High resolution nanoscale chemical analysis of bitumen surface microstructures.
Ontology highlight
ABSTRACT:
SUBMITTER: Koyun AN
PROVIDER: S-EPMC8245519 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Scanning thermal microscopy (SThM) is a powerful technique for thermal characterization. However, one of the most challenging aspects of thermal characterization is obtaining quantitative information on thermal conductivity with nanoscale lateral resolution. We used this technique with the cross-point calibration method to obtain the thermal contact resistance, R c, and thermal exchange radius, b, using thermo-resistive Pd/Si3N4 probes. The cross-point curves correlate the dependence of R c and b with the sample's thermal conductivity. We implemented a 3ω-SThM method in which reference samples with known thermal conductivity were used in the calibration and validation process to guarantee optimal working conditions. We achieved values of R c = 0.94 × 106 ± 0.02 K W-1 and b = 2.41 × 10-7 ± 0.02 m for samples with a low thermal conductivity (between 0.19 and 1.48 W m-1 K-1). These results show a large improvement in spatial resolution over previously reported data for the Wollaston probes (where b ∼ 2.8 μm). Furthermore, the contact resistance with the Pd/Si3N4 is ∼20× larger than reported for a Wollaston wire probe (with 0.45 × 105 K W-1). These thermal parameters were used to determine the unknown thermal conductivity of thermoelectric films of Ag2Se, Ag2-x Se, Cu2Se (smooth vs. rough surface), and Bi2Te3, obtaining, in units of W m-1 K-1, the values of 0.63 ± 0.07, 0.69 ± 0.15, 0.79 ± 0.03, 0.82 ± 0.04, and 0.93 ± 0.12, respectively. To the best of our knowledge, this is the first time these microfabricated probes have been calibrated using the cross-point method to perform quantitative thermal analysis with nanoscale resolution. Moreover, this work shows high-resolution thermal images of the V 1ω and V 3ω signals, which can offer relevant information on the material's heat dissipation.
| S-EPMC9419519 | biostudies-literature
Project description:Diffusivity and solubility of cyclohexane in nanoscale bitumen films coated on hydrophilic substrates at ambient conditions were studied using a gravimetric analyzer. Three substrates were used, and they are as follows: sample A, monodisperse spherical glass beads; sample B, polydisperse spherical glass beads mixed with polydisperse irregular-shape kaolin clay particles; and sample C, irregular-shape residual solids generated from a solvent extraction process of an oil sand ore. All of the above samples had a mean diameter of 150 μm. Diffusion coefficients were determined based upon the initial rates of cyclohexane absorption when bitumen-coated samples at various amounts (thicknesses) were exposed to a carrier gas with cyclohexane vapors at two levels of relative saturations (RSs), and they were found to be in the range of 10-18 to 10-16 m2/s. A double-first-order kinetics model fits well to the absorption data, suggesting that there exists a concentration gradient of polar (or nonpolar) bitumen molecules in the nanoscale films. This is because the hydrophilic substrates attract the relatively polar fraction of bitumen molecules to the region close to the substrates and the nonpolar fraction resides in the region near the free surface. As a result, the measured diffusion coefficients exhibited positive thickness dependence when the thickness of the bitumen films was at the nanoscale. The molecules near the substrates tended to diffuse slower than those in the free surface region. However, diffusivity was insensitive to the cyclohexane RS. On the other hand, the measured solubility of cyclohexane in the nanoscale bitumen films exhibited no thickness dependence but strong cyclohexane RS dependence. These results suggest that solubility is not affected by the inhomogeneous distribution of bitumen molecules in the nanoscale films and that it follows more or less Henry's law.
| S-EPMC6921648 | biostudies-literature
Project description:A light field print (LFP) displays three-dimensional (3D) information to the naked-eye observer under ambient white light illumination. Changing perspectives of a 3D image are seen by the observer from varying angles. However, LFPs appear pixelated due to limited resolution and misalignment between their lenses and colour pixels. A promising solution to create high-resolution LFPs is through the use of advanced nanofabrication techniques. Here, we use two-photon polymerization lithography as a one-step nanoscale 3D printer to directly fabricate LFPs out of transparent resin. This approach produces simultaneously high spatial resolution (29-45 µm) and high angular resolution (~1.6°) images with smooth motion parallax across 15 × 15 views. Notably, the smallest colour pixel consists of only a single nanopillar (~300 nm diameter). Our LFP signifies a step towards hyper-realistic 3D images that can be applied in print media and security tags for high-value goods.
