Binding of collagen gene products with titanium oxide.
Ontology highlight
ABSTRACT:
SUBMITTER: Song Q
PROVIDER: S-EPMC8254516 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:The electric capacitance of an amorphous TiO2-x surface increases proportionally to the negative sixth power of the convex diameter d. This occurs because of the van der Waals attraction on the amorphous surface of up to 7?mF/cm2, accompanied by extreme enhanced electron trapping resulting from both the quantum-size effect and an offset effect from positive charges at oxygen-vacancy sites. Here we show that a supercapacitor, constructed with a distributed constant-equipment circuit of large resistance and small capacitance on the amorphous TiO2-x surface, illuminated a red LED for 37?ms after it was charged with 1?mA at 10?V. The fabricated device showed no dielectric breakdown up to 1,100?V. Based on this approach, further advances in the development of amorphous titanium-dioxide supercapacitors might be attained by integrating oxide ribbons with a micro-electro mechanical system.
| S-EPMC5073320 | biostudies-literature
Project description:Titanium dioxide is a common additive in many food, personal care, and other consumer products used by people, which after use can enter the sewage system and, subsequently, enter the environment as treated effluent discharged to surface waters or biosolids applied to agricultural land, incinerated wastes, or landfill solids. This study quantifies the amount of titanium in common food products, derives estimates of human exposure to dietary (nano-) TiO(2), and discusses the impact of the nanoscale fraction of TiO(2) entering the environment. The foods with the highest content of TiO(2) included candies, sweets, and chewing gums. Among personal care products, toothpastes and select sunscreens contained 1% to >10% titanium by weight. While some other crèmes contained titanium, despite being colored white, most shampoos, deodorants, and shaving creams contained the lowest levels of titanium (<0.01 ?g/mg). For several high-consumption pharmaceuticals, the titanium content ranged from below the instrument detection limit (0.0001 ?g Ti/mg) to a high of 0.014 ?g Ti/mg. Electron microscopy and stability testing of food-grade TiO(2) (E171) suggests that approximately 36% of the particles are less than 100 nm in at least one dimension and that it readily disperses in water as fairly stable colloids. However, filtration of water solubilized consumer products and personal care products indicated that less than 5% of the titanium was able to pass through 0.45 or 0.7 ?m pores. Two white paints contained 110 ?g Ti/mg while three sealants (i.e., prime coat paint) contained less titanium (25 to 40 ?g Ti/mg). This research showed that, while many white-colored products contained titanium, it was not a prerequisite. Although several of these product classes contained low amounts of titanium, their widespread use and disposal down the drain and eventually to wastewater treatment plants (WWTPs) deserves attention. A Monte Carlo human exposure analysis to TiO(2) through foods identified children as having the highest exposures because TiO(2) content of sweets is higher than other food products and that a typical exposure for a US adult may be on the order of 1 mg Ti per kilogram body weight per day. Thus, because of the millions of tons of titanium-based white pigment used annually, testing should focus on food-grade TiO(2) (E171) rather than that adopted in many environmental health and safety tests (i.e., P25), which is used in much lower amounts in products less likely to enter the environment (e.g., catalyst supports, photocatalytic coatings).
| S-EPMC3288463 | biostudies-literature
Project description:Due to their unique physical and chemical properties, monodisperse titanium oxide microspheres can be used in dye-sensitized solar cells, as cosmetic pigments, and for other applications. However, the synthesis of microspheres with narrow size distribution, desired phase composition, and porosity is still a challenge. In this work, spherical titania particles with controllable size, crystallinity, and pore size were obtained by Ti(OnBu)4 hydrolysis in ethanol. The influence of NaOH addition on the particles' size and morphology was investigated for the first time. Particle diameter can be tailored from 300 nm to 1.5 ?m by changing water and NaOH concentrations. Particle size was analyzed by the statistical processing of scanning electron microscopy (SEM) images and differential centrifugal sedimentation (DCS) measurements. Optical properties of the microspheres were studied by diffuse reflectance UV-Vis spectroscopy. Thermal and hydrothermal treatment allowed transforming amorphous phase in as-prepared particles into nanocrystalline anatase and/or rutile. Transmission electron microscopy (TEM) study of the lamellae, cut out from spherical particles using focused ion beam (FIB), revealed that as-synthesized microspheres are non-hollow, homogeneous, and crystallize throughout the whole volume of the particle. The spherical particles possess photoprotective properties; the highest sun protection factor (SPF) was observed for amorphous microspheres.
| S-EPMC6539129 | biostudies-literature
Project description:Titanium oxides crystals are widely used in a variety of fields, but little has been reported on the functionalities of noncrystalline intermediates formed in their structural transformation. We measured the oxygen reduction reaction activity of titanium oxide nanoparticles heat-treated for a different time and found that the activity abruptly increased at a certain time of the treatment. We analyzed their structures by using X-ray pair distribution functions with the help of high-resolution transmission electron microscopy and X-ray photoelectron spectroscopy and ascertained that the abrupt increase in the activity corresponded to a structural transformation from a reduced lepidocrocite-type layered titanate to a disordered structure consisting of domains of brookite-like TiO6 octahedral linkages. The further treatment transformed these brookite-like domains into another phase having more edge-sharing sites like the TiO-type cubic structure. This finding would position noncrystalline, disordered structure as a possible origin of the catalytic activity, though nanocrystalline rutile particles might be also considered as the origin.
| S-EPMC6641928 | biostudies-literature
Project description:A comprehensive in vitro assessment of two commercial metal oxide nanoparticles, TiO2 and ZnO, was performed using human monocyte-derived macrophages (HMDM), monocyte-derived dendritic cells (MDDC), and Jurkat T cell leukemia-derived cell line. TiO2 nanoparticles were found to be non-toxic whereas ZnO nanoparticles caused dose-dependent cell death. Subsequently, global gene expression profiling was performed to identify transcriptional response underlying the cytotoxicity caused by ZnO nanoparticles. Analysis was done with doses 1 µg/ml and 10 µg/ml after 6 and 24 h of exposure. Interestingly, 2703 genes were significantly differentially expressed in HMDM upon exposure to 10 µg/ml ZnO nanoparticles, while in MDDCs only 12 genes were affected. In Jurkat cells, 980 genes were differentially expressed. It is noteworthy that only the gene expression of metallothioneins was upregulated in all the three cell types and a notable proportion of the genes were regulated in a cell type-specific manner. Gene ontology analysis revealed that the top biological processes disturbed in HMDM and Jurkat cells were regulating cell death and growth. In addition, genes controlling immune system development were affected. Using a panel of modified ZnO nanoparticles, we obtained an additional support that the cellular response to ZnO nanoparticles is largely dependent on particle dissolution and show that the ligand used to modify ZnO nanoparticles modulates Zn(2+) leaching. Overall, the study provides an extensive resource of transcriptional markers for mediating ZnO nanoparticle-induced toxicity for further mechanistic studies, and demonstrates the value of assessing nanoparticle responses through a combined transcriptomics and bioinformatics approach.
| S-EPMC3718780 | biostudies-literature
Project description:Gene expression analysis of HeLa cell samples treated with nanoparticles for 2 or 4 hours, with matching non-treated samples as controls - exact cell culture growing conditions were replicated, same cell numbers plated in matching pairs of flasks Dopamine covered Fe3O4@TiO2 nanoparticles were added to cells grown for 16h and incubated fror 2 or 4 hours
2016-10-15 | GSE88786 | GEO
Project description:Titanium dioxide (TiO2) is a common component in personal care products (PCP), which through use enters the wastewater treatment plant (WWTP) and ultimately the environment. A citizen science approach is utilized here to inform the prevalence and usage of TiO2 containing PCP on a household scale, which generates information as to the quantity of TiO2 entering the WWTP, and the portion ultimately discharged to the environment. Meanwhile, citizen science sourced inventories were generated to estimate the quantity of TiO2, and potentially nanoscale TiO2 entering the WWTP from consumer products and to determine which products had the greatest contribution. The estimated values were compared with water samples from the WWTP which quantified the amount of total titanium present using ICP-AES. These values were at a similar level with other top-down estimation approaches and suggest that a citizen science approach is valid to estimate the loading of TiO2, and potentially other emerging contaminants, while at the same time engaging with community stakeholders.
