Wetting-Induced Polyelectrolyte Pore Bridging.
Ontology highlight
ABSTRACT:
SUBMITTER: Kalde A
PROVIDER: S-EPMC8466633 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:By using a combination of readily accessible experimental and computational experiments in water, we explored the factors governing the association between polyanionic dyn[4]arene and a series of α,ω-alkyldiammonium ions of increasing chain length. We found that the lock-and-key concept based on the best match between the apolar and polar regions of the molecular partners failed to explain the observed selectivities. Instead, the dissection of the energetic and structural contributions demonstrated that the binding events were actually guided by two crucial solvent-related phenomena as the chain length of the guest increases: the expected decrease of the enthalpic cost of guest desolvation and the unexpected increase of the favourable enthalpy of complex solvation. By bringing to light the decisive enthalpic impact of complex solvation during the binding of polyelectrolytes by inclusion, this study may provide a missing piece to a puzzle that one day could display the global picture of molecular recognition in water.
| S-EPMC6335637 | biostudies-literature
Project description:Wettability, or preferential affinity of a fluid to a solid substrate in the presence of another fluid, plays a critical role in the statics and dynamics of fluid-fluid displacement in porous media. The complex confined geometry of porous media, however, makes upscaling of microscopic wettability to the macroscale a nontrivial task. Here, we elucidate the contribution of pore geometry in controlling the apparent wettability characteristics of a porous medium. Using direct numerical simulations of fluid-fluid displacement, we study the reversal of interface curvature in a single converging-diverging capillary, and demonstrate the co-existence of concave and convex interfaces in a porous medium-a phenomenon that we also observe in laboratory micromodel experiments. We show that under intermediate contact angles the sign of interface curvature is strongly influenced by the pore geometry. We capture the interplay between surface chemical properties and pore geometry in the form of a dimensionless quantity, the apparent wettability number, which predicts the conditions under which concave and convex interfaces co-exist. Our findings advance the fundamental understanding of wettability in confined geometries, with implications to macroscopic multiphase-flow processes in porous media, from fuel cells to enhanced oil recovery.
| S-EPMC6200799 | biostudies-literature
Project description:Wetting of actual surfaces involves diverse hysteretic phenomena stemming from ever-present imperfections. Here, we clarify the origin of wetting hysteresis for a liquid front advancing or receding across an isolated defect of nanometric size. Various kinds of chemical and topographical nanodefects, which represent salient features of actual heterogeneous surfaces, are investigated. The most probable wetting path across surface heterogeneities is identified by combining, within an innovative approach, microscopic classical density functional theory and the string method devised for the study of rare events. The computed rugged free-energy landscape demonstrates that hysteresis emerges as a consequence of metastable pinning of the liquid front at the defects; the barriers for thermally activated defect crossing, the pinning force, and hysteresis are quantified and related to the geometry and chemistry of the defects allowing for the occurrence of nanoscopic effects. The main result of our calculations is that even weak nanoscale defects, which are difficult to characterize in generic microfluidic experiments, can be the source of a plethora of hysteretical phenomena, including the pinning of nanobubbles.
| S-EPMC4725530 | biostudies-literature
Project description:The soil water retention curve is one of the most important properties used to predict the amount of water available to plants, pore size distribution and hydraulic conductivity, as well as knowledge for drainage and irrigation modeling. Depending on the method of measurement adopted, the water retention curve can involve the application of several wetting and drying (W-D) cycles to a soil sample. The method assumes soil pore structure is constant throughout however most of the time soil structure is dynamic and subjected to change when submitted to continuous W-D. Consequently, the pore size distribution, as well as other soil morphological properties can be affected. With this in mind, high resolution X-ray Computed micro-Tomography was utilized to evaluate changes in the soil pore architecture following W-D cycles during the procedure of the water retention curve evaluation. Two different soil sample volumes were analyzed: ROIW (whole sample) and ROIHC (the region close to the bottom of the sample). The second region was selected due to its proximity to the hydraulic contact of the soil with the water retention curve measurement apparatus. Samples were submitted to the following W-D treatments: 0, 6 and 12 W-D. Results indicated the soil changed its porous architecture after W-D cycles. The image-derived porosity did not show differences after W-D cycles for ROIW; while for ROIHC it increased porosity. The porosity was also lower in ROIHC in comparison to ROIW. Pore connectivity improved after W-D cycles for ROIHC, but not for ROIW. W-D cycles induced more aligned pores for both ROIs as observed by the tortuosity results. Pore shape showed changes mainly for ROIW for the equant and triaxial shaped pores; while pore size was significantly influenced by the W-D cycles. Soil water retention curve measurements showed that W-D cycles can affect water retention evaluation and that the changes in the soil morphological properties can play an important role in it.
| S-EPMC7043393 | biostudies-literature
Project description:Herein, we present the imbibition-induced, spontaneous, and selective wetting characteristics of gallium-based liquid metal alloys on a metallized surface with micro-scale topographical features. Gallium-based liquid metal alloys are fascinating materials that have enormous surface tension; therefore, they are difficult to pattern into films. The complete wetting of eutectic alloy of gallium and indium is realized on microstructured copper surfaces in the presence of HCl vapor, which removes the native oxide from the liquid metal alloy. This wetting is numerically explained based on the Wenzel's model and imbibition process, revealing that the dimensions of the microstructures are critical for effective imbibition-driven wetting of the liquid metal. Further, we demonstrate that the spontaneous wetting of the liquid metal can be directed selectively along the microstructured region on the metallic surface to create patterns. This simple process enables the uniform coating and patterning of the liquid metal over large areas without an external force or complex processing. We demonstrate that the liquid metal-patterned substrates maintain electrical connection even in a stretched state and after repetitive stretching cycles.
