Intent to purchase IoT home security devices: Fear vs privacy.
Ontology highlight
ABSTRACT:
SUBMITTER: George JF
PROVIDER: S-EPMC8454981 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:In recent times, security and privacy at the physical (PHY) layer has been a major issue of several communication technologies which comprise the internet of things (IoT) and mostly, the emerging fifth-generation (5G) cellular network. The most real-world PHY security challenge stems from the fact that the passive eavesdropper's information is unavailable to the genuine source and destination (transmitter/receiver) nodes in the network. Without this information, it is difficult to optimize the broadcasting parameters. Therefore, in this research, we propose an efficient sequential convex estimation optimization (SCEO) algorithm to mitigate this challenge and improve the security of physical layer (PHY) in a three-node wireless communication network. The results of our experiments indicate that by using the SCEO algorithm, an optimal performance and enhanced convergence is achieved in the transmission. However, considering possible security challenges envisaged when a multiple eavesdropper is active in a network, we expanded our research to develop a swift privacy rate optimization algorithm for a multiple-input, multiple-output, multiple-eavesdropper (MIMOME) scenario as it is applicable to security in IoT and 5G technologies. The result of the investigation show that the algorithm executes significantly with minimal complexity when compared with nonoptimal parameters. We further employed the use of rate constraint together with self-interference of the full-duplex transmission at the receiving node, which makes the performance of our technique outstanding when compared with previous studies.
| S-EPMC7249050 | biostudies-literature
Project description:The introduction of the Internet of Things (IoT), i.e., the interconnection of embedded devices over the Internet, has changed the world we live in from the way we measure, make calls, print information and even the way we get energy in our offices or homes. The convenience of IoT products, like closed circuit television (CCTV) cameras, internet protocol (IP) phones, and oscilloscopes, is overwhelming for end users. In parallel, however, security issues have emerged and it is essential for infrastructure providers to assess the associated security risks. In this paper, we propose a novel method to detect IoT devices and identify the manufacturer, device model, and the firmware version currently running on the device using the page source from the web user interface. We performed automatic scans of the large-scale network at the European Organization for Nuclear Research (CERN) to evaluate our approach. Our tools identified 233 IoT devices that fell into eleven distinct device categories and included 49 device models manufactured by 26 vendors from across the world.
| S-EPMC6806295 | biostudies-literature
Project description:The reliance on data donation from citizens as a driver for research, known as citizen science, has accelerated during the Sars-Cov-2 pandemic. An important enabler of this is Internet of Things (IoT) devices, such as mobile phones and wearable devices, that allow continuous data collection and convenient sharing. However, potentially sensitive health data raises privacy and security concerns for citizens, which research institutions and industries must consider. In e-commerce or social network studies of citizen science, a privacy calculus related to user perceptions is commonly developed, capturing the information disclosure intent of the participants. In this study, we develop a privacy calculus model adapted for IoT-based health research using citizen science for user engagement and data collection. Based on an online survey with 85 participants, we make use of the privacy calculus to analyse the respondents' perceptions. The emerging privacy personas are clustered and compared with previous research, resulting in three distinct personas which can be used by designers and technologists who are responsible for developing suitable forms of data collection. These are the 1) Citizen Science Optimist, the 2) Selective Data Donor, and the 3) Health Data Controller. Together with our privacy calculus for citizen science based digital health research, the three privacy personas are the main contributions of this study.
| S-EPMC8716597 | biostudies-literature
Project description:BACKGROUND:In China, home-based healthcare/rehabilitation has always been advocated by the government and is the most prevalent healthcare pattern. However, there is currently no data on how many each product has been purchased, and it is not clear what factors are associated with their use. The research aims to clarify the current practices and attitudes of the elderly on such matters, and further analyze their influence factors. METHODS:This pilot study consisted of two-round regional survey, conducted from July 25 to August 3, 2015 and July 20 to August 10, 2018 respectively. Both surveys released on-site paper questionnaires and collected after filling out in different communities. RESULTS:Two hundred forty-four valid questionnaires from 52 communities were collected. Compared with 2015 (30.8%), the number of people who did not purchase home healthcare devices in the same area decreased in 2018 (28.2%). Hemopiezometer (44.3%), glucometer (18.4%), massager (21.3%) and walking devices (19.3%) are the four main types of products that urbanites are most willing to buy. In addition, users' age group, education level, and income level were significantly correlated with the purchase of certain products. CONCLUSIONS:The types of home healthcare devices purchased by respondents are consistent with the distribution of chronic diseases of urban residents in China. The analysis of product brands also revealed the existing problems and huge growth space of the industry market, which also requires the government to introduce relevant policies and measures to regulate the market and accelerate the development of the industry.
