Critical Solutal Marangoni Number Correlation for Short-Scale Convective Instabilities in Drying Poly(vinyl acetate)-Methanol Thin Films.
Ontology highlight
ABSTRACT:
SUBMITTER: Tonsmann M
PROVIDER: S-EPMC8433935 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Ethylene vinyl acetate (EVA) is a copolymer comprehending the semi-crystalline polyethylene and amorphous vinyl acetate phases, which potentially allow the fabrication of tunable materials. This paper aims at describing the fabrication and characterization of nanocomposite thin films made of polyethylene vinyl acetate, at different polymer concentration and vinyl acetate content, doped with piezoelectric nanomaterials, namely zinc oxide and barium titanate. These membranes are prepared by solvent casting, achieving a thickness in the order of 100-200 µm. The nanocomposites are characterized in terms of morphological, mechanical, and chemical properties. Analysis of the nanocomposites shows the nanofillers to be homogeneously dispersed in EVA matrix at different vinyl acetate content. Their influence is also noted in the mechanical behavior of thin films, which elastic modulus ranged from about 2 to 25 MPa, while keeping an elongation break from 600% to 1500% and tensile strength from 2 up to 13 MPa. At the same time, doped nanocomposite materials increase their crystallinity degree than the bare ones. The radiopacity provided by the addition of the dopant agents is proven. Finally, the direct piezoelectricity of nanocomposites membranes is demonstrated, showing higher voltage outputs (up to 2.5 V) for stiffer doped matrices. These results show the potentialities provided by the addition of piezoelectric nanomaterials towards mechanical reinforcement of EVA-based matrices while introducing radiopaque properties and responsiveness to mechanical stimuli.
| S-EPMC6724128 | biostudies-literature
Project description:In the minutes immediately preceding the rupture of a soap bubble, distinctive and repeatable patterns can be observed. These quasistable transient structures are associated with the instabilities of the complex Marangoni flows on the curved thin film in the presence of a surfactant solution. Here, we report a generalized Cahn-Hilliard-Swift-Hohenberg model derived using asymptotic theory that describes the quasielastic wrinkling pattern formation and the consequent coarsening dynamics in a curved surfactant-laden thin film. By testing the theory against experiments on soap bubbles, we find quantitative agreement with the analytical predictions of the nucleation and the early coarsening phases associated with the patterns. Our findings provide fundamental physical understanding that can be used to (de-)stabilize thin films in the presence of surfactants and have important implications for both natural and industrial contexts, such as the production of thin coating films, foams, emulsions, and sprays.
| S-EPMC7343401 | biostudies-literature
Project description:Drying is a simultaneous heat and mass transfer processes. Drying kinetics is determined by both internal properties and external drying conditions. In this study, two important drying kinetics parameters of onions i.e. effective water diffusivity and relative activation energy of reaction engineering approach (REA) are determined. The generated parameters are used to model thin layer drying of onion at different temperatures (40, 50, 60, and 70 °C) and relative humidity of 20%. The effective water diffusivity is in the range of 2.8 × 10-10 m2 s-1 and 8.1 × 10-10 m2 s-1. Unlike the diffusivity, the relative activation energy of the REA is independent on drying conditions and thus the latter approach requires less effort in generating the transport properties. The transport parameters can be applied for assisting in designing dryer units and evaluating the performance of existing dryer units.
| S-EPMC6582086 | biostudies-literature
Project description:We discuss the formation and post-deposition instability of nanodrop-like structures in thin films of PDIF-CN2 (a perylene derivative) deposited via supersonic molecular beam deposition technique on highly hydrophobic substrates at room temperature. The role of the deposition rate on the characteristic lengths of the organic nanodrops has been investigated by a systematic analysis of atomic force microscope images of the thin films and through the use of the height-height correlation function. The nanodrops appear to be a metastable configuration for the freshly-deposited films. For this reason, post-deposition wetting effect has been examined with unprecedented accuracy throughout a year of experimental observations. The observed time scales, from few hours to months, are related to the growth rate, and characterize the thin films morphological reordering from three-dimensional nanodrops to a well-connected terraced film. While the interplay between adhesion and cohesion energies favors the formation of 3D-mounted structures during the growth, wetting phenomenon following the switching off of the molecular flux is found to be driven by an instability. A slow rate downhill process survives at the molecular flux shutdown and it is accompanied and maybe favored by the formation of a precursor layer composed of more lying molecules. These results are supported by simulations based on a non-linear stochastic model. The instability has been simulated, for both the growth and the post-growth evolution. To better reproduce the experimental data it is needed to introduce a surface equalizer term characterized by a relaxation time taking into account the presence of a local mechanism of molecular correlation.
| S-EPMC6089966 | biostudies-literature
Project description:Charged colloidal dispersions make up the basis of a broad range of industrial and commercial products, from paints to coatings and additives in cosmetics. During drying, an initially liquid dispersion of such particles is slowly concentrated into a solid, displaying a range of mechanical instabilities in response to highly variable internal pressures. Here we summarize the current appreciation of this process by pairing an advection-diffusion model of particle motion with a Poisson-Boltzmann cell model of inter-particle interactions, to predict the concentration gradients in a drying colloidal film. We then test these predictions with osmotic compression experiments on colloidal silica, and small-angle X-ray scattering experiments on silica dispersions drying in Hele-Shaw cells. Finally, we use the details of the microscopic physics at play in these dispersions to explore how two macroscopic mechanical instabilities-shear-banding and fracture-can be controlled.This article is part of the themed issue 'Patterning through instabilities in complex media: theory and applications.'