| S-EPMC7390335 | biostudies-literature
Project description:Clostridium histolyticum collagenase causes extensive degradation of collagen in connective tissue that results in gas gangrene. The C-terminal collagen-binding domain (CBD) of these enzymes is the minimal segment required to bind to a collagen fibril. CBD binds unidirectionally to the undertwisted C-terminus of triple helical collagen. Here, we examine whether CBD could also target undertwisted regions even in the middle of the triple helix. Collageneous peptides with an additional undertwisted region were synthesized by introducing a Gly ? Ala substitution [(POG)(x) POA(POG)(y)]?, where x + y = 9 and x > 3). ¹H-¹?N heteronuclear single quantum coherence nuclear magnetic resonance (HSQC NMR) titration studies with ¹?N-labeled CBD demonstrated that the minicollagen binds to a 10 Å wide 25 Å long cleft. Six collagenous peptides each labeled with a nitroxide radical were then titrated with ¹?N-labeled CBD. CBD binds to either the Gly ? Ala substitution site or to the C-terminus of each minicollagen. Small-angle X-ray scattering measurements revealed that CBD prefers to bind the Gly ? Ala site to the C-terminus. The HSQC NMR spectra of ¹?N-labeled minicollagen and minicollagen with undertwisted regions were unaffected by the titration of unlabeled CBD. The results imply that CBD binds to the undertwisted region of the minicollagen but does not actively unwind the triple helix.
| S-EPMC3526996 | biostudies-literature
Project description:Soft tissue adhesion on titanium represents a challenge for implantable materials. In order to improve adhesion at the cell/material interface we used a new approach based on the molecular recognition of titanium by specific peptides. Silk fibroin protein was chemically grafted with titanium binding peptide (TiBP) to increase adsorption of these chimeric proteins to the metal surface. A quartz crystal microbalance was used to quantify the specific adsorption of TiBP-functionalized silk and an increase in protein deposition by more than 35% was demonstrated due to the presence of the binding peptide. A silk protein grafted with TiBP and fibronectin-derived arginine-glycine-aspartic acid (RGD) peptide was then prepared. The adherence of fibroblasts on the titanium surface modified with the multifunctional silk coating demonstrated an increase in the number of adhering cells by 60%. The improved adhesion was demonstrated by scanning electron microscopy and immunocytochemical staining of focal contact points. Chick embryo organotypic culture also revealed strong adhesion of endothelial cells expanding on the multifunctional silk peptide coating. These results demonstrated that silk functionalized with TiBP and RGD represents a promising approach to modify cell-biomaterial interfaces, opening new perspectives for implantable medical devices, especially when reendothelialization is required.
| S-EPMC3508072 | biostudies-literature
Project description:A large relative surface area is crucial for high catalytic activity. Monolithic catalysts are important catalytic materials because of minimal self-degradation. Regarding large surface area catalysts, the glass-ceramics (GCs) with high formability, obtained by heat-treatment of the precursor glass, are plausible candidates. This study examines the photocatalytic behaviour of porous GCs obtained after acid leaching of MgO-TiO2-P2O5 GCs. After heat-treatment, anatase TiO2 was precipitated along with other phases. The diffraction intensity ratio between anatase and other phases was the maximum for a heat-treatment temperature of 900 °C. After acid leaching of the GCs, the relative surface area decreased with increasing TiO2 fraction; the surface area was also affected by the sample morphology. H2 generation was observed from porous GCs, while GCs without etching exhibited approximately zero activity. Thus, it was demonstrated that high surface area and prevention of the reduction reaction to Ti(III) are important for tailoring monolithic photocatalytic materials.
| S-EPMC7363924 | biostudies-literature