Lateral PbS Photovoltaic Devices for High Performance Infrared and Terahertz Photodetectors.
Ontology highlight
ABSTRACT:
SUBMITTER: Ampadu EK
PROVIDER: S-EPMC8306324 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Over the past decades, graphene has attracted much attention from the scientific community due to its broad applications in the optoelectronics industries [1]. Owing to graphene's high transmission and high electrical conductivity, diverse functional materials/graphene hybridized heterostructures and interfaces are under extensive investigation to satisfy the increasing interest in the need for bendable, flexible and high performance optoelectronic devices [2]. Due to the good atomic lattice structure of graphene, varying heterostructures have been formed by depositing different functional materials directly on graphene [3], [4], [5]. We fabricated a vertical photovoltaic type G/PbS/Ti device by making use of the Ti/PbS Schottky junction and discussed the photocurrent transient characteristics. Lead sulfide (PbS) was deposited directly on large area CVD (Chemical vapor deposition) graphene by CBD (Chemical bath deposition). Temperature dependent photocurrent spectra of our G/PbS/Ti photovoltaic devices were measured by a Fourier transformed infrared (FTIR) set-up. In this paper, we present the experimental procedures and the raw experimental data for the direct chemical deposition of PbS on CVD-graphene for high performance photovoltaic infrared photo-detectors. The manuscript is already available [6].
| S-EPMC7494446 | biostudies-literature
Project description:A graphene-PbS quantum dot (QD) composite for application in high-performance near-infrared (NIR) photodetectors (PDs) is proposed in this study. A single-layer graphene flake and oleic acid-capped PbS QD composite is fabricated through the conventional sonication process, in hexane solution. Field emission scanning electron microscopy images of the graphene-PbS QD composite dispersed on a glass substrate confirm that the composite contains both aggregated graphene flakes and single-layer graphene with wrinkles; Transmission electron microscopy images reveal close packing with uniform size. The increased absorbance and quenched photoluminescence intensity of the graphene-PbS QD composite supports enhanced photoinduced charge transfer between graphene and the PbS QDs. Moreover, the specific Raman mode of the PbS QDs, embedded in the spectrum, is enhanced by combination with graphene, which can be interpreted by SERS as relevant to the photoinduced charge transfer between the Pbs QDs and graphene. For device application, a PD structure comprised by graphene-PbS QDs is fabricated. The photocurrent of the PD is measured using a conventional probe station with a 980-nm NIR laser diode. In the fabricated PD comprising graphene-PbS QDs, five-times higher photocurrent, 22% faster rise time, and 47% faster decay time are observed, compared to that comprising PbS QDs alone. This establishes the potential of the graphene-PbS QD composite for application in ultrathin, flexible, high-performance NIR PDs.
| S-EPMC7385648 | biostudies-literature
Project description:InGaAs is an important bandgap-variable ternary semiconductor which has wide applications in electronics and optoelectronics. In this work, single-crystal InGaAs nanowires were synthesized by a chemical vapor deposition method. Photoluminescence measurements indicate the InGaAs nanowires have strong light emission in near-infrared region. For the first time, photodetector based on as-grown InGaAs nanowires was also constructed. It shows good light response over a broad spectral range in infrared region with responsivity of 6.5 × 103 A W-1 and external quantum efficiency of 5.04 × 105 %. This photodetector may have potential applications in integrated optoelectronic devices and systems.
| S-EPMC6223916 | biostudies-literature
Project description:Two-dimensional (2D) MoS2 nanosheets have been integrated with zero-dimensional (0D) PbS quantum dots to achieve a superior optical response extending to the short-wavelength infrared region along with a broadband visible response for multispectral photodetection. The 0D/2D hybrid nanostructures have been synthesized by a one pot, stabilizer-free solvothermal growth process. Microscopic and spectroscopic studies confirmed the formation of PbS QD decorated semiconducting 2H-MoS2 layers. The size tunable absorption features with longer photo-generated carrier lifetime of synthesized hybrid nanostructures indicate that the integration of PbS QDs in MoS2 could be a viable approach for fabricating two-colour band photodetectors, viz. visible broadband and wavelength selective short-wave IR photodetectors. Devices have also been demonstrated on polyethylene terephthalate substrates using a solution-based synthesis technique for flexible and ultrathin optoelectronic device applications. The photodetection performance of fabricated devices suggests that the synergic 0D/2D hybrid nanostructures are significantly superior to solution processed hybrid devices operating in the infrared region. The successful integration of 0D QDs in 2D materials may pave the way for novel, high performance, next-generation CMOS compatible flexible photonic devices.
| S-EPMC9419818 | biostudies-literature
Project description:Graphene quantum dots (GQDs) have received much attention due to their novel phenomena of charge transport and light absorption/emission. The optical transitions are known to be available up to ~6?eV in GQDs, especially useful for ultraviolet (UV) photodetectors (PDs). Thus, the demonstration of photodetection gain with GQDs would be the basis for a plenty of applications not only as a single-function device in detecting optical signals but also a key component in the optoelectronic integrated circuits. Here, we firstly report high-efficient photocurrent (PC) behaviors of PDs consisting of multiple-layer GQDs sandwiched between graphene sheets. High detectivity (>10(11)?cm Hz(1/2)/W) and responsivity (0.2 ~ 0.5 A/W) are achieved in the broad spectral range from UV to near infrared. The observed unique PD characteristics prove to be dominated by the tunneling of charge carriers through the energy states in GQDs, based on bias-dependent variations of the band profiles, resulting in novel dark current and PC behaviors.
