Browse
Submit Data
Databases
API
Help

Dataset Information

29 Views

0 Connections

0 Citations

0 Reanalyses

0 Downloads

Omics score: 0

Polycrystalline SnSe with a thermoelectric figure of merit greater than the single crystal.

ABSTRACT: Thermoelectric materials generate electric energy from waste heat, with conversion efficiency governed by the dimensionless figure of merit, ZT. Single-crystal tin selenide (SnSe) was discovered to exhibit a high ZT of roughly 2.2-2.6 at 913 K, but more practical and deployable polycrystal versions of the same compound suffer from much poorer overall ZT, thereby thwarting prospects for cost-effective lead-free thermoelectrics. The poor polycrystal bulk performance is attributed to traces of tin oxides covering the surface of SnSe powders, which increases thermal conductivity, reduces electrical conductivity and thereby reduces ZT. Here, we report that hole-doped SnSe polycrystalline samples with reagents carefully purified and tin oxides removed exhibit an ZT of roughly 3.1 at 783 K. Its lattice thermal conductivity is ultralow at roughly 0.07 W m^-1 K^-1 at 783 K, lower than the single crystals. The path to ultrahigh thermoelectric performance in polycrystalline samples is the proper removal of the deleterious thermally conductive oxides from the surface of SnSe grains. These results could open an era of high-performance practical thermoelectrics from this high-performance material.

SUBMITTER: Zhou C

PROVIDER: S-EPMC8463294 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Json Xml

Similar Datasets

Thermoelectric Figure-of-Merit of Fully Dense Single-Crystalline SnSe.

Project description:Single-crystalline SnSe has attracted much attention because of its record high figure-of-merit ZT ≈ 2.6; however, this high ZT has been associated with the low mass density of samples which leaves the intrinsic ZT of fully dense pristine SnSe in question. To this end, we prepared high-quality fully dense SnSe single crystals and performed detailed structural, electrical, and thermal transport measurements over a wide temperature range along the major crystallographic directions. Our single crystals were fully dense and of high purity as confirmed via high statistics 119Sn Mössbauer spectroscopy that revealed <0.35 at. % Sn(IV) in pristine SnSe. The temperature-dependent heat capacity (C p) provided evidence for the displacive second-order phase transition from Pnma to Cmcm phase at T c ≈ 800 K and a small but finite Sommerfeld coefficient γ0 which implied the presence of a finite Fermi surface. Interestingly, despite its strongly temperature-dependent band gap inferred from density functional theory calculations, SnSe behaves like a low-carrier-concentration multiband metal below 600 K, above which it exhibits a semiconducting behavior. Notably, our high-quality single-crystalline SnSe exhibits a thermoelectric figure-of-merit ZT ∼1.0, ∼0.8, and ∼0.25 at 850 K along the b, c, and a directions, respectively.

| S-EPMC6648424 | biostudies-literature

Layered Tin Chalcogenides SnS and SnSe: Lattice Thermal Conductivity Benchmarks and Thermoelectric Figure of Merit.

Project description:Tin sulfide (SnS) and tin selenide (SnSe) are attractive materials for thermoelectric conversion applications. Favorable small band gap, high carrier mobility, large Seebeck coefficient, and remarkably low lattice thermal conductivity are a consequence of their anisotropic crystal structure of symmetry Pnma , made of corrugated, black phosphorus-like layers. Their internal lattice dynamics combined with chemical bond softening in going from SnS to SnSe make for subtle effects on lattice thermal conductivity. Reliable prediction of phonon transport for these materials must therefore include many-body effects. Using first principles methods and a transferable tight-binding potential for frozen phonon calculations, here, we investigate the evolution of thermal lattice conductivity and thermoelectric figure of merit in Pnma -SnS and -SnSe, also including the high-temperature Cmcm -SnS phase. We show how thermal conductivity lowering in SnS at higher temperatures is largely due to dynamic phonon softening ahead of the Pnma - Cmcm structural phase transition. SnS becomes more similar to SnSe in its lifetime and mean free path profiles as it approaches its high-temperature Cmcm phase. The latter nonetheless intrinsically constraints phonon group velocity modules, preventing SnS to overtake SnSe. Our analysis provides important insights and computational benchmarks for optimization of thermoelectric materials via a more efficient computational strategy compared to previous ab initio attempts, one that can be easily transferred to larger systems for further thermoelectric materials nanoengineering. The good description of anharmonicity at higher temperatures inherent to the tight-binding potential yields calculated lattice conductivity values that are in very good agreement with experiments.

| S-EPMC9421910 | biostudies-literature

Thermoelectric Properties of Hot-Pressed Bi-Doped n-Type Polycrystalline SnSe.

