Intercalates of Bi2Se3 studied in situ by time-resolved powder X-ray diffraction and neutron diffraction.
Ontology highlight
ABSTRACT:
SUBMITTER: Kamminga ME
PROVIDER: S-EPMC8383151 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:A hitherto unrecognized resolution effect in neutron Larmor diffraction (LD) is reported, resulting from small-angle neutron scattering (SANS) in the sample. Small distortions of the neutron trajectories by SANS give rise to a blurring of the Bragg angles of the order of a few hundredths of a degree, leading to a degradation of the momentum resolution. This effect is negligible for single crystals but may be significant for polycrystalline or powder samples. A procedure is presented to correct the LD data for the parasitic SANS. The latter is accurately determined by the SESANS technique (spin-echo small-angle neutron scattering), which is readily available on Larmor diffractometers. The analysis technique is demonstrated on LD and SESANS data from α-Fe2O3 powder samples. The resulting d-spacing range agrees with experimental data from high-resolution synchrotron radiation powder diffraction on the same sample.
| S-EPMC6998774 | biostudies-literature
Project description:Half-Heusler alloys are leading contenders for application in thermoelectric generators. However, reproducible synthesis of these materials remains challenging. Here, we have used in situ neutron powder diffraction to monitor the synthesis of TiNiSn from elemental powders, including the impact of intentional excess Ni. This reveals a complex sequence of reactions with an important role for molten phases. The first reaction occurs upon melting of Sn (232 °C), when Ni3Sn4, Ni3Sn2, and Ni3Sn phases form upon heating. Ti remains inert with formation of Ti2Ni and small amounts of half-Heusler TiNi1+ySn only occurring near 600 °C, followed by the emergence of TiNi and full-Heusler TiNi2y'Sn phases. Heusler phase formation is greatly accelerated by a second melting event near 750-800 °C. During annealing at 900 °C, full-Heusler TiNi2y'Sn reacts with TiNi and molten Ti2Sn3 and Sn to form half-Heusler TiNi1+ySn on a timescale of 3-5 h. Increasing the nominal Ni excess leads to increased concentrations of Ni interstitials in the half-Heusler phase and an increased fraction of full-Heusler. The final amount of interstitial Ni is controlled by defect chemistry thermodynamics. In contrast to melt processing, no crystalline Ti-Sn binaries are observed, confirming that the powder route proceeds via a different pathway. This work provides important new fundamental insights in the complex formation mechanism of TiNiSn that can be used for future targeted synthetic design. Analysis of the impact of interstitial Ni on the thermoelectric transport data is also presented.
| S-EPMC10173456 | biostudies-literature
Project description:A sapphire single-crystal gas-pressure cell without external support allowing unobstructed optical access by neutrons has been developed and optimized for elastic in situ neutron powder diffraction using hydrogen (deuterium) gas at the high-intensity two-axis diffractometer D20 at the Institut Laue-Langevin (Grenoble, France). Given a proper orientation of the single-crystal sample holder with respect to the detector, parasitic reflections from the sample holder can be avoided and the background can be kept low. Hydrogen (deuterium) gas pressures of up to 16.0 MPa at 298 K and 8.0 MPa at 655 K were tested successfully for a wall thickness of 3 mm. Heating was achieved by a two-sided laser heating system. The typical time resolution of in situ investigations of the reaction pathway of hydrogen (deuterium) uptake or release is on the order of 1 min. Detailed descriptions of all parts of the sapphire single-crystal gas-pressure cell are given, including materials information, technical drawings and instructions for use.
| S-EPMC8202029 | biostudies-literature
Project description:The bismuth oxychalcogenide compounds contain many different kinds of materials, such as Bi2O2X and Bi2OX2 (X = S, Se, and Te). These materials have different but similar layered crystal structures and exhibit various interesting physical properties. Here, we have theoretically investigated their Raman and infrared spectra by first principles calculations based on density functional theory. It is found that in Bi2O2Se the calculated frequency of the A1g Raman active mode is in good agreement with the experimental measurements while the other three modes are ambiguous or not observed yet. The Raman and infrared spectra of other materials are also presented and need further confirmation. Our work provides the structural fingerprints of these materials, which could be helpful in identifying the crystal structures in future experiments.
