Impact of Varying Light and Dew on Ground Cover Estimates from Active NDVI, RGB, and LiDAR.
Ontology highlight
ABSTRACT:
SUBMITTER: Deery DM
PROVIDER: S-EPMC8240513 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Landscape attributes that vary with microtopography, such as active layer thickness (ALT), are labor intensive and difficult to document effectively through in situ methods at kilometer spatial extents, thus rendering remotely sensed methods desirable. Spatially explicit estimates of ALT can provide critically needed data for parameterization, initialization, and evaluation of Arctic terrestrial models. In this work, we demonstrate a new approach using high-resolution remotely sensed data for estimating centimeter-scale ALT in a 5 km(2) area of ice-wedge polygon terrain in Barrow, Alaska. We use a simple regression-based, machine learning data-fusion algorithm that uses topographic and spectral metrics derived from multisensor data (LiDAR and WorldView-2) to estimate ALT (2 m spatial resolution) across the study area. Comparison of the ALT estimates with ground-based measurements, indicates the accuracy (r(2)?=?0.76, RMSE ±4.4 cm) of the approach. While it is generally accepted that broad climatic variability associated with increasing air temperature will govern the regional averages of ALT, consistent with prior studies, our findings using high-resolution LiDAR and WorldView-2 data, show that smaller-scale variability in ALT is controlled by local eco-hydro-geomorphic factors. This work demonstrates a path forward for mapping ALT at high spatial resolution and across sufficiently large regions for improved understanding and predictions of coupled dynamics among permafrost, hydrology, and land-surface processes from readily available remote sensing data.
| S-EPMC4280899 | biostudies-literature
Project description:Forest understory vegetation is an important characteristic of the forest. Predicting and mapping understory is a critical need for forest management and conservation planning, but it has proved difficult with available methods to date. LiDAR has the potential to generate remotely sensed forest understory structure data, but this potential has yet to be fully validated. Our objective was to examine the capacity of LiDAR point cloud data to predict forest understory cover. We modeled ground-based observations of understory structure in three vertical strata (0.5 m to < 1.5 m, 1.5 m to < 2.5 m, 2.5 m to < 3.5 m) as a function of a variety of LiDAR metrics using both mixed-effects and Random Forest models. We compared four understory LiDAR metrics designed to control for the spatial heterogeneity of sampling density. The four metrics were highly correlated and they all produced high values of variance explained in mixed-effects models. The top-ranked model used a voxel-based understory metric along with vertical stratum (Akaike weight = 1, explained variance = 87%, cross-validation error = 15.6%). We found evidence of occlusion of LiDAR pulses in the lowest stratum but no evidence that the occlusion influenced the predictability of understory structure. The Random Forest model results were consistent with those of the mixed-effects models, in that all four understory LiDAR metrics were identified as important, along with vertical stratum. The Random Forest model explained 74.4% of the variance, but had a lower cross-validation error of 12.9%. We conclude that the best approach to predict understory structure is using the mixed-effects model with the voxel-based understory LiDAR metric along with vertical stratum, because it yielded the highest explained variance with the fewest number of variables. However, results show that other understory LiDAR metrics (fractional cover, normalized cover and leaf area density) would still be effective in mixed-effects and Random Forest modelling approaches.
| S-EPMC6881062 | biostudies-literature
Project description:There have been substantial advances in the ability to monitor the activity of hazardous volcanoes in recent decades. However, obtaining early warning of eruptions remains challenging, because the patterns and consequences of volcanic unrests are both complex and nonlinear. Measuring volcanic gases has long been a key aspect of volcano monitoring since these mobile fluids should reach the surface long before the magma. There has been considerable progress in methods for remote and in-situ gas sensing, but measuring the flux of volcanic CO2-the most reliable gas precursor to an eruption-has remained a challenge. Here we report on the first direct quantitative measurements of the volcanic CO2 flux using a newly designed differential absorption lidar (DIAL), which were performed at the restless Campi Flegrei volcano. We show that DIAL makes it possible to remotely obtain volcanic CO2 flux time series with a high temporal resolution (tens of minutes) and accuracy (<30%). The ability of this lidar to remotely sense volcanic CO2 represents a major step forward in volcano monitoring, and will contribute improved volcanic CO2 flux inventories. Our results also demonstrate the unusually strong degassing behavior of Campi Flegrei fumaroles in the current ongoing state of unrest.
