Browse
Submit Data
Databases
API
Help

Dataset Information

8 Views

0 Connections

0 Citations

0 Reanalyses

0 Downloads

Omics score: 0

Low limit of detection of the AlGaN/GaN-based sensor by the Kelvin connection detection technique.

ABSTRACT: The AlGaN/GaN-based sensor is a promising POCT (point-of-care-testing) device featuring miniaturization, low cost, and high sensitivity. BNP is an effective protein biomarker for the early diagnosis of HF (heart failure). In this work, a novel AlGaN/GaN device with the Kelvin connection structure and the corresponding detection technique was proposed. This technique can effectively suppress the background noise and improve the SNR (signal-to-noise ratio). A BNP detection experiment was carried out to verify the effectiveness of this technique. It is shown that compared with that of the traditional detection method, the LOD (limit of detection) was improved from 0.47 ng/mL to 1.29 pg/mL. The BNP detection experiment was also carried out with a traditional electrochemical Au-electrode sensor with the same surface functionalization steps. The AlGaN/GaN sensor showed a better LOD than the Au-electrode sensor. Moreover, the influence of AlGaN/GaN sensor package on background noise was investigated with the mechanism of the noise source revealed. Finally, based on the optimized package, the optimal SNR quiescent operating point of the AlGaN/GaN sensor was determined. By biasing the sensor at the optimal quiescent operating point and immobilizing the magnetic beads with anti-BNP on the gate of the AlGaN/GaN sensor, the LOD for BNP detection was further improved to 0.097 pg/mL.

SUBMITTER: Zhang H

PROVIDER: S-EPMC8433396 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Json Xml

Similar Datasets

Low-Power AlGaN/GaN Triangular Microcantilever for Air Flow Detection.

Project description:This paper investigates an AlGaN/GaN triangular microcantilever with a heated apex for airflow detection utilizing a very simple two-terminal sensor configuration. Thermal microscope images were used to verify that the apex region of the microcantilever reached significantly higher temperatures than other parts under applied voltage bias. The sensor response was found to vary linearly with airflow rate when tested over a range of airflow varying from 16 to 2000 sccm. The noise-limited flow volume measurement yielded ~4 sccm resolution, while the velocity resolution was found to be 0.241 cm/s, which is one of the best reported so far for thermal sensors. The sensor was able to operate at a very low power consumption level of ~5 mW, which is one of the lowest reported for these types of sensors. The intrinsic response time of the sensor was estimated to be on the order of a few ms, limited by its thermal properties. Overall, the microcantilever sensor, with its simple geometry and measurement configurations, was found to exhibit attractive performance metrics useful for various sensing applications.

| S-EPMC10490568 | biostudies-literature

Strain Balanced AlGaN/GaN/AlGaN nanomembrane HEMTs.

Project description:Single crystal semiconductor nanomembranes (NM) are important in various applications such as heterogeneous integration and flexible devices. This paper reports the fabrication of AlGaN/GaN NMs and NM high electron mobility transistors (HEMT). Electrochemical etching is used to slice off single-crystalline AlGaN/GaN layers while preserving their microstructural quality. A double heterostructure design with a symmetric strain profile is employed to ensure minimal residual strain in freestanding NMs after release. The mobility of the two-dimensional electron gas (2DEG), formed by the AlGaN/GaN heterostructure, is noticeably superior to previously reported values of many other NMs. AlGaN/GaN nanomembrane HEMTs are fabricated on SiO2 and flexible polymeric substrates. Excellent electrical characteristics, including a high ON/OFF ratio and transconductance, suggest that III-Nitrides nanomembranes are capable of supporting high performance applications.

| S-EPMC5527108 | biostudies-literature

High Temperature AlGaN/GaN Membrane Based Pressure Sensors.

Project description:A highly sensitive Gallium Nitride (GaN) diaphragm based micro-scale pressure sensor with an AlGaN/GaN heterostructure field effect transistor (HFET) deflection transducer has been designed and fabricated for high temperature applications. The performance of the pressure sensor was studied over a pressure range of 20 kPa, which resulted in an ultra-high sensitivity of ~0.76%/kPa, with a signal-to-noise ratio as high as 16 dB, when biased optimally in the subthreshold region. A high gauge factor of 260 was determined from strain distribution in the sensor membrane obtained from finite element simulations. A repeatable sensor performance was observed over multiple pressure cycles up to a temperature of 200 °C.

| S-EPMC6187712 | biostudies-literature

AlGaN/GaN High Electron Mobility Transistor-Based Biosensor for the Detection of C-Reactive Protein.

Project description:In this paper, we propose an AlGaN/GaN high electron mobility transistor (HEMT)-based biosensor for the detection of C-reactive protein (CRP) using a null-balancing circuit. A null-balancing circuit was used to measure the output voltage of the sensor directly. The output voltage of the proposed biosensor was varied by antigen-antibody interactions on the gate surface due to CRP charges. The AlGaN/GaN HFET-based biosensor with null-balancing circuit applied shows that CRP can be detected in a wide range of concentrations, varying from 10 ng/mL to 1000 ng/mL. X-ray photoelectron spectroscopy was carried out to verify the immobilization of self-assembled monolayer with Au on the gated region.

| S-EPMC4570328 | biostudies-literature

Low Detection Limit and High Sensitivity Wind Speed Sensor Based on Triboelectrification-Induced Electroluminescence.

Project description:The rapid development of the Internet of Things (IoT) has tremendously increased the demands for wind speed sensors in various applications, such as weather forecasting and environmental monitoring. To date, many wind speed sensors are developed based on triboelectric nanogenerators (TENGs). However, the low output current leads to a poor sensing precision, which greatly limits their practical applications. Here, a wind speed sensor is proposed by integrating a wind-driven triboelectrification-induced electroluminescence (TIEL) component with a perovskite-based photodetector (PD) for enlarged electric current output. Compared with mechanoluminescence (ML), TIEL displays significantly higher signal intensity even under gentle breezes. In addition, the emission peak of TIEL matches with the absorption band of perovskite materials. Thus, TIEL materials are promising candidates for generating distinct electrical signals in real-time to facilitate the detection of wind speed. With a comparable detection limit (5 m s-1) to a conventional TENG-based wind speed sensor, the sensitivity of this hybrid sensor is three magnitudes higher at low bias voltages and, the response time is extremely short (<0.3 s). Moreover, it shows a favorable correlation with a commercial sensor. This research provides important progress toward environmentally-friendly light sources and TIEL-related sensor systems.

| S-EPMC6891903 | biostudies-literature

Investigation of AlGaN/GaN HFET and VO2 Thin Film Based Deflection Transducers Embedded in GaN Microcantilevers.

Project description:The static and dynamic deflection transducing performances of piezotransistive AlGaN/GaN heterojunction field effect transistors (HFET) and piezoresistive VO2 thin films, fabricated on GaN microcantilevers of similar dimensions, were investigated. Deflection sensitivities were tuned with the gate bias and operating temperature for embedded AlGaN/GaN HFET and VO2 thin film transducers, respectively. The GaN microcantilevers were excited with a piezoactuator in their linear and nonlinear oscillation regions of the fundamental oscillatory mode. In the linear regime, the maximum deflection sensitivity of piezotransistive AlGaN/GaN HFET reached up to a 0.5% change in applied drain voltage, while the responsivity of the piezoresistive VO2 thin film based deflection transducer reached a maximum value of 0.36% change in applied drain current. The effects of the gate bias and the operation temperature on nonlinear behaviors of the microcantilevers were also experimentally examined. Static deflection sensitivity measurements demonstrated a large change of 16% in drain-source resistance of the AlGaN/GaN HFET, and a similarly high 11% change in drain-source resistance in the VO2 thin film, corresponding to a 10 ?m downward step bending of the cantilever free end.

| S-EPMC7570367 | biostudies-literature

Effects of GaN/AlGaN/Sputtered AlN nucleation layers on performance of GaN-based ultraviolet light-emitting diodes.

Project description:We report on the demonstration of GaN-based ultraviolet light-emitting diodes (UV LEDs) emitting at 375 nm grown on patterned sapphire substrate (PSS) with in-situ low temperature GaN/AlGaN nucleation layers (NLs) and ex-situ sputtered AlN NL. The threading dislocation (TD) densities in GaN-based UV LEDs with GaN/AlGaN/sputtered AlN NLs were determined by high-resolution X-ray diffraction (XRD) and cross-sectional transmission electron microscopy (TEM), which revealed that the TD density in UV LED with AlGaN NL was the highest, whereas that in UV LED with sputtered AlN NL was the lowest. The light output power (LOP) of UV LED with AlGaN NL was 18.2% higher than that of UV LED with GaN NL owing to a decrease in the absorption of 375 nm UV light in the AlGaN NL with a larger bandgap. Using a sputtered AlN NL instead of the AlGaN NL, the LOP of UV LED was further enhanced by 11.3%, which is attributed to reduced TD density in InGaN/AlInGaN active region. In the sputtered AlN thickness range of 10-25 nm, the LOP of UV LED with 15-nm-thick sputtered AlN NL was the highest, revealing that optimum thickness of the sputtered AlN NL is around 15 nm.

| S-EPMC5353678 | biostudies-literature

The detrimental effect of AlGaN barrier quality on carrier dynamics in AlGaN/GaN interface.

Project description:Carrier recombination and scattering at the semiconductor boundaries can substantially limit the device efficiency. However, surface and interface recombination is generally neglected in the nitride-based devices. Here, we study carrier recombination and diffusivity in AlGaN/GaN/sapphire heterointerfaces with AlGaN barriers of different quality. We employ the light induced transient grating and time-resolved photoluminescence spectroscopy techniques to extract carrier lifetime in different depths of the GaN buffer as well as in the AlGaN barrier, and to evaluate the carrier diffusion coefficient in the buffer. Moreover, we assess interface recombination velocity, Shockley-Read-Hall and radiative recombination rates. We reveal the adverse barrier influence on carrier dynamics in the underlying buffer: AlGaN barrier accelerates the nonradiative carrier recombination in the GaN buffer. The interface recombination velocity in the GaN buffer increases with decreasing AlGaN barrier quality, and the dominating recombination mechanism switches from Shockley-Read-Hall to interface recombination. These phenomena are governed by a cumulative effect of various interface-deteriorating barrier defects. Meanwhile, the carrier diffusivity in the GaN buffer is not affected by the AlGaN barrier. We conclude that barrier-accelerated interface recombination can become a major carrier loss mechanism in AlGaN/GaN interface, and may substantially limit the efficiency in nitride-based UV LEDs.

| S-EPMC6874540 | biostudies-literature

Formation of quantum dots in GaN/AlGaN FETs.

Project description:GaN and the heterostructures are attractive in condensed matter science and applications for electronic devices. We measure the electron transport in GaN/AlGaN field-effect transistors (FETs) at cryogenic temperature. We observe formation of quantum dots in the conduction channel near the depletion of the 2-dimensional electron gas (2DEG). Multiple quantum dots are formed in the disordered potential induced by impurities in the FET conduction channel. We also measure the gate insulator dependence of the transport properties. These results can be utilized for the development of quantum dot devices utilizing GaN/AlGaN heterostructures and evaluation of the impurities in GaN/AlGaN FET channels.

| S-EPMC7508848 | biostudies-literature

A novel AlGaN/GaN heterostructure field-effect transistor based on open-gate technology.

Project description:In this study, a novel AlGaN/GaN heterostructure field-effect transistor based on open-gate technology was fabricated. Sample transistors of different structures and sizes were constructed. Through measurements, it was found that by changing the width of the opening, the threshold voltage of the device could be easily modulated across a larger range. The open-gate device had two working modes with different transconductance. When the gate-source voltage VGS ≤ - 4.5 V, only the open region was conductive, and a new working mechanism modulated the channel current. Corresponding theoretical analysis and calculations showed that its saturation mechanism was related to a virtual gate formed by electron injection onto the surface. Also, the gate-source voltage modulated the open channel current by changing the channel electron mobility through polarization Coulomb field scattering. When used as class-A voltage amplifiers, open-gate devices can achieve effective voltage amplification with very low power consumption.

| S-EPMC8599847 | biostudies-literature

OmicsDI is part of the ELIXIR infrastructure

OmicsDI is an Elixir interoperability service. Learn more ›

Tweets

OmicsDI Databases

PRIDE
PeptideAtlas
MassIVE
JPOST Repository
Physiome Model Repository

EGA
EVA
ENA
LINCS
PAXDB
Cell Collective

MetaboLights
Metabolomics Workbench
MetabolomeExpress
GNPS
BioModels
FAIRDOMHub

ArrayExpress
dbGaP
ExpressionAtlas
GEO
NODE

Information

Databases
Help
API
Contact us
Code on GitHub
Terms of use
Submit Data