| S-EPMC9376080 | biostudies-literature
Project description:The innovative design and synthesis of nanofiber based hydro-philic/phobic membranes with a thin hydro-phobic nanofiber layer on the top and a thin hydrophilic nanofiber layer on the bottom of the conventional casted micro-porous layer which opens up a solution for membrane pore wetting and improves the pure water flux in membrane distillation.
| S-EPMC4223684 | biostudies-literature
Project description:Electrochemical impedance spectroscopy (EIS) is used to compare the apparent electron transfer rate constant (kapp) for a series of alkanethiol and of carbohydrate-terminated alkanethiol self-assembled monolayers (SAMs) on both flat gold and on nanoporous gold (np-Au). Using the surface area for np-Au determined by oxide stripping, the values of kapp for the alkanethiol modified np-Au are initially over two orders of magnitude smaller than the values found on flat Au. This result provides evidence that the diffusing redox probe Fe(CN)63-/4- only accesses a fraction of the np-Au surface after alkanethiol modification suggesting very limited wetting of the internal pores due to the hydrophobic nature of these surfaces. In contrast, for np-Au modified by carbohydrate-terminated (mannose or galactose) alkanethiols the values of kapp are about 10-40 fold smaller than on flat gold, suggesting more extensive access of the diffusing redox probe within the pores and better but still incomplete wetting, a result also found for modification of np-Au with mercaptododecanoic acid. A short chain PEG thiol derivative is found to result in a comparison of kapp values that suggests nearly complete wetting of the internal pores for this highly hydrophilic derivative. These results are of significance for the potential applications of SAM modified np-Au in electrochemical sensors, especially for those based on carbohydrate-protein recognition, or those of np-Au modified by SAMs with polar terminal groups.
| S-EPMC5388453 | biostudies-literature
Project description:A biomimetic cellular-eating phenomenon in gallium-based liquid metal to realize particle internalization in full-pH-range solutions is reported. The effect, which is called liquid metal phagocytosis, represents a wet-processing strategy to prepare various metallic liquid metal-particle mixtures through introducing excitations such as an electrical polarization, a dissolving medium, or a sacrificial metal. A nonwetting-to-wetting transition resulting from surface transition and the reactive nature of the intermetallic wetting between the two metallic phases are found to be primarily responsible for such particle-eating behavior. Theoretical study brings forward a physical picture to the problem, together with a generalized interpretation. The model developed here, which uses the macroscopic contact angle between the two metallic phases as a criterion to predict the particle internalization behavior, shows good consistency with experimental results.
| S-EPMC5441499 | biostudies-literature
Project description:The relative wettability of oil and water on solid surfaces is generally governed by a complex competition of molecular interaction forces acting in such three-phase systems. Herein, we experimentally demonstrate how the adsorption of in nature abundant divalent Ca(2+) cations to solid-liquid interfaces induces a macroscopic wetting transition from finite contact angles (≈ 10°) with to near-zero contact angles without divalent cations. We developed a quantitative model based on DLVO theory to demonstrate that this transition, which is observed on model clay surfaces, mica, but not on silica surfaces nor for monovalent K(+) and Na(+) cations is driven by charge reversal of the solid-liquid interface. Small amounts of a polar hydrocarbon, stearic acid, added to the ambient decane synergistically enhance the effect and lead to water contact angles up to 70° in the presence of Ca(2+). Our results imply that it is the removal of divalent cations that makes reservoir rocks more hydrophilic, suggesting a generalizable strategy to control wettability and an explanation for the success of so-called low salinity water flooding, a recent enhanced oil recovery technology.
| S-EPMC4444960 | biostudies-literature
Project description:Biological soil crusts (biocrusts) are photosynthetic "hot spots" in deserts and cover ∼12% of the Earth's terrestrial surface, and yet they face an uncertain future given expected shifts in rainfall events. Laboratory wetting of biocrust communities is known to cause a bloom of Firmicutes which rapidly become dominant community members within 2 days after emerging from a sporulated state. We hypothesized that their bacteriophages (phages) would respond to such a dramatic increase in their host's abundance. In our experiment, wetting caused Firmicutes to bloom and triggered a significant depletion of cyanobacterial diversity. We used genome-resolved metagenomics to link phage to their hosts and found that the bloom of the genus Bacillus correlated with a dramatic increase in the number of Caudovirales phages targeting these diverse spore-formers (r = 0.762). After 2 days, we observed dramatic reductions in the relative abundances of Bacillus, while the number of Bacillus phages continued to increase, suggestive of a predator-prey relationship. We found predicted auxiliary metabolic genes (AMGs) associated with sporulation in several Caudovirales genomes, suggesting that phages may influence and even benefit from sporulation dynamics in biocrusts. Prophage elements and CRISPR-Cas repeats in Firmicutes metagenome-assembled genomes (MAGs) provide evidence of recent infection events by phages, which were corroborated by mapping viral contigs to their host MAGs. Combined, these findings suggest that the blooming Firmicