Dataset Information

Comparison of two techniques (in vivo and ex-vivo) for evaluating the elastic properties of the ascending aorta: Prospective cohort study.

ABSTRACT:

Introduction

Aneurysms of the ascending aorta (AA) correspond to a dilatation of the ascending aorta that progressively evolves over several years. The main complication of aneurysms of the ascending aorta is type A aortic dissection, which is associated with very high rates of morbidity and mortality. Prophylactic ascending aorta replacement guidelines are currently based on maximal AA diameter. However, this criterion is imperfect. Stretching tests on the aorta carried out ex-vivo make it possible to determine the elastic properties of healthy and aneurysmal aortic fragments (tension test, resistance before rupture). For several years now, cardiac magnetic resonance imaging (MRI) has provided another means of evaluating the elastic properties of the aorta. This imaging technique has the advantage of being non-invasive and of establishing aortic compliance (local measurement of stiffness) without using contrast material by measuring the variation of the aortic surface area during the cardiac cycle, and pulse wave velocity (overall stiffness of the aorta).

Materials and methods

Prospective single-center study including 100 patients with ascending aortic aneurysm requiring surgery. We will perform preoperative cine-MRI and biomechanical laboratory stretching tests on aortic samples collected during the cardiac procedure. Images will be acquired with a 3T MRI with only four other acquisitions in addition to the conventional protocol. These additional sequences are a Fast Low Angle Shot (FLASH)-type sequence performed during a short breath-hold in the transverse plane at the level of the bifurcation of the pulmonary artery, and phase-contrast sequences that encodes velocity at the same localization, and also in planes perpendicular to the aorta at the levels of the sino-tubular junction and the diaphragm for the descending aorta. For ex-vivo tests, the experiments will be carried out by a biaxial tensile test machine (ElectroForce®). Each specimen will be stretched with 10 times of 10% preconditioning and at a rate of 10 mm/min until rupture. During the experiment, the tissue is treated under a 37°C saline bath. The maximum elastic modulus from each sample will be calculated.

Results

The aim of this study is to obtain local patient-specific elastic modulus distribution of the ascending aorta from biaxial tensile tests and to assess elastic properties of the aorta using MRI, then to evaluate the correlation between biaxial tests and MRI measurements.

Discussion

Our research hypothesis is that there is a correlation between the evaluation of the elastic properties of the aorta from cardiac MRI and from stretching tests performed ex-vivo on aorta samples collected during ascending aorta replacement.

SUBMITTER: Morgant MC

PROVIDER: S-EPMC8437267 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Similar Datasets

Project description:PurposeAortic dissection (AD) is a life-threatening event that occurs when the intimal entry tear propagates and separates inner from outer layers of the aorta. Diameter, the current criterion for aneurysm repair, is far from ideal and additional evidence to optimize clinical decision would be extremely beneficial. Biomechanical investigation of the regional failure properties of aortic tissue is essential to understand and proactively prevent AD. We previously studied biaxial mechanical properties of healthy human aorta. In this study, we investigated the regional failure properties of healthy human ascending aorta (AscAo) including sinuses of Valsalva (SOV), and sinotubular junction (STJ).ResultsA total of 430 intact tissue samples were harvested from 19 healthy donors whose hearts were excluded from heart transplantation. The donors had mean age of 51 ± 11.7 years and nearly equal gender distribution. Samples were excised from aortic regions and subregions at defined locations. Tissue strips were subjected to either biaxial or uniaxial failure testing. Wall thickness varied regionally being thickest at AscAo (2.08 ± 0.66 mm) and thinnest at SOV (1.46 ± 0.31 mm). Biaxial testing demonstrated hyperplastic behavior of aortic tissues. Posterior and lateral STJ subregions were found to be stiffer than anterior and medial subregions in both circumferential and longitudinal directions. Failure stresses were significantly higher in the circumferential than longitudinal directions in each subregion of AscAo, STJ, and SOV. Longitudinal failure stresses were significantly greater in AscAo than those in STJ or SOV. Longitudinal failure stresses in AscAo were much smaller anteriorly than posteriorly, and medially than laterally.ConclusionsThe finding of weakest region at the sinotubular junction along the longitudinal direction corroborates clinical observations of that region being commonly involved as the initial site of intimal tear in aortic dissections. Failure stretch ratios correlated to elastic modulus at each region. Furthermore, strong correlation was seen between STJ failure stresses and elastic modulus at physiological pressure along both circumferential and longitudinal directions. Correlating in-vivo aortic elastic modulus based on in-vivo imaging with experimentally determined elastic modulus at physiological pressure and failure stresses may potentially provide valuable information regarding aortic wall strength. Better understanding of aortic biomechanics in normal physiologic and aneurysmal pathologic states may aid in determining risk factors for predicting dissection in patient-specific fashion.

Project description:BackgroundLimited studies have focused on the performance of self-expandable valves (SEVs) and balloon-expandable valves (BEVs) in patients with dilatated ascending aorta (AA) undergoing transcatheter aortic valve replacement (TAVR). The present study compared the performance of widely used Edwards BEVs and domestic SEVs in patients with dilatated AA among Chinese population.MethodsWe identified and reviewed 207 patients who had baseline AA diameter ≥40 mm and underwent transfemoral TAVR. Patients were divided into two groups: SEV and BEV. The SEVs were locally manufactured valves that have received Chinese regulatory approval (Venus-A, Taurus One, and VitaFlow), while the BEVs were Edwards Sapien XT and Sapien3. Procedural device success and post-procedural changes of AA diameters were compared.ResultsThe sample size of SEV group was larger than that of BEV group because BEVs were not available in China in the early clinical practice. The overall device success was slightly lower in SEV group compared with BEV group (84.2% vs. 95.8%, P=0.213). However, in the univariable and multivariable logistic regression analyses, only bicuspid aortic valve (BAV) was found to be an independent risk factor for device failure (OR: 2.632, CI: 1.107-6.257, P=0.029). During the median follow-up of 21 months, no statistical difference was found between the two groups regarding the overall survival (83.1%±4.7% vs. 95.8%±4.1%, P=0.533), and no aortic dissection nor rupture was observed. In a subgroup of patients who had follow-up CTs ≥12-month intervals, the AA diameter appeared to remain stable in SEV group with an aortic expansion rate of 0 (-0.4 to 0.8) mm (P=0.102), while it slightly enlarged in BEV group with an aortic expansion rate of 0.4 (-0.4 to 0.6) mm/y (P=0.038). In addition, the AA diameter also slightly enlarged in patients with BAV [0.2 (0 to 1.0) mm/y, P=0.015], while it remained stable in patients with tricuspid aortic valve (TAV) [0 (-0.8 to 0.6) mm/y, P=0.640].ConclusionsIn patients with dilatated AA who underwent TAVR, the type of THVs did not affect the procedural device success. BAV appeared to be a risk factor for both device failure and higher aortic expansion rate in these patients.