| S-EPMC7197117 | biostudies-literature
Project description:Text-based passwords are a fundamental and popular means of authentication. Password authentication can be simply implemented because it does not require any equipment, unlike biometric authentication, and it relies only on the users' memory. This reliance on memory is a weakness of passwords, and people therefore usually use easy-to-remember passwords, such as "iloveyou1234". However, these sample passwords are not difficult to crack. The default passwords of IoT also are text-based passwords and are easy to crack. This weakness enables free password cracking tools such as Hashcat and JtR to execute millions of cracking attempts per second. Finally, this weakness creates a security hole in networks by giving hackers access to an IoT device easily. Research has been conducted to better exploit weak passwords to improve password-cracking performance. The Markov model and probabilistic context-free-grammar (PCFG) are representative research results, and PassGAN, which uses generative adversarial networks (GANs), was recently introduced. These advanced password cracking techniques contribute to the development of better password strength checkers. We studied some methods of improving the performance of PassGAN, and developed two approaches for better password cracking: the first was changing the convolutional neural network (CNN)-based improved Wasserstein GAN (IWGAN) cost function to an RNN-based cost function; the second was employing the dual-discriminator GAN structure. In the password cracking performance experiments, our models showed 10%-15% better performance than PassGAN. Through additional performance experiments with PCFG, we identified the cracking performance advantages of PassGAN and our models over PCFG. Finally, we prove that our models enhanced password strength estimation through a comparison with zxcvbn.
| S-EPMC7309056 | biostudies-literature
Project description:The Internet of Things (IoT) technology is widely used and has been improved in research. However, due to the extensiveness of IoT technology, the heterogeneity and diversity of the device structure, the number of attacks against IoT has increased dramatically, so we need a method that can effectively and actively determine safety. Considering the diversity of the terminal structure of IoT, a security method for the IoT terminal based on structural balance, method objectivity, and reliability is currently a challenging task. This paper introduces the idea of rate of change in mathematics into trust analysis, and forms three attribute sets based on trust interval and rate of change: discrete interval, change range, and change frequency. By calculating the above attributes of the entity's trust value, the entity's trust situation is obtained, and an overall assessment of the terminal entity's trust situation is made from the three levels of completeness, accuracy and objectivity. Under the premise of reducing encryption and other means, the above method can evaluate the trust state of the IoT terminal from the perspective of the data, and this evaluation method can provide a basis for the judgment of the IoT terminal more objectively and accurately.
| S-EPMC8425574 | biostudies-literature
Project description:Enforcement of the Health Insurance Portability and Accountability Act (HIPAA) and the Health Information Technology for Economic and Clinical Health Act (HITECH) has gotten stricter and penalties have become more severe in response to a significant increase in computer-related information breaches in recent years. With health information said to be worth twice as much as other forms of information on the underground market, making preservation of privacy and security an integral part of health technology development, rather than an afterthought, not only mitigates risks but also helps to ensure HIPAA and HITECH compliance. This paper provides a guide, based on the Office for Civil Rights (OCR) audit protocol, for creating and maintaining an audit checklist for multi-user health kiosks. Implementation of selected audit elements for a multi-user health kiosk designed for use by community-residing older adults illustrates how the guide can be applied.
