Functional Integration of Catalysts with Si Nanowire Photocathodes for Efficient Utilization of Photogenerated Charge Carriers.
Ontology highlight
ABSTRACT:
SUBMITTER: Lim SY
PROVIDER: S-EPMC8412901 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Bulk heterojunction polymer solar cells (PSCs) blended with non-fullerene-type acceptors (NFAs) possess good solar power conversion efficiency and compatibility with flexible electronics, rendering them good candidates for mobile photovoltaic applications. However, their internal absorption performance and mechanism are yet to be fully elucidated because of their complicated interference effect caused by their multilayer device structure. The transfer matrix method (TMM) is ideal for analyzing complex optical electric fields by considering multilayer interference effects. In this study, an active layer (AL) thickness-dependent TMM is used to obtain accurate information on the photon-capturing mechanisms of NFA-based PSCs for comparison with experimental results. Devices with AL thicknesses of 40-350 nm were prepared, and the AL-thickness-dependent device parameters with incident photon-to-current efficiency spectra were compared with the calculated internal absorption spectra of the TMM. The spectrally and spatially resolved spectra as a function of the AL thickness and excitation wavelength revealed that the power conversion efficiency of the NFA-blended PSC decreased with the increasing AL thickness after reaching a maximum of ~100 nm; by contrast, the internal absorption efficiency showed the opposite trend. Furthermore, the TMM spectra indicated that the spatial distribution of the photogenerated charge carriers became significantly imbalanced as the AL thickness increased, implying that the AL-dependent loss stemmed from the discrepancy between the absorption and the extracted charge carriers.
| S-EPMC10421118 | biostudies-literature
Project description:Among the parameters determining the efficiency of an organic solar cell, the open-circuit voltage (VOC) is the one with most room for improvement. Existing models for the description of VOC assume that photogenerated charge carriers are thermalized. Here, we demonstrate that quasi-equilibrium concepts cannot fully describe VOC of disordered organic devices. For two representative donor:acceptor blends, it is shown that VOC is actually 0.1-0.2 V higher than it would be if the system was in thermodynamic equilibrium. Extensive numerical modeling reveals that the excess energy is mainly due to incomplete relaxation in the disorder-broadened density of states. These findings indicate that organic solar cells work as nonequilibrium devices, in which part of the photon excess energy is harvested in the form of an enhanced VOC.
| S-EPMC8521526 | biostudies-literature
Project description:We developed here the efficient photocatalysts for the removal of high concentrations of tetracycline under visible light by immobilizing the AWO (A = Ag, Bi, Na) nanocrystals on the surface of siligraphene (g-SiC) nanosheets. The g-SiC/AWO composites was synthesized by magnesiothermic synthesis of g-SiC and sonochemical immobilization of tungstates. These new heterojunctions of g-SiC/tungstates show superior photocatalytic activities in the degradation of high concentrations of tetracycline and 97, 98, and 94% of tetracycline were removed by using low amounts of g-SiC/Ag2WO4, g-SiC/Bi2WO6, and g-SiC/Na2WO4 catalysts, respectively. Based on band structures, the band gaps reduce and the photocatalytic activities were extremely enhanced due to the shortening of electron transfer distance through the Z-scheme mechanism. Also, the graphenic structure of g-SiC is another parameter that was effective in improving photocatalytic performance by increasing the electron transfer and decreasing the rate of electron-hole recombination. Furthermore, the π back-bonding of g-SiC with metal atoms increases the electron-hole separation to enhance the photocatalytic activity. Interestingly, g-SiC composites (g-SiC/AWO) showed much higher photocatalytic properties compared to graphene composites (gr/AWO) and can remove the tetracycline even at dark by producing the oxygenated radicals via adsorption of oxygen on the positive charge of Si atoms in siligraphene structure.
| S-EPMC10282037 | biostudies-literature
Project description:Excitons are spin integer particles that are predicted to condense into a coherent quantum state at sufficiently low temperature. Here by using photocurrent imaging we report experimental evidence of formation and efficient transport of non-equilibrium excitons in Bi2-xSbxSe3 nanoribbons. The photocurrent distributions are independent of electric field, indicating that photoexcited electrons and holes form excitons. Remarkably, these excitons can transport over hundreds of micrometers along the topological insulator (TI) nanoribbons before recombination at up to 40?K. The macroscopic transport distance, combined with short carrier lifetime obtained from transient photocurrent measurements, indicates an exciton diffusion coefficient at least 36?m2?s-1, which corresponds to a mobility of 6?×?104?m2?V-1?s-1 at 7?K and is four order of magnitude higher than the value reported for free carriers in TIs. The observation of highly dissipationless exciton transport implies the formation of superfluid-like exciton condensate at the surface of TIs.
| S-EPMC6915787 | biostudies-literature
Project description:Wafer-scale graphene/Si-nanowire (Si-NW) array heterostructures for molecular sensing have been fabricated by vertically contacting single-layer graphene with high-density Si NWs. Graphene is grown in large scale by chemical vapour deposition and Si NWs are vertically aligned by metal-assisted chemical etching of Si wafer. Graphene plays a key role in preventing tips of vertical Si NWs from being bundled, thereby making Si NWs stand on Si wafer separately from each other under graphene, a critical structural feature for the uniform Schottky-type junction between Si NWs and graphene. The molecular sensors respond very sensitively to gas molecules by showing 37 and 1280% resistance changes within 3.5/0.15 and 12/0.15 s response/recovery times under O2 and H2 exposures in air, respectively, highest performances ever reported. These results together with the sensor responses in vacuum are discussed based on the surface-transfer doping mechanism.
| S-EPMC4064328 | biostudies-literature
Project description:Researching optical effects in nanowires may require a high pump intensity which under ambient conditions can degrade nanowires due to thermal oxidation. In this work we investigated the photodegradation of a single Si-doped GaAs nanowire by laser heating in air. To understand the changes that occurred on the nanowire we carried out Raman spectroscopy, scanning electron microscopy, energy dispersive X-ray spectroscopy, and photoluminescence spectroscopy in laser damaged regions as well as in non-affected ones. From Raman Stokes and anti-Stokes measurements we estimated the local temperature that the oxidation process of the nanowire (NW) surface starts at as 661 K, resulting in two new Raman modes at 200 cm-1 and 259 cm-1. Scanning electron microscopy and energy dispersive X-ray spectroscopy measurements showed a significant loss of arsenic in the oxidized regions, but no erosion of the nanowire. Micro-photoluminescence measurements showed the near-band-edge emission of GaAs along the nanowire, as well as a new emission band at 755 nm corresponding to polycrystalline β-Ga2O3 formation. Our results also indicate that neither amorphous As nor crystalline As were deposited on the surface of the nanowire. Combining different experimental techniques, this study showed the formation of polycrystalline β-Ga2O3 by oxidation of the nanowire surface and the limits for performing spectroscopic investigations on individual GaAs NWs under ambient air conditions.
| S-EPMC9076065 | biostudies-literature
Project description:Electrodepositing low loadings of metallic nanoparticle catalysts onto the surface of semiconducting photoelectrodes is a highly attractive approach for decreasing catalyst costs and minimizing optical losses. However, securely anchoring nanoparticles to the photoelectrode surface can be challenging-especially if the surface is covered by a thin insulating overlayer. Herein, we report on Si-based photocathodes for the hydrogen evolution reaction that overcome this problem through the use of a 2-10 nm thick layer of silicon oxide (SiOx) that is deposited on top of Pt nanoparticle catalysts that were first electrodeposited on a 1.5 nm SiO2|p-Si(100) absorber layer. Such insulator-metal-insulator-semiconductor (IMIS) photoelectrodes exhibit superior durability and charge transfer properties compared to metal-insulator-semiconductor (MIS) control samples that lacked the secondary SiOx overlayer. Systematic investigation of the influence of particle loading, SiOx layer thickness, and illumination intensity suggests that the SiOx layer possesses moderate conductivity, thereby reducing charge transfer resistance associated with high local tunneling current densities between the p-Si and Pt nanoparticles. Importantly, the IMIS architecture is proven to be a highly effective approach for stabilizing electrocatalytic nanoparticles deposited on insulating overlayers without adversely affecting mass transport of reactant and product species associated with the hydrogen evolution reaction.
| S-EPMC7673655 | biostudies-literature
Project description:ZnO has long been considered as a model UV-driven photoanode for photoelectrochemical water splitting, but its performance has been limited by fast charge-carrier recombination, extremely poor stability in aqueous solution, and slow kinetics of water oxidation. These issues were addressed by applying a strategy of optimization and passivation of hydrothermally grown 1D ZnO nanowire arrays. The length and diameter of bare ZnO nanowires were optimized by varying the growth time and precursor concentration to achieve optimal photoelectrochemical performance. The addition of earth-abundant cobalt phosphate (Co-Pi) and nickel borate (Ni-B) oxygen evolution catalysts onto ZnO nanowires resulted in substantial cathodic shifts in onset potential to as low as about 0.3 V versus the reversible hydrogen electrode (RHE) for Ni-B/ZnO, for which a maximum photocurrent density of 1.1 mA cm(-2) at 0.9 V (vs. RHE) with applied bias photon-to-current efficiency of 0.4 % and an unprecedented near-unity incident photon-to-current efficiency at 370 nm. In addition the potential required for saturated photocurrent was dramatically reduced from 1.6 to 0.9 V versus RHE. Furthermore, the stability of these ZnO nanowires was significantly enhanced by using Ni-B compared to Co-Pi due to its superior chemical robustness, and it thus has additional functionality as a stable protecting layer on the ZnO surface. These remarkable enhancements in both photocatalytic activity and stability directly address the current severe limitations in the use of ZnO-based photoelectrodes for water-splitting applications, and can be applied to other photoanodes for efficient solar-driven fuel synthesis.
| S-EPMC4517101 | biostudies-literature
Project description:Nanostructured semiconductors feature resonant optical modes that confine light absorption in specific areas called "hot spots". These areas can be used for localized extraction of the photogenerated charges, which in turn could drive chemical reactions for synthesis of catalytic materials. In this work, we use these nanophotonic hot spots in vertical silicon nanowires to locally deposit platinum nanoparticles in a photo-electrochemical system. The tapering angle of the silicon nanowires as well as the excitation wavelength are used to control the location of the hot spots together with the deposition sites of the platinum catalyst. A combination of finite difference time domain (FDTD) simulations with scanning electron microscopy image analysis showed a reasonable correlation between the simulated hot spots and the actual experimental localization and quantity of platinum atoms. This nanophotonic approach of driving chemical reactions at the nanoscale using the optical properties of the photo-electrode, can be very promising for the design of lithography-free and efficient hierarchical nanostructures for the generation of solar fuels.
| S-EPMC6122171 | biostudies-literature
Project description:Photogenerated hot electrons from plasmonic nanostructures are very promising for photocatalysis, mostly due to their potential for enhanced chemical selectivity. Here, we present a self-optimized fabrication method of plasmonic photocathodes using hot-electron chemistry, for enhanced photocatalytic efficiencies. Plasmonic Au/TiO2 nanoislands are excited at their surface plasmon resonance to generate hot electrons in an aqueous bath containing a platinum (cocatalyst) precursor. Hot electrons drive the deposition of Pt cocatalyst nanoparticles, without any nanoparticle functionalization and negligible applied bias, close to the hotspots of the plasmonic nanoislands. The presence of TiO2 is crucial for achieving higher chemical reaction rates. The Au/TiO2/Pt photocathodes synthesized using hot-electron chemistry show a photocatalytic activity of up to 2 times higher than that of a control made with random electrodeposited Pt nanoparticles. This light-driven positioning of the cocatalyst close to the same positions where hot electrons are most efficiently generated and transferred represents a novel and simple method for synthesizing complex, self-optimized photocatalytic nanostructures with improved efficiency and selectivity.
| S-EPMC6778899 | biostudies-literature