| S-EPMC9064694 | biostudies-literature
Project description:Time-of-flight neutron powder diffraction data have been collected from Na2MoO4 and Na2WO4 to a resolution of sin (θ)/λ = 1.25 Å(-1), which is substanti-ally better than the previous analyses using Mo Kα X-rays, providing roughly triple the number of measured reflections with respect to the previous studies [Okada et al. (1974 ▶). Acta Cryst. B30, 1872-1873; Bramnik & Ehrenberg (2004 ▶). Z. Anorg. Allg. Chem. 630, 1336-1341]. The unit-cell parameters are in excellent agreement with literature data [Swanson et al. (1962 ▶). NBS Monograph No. 25, sect. 1, pp. 46-47] and the structural parameters for the molybdate agree very well with those of Bramnik & Ehrenberg (2004 ▶). However, the tungstate structure refinement of Okada et al. (1974 ▶) stands apart as being conspicuously inaccurate, giving significantly longer W-O distances, 1.819 (8) Å, and shorter Na-O distances, 2.378 (8) Å, than are reported here or in other simple tungstates. As such, this work represents an order-of-magnitude improvement in precision for sodium molybdate and an equally substantial improvement in both accuracy and precision for sodium tungstate. Both compounds adopt the spinel structure type. The Na(+) ions have site symmetry .-3m and are in octa-hedral coordination while the transition metal atoms have site symmetry -43m and are in tetra-hedral coordination.
| S-EPMC4459306 | biostudies-literature
Project description:The prominent light-matter interaction in 2D materials has become a pivotal research area that involves either an archetypal study of inherent mechanisms to explore such interactions or specific applications to assess the efficacy of such novel phenomena. With scientifically controlled light-matter interactions, various applications have been developed. Here, we report four diverse applications on a single structure utilizing the efficient photoresponse of Bi2O2Se with precisely tuned multiple optical wavelengths. First, the Bi2O2Se-based device performs the function of optoelectronic memory using UV (λ = 365 nm, 1.1 mW cm-2) for the write-in process with SiO2 as the charge trapping medium followed by a +1 V bias for read-out. Second, associative learning is mimicked with wavelengths of 525 nm and 635 nm. Third, using similar optical inputs, functions of logic gates "AND", "OR", "NAND", and "NOR" are realized with response current and resistance as outputs. Fourth is the demonstration of a 4 bit binary to the decimal converter using wavelengths of 740 nm (LSB), 595 nm, 490 nm, and 385 nm (MSB) as binary inputs and output response current regarded as equivalent decimal output. Our demonstration is a paradigm for Bi2O2Se-based devices to be an integral part of future advanced multifunctional electronic systems.
| S-EPMC9470018 | biostudies-literature
Project description:The room-temperature formation of bismuth oxycarbonate (Bi2O2CO3) from Bi2O3 in sodium carbonate buffer was investigated with in situ powder X-ray diffraction (PXRD) in combination with electron microscopy and vibrational spectroscopy. Time-resolved PXRD measurements indicate a pronounced and rather complex pH dependence of the reaction mechanism. Bi2O2CO3 formation proceeds within a narrow window between pH 8 and 10 via different mechanisms. Although a zero-dimensional nucleation model prevails around pH 8, higher pH values induce a change toward a diffusion-controlled model, followed by a transition to regular nucleation kinetics. Ex situ synthetic and spectroscopic studies confirm these trends and demonstrate that in situ monitoring affords vital parameter information for the controlled fabrication of Bi2O2CO3 materials. Furthermore, the β → α bismuth oxide transformation temperatures of Bi2O2CO3 precursors obtained from different synthetic routes differ notably (by min 50 °C) from commercially available bismuth oxide. Parameter studies suggest a stabilizing role of surface carbonate ions in the as-synthesized bismuth oxide sources. Our results reveal the crucial role of multiple preparative history parameters, especially of pH value and source materials, for the controlled access to bismuth oxide-based catalysts and related functional compounds.
