A Novel, Low-cost, Low-fidelity Pericardiocentesis Teaching Model
Ontology highlight
ABSTRACT: Introduction
Pericardiocentesis is a high-risk/low-frequency procedure important to emergency medicine (EM). However, due to case rarity it is not often performed on a patient during residency training. Because the coronavirus disease 2019 pandemic limited cadaver-based practice, we developed a novel, low-cost, low-fidelity pericardiocentesis model using three dimensional-printing technology to provide advances on prior home-made models. Methods
Residents watched a 20-minute video about performing a pericardiocentesis and practiced both a blind and ultrasound-guided technique. We assessed model fidelity, convenience, and perceived provider competence via post-workshop questionnaire. Results
A total of 24/26 (93%) individuals practicing on the ultrasound-guided model and 22/24 (92%) on the blind approach model agreed or strongly agreed that the models reasonably mimicked a pericardial effusion. Conclusion
Our low-cost, low-fidelity model is durable, mimics the clinical case, and is easy to use. It also addresses known limitations from prior low-fidelity models.
SUBMITTER: Lord S
PROVIDER: S-EPMC8328165 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:ObjectiveDevelop and describe a set of low-cost hemorrhoidectomy task trainer prototypes in the setting of inadequate junior resident surgical skill preparation for anorectal cases.DesignThis is a study comparing expert and novice performance and opinions. Three task trainers were developed to simulate dissecting, knot-tying, and suturing in a confined space, like the anus. Participants were asked to dissect the peel off of an orange, tie seven 2-handed knots on a weight, and close a defect in a piece of felt with a running stitch. An 8-oz mason jar was used to simulate the confined space. Participants were asked to fill out a 5-point Likert-based evaluation regarding the skills. The primary outcome was time to complete each task in seconds. Secondary outcome measures were number of errors associated with each task, subjective achievability of tasks, and utility of tasks for improving surgical skills.SettingGeneral surgery residency program at a safety-net academic center.ParticipantsForty subjects participated in this study. There were 20 experts (7 attending surgeons, 13 PGY-1-PGY-5 surgical residents) and 20 novices (11 third- and 9 fourth-year medical students).ResultsExperts knot-tied (59s vs 140s, p < 0.001) and sutured (219s vs 295s, p < 0.001) faster than novices. Experts were able to tie 7 knots in fewer attempts than novices (p < 0.001). There was no significant difference in speed of orange dissection between groups. There were no significant differences in the number or frequency of other errors. All participants felt the tasks were achievable (4.90/5) and would be useful in improving skills (4.93/5).ConclusionsThis study demonstrated that a set of low-cost, low-fidelity prototypical hemorrhoidectomy task trainers can discriminate between experts and novices. Simulation models such as these can offer useful practice opportunities for junior general surgery trainees.
| S-EPMC7487032 | biostudies-literature
Project description:Introduction: Patients present to the emergency department (ED) relatively commonly with traumatic closed proximal interphalangeal joint (PIPJ) dislocations, an orthopedic emergency. There is a paucity of teaching models and training simulations for clinicians to learn either the closed dislocated dorsal or volar interphalangeal joint reduction technique. We implemented a teaching model to demonstrate the utility of a novel reduction model designed from three-dimensional (3D) printable components that are easy to connect and do not require further machining or resin models to complete. Methods: Students watched a two-minute video and a model demonstration by the authors. Learners including emergency medicine (EM) residents and physician assistant fellows assessed model fidelity, convenience, perceived competency, and observed competency. Results: Seventeen of 21 (81%) participants agreed the model mimicked dorsal and volar PIPJ dislocations. Nineteen of 21 (90%) agreed the model was easy to use, 21/21 (100%) agreed the dorsal PIPJ model and 20/21 (95%) agreed the volar PIPJ model improved their competency. Conclusion: Our 3D-printed, dorsal and volar dislocation reduction model is easy to use and affordable, and it improved perceived competency among EM learners at an academic ED.
| S-EPMC10527832 | biostudies-literature
Project description:Robot-assisted partial nephrectomy (RAPN) has rapidly evolved as the standard of care for appropriately selected renal tumours, offering key patient benefits over radical nephrectomy or open surgical approaches. Accordingly, RAPN is a key competency that urology trainees wishing to treat kidney cancer must master. Training in robotic surgery is subject to numerous challenges, and simulation has been established as valuable step in the robotic learning curve. However, simulation models are often both expensive and suboptimal in fidelity. This means that the number of practice repetitions for a trainee may limited by cost restraints, and that trainees may struggle to reconcile the skills obtained in the simulation laboratory with real-world practice in the operating room. We have developed a high-fidelity, low-cost, customizable model for RAPN simulation based on porcine tissue. The model has been utilised in teaching courses at our institution, confirming both feasibility of use and high user acceptability. We share the design of our model in this proof-of-concept report.
