Dataset Information

Reactivity of Hydrogen-Related Electron Centers in Powders, Layers, and Electrodes Consisting of Anatase TiO₂ Nanocrystal Aggregates.

ABSTRACT: Anatase TiO₂ nanoparticle aggregates were used as model systems for studying at different water activities the reactivity of electron centers at semiconductor surfaces. The investigated surface conditions evolve from a solid/vacuum interface to a solid/bulk electrolyte interface. Hydrogen-related electron centers were generated either chemically-upon sample exposure to atomic hydrogen at the semiconductor/gas interface-or electrochemically-upon bias-induced charge accumulation at the semiconductor/electrolyte interface. Based on their corresponding spectroscopic and electrochemical fingerprints, we investigated the reactivity of hydrogen-related electron centers as a function of the interfacial condition and at different levels of complexity, that is, (i) for dehydrated and (partially) dehydroxylated oxide surfaces, (ii) for oxide surfaces covered by a thin film of interfacial water, and (iii) for oxide surfaces in contact with a 0.1 M HClO₄ aqueous solution. Visible (Vis) and infrared (IR) spectroscopy evidence a chemical equilibrium between hydrogen atoms in the gas phase and-following their dissociation-electron/proton centers in the oxide. The excess electrons are either localized forming (Vis-active) Ti³⁺ centers or delocalized as (IR-active) free conduction band electrons. The addition of molecular oxygen to chemically reduced anatase TiO₂ nanoparticle aggregates leads to a quantitative quenching of Ti³⁺ centers, while a fraction of ∼10% of hydrogen-derived conduction band electrons remains in the oxide pointing to a persistent hydrogen doping of the semiconductor. Neither trapped electrons (i.e., Ti³⁺ centers) nor conduction band electrons react with water or its adsorption products at the oxide surface. However, the presence of an interfacial water layer does not impede the electron transfer to molecular oxygen. At the semiconductor/electrolyte interface, inactivity of trapped electrons with regard to water reduction and electron transfer to oxygen were evidenced by cyclic voltammetry.

SUBMITTER: Jimenez JM

PROVIDER: S-EPMC8256420 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Similar Datasets

Project description:A sequence of chemical vapor synthesis and thermal annealing in defined gas atmospheres was used to prepare phase-pure anatase TiO2 nanocrystal powders featuring clean surfaces and a narrow particle size distribution with a median particle diameter of 14.5 ± 0.5 nm. Random networks of these nanocrystals were immobilized from aqueous dispersions onto conducting substrates and are introduced as model systems for electronic conductivity studies. Thermal annealing of the immobilized films at 100 °C < T < 450 °C in air was performed to generate particle-particle contacts upon virtual preservation of the structural properties of the nanoparticle films. The distribution of electrochemically active electronic states as well as the dependence of the electronic conductivity on the Fermi level position in the semiconductor films was studied in aqueous electrolytes in situ using electrochemical methods. An exponential distribution of surface states is observed to remain unchanged upon sintering. However, capacitive peaks corresponding to deep electron traps in the nanoparticle films shift positive on the potential scale evidencing an increase of the trapping energy upon progressive thermal annealing. These peaks are attributed to trap states at particle-particle interfaces in the random nanocrystal network (i.e., at grain boundaries). In the potential region, where the capacitive peaks are detected, we observe an exponential conductivity variation by up to 5 orders of magnitude. The potential range featuring the exponential conductivity variation shifts positive by up to 0.15 V when increasing the sintering temperature from 100 to 450 °C. Importantly, all films approach a potential- and sintering-temperature-independent maximum conductivity of ∼10-4 Ω-1·cm-1 at more negative potentials. On the basis of these results we introduce a qualitative model, which highlights the detrimental impact of electron traps located on particle-particle interfaces on the electronic conductivity in random semiconductor nanoparticle networks.

Dataset Information

Reactivity of Hydrogen-Related Electron Centers in Powders, Layers, and Electrodes Consisting of Anatase TiO₂ Nanocrystal Aggregates.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets

Dataset Information

Reactivity of Hydrogen-Related Electron Centers in Powders, Layers, and Electrodes Consisting of Anatase TiO2 Nanocrystal Aggregates.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets

Reactivity of Hydrogen-Related Electron Centers in Powders, Layers, and Electrodes Consisting of Anatase TiO₂ Nanocrystal Aggregates.