| S-EPMC5379044 | biostudies-literature
Project description:Kinetics of osmotic dehydration (OD) and insights into the effect of salt concentration (5%, 10%, 15%, 20%), drying temperature (50 ∘C, 60 ∘C, 70 ∘C), and sample thickness (4 mm, 6 mm, 8 mm) on the drying kinetics of sweet gourd of two varieties (SGV-1 and SGV-2) were investigated based on the Fick's second law of diffusion model. Quality attributes (chemical and organoleptic) of biscuit formulated with osmotic dehydrated sweet gourd powder were assessed. Results showed that, significant changes occurred during the first 2 h of process where mass transfer kinetics were increased with increasing salt concentration. With increasing time, drying rate was proportional to the temperature, inversely proportional to the sample thickness as well as salt concentration. Moreover, sweet gourd variety has shown impact on formulated products quality and consumer acceptability which could serve as a ground to diversify the use of sweet gourd towards industrial application.Supplementary informationThe online version contains supplementary material available at 10.1007/s10068-022-01193-x.
| S-EPMC10786769 | biostudies-literature
Project description:In this study we investigated the influence of an organic polystyrene brush on the deposition of ZnO thin films under moderate conditions. On a non-modified SiO x surface, island growth is observed, whereas the polymer brush induces homogeneous film growth. A chemical modification of the polystyrene brushes during the mineralization process occurs, which enables stronger interaction between the then polar template and polar ZnO crystallites in solution. This may lead to oriented attachment of the crystallites so that the observed (002) texture arises. Characterization of the templates and the resulting ZnO films were performed with ?-potential and contact angle measurements as well as scanning electron microscopy (SEM), atomic force microscopy (AFM) and X-ray diffraction (XRD). Infrared spectroscopy (IR) measurements were used to investigate the polystyrene brushes before and after modification.
| S-EPMC4734420 | biostudies-literature
Project description:We investigated the adsorption and reaction of methanol on continuous and discontinuous films of samarium oxide (SmOx) grown on Pt(111) in ultrahigh vacuum. The methanol decomposition was studied by temperature programmed desorption (TPD) and infrared reflection absorption spectroscopy (IRRAS), while structural changes of the oxide surface were monitored by low-energy electron diffraction (LEED). Methanol dehydrogenates to adsorbed methoxy species on both the continuous and discontinuous SmOx films, eventually leading to the desorption of CO and H? which desorbs at temperatures in the range 400-600 K. Small quantities of CO? are also detected mainly on as-prepared Sm?O? thin films, but the production of CO? is limited during repeated TPD runs. The discontinuous film exhibits the highest reactivity compared to the continuous film and the Pt(111) substrate. The reactivity of methanol on reduced and reoxidized films was also investigated, revealing how SmOx structures influence the chemical behavior. Over repeated TPD experiments, a SmOx structural/chemical equilibrium condition is found which can be approached either from oxidized or reduced films. We also observed hydrogen absence in TPD which indicates that hydrogen is stored either in SmOx films or as OH groups on the SmOx surfaces.
| S-EPMC5512909 | biostudies-other
Project description:Precipitation of calcium carbonate from water films generates fascinating calcite morphologies that have attracted scientific interest over past centuries. Nowadays, speleothems are no longer known only for their beauty but they are also recognized to be precious records of past climatic conditions, and research aims to unveil and understand the mechanisms responsible for their morphological evolution. In this paper, we focus on crenulations, a widely observed ripple-like instability of the the calcite-water interface that develops orthogonally to the film flow. We expand a previous work providing new insights about the chemical and physical mechanisms that drive the formation of crenulations. In particular, we demonstrate the marginal role played by carbon dioxide transport in generating crenulation patterns, which are indeed induced by the hydrodynamic response of the free surface of the water film. Furthermore, we investigate the role of different environmental parameters, such as temperature, concentration of dissolved ions and wall slope. We also assess the convective/absolute nature of the crenulation instability. Finally, the possibility of using crenulation wavelength as a proxy of past flows is briefly discussed from a theoretical point of view.
| S-EPMC4991261 | biostudies-literature
Project description:Recently, freestanding polymer thin films encapsulated with nanostructures have attracted the significant attention of the scientific community due to their promising application in portable optoelectronic devices. In this research contribution, we have fabricated a freestanding polymer thin film of poly(vinyl alcohol) (PVA) encapsulated with carbon nitride quantum dots (CN-QDs) using the casting method, for the first time. The PVA polymer matrix provides mechanical support as well as dispersion of the CN-QDs preventing its solid-state quenching. From UV-visible spectra, it is revealed that optical transparency decreases with an increase in the concentration of CN-QDs within the PVA polymeric thin film. Such kind of decrease in optical transparency is one of the crucial factors for the optical concert of a nanomaterial. Interestingly, we have optimized the synthesis protocol to retain 40% transparency of the thin film by incorporating 10 wt % CN-QDs along with PVA without deteriorating its optical behavior. It is observed that when CN-QDs are embedded in the PVA matrix, emission becomes independent of excitation wavelength and is localized in the 510-530 nm region of the spectrum. Thus, the films exhibit excellent greenish-yellow emission when excited at 420 nm with the Commission Internationale de l'èclairage (CIE) coordinates (0.39, 0.46) and a correlated color temperature (CCT) of 4105 K. These excellent optoelectronic properties make them a promising candidate for practical phosphor applications. In a nutshell, this study demonstrates a promising way to exhibit the luminescence potential of freestanding polymer/CN-QD films in CN-QD-based solid-state lighting systems.
| S-EPMC8427780 | biostudies-literature