| S-EPMC4083259 | biostudies-literature
Project description:Organic-inorganic perovskites have already shown a tremendous potential for low-cost light-harvesting devices. Yet, the relatively low carrier mobilities in bulk perovskites still prevent large-area devices with performances competing with state-of-the-art technologies. Here, we tackle this fundamental challenge by incorporating single-wall carbon nanotubes within a perovskite matrix by means of a simple two-step method in ambient air. Using this nano-engineered hybrid film, we demonstrate large-area photodetectors with responsivities up-to 13.8 A.W-1 and a broad spectral response from 300 to 800 nm, indicating that photocurrent generation arises from the charge transfer from the perovskite matrix to the embedded nanotube network. As the nanotubes facilitate the carrier extraction, these photodetectors also show a fast response time of 10 ms. This is significantly faster than most of previous reports on perovskite-based photodetectors, including devices with much smaller photosensitive areas. This approach is also well-suited for large-scale production of other perovskite-based light-harvesting devices.
| S-EPMC5371979 | biostudies-literature
Project description:Graphene is an ideal material for flexible optoelectronic devices due to its excellent electrical and optical properties. However, the extremely high growth temperature of graphene has greatly limited the direct fabrication of graphene-based devices on flexible substrates. Here, we have realized in situ growth of graphene on a flexible polyimide substrate. Based on the multi-temperature-zone chemical vapor deposition cooperated with bonding a Cu-foil catalyst onto the substrate, the growth temperature of graphene was controlled at only 300 °C, enabling the structural stability of polyimide during growth. Thus, large-area high-quality monolayer graphene film was successfully in situ grown on polyimide. Furthermore, a PbS-graphene flexible photodetector was fabricated using the graphene. The responsivity of the device reached 105 A/W with 792 nm laser illumination. The in-situ growth ensures good contact between graphene and substrate; therefore, the device performance can remain stable after multiple bending. Our results provide a highly reliable and mass-producible path for graphene-based flexible devices.
| S-EPMC10147023 | biostudies-literature
Project description:Lateral graphene p-n junctions are important since they constitute the core components in a variety of electronic/photonic systems. However, formation of lateral graphene p-n junctions with a controllable doping levels is still a great challenge due to the monolayer feature of graphene. Herein, by performing selective ion implantation and in situ growth by dynamic chemical vapor deposition, direct formation of seamless lateral graphene p-n junctions with spatial control and tunable doping is demonstrated. Uniform lattice substitution with heteroatoms is achieved in both the boron-doped and nitrogen-doped regions and photoelectrical assessment reveals that the seamless lateral p-n junctions exhibit a distinct photocurrent response under ambient conditions. As ion implantation is a standard technique in microelectronics, our study suggests a simple and effective strategy for mass production of graphene p-n junctions with batch capability and spatial controllability, which can be readily integrated into the production of graphene-based electronics and photonics.
| S-EPMC6281711 | biostudies-literature
Project description:Organic-inorganic hybrid perovskites have been widely used as light sensitive components for high-efficient photodetectors due to their superior optoelectronic properties. However, the unwanted crystallographic defects of perovskites typically result in high dark current, and thus limit the performance of the device. Herein, we introduce a simple route of microstructures control in MAPbI3 perovskites that associates with introducing an additive of 3,3,4,4-benzophenonetetracarboxylic dianhydridean (BPTCD) for crystallization adjustment of the perovskite film. The BPTCD additive can facilitate the formation of high-quality perovskite film with a compact and nearly pinhole-free morphology. Through characterizing the molecular interactions, it was found that the carbonyl groups in BPTCD is the key reason that promoted the nucleation and crystallization of MAPbI3. As a result, we obtained high-efficient and stable perovskite photodetectors with low dark current of 9.98 × 10-8 A at -0.5 V, an on/off ratio value of 103, and a high detectivity exceeding 1012 Jones over the visible region.
| S-EPMC7763584 | biostudies-literature
Project description:The inherent zero-band gap nature of graphene and its fast photocarrier recombination rate result in poor optical gain and responsivity when graphene is used as the light absorption medium in photodetectors. Here, semiconducting graphene nanoribbons with a direct bandgap of 1.8 eV are synthesized and employed to construct a vertical heterojunction photodetector. At a bias voltage of -5 V, the photodetector exhibits a responsivity of 1052 A/W, outperforming previous graphene-based heterojunction photodetectors by several orders of magnitude. The achieved detectivity of 3.13 × 1013 Jones and response time of 310 μs are also among the best values for graphene-based heterojunction photodetectors reported until date. Furthermore, even under zero bias, the photodetector demonstrates a high responsivity and detectivity of 1.04 A/W and 2.45 × 1012 Jones, respectively. The work shows a great potential of graphene nanoribbon-based photodetection technology.
| S-EPMC10786164 | biostudies-literature