| S-EPMC10907476 | biostudies-literature
Project description:PURPOSE: The purpose of this study was to assess the effectiveness of high-fidelity simulation for teaching root cause analysis (RCA) in graduate medical education. METHODS: Thirty clinical anesthesiology-1 through clinical anesthesiology-3 residents were randomly assigned to 2 groups: group A participants received a 10-minute lecture on RCA and participated in a simulation exercise where a medical error occurs, and group B participants received the 10-minute lecture on RCA only. Participants completed baseline, postintervention, and 6-month follow-up assessments, and they were evaluated on their attitude toward as well as understanding of RCA and "systems-based" care. RESULTS: All 30 residents completed the surveys. Baseline attitudes and knowledge scores were similar between groups. Postintervention knowledge scores were also similar between groups; however, group B was significantly more skeptical (P < .001) about the use of RCA and "systems improvement" strategies. Six months later, group A demonstrated retained knowledge scores and unchanged attitude, whereas group B demonstrated significantly worse knowledge scores (P = .001) as well as continued skepticism toward a systems-based approach (P < .001) to medical error reduction. CONCLUSION: High-fidelity simulation in conjunction with focused didactics is an effective strategy for teaching RCA and systems theory in graduate medical education. Our findings also suggest that there is greater retention of knowledge and increased positive attitude toward systems improvement when focused didactics are coupled with a high-fidelity simulation exercise.
| S-EPMC3244320 | biostudies-other
Project description:BackgroundShoulder dystocia (SD) requires emergent intervention to prevent maternal and fetal harm, and simulation models for training can be expensive. We developed a novel, cheap and easily transportable low-fidelity simulation (LFS) model to compare to a commercially available high-fidelity simulation (HFS) model.MethodsEmergency medicine residents were randomized to training on the HFS or novel LFS model. Subjects completed a pretest and a 1-week and 6-month posttest including a self-assessment and a simulated SD delivery.ResultsTwenty-seven of the 43 residents completed the study (63%). The number of individuals performing dangerous maneuvers at baseline was similar, 1 week after training was five in HFS and 11 in LFS (p = 0.08) groups and at 6 months was again similar between groups. Mean checklist scores for appropriate actions increased 1 week after training but returned to baseline by 6 months and were similar between groups. The rate of successful delivery, median time to successful delivery, and maximum force applied improved at 1 week and was sustained at 6 months in both groups.ConclusionWithin our limited study population, we did not find a large difference in the occurrence of dangerous actions during simulated SD delivery following HFS and LFS training. Our novel and easily transportable LFS trainer, assembled for less than US$10 each, may be a useful tool to train inexperienced providers on the steps of this procedure. However, this requires further study, as does whether HFS models with force monitoring capabilities may be helpful to train providers to minimize dangerous maneuvers such as the application of excessive force.
| S-EPMC6001827 | biostudies-literature
Project description:ObjectiveThe aim of this study was to evaluate a novel pericardiocentesis technique using an in-plane parasternal medial-to-lateral approach with the use of a high-frequency probe in patients with cardiac tamponade.BackgroundEchocardiography is pivotal in the diagnosis of pericardial effusion and tamponade physiology. Ultrasound guidance for pericardiocentesis is currently considered the standard of care. Several approaches have been described recently, which differ mainly on the site of puncture (subxiphoid, apical, or parasternal). Although they share the use of low-frequency probes, there is absence of complete control of needle trajectory and real-time needle visualization. An in-plane and real-time technique has only been described anecdotally.Methods and resultsA retrospective analysis of 11 patients (63% men, mean age: 37.7±21.2 years) presenting with cardiac tamponade admitted to the tertiary-care emergency department and treated with parasternal medial-to-lateral in-plane pericardiocentesis was carried out. The underlying causes of cardiac tamponade were different among the population. All the pericardiocentesis were successfully performed in the emergency department, without complications, relieving the hemodynamic instability. The mean time taken to perform the eight-step procedure was 309±76.4 s, with no procedure-related complications.ConclusionThe parasternal medial-to-lateral in-plane pericardiocentesis is a new technique theoretically free of complications and it enables real-time monitoring of needle trajectory. For the first time, a pericardiocentesis approach with a medial-to-lateral needle trajectory and real-time, in-plane, needle visualization was performed in a tamponade patient population.