| S-EPMC6644937 | biostudies-literature
Project description:The solid-state synthesis and structural characterisation of perovskite BaSn1-x Sc x O3-δ (x = 0.0, 0.1, 0.2, 0.3, 0.4) and its corresponding hydrated ceramics are reported. Powder and neutron X-ray diffractions reveal the presence of cubic perovskites (space group Pm3m) with an increasing cell parameter as a function of scandium concentration along with some indication of phase segregation. 119Sn and 45Sc solid-state NMR spectroscopy data highlight the existence of oxygen vacancies in the dry materials, and their filling upon hydrothermal treatment with D2O. It also indicates that the Sn4+ and Sc3+ local distribution at the B-site of the perovskite is inhomogeneous and suggests that the oxygen vacancies are located in the scandium dopant coordination shell at low concentrations (x ≤ 0.2) and in the tin coordination shell at high concentrations (x ≥ 0.3). 17O NMR spectra on 17O enriched BaSn1-x Sc x O3-δ materials show the existence of Sn-O-Sn, Sn-O-Sc and Sc-O-Sc bridging oxygen environments. A further room temperature neutron powder diffraction study on deuterated BaSn0.6Sc0.4O3-δ refines the deuteron position at the 24k crystallographic site (x, y, 0) with x = 0.579(3) and y = 0.217(3) which leads to an O-D bond distance of 0.96(1) Å and suggests tilting of the proton towards the next nearest oxygen. Proton conduction was found to dominate in wet argon below 700 °C with total conductivity values in the range 1.8 × 10-4 to 1.1 × 10-3 S cm-1 between 300 and 600 °C. Electron holes govern the conduction process in dry oxidizing conditions, whilst in wet oxygen they compete with protonic defects leading to a wide mixed conduction region in the 200 to 600 °C temperature region, and a suppression of the conductivity at higher temperature.
| S-EPMC4894074 | biostudies-literature
Project description:Near-field microscopy discloses a peculiar potential to explore novel quantum state of matter at the nanoscale, providing an intriguing playground to investigate, locally, carrier dynamics or propagation of photoexcited modes as plasmons, phonons, plasmon-polaritons or phonon-polaritons. Here, we exploit a combination of hyperspectral time domain spectroscopy nano-imaging and detectorless scattering near-field optical microscopy, at multiple terahertz frequencies, to explore the rich physics of layered topological insulators as Bi2Se3 and Bi2Te2.2Se0.8, hyperbolic materials with topologically protected surface states. By mapping the near-field scattering signal from a set of thin flakes of Bi2Se3 and Bi2Te2.2Se0.8 of various thicknesses, we shed light on the nature of the collective modes dominating their optical response in the 2-3 THz range. We capture snapshots of the activation of transverse and longitudinal optical phonons and reveal the propagation of sub-diffractional hyperbolic phonon-polariton modes influenced by the Dirac plasmons arising from the topological surface states and of bulk plasmons, prospecting new research directions in plasmonics, tailored nanophotonics, spintronics and quantum technologies.
| S-EPMC8602307 | biostudies-literature
Project description:Gas generation as a result of electrolyte decomposition is one of the major issues of high-performance rechargeable batteries. Here, we report the direct observation of gassing in operating lithium-ion batteries using neutron imaging. This technique can be used to obtain qualitative as well as quantitative information by applying a new analysis approach. Special emphasis is placed on high voltage LiNi0.5Mn1.5O4/graphite pouch cells. Continuous gassing due to oxidation and reduction of electrolyte solvents is observed. To separate gas evolution reactions occurring on the anode from those associated with the cathode interface and to gain more insight into the gassing behavior of LiNi0.5Mn1.5O4/graphite cells, neutron experiments were also conducted systematically on other cathode/anode combinations, including LiFePO4/graphite, LiNi0.5Mn1.5O4/Li4Ti5O12 and LiFePO4/Li4Ti5O12. In addition, the data were supported by gas pressure measurements. The results suggest that metal dissolution in the electrolyte and decomposition products resulting from the high potentials adversely affect the gas generation, particularly in the first charge cycle (i.e., during graphite solid-electrolyte interface layer formation).
| S-EPMC4620486 | biostudies-literature