| S-EPMC5546557 | biostudies-other
Project description:The latest Internet of Things (IoT) edge-centric architectures allow for unburdening higher layers from part of their computational and data processing requirements. In the specific case of fog computing systems, they reduce greatly the requirements of cloud-centric systems by processing in fog gateways part of the data generated by end devices, thus providing services that were previously offered by a remote cloud. Thanks to recent advances in System-on-Chip (SoC) energy efficiency, it is currently possible to create IoT end devices with enough computational power to process the data generated by their sensors and actuators while providing complex services, which in recent years derived into the development of the mist computing paradigm. To allow mist computing nodes to provide the previously mentioned benefits and guarantee the same level of security as in other architectures, end-to-end standard security mechanisms need to be implemented. In this paper, a high-security energy-efficient fog and mist computing architecture and a testbed are presented and evaluated. The testbed makes use of Transport Layer Security (TLS) 1.2 Elliptic Curve Cryptography (ECC) and Rivest-Shamir-Adleman (RSA) cipher suites (that comply with the yet to come TLS 1.3 standard requirements), which are evaluated and compared in terms of energy consumption and data throughput for a fog gateway and two mist end devices. The obtained results allow a conclusion that ECC outperforms RSA in both energy consumption and data throughput for all the tested security levels. Moreover, the importance of selecting a proper ECC curve is demonstrated, showing that, for the tested devices, some curves present worse energy consumption and data throughput than other curves that provide a higher security level. As a result, this article not only presents a novel mist computing testbed, but also provides guidelines for future researchers to find out efficient and secure implementations for advanced IoT devices.
| S-EPMC6264011 | biostudies-other
Project description:With the growing number of heterogeneous resource-constrained devices connected to the Internet, it becomes increasingly challenging to secure the privacy and protection of data. Strong but efficient cryptography solutions must be employed to deal with this problem, along with methods to standardize secure communications between these devices. The PRISEC module of the UbiPri middleware has this goal. In this work, we present the performance of the AES (Advanced Encryption Standard), RC6 (Rivest Cipher 6), Twofish, SPECK128, LEA, and ChaCha20-Poly1305 algorithms in Internet of Things (IoT) devices, measuring their execution times, throughput, and power consumption, with the main goal of determining which symmetric key ciphers are best to be applied in PRISEC. We verify that ChaCha20-Poly1305 is a very good option for resource constrained devices, along with the lightweight block ciphers SPECK128 and LEA.
| S-EPMC6806263 | biostudies-literature
Project description:Semantic interoperability for the Internet of Things (IoT) is enabled by standards and technologies from the Semantic Web. As recent research suggests a move towards decentralised IoT architectures, we have investigated the scalability and robustness of RDF (Resource Description Framework)engines that can be embedded throughout the architecture, in particular at edge nodes. RDF processing at the edge facilitates the deployment of semantic integration gateways closer to low-level devices. Our focus is on how to enable scalable and robust RDF engines that can operate on lightweight devices. In this paper, we have first carried out an empirical study of the scalability and behaviour of solutions for RDF data management on standard computing hardware that have been ported to run on lightweight devices at the network edge. The findings of our study shows that these RDF store solutions have several shortcomings on commodity ARM (Advanced RISC Machine) boards that are representative of IoT edge node hardware. Consequently, this has inspired us to introduce a lightweight RDF engine, which comprises an RDF storage and a SPARQL processor for lightweight edge devices, called RDF4Led. RDF4Led follows the RISC-style (Reduce Instruction Set Computer) design philosophy. The design constitutes a flash-aware storage structure, an indexing scheme, an alternative buffer management technique and a low-memory-footprint join algorithm that demonstrates improved scalability and robustness over competing solutions. With a significantly smaller memory footprint, we show that RDF4Led can handle 2 to 5 times more data than popular RDF engines such as Jena TDB (Tuple Database) and RDF4J, while consuming the same amount of memory. In particular, RDF4Led requires 10%-30% memory of its competitors to operate on datasets of up to 50 million triples. On memory-constrained ARM boards, it can perform faster updates and can scale better than Jena TDB and Virtuoso. Furthermore, we demonstrate considerably faster query operations than Jena TDB and RDF4J.
| S-EPMC7284853 | biostudies-literature