| S-EPMC4642548 | biostudies-literature
Project description:Airborne remote sensing offers unprecedented opportunities to efficiently monitor vegetation, but methods to delineate and classify individual plant species using the collected data are still actively being developed and improved. The Integrating Data science with Trees and Remote Sensing (IDTReeS) plant identification competition openly invited scientists to create and compare individual tree mapping methods. Participants were tasked with training taxon identification algorithms based on two sites, to then transfer their methods to a third unseen site, using field-based plant observations in combination with airborne remote sensing image data products from the National Ecological Observatory Network (NEON). These data were captured by a high resolution digital camera sensitive to red, green, blue (RGB) light, hyperspectral imaging spectrometer spanning the visible to shortwave infrared wavelengths, and lidar systems to capture the spectral and structural properties of vegetation. As participants in the IDTReeS competition, we developed a two-stage deep learning approach to integrate NEON remote sensing data from all three sensors and classify individual plant species and genera. The first stage was a convolutional neural network that generates taxon probabilities from RGB images, and the second stage was a fusion neural network that "learns" how to combine these probabilities with hyperspectral and lidar data. Our two-stage approach leverages the ability of neural networks to flexibly and automatically extract descriptive features from complex image data with high dimensionality. Our method achieved an overall classification accuracy of 0.51 based on the training set, and 0.32 based on the test set which contained data from an unseen site with unknown taxa classes. Although transferability of classification algorithms to unseen sites with unknown species and genus classes proved to be a challenging task, developing methods with openly available NEON data that will be collected in a standardized format for 30 years allows for continual improvements and major gains for members of the computational ecology community. We outline promising directions related to data preparation and processing techniques for further investigation, and provide our code to contribute to open reproducible science efforts.
| S-EPMC8325917 | biostudies-literature
Project description:Highly repeatable, nondestructive, and high-throughput measures of above-ground biomass (AGB) and crop growth rate (CGR) are important for wheat improvement programs. This study evaluates the repeatability of destructive AGB and CGR measurements in comparison to two previously described methods for the estimation of AGB from LiDAR: 3D voxel index (3DVI) and 3D profile index (3DPI). Across three field experiments, contrasting in available water supply and comprising up to 98 wheat genotypes varying for canopy architecture, several concurrent measurements of LiDAR and AGB were made from jointing to anthesis. Phenotypic correlations at discrete events between AGB and the LiDAR-derived biomass indices were significant, ranging from 0.31 (P < 0.05) to 0.86 (P < 0.0001), providing confidence in the LiDAR indices as effective surrogates for AGB. The repeatability of the LiDAR biomass indices at discrete events was at least similar to and often higher than AGB, particularly under water limitation. The correlations between calculated CGR for AGB and the LiDAR indices were moderate to high and varied between experiments. However, across all experiments, the repeatabilities of the CGR derived from the LiDAR indices were appreciably greater than those for AGB, except for the 3DPI in the water-limited environment. In our experiments, the repeatability of either LiDAR index was consistently higher than that of AGB, both at discrete time points and when CGR was calculated. These findings provide promising support for the reliable use of ground-based LiDAR, as a surrogate measure of AGB and CGR, for screening germplasm in research and wheat breeding.
| S-EPMC7706344 | biostudies-literature
Project description:Ground cover management (GCM) is an important agricultural practice used to reduce weed growth, erosion and runoff, and improve soil fertility. In the present study, an approach to account for GCM is proposed in the modeling of pesticide emissions to evaluate the environmental sustainability of agricultural practices. As a starting point, we include a cover crop compartment in the mass balance of calculating initial (within minutes after application) and secondary (including additional processes) pesticide emission fractions. The following parameters were considered: (i) cover crop occupation between the rows of main field crops, (ii) cover crop canopy density, and (iii) cover crop family. Two modalities of cover crop occupation and cover crop canopy density were tested for two crop growth stages, using scenarios without cover crops as control. From that, emission fractions and related ecotoxicity impacts were estimated for pesticides applied to tomato production in Martinique (French West Indies) and to grapevine cultivation in the Loire Valley (France). Our results demonstrate that, on average, the presence of a cover crop reduced the pesticide emission fraction reaching field soil by a factor of 3 compared with bare soil, independently of field crop and its growth stage, and cover crop occupation and density. When considering cover exported from the field, ecotoxicity impacts were reduced by approximately 65% and 90%, compared with bare soil for grapevine and tomato, respectively, regardless of the emission distribution used. Because additional processes may influence emission distributions under GCM, such as runoff, leaching, or preferential flow, further research is required to incorporate these processes consistently in our proposed GCM approach. Considering GCM in pesticide emission modeling highlights the potential of soil cover to reduce pesticide emissions to field soil and related freshwater ecotoxicity. Furthermore, the consideration of GCM as common farming practice allows the modeling of pesticide emissions in intercropping systems. Integr Environ Assess Manag 2022;18:274-288. © 2021 The Authors. Integrated Environmental Assessment and Management published by Wiley Periodicals LLC on behalf of Society of Environmental Toxicology & Chemistry (SETAC).
