to a particulate photocatalyst, to near negligible levels. Such considerably reduced attrition makes the as-developed porous glass beads supported rutile TiO2 nanorods a viable fluidizable photocatalyst candidate for various applications, including water splitting and degradation of organic compounds.
| S-EPMC8981402 | biostudies-literature
Project description:While titanium (Ti) implants have been extensively used in orthopaedic and dental applications, the intrinsic bioinertness of untreated Ti surface usually results in insufficient osseointegration irrespective of the excellent biocompatibility and mechanical properties of it. In this study, we prepared surface modified Ti substrates in which silicon (Si) was doped into the titanium dioxide (TiO₂) nanotubes on Ti surface using plasma immersion ion implantation (PIII) technology. Compared to TiO₂ nanotubes and Ti alone, Si-doped TiO₂ nanotubes significantly enhanced the expression of genes related to osteogenic differentiation, including Col-I, ALP, Runx2, OCN, and OPN, in mouse pre-osteoblastic MC3T3-E1 cells and deposition of mineral matrix. In vivo, the pull-out mechanical tests after two weeks of implantation in rat femur showed that Si-doped TiO₂ nanotubes improved implant fixation strength by 18% and 54% compared to TiO₂-NT and Ti implants, respectively. Together, findings from this study indicate that Si-doped TiO₂ nanotubes promoted the osteogenic differentiation of osteoblastic cells and improved bone-Ti integration. Therefore, they may have considerable potential for the bioactive surface modification of Ti implants.
| S-EPMC4813156 | biostudies-literature
Project description:For the last two decades, titanium dioxide (TiO2) has received wide attention in several areas such as in medicine, sensor technology and solar cell industries. TiO2‑based gas sensors have attracted significant attention in past decades due to their excellent physical/chemical properties, low cost and high abundance on Earth. In recent years, more and more efforts have been invested for the further improvement in sensing properties of TiO2 by implementing new strategies such as growth of TiO2 in different morphologies. Indeed, in the last five to seven years, 1D nanostructures and heterostructures of TiO2 have been synthesized using different growth techniques and integrated in chemical/gas sensing. Thus, in this review article, we briefly summarize the most important contributions by different researchers within the last five to seven years in fabrication of 1D nanostructures of TiO2‑based chemical/gas sensors and the different strategies applied for the improvements of their performances. Moreover, the crystal structure of TiO2, different fabrication techniques used for the growth of TiO2‑based 1D nanostructures, their chemical sensing mechanism and sensing performances towards reducing and oxidizing gases have been discussed in detail.
| S-EPMC7372330 | biostudies-literature
Project description:Titanium dioxide (TiO?) nanoparticles (NPs) have been widely applied in various industrial fields, such as electronics, packaging, food, and cosmetics. Accordingly, concerns about the potential toxicity of TiO? NPs have increased. In order to comprehend their in vivo behavior and potential toxicity, we must evaluate the interactions between TiO? NPs and biomolecules, which can alter the physicochemical properties and the fate of NPs under physiological conditions. In the present study, in vivo solubility, oral absorption, tissue distribution, and excretion kinetics of food grade TiO? (f-TiO?) NPs were evaluated following a single-dose oral administration to rats and were compared to those of general grade TiO? (g-TiO?) NPs. The effect of the interactions between the TiO? NPs and biomolecules, such as glucose and albumin, on oral absorption was also investigated, with the aim of determining the surface interactions between them. The intestinal transport pathway was also assessed using 3-dimensional culture systems. The results demonstrate that slightly higher oral absorption of f-TiO? NPs compared to g-TiO? NPs could be related to their intestinal transport mechanism by microfold (M) cells, however, most of the NPs were eliminated through the feces. Moreover, the biokinetics of f-TiO? NPs was highly dependent on their interaction with biomolecules, and the dispersibility was affected by modified surface chemistry.
| S-EPMC5302714 | biostudies-literature
Project description:The formation of nanoscale phases at grain boundaries in polycrystalline materials has attracted much attention, since it offers a route toward targeted and controlled design of interface properties. However, understanding structure-property relationships at these complex interfacial defects is hampered by the great challenge of accurately determining their atomic structure. Here, we combine advanced electron microscopy together with ab initio random structure searching to determine the atomic structure of an experimentally fabricated Σ13 (221) [11̅0] grain boundary in rutile TiO2. Through careful analysis of the atomic structure and complementary electron energy-loss spectroscopy analysis we identify the existence of a unique nanoscale phase at the grain boundary with striking similarities to the bulk anatase crystal structure. Our results show a path to embed nanoscale anatase into rutile TiO2 and showcase how the atomic structure of even complex internal interfaces can be accurately determined using a combined theoretical and experimental approach.
| S-EPMC8155194 | biostudies-literature