| S-EPMC8211842 | biostudies-literature
Project description:Cloud-to-ground lightning causes both high-temperature and high-pressure metamorphism of rocks, forming rock fulgurite. We demonstrate that a range of microstructural features indicative of high temperatures and pressures can form in fulgurites at the surface and in fractures up to several meters below the surface. In comparison to a granite reference sample collected from a borehole at a depth of 138 m, microstructures in both the surface and fracture fulgurite are characterized by: (i) the presence of glass, (ii) a phase transformation in K-feldspar with the presence of exsolution lamellae of plagioclase, and (iii) high residual stresses up to 1.5 GPa. Since this is the first time that fracture-related fulgurite has been described, we also carried out a 1-D numerical model to investigate the processes by which these can form. The model shows that the electric current density in fractures up to 40 m from the landing point can be as high as that on the surface, providing an explanation for the occurrence of fracture-related fulgurites. Our work broadens the near-surface environments in which rock fulgurite has been reported, and provides a detailed description of microstructures that can be compared to those formed during other types of extreme metamorphic events.
| S-EPMC8586016 | biostudies-literature
Project description:Femtosecond-laser-assisted material restructuring employs extreme optical intensities to localize the ablation regions. To overcome the minimum feature size limit set by the wave nature of photons, there is a need for new approaches to tailored material processing at the nanoscale. Here, we report the formation of deeply-subwavelength features in silicon, enabled by localized laser-induced phase explosions in prefabricated silicon resonators. Using short trains of mid-infrared laser pulses, we demonstrate the controllable formation of high aspect ratio (>10:1) nanotrenches as narrow as [Formula: see text]. The trench geometry is shown to be scalable with wavelength, and controlled by multiple parameters of the laser pulse train, such as the intensity and polarization of each laser pulse and their total number. Particle-in-cell simulations reveal localized heating of silicon beyond its boiling point and suggest its subsequent phase explosion on the nanoscale commensurate with the experimental data. The observed femtosecond-laser assisted nanostructuring of engineered microstructures (FLANEM) expands the nanofabrication toolbox and opens exciting opportunities for high-throughput optical methods of nanoscale structuring of solid materials.
| S-EPMC10590427 | biostudies-literature
Project description:Neuroligins (NLGNs) form a family of cell adhesion molecules implicated in synapse development, but the mechanisms that retain these proteins at synapses are still incompletely understood. Recent studies indicate that surface-associated NLGN1 is diffusionally trapped at synapses, where it interacts with quasi-static scaffolding elements of the post-synaptic density. Whereas single molecule tracking reveals rapid diffusion and transient immobilization of NLGN1 at synapses within seconds, fluorescence recovery after photobleaching experiments indicate instead a long-term turnover of NLGN1 at synapse, in the hour time range. To gain insight into the mechanisms supporting NLGN1 anchorage at post-synapses and try to reconcile those experimental paradigms, we quantitatively analyzed here live-cell and super-resolution imaging experiments performed on NLGN1 using a newly released simulator of membrane protein dynamics for fluorescence microscopy, FluoSim. Based on a small set of parameters including diffusion coefficients, binding constants, and photophysical rates, the framework describes fairly well the dynamic behavior of extra-synaptic and synaptic NLGN1 over both short and long time ranges, and provides an estimate of NLGN1 copy numbers in post-synaptic densities at steady-state (around 50 dimers). One striking result is that the residence time of NLGN1 at synapses is much longer than what can be expected from extracellular interactions with pre-synaptic neurexins only, suggesting that NLGN1 is stabilized at synapses through multivalent interactions with intracellular post-synaptic scaffolding proteins.
| S-EPMC9083120 | biostudies-literature
Project description:Conventional gold standard histopathologic diagnosis requires information of both high resolution structural and chemical changes in tissue. Providing optical information at ultrasonic resolution, photoacoustic (PA) technique could provide highly sensitive and highly accurate tissue characterization noninvasively in the authentic in vivo environment, offering a replacement for histopathology. A two-dimensional (2D) physio-chemical spectrogram (PCS) combining micrometer to centimeter morphology and chemical composition simultaneously can be generated for each biological sample with PA measurements at multiple optical wavelengths. This spectrogram presents a unique 2D "physio-chemical signature" for any specific type of tissue. Comprehensive analysis of PCS, termed PA physio-chemical analysis (PAPCA), can lead to very rich diagnostic information, including the contents of all relevant molecular and chemical components along with their corresponding histological microfeatures, comparable to those accessible by conventional histology. PAPCA could contribute to the diagnosis of many diseases involving diffusive patterns such as fatty liver.
| S-EPMC4740791 | biostudies-other
Project description:Chemical fixations have been thought to preserve the structures of the cells or tissues. However, given that the fixatives create crosslinks or aggregate proteins, there is a possibility that these fixatives create nanoscale artefacts by aggregation of membrane proteins which move around freely to some extent on the cell surface. Despite this, little research has been conducted about this problem, probably because there has been no method for observing cell surface structures at the nanoscale. In this study, we have developed a method to observe cell surfaces stably and with high resolution using atomic force microscopy and a microporous silicon nitride membrane. We demonstrate that the size of the protrusions on the cell surface is increased after treatment with three commonly used fixatives and show that these protrusions were created by the aggregation of membrane proteins by fixatives. These results call attention when observing fixed cell surfaces at the nanoscale.
| S-EPMC9122943 | biostudies-literature
Project description:Detailed offline speciation of gas- and particle-phase organic compounds was conducted using gas/liquid chromatography with traditional and high-resolution mass spectrometers in a hybrid targeted/nontargeted analysis. Observations were focused on an unoccupied home and were compared to two other indoor sites. Observed gas-phase organic compounds span the volatile to semivolatile range, while functionalized organic aerosols extend from intermediate volatility to ultra-low volatility, including a mix of oxygen, nitrogen, and sulfur-containing species. Total gas-phase abundances of hydrocarbon and oxygenated gas-phase complex mixtures were elevated indoors and strongly correlated in the unoccupied home. While gas-phase concentrations of individual compounds generally decreased slightly with greater ventilation, their elevated ratios relative to controlled emissions of tracer species suggest that the dilution of gas-phase concentrations increases off-gassing from surfaces and other indoor reservoirs, with volatility-dependent responses to dynamically changing environmental factors. Indoor-outdoor emissions of gas-phase intermediate-volatility/semivolatile organic hydrocarbons from the unoccupied home averaged 6-11 mg h-1, doubling with ventilation. While the largest single-compound emissions observed were furfural (61-275 mg h-1) and acetic acid, observations spanned a wide range of individual volatile chemical products (e.g., terpenoids, glycol ethers, phthalates, other oxygenates), highlighting the abundance of long-lived reservoirs resulting from prior indoor use or materials, and their gradual transport outdoors.
| S-EPMC8461992 | biostudies-literature
Project description:Molecular imprinting technique enables the selective binding of nanoscale target molecules to a polymer film, within which their chemical structure is transcribed. Here, we report the successful production of mixed bacterial imprinted film (BIF) from several food poisoning bacteria by the simultaneous imprinting of their nanoscale surface chemical structures (SCS), and provide highly selective trapping of original micron-scale bacteria used in the production process of mixed BIF even for multiple kinds of bacteria in real samples. Particularly, we reveal the rapid specific identification of E. coli group serotypes (O157:H7 and O26:H11) using an alternating electric field and a quartz crystal microbalance. Furthermore, we have performed the detailed physicochemical analysis of the specific binding of SCS and molecular recognition sites (MRS) based on the dynamic Monte Carlo method under taking into account the electromagnetic interaction. The dielectrophoretic selective trapping greatly depends on change in SCS of bacteria damaged by thermal treatment, ultraviolet irradiation, or antibiotic drugs, which can be well explained by the simulation results. Our results open the avenue for an innovative means of specific and rapid detection of unknown bacteria for food safety and medicine from a nanoscale viewpoint.
| S-EPMC5709418 | biostudies-literature