Project description:ᅟ: We report on the successful preparation of Bi-doped n-type polycrystalline SnSe by hot-press method. We observed anisotropic transport properties due to the (h00) preferred orientation of grains along the pressing direction. The electrical conductivity perpendicular to the pressing direction is higher than that parallel to the pressing direction, 12.85 and 6.46 S cm-1 at 773 K for SnSe:Bi 8% sample, respectively, while thermal conductivity perpendicular to the pressing direction is higher than that parallel to the pressing direction, 0.81 and 0.60 W m-1 K-1 at 773 K for SnSe:Bi 8% sample, respectively. We observed a bipolar conducting mechanism in our samples leading to n- to p-type transition, whose transition temperature increases with Bi concentration. Our work addressed a possibility to dope polycrystalline SnSe by a hot-pressing process, which may be applied to module applications.Highlights1. We have successfully achieved Bi-doped n-type polycrystalline SnSe by the hot-press method. 2. We observed anisotropic transport properties due to the [h00] preferred orientation of grains along pressing direction. 3. We observed a bipolar conducting mechanism in our samples leading to n- to p-type transition.

| S-EPMC6035122 | biostudies-literature

Paramagnon drag in high thermoelectric figure of merit Li-doped MnTe.

Project description:Local thermal magnetization fluctuations in Li-doped MnTe are found to increase its thermopower α strongly at temperatures up to 900 K. Below the Néel temperature (T N ~ 307 K), MnTe is antiferromagnetic, and magnon drag contributes αmd to the thermopower, which scales as ~T 3. Magnon drag persists into the paramagnetic state up to >3 × T N because of long-lived, short-range antiferromagnet-like fluctuations (paramagnons) shown by neutron spectroscopy to exist in the paramagnetic state. The paramagnon lifetime is longer than the charge carrier-magnon interaction time; its spin-spin spatial correlation length is larger than the free-carrier effective Bohr radius and de Broglie wavelength. Thus, to itinerant carriers, paramagnons look like magnons and give a paramagnon-drag thermopower. This contribution results in an optimally doped material having a thermoelectric figure of merit ZT > 1 at T > ~900 K, the first material with a technologically meaningful thermoelectric energy conversion efficiency from a spin-caloritronic effect.

| S-EPMC6744264 | biostudies-literature

Defect Engineering in Solution-Processed Polycrystalline SnSe Leads to High Thermoelectric Performance.

Project description:SnSe has emerged as one of the most promising materials for thermoelectric energy conversion due to its extraordinary performance in its single-crystal form and its low-cost constituent elements. However, to achieve an economic impact, the polycrystalline counterpart needs to replicate the performance of the single crystal. Herein, we optimize the thermoelectric performance of polycrystalline SnSe produced by consolidating solution-processed and surface-engineered SnSe particles. In particular, the SnSe particles are coated with CdSe molecular complexes that crystallize during the sintering process, forming CdSe nanoparticles. The presence of CdSe nanoparticles inhibits SnSe grain growth during the consolidation step due to Zener pinning, yielding a material with a high density of grain boundaries. Moreover, the resulting SnSe-CdSe nanocomposites present a large number of defects at different length scales, which significantly reduce the thermal conductivity. The produced SnSe-CdSe nanocomposites exhibit thermoelectric figures of merit up to 2.2 at 786 K, which is among the highest reported for solution-processed SnSe.

| S-EPMC8793148 | biostudies-literature

Exceptional figure of merit achieved in boron-dispersed GeTe-based thermoelectric composites.

Project description:GeTe is a promising p-type material with increasingly enhanced thermoelectric properties reported in recent years, demonstrating its superiority for mid-temperature applications. In this work, the thermoelectric performance of GeTe is improved by a facile composite approach. We find that incorporating a small amount of boron particles into the Bi-doped GeTe leads to significant enhancement in power factor and simultaneous reduction in thermal conductivity, through which the synergistic modulation of electrical and thermal transport properties is realized. The thermal mismatch between the boron particles and the matrix induces high-density dislocations that effectively scatter the mid-frequency phonons, accounting for a minimum lattice thermal conductivity of 0.43 Wm-1K-1 at 613 K. Furthermore, the presence of boron/GeTe interfaces modifies the interfacial potential barriers, resulting in increased Seebeck coefficient and hence enhanced power factor (25.4 μWcm-1K-2 at 300 K). Consequently, we obtain a maximum figure of merit Zmax of 4.0 × 10-3 K-1 at 613 K in the GeTe-based composites, which is the record-high value in GeTe-based thermoelectric materials and also superior to most of thermoelectric systems for mid-temperature applications. This work provides an effective way to further enhance the performance of GeTe-based thermoelectrics.

| S-EPMC11246464 | biostudies-literature

Relationship between thermoelectric figure of merit and energy conversion efficiency.