| S-EPMC6133212 | biostudies-literature
Project description: Not available
| S-EPMC6360906 | biostudies-literature
Project description:IntroductionA retrobulbar hematoma (RH) is a serious time-dependent diagnosis due to its potential for permanent damage of the optic nerve, resulting in blindness. Emergency medicine (EM) physicians face the challenge of recognizing this time-sensitive injury and treating it before irreversible damage occurs. Due to its relative infrequency in the emergency department, residents may not have adequate experience in recognizing and treating RH.MethodsThis educational intervention outlined a simulated scenario that we developed to educate EM residents to diagnose RH and perform an emergent lateral canthotomy and cantholysis (LCC). Participating residents were asked to obtain a history and perform a physical examination that was consistent with a 34-year-old patient presenting with pushing behind the eye suggesting RH. Once residents made a diagnosis, they practiced performing an emergent LCC on a low-fidelity task trainer supplemented with a novel checklist. The residents completed an assessment questionnaire before and after the teaching module to measure the educational intervention's effectiveness.ResultsLearners' scores significantly improved in the ability to recognize and treat RH (12%, p < .001), in confidence in performing the procedure (18%, p < .001), but did not significantly decrease in stress (-10%, p = .058). The intervention was effective in improving preparedness, with all participants indicating that they felt more prepared to treat RH compared to before the educational intervention.DiscussionThis educational intervention is a successful resource that can decrease cases of preventable blindness by improving EM residents' ability to recognize and treat RHs.
| S-EPMC7837065 | biostudies-literature
Project description:As previously reported, a novel low temperature (LoTemp) polymerase chain reaction (PCR) catalyzed by a moderately heat-resistant (MHR) DNA polymerase with a chemical-assisted denaturation temperature set at 85 °C instead of the conventional 94-96 °C can achieve high-fidelity DNA amplification of a target DNA, even after up to 120 PCR thermal cycles. Furthermore, such accurate amplification is not achievable with conventional PCR. Now, using a well-recognized L1 gene segment of the human papillomavirus (HPV) type 52 (HPV-52) as the template for experiments, we demonstrate that the LoTemp high-fidelity DNA amplification is attributed to an unusually high processivity and stability of the MHR DNA polymerase whose high fidelity in template-directed DNA synthesis is independent of non-existent 3'-5' exonuclease activity. Further studies and understanding of the characteristics of the LoTemp PCR technology may facilitate implementation of DNA sequencing-based diagnostics at the point of care in community hospital laboratories.
| S-EPMC3709816 | biostudies-literature
Project description:BackgroundCarotid Artery Stenting (CAS) is increasingly being used in selected patients as a minimal invasive approach to carotid endarterectomy. Despite the long standing tradition of endovascular treatments, visual feedback during stent-deployment is impossible to obtain as deployment is performed under fluoroscopic imaging. Furthermore, the concept of stent-placement is often still unclear to patients. 3D Printing allows to replicate patient-specific anatomies and deploy stents inside them to simulate procedures. As such these models are being used for endovascular training as well as patient education.PurposeTo our knowledge, this study reports the first use of a low-cost patient-specific 3D printed model for teaching CAS deployment under direct visualization, without fluoroscopy.MethodologyA CT-angiogram was segmented and converted to STL format using Mimics inPrint™ software. The carotid arteries were bilaterally truncated to fit the whole model on a Formlabs 2 printer without omitting the internal vessel diameter. Next, this model was offset using a 1 mm margin. A ridge was modelled on the original vessel anatomy which was subsequently subtracted from the offset model in order to obtain a deroofed 3D model. All vessels were truncated to facilitate post-processing, flow and guide wire placement.ResultsCarotid artery stents were successfully deployed inside the vessel. The deroofing allows for clear visualization of the bottlenecks and characteristics of CAS deployment and positioning, including stent foreshortening, tapering and recoil. This low-cost 3D model provides visual insights in stent deployment and positioning, and can allow for patient-specific procedure planning.ConclusionsThe presented approach demonstrates the use of low-cost 3D Printed CAS models in teaching complex stent behavior as observed during deployment. Two main findings are illustrated. On one hand, the feasibility of low-cost in-hospital model production is shown. On the other hand, the teaching of CAS deployment bottlenecks at the carotid level without the need for fluoroscopic guidance, is illustrated. The observed stent characteristics as shown during deployment are difficult to assess in radiologic models. Furthermore, printing patient-specific 3D models preoperatively could possibly assist in accurate patient selection, preoperative planning, case-specific training and patient education.
| S-EPMC8414696 | biostudies-literature