| S-EPMC9291296 | biostudies-literature
Project description:Roof greening is an important national policy for maintaining the hydrological balance in China; however, plant growth is limited by drought stress. This study aims to identify strong drought resistant plant species for roof greening from ten common species: Paeonia lactiflora, Hemerocallis dumortieri, Meehania urticifolia, Iris lactea var. chinensis, Hylotelephium erythrostictum, Sedum lineare, Iris germanica, Cosmos bipinnata, Hosta plantaginea, and Dianthus barbatus. By controlling the soil relative water content (RWC), we designed three treatments: moderate drought stress (40±2% < RWC < 45±2%), severe drought stress (RWC < 30±2%) and well-watered control (RWC > 75±2%). After the seedlings were provided different levels of water, their membrane permeability (MP), chlorophyll concentration (Chl), and superoxide dismutase (SOD), peroxidase (POD) and ascorbate peroxidase (APX) activity were measured. Finally, the membership function method was used to assess the drought resistance of these species. The results showed that C. bipinnata and M. urticifolia were not suitable for moderate or severe drought stress and did not survive. The other species presented variations in physiological and biochemical parameters. The MP of He. dumortieri, I. lactea and Ho. plantaginea showed minor changes between the well-watered control and drought stress. Most of the species showed reduced SOD activity under moderate drought stress but increased activity under severe stress. All of the plant species showed decreases in the protective enzymes POD and APX with increasing drought stress. The membership function method was applied to calculate the plant species' drought resistance, and the following order of priority of the roof-greening plant species was suggested: He. dumortieri > I. germanica > I. lactea > D. barbatus > Hy. erythrostictum > S. lineare > Ho. plantaginea > P. lactiflora.
| S-EPMC7313738 | biostudies-literature
Project description:A large and growing body of evidence has demonstrated that airborne scanning light detection and ranging (lidar) systems can be an effective tool in measuring and monitoring above-ground forest tree biomass. However, the potential of lidar as an all-round tool for assisting in assessment of carbon (C) stocks in soil and non-tree vegetation components of the forest ecosystem has been given much less attention. Here we combine the use airborne small footprint scanning lidar with fine-scale spatial C data relating to vegetation and the soil surface to describe and contrast the size and spatial distribution of C pools within and among multilayered Norway spruce (Picea abies) stands. Predictor variables from lidar derived metrics delivered precise models of above- and below-ground tree C, which comprised the largest C pool in our study stands. We also found evidence that lidar canopy data correlated well with the variation in field layer C stock, consisting mainly of ericaceous dwarf shrubs and herbaceous plants. However, lidar metrics derived directly from understory echoes did not yield significant models. Furthermore, our results indicate that the variation in both the mosses and soil organic layer C stock plots appears less influenced by differences in stand structure properties than topographical gradients. By using topographical models from lidar ground returns we were able to establish a strong correlation between lidar data and the organic layer C stock at a stand level. Increasing the topographical resolution from plot averages (~2000 m2) towards individual grid cells (1 m2) did not yield consistent models. Our study demonstrates a connection between the size and distribution of different forest C pools and models derived from airborne lidar data, providing a foundation for future research concerning the use of lidar for assessing and monitoring boreal forest C.
| S-EPMC4591287 | biostudies-literature
Project description:This article contains data related to the research article entitled "Assessing terrestrial laser scanning for developing non-destructive biomass allometry" (Stovall et al., 2018 [1]) and presents 258 terrestrial LiDAR-derived estimates of tree volume and biomass. The terrestrial LiDAR acquisitions were completed in the Center for Tropical Forest Science - Forest Global Earth Observatory (CTFS-ForestGEO) plot in Front Royal, Virginia, USA. The data includes tree diameter at breast height (DBH), total tree height, tree length (correcting for tree lean), average wood density, estimated wood volume, and dry weight or biomass for all trees. These data were used to develop aboveground biomass models [1] and the reader is referred to this study for additional information, interpretation, and reflection on applying this data.
| S-EPMC6141268 | biostudies-literature
Project description:In the Ross Sea, biodiversity organisation is strongly influenced by sea-ice cover, which is characterised by marked spatio-temporal variations. Expected changes in seasonal sea-ice dynamics will be reflected in food web architecture, providing a unique opportunity to study effects of climate change. Based on individual stable isotope analyses and the high taxonomic resolution of sampled specimens, we described benthic food webs in contrasting conditions of seasonal sea-ice persistence (early vs. late sea-ice break up) in medium-depth waters in Terra Nova Bay (Ross Sea). The architecture of biodiversity was reshaped by the pulsed input of sympagic food sources following sea-ice break up, with food web simplification, decreased intraguild predation, potential disturbance propagation and increased vulnerability to biodiversity loss. Following our approach, it was possible to describe in unprecedented detail the complex structure of biodiverse communities, emphasising the role of sympagic inputs, regulated by sea-ice dynamics, in structuring Antarctic medium-depth benthic food webs.
| S-EPMC6713710 | biostudies-literature