Project description:The formula for maximum efficiency (ηmax) of heat conversion into electricity by a thermoelectric device in terms of the dimensionless figure of merit (ZT) has been widely used to assess the desirability of thermoelectric materials for devices. Unfortunately, the ηmax values vary greatly depending on how the average ZT values are used, raising questions about the applicability of ZT in the case of a large temperature difference between the hot and cold sides due to the neglect of the temperature dependences of the material properties that affect ZT. To avoid the complex numerical simulation that gives accurate efficiency, we have defined an engineering dimensionless figure of merit (ZT)eng and an engineering power factor (PF)eng as functions of the temperature difference between the cold and hot sides to predict reliably and accurately the practical conversion efficiency and output power, respectively, overcoming the reporting of unrealistic efficiency using average ZT values.

| S-EPMC4500231 | biostudies-other

Heavy Doping by Bromine to Improve the Thermoelectric Properties of n-type Polycrystalline SnSe.

Project description:Single crystal tin selenide (SnSe) has attracted much attention for its excellent thermoelectric performance. However, polycrystalline SnSe exhibits unsatisfactory figure-of-merit due to the inferior electrical properties, especially for n-type SnSe. In this work, a high concentration of Br doping (6-12 atm%) on the Se site effectively increases the Hall carrier concentration from 1.6 × 1017 cm-3 (p-type) in undoped SnSe to 1.3 × 1019 cm-3 (n-type) in Br-doped SnSe0.88Br0.12, leading to an increased electrical conductivity close to that of a single crystal. Combined with the decreased lattice thermal conductivity due to the enhanced phonon scattering by composition fluctuation and dislocations, a peak ZT of ≈1.3 at 773 K, together with the enhanced average ZT is obtained in SnSe0.9Br0.1 along the hot pressing direction.

| S-EPMC6145293 | biostudies-literature

Non-equilibrium processing leads to record high thermoelectric figure of merit in PbTe-SrTe.

Project description:The broad-based implementation of thermoelectric materials in converting heat to electricity hinges on the achievement of high conversion efficiency. Here we demonstrate a thermoelectric figure of merit ZT of 2.5 at 923?K by the cumulative integration of several performance-enhancing concepts in a single material system. Using non-equilibrium processing we show that hole-doped samples of PbTe can be heavily alloyed with SrTe well beyond its thermodynamic solubility limit of <1?mol%. The much higher levels of Sr alloyed into the PbTe matrix widen the bandgap and create convergence of the two valence bands of PbTe, greatly boosting the power factors with maximal values over 30??W?cm(-1)?K(-2). Exceeding the 5?mol% solubility limit leads to endotaxial SrTe nanostructures which produce extremely low lattice thermal conductivity of 0.5?W?m(-1)?K(-1) but preserve high hole mobilities because of the matrix/precipitate valence band alignment. The best composition is hole-doped PbTe-8%SrTe.

| S-EPMC4963473 | biostudies-literature

High thermoelectric figure of merit of porous Si nanowires from 300 to 700 K.

Project description:Thermoelectrics operating at high temperature can cost-effectively convert waste heat and compete with other zero-carbon technologies. Among different high-temperature thermoelectrics materials, silicon nanowires possess the combined attributes of cost effectiveness and mature manufacturing infrastructures. Despite significant breakthroughs in silicon nanowires based thermoelectrics for waste heat conversion, the figure of merit (ZT) or operating temperature has remained low. Here, we report the synthesis of large-area, wafer-scale arrays of porous silicon nanowires with ultra-thin Si crystallite size of ~4 nm. Concurrent measurements of thermal conductivity (κ), electrical conductivity (σ), and Seebeck coefficient (S) on the same nanowire show a ZT of 0.71 at 700 K, which is more than ~18 times higher than bulk Si. This ZT value is more than two times higher than any nanostructured Si-based thermoelectrics reported in the literature at 700 K. Experimental data and theoretical modeling demonstrate that this work has the potential to achieve a ZT of ~1 at 1000 K.

| S-EPMC8225643 | biostudies-literature

OmicsDI is part of the ELIXIR infrastructure

OmicsDI is an Elixir interoperability service. Learn more ›

Tweets

OmicsDI Databases

PRIDE
PeptideAtlas
MassIVE
JPOST Repository
Physiome Model Repository

EGA
EVA
ENA
LINCS
PAXDB
Cell Collective

MetaboLights
Metabolomics Workbench
MetabolomeExpress
GNPS
BioModels
FAIRDOMHub

ArrayExpress
dbGaP
ExpressionAtlas
GEO
NODE

Information

Databases
Help
API
Contact us
Code on GitHub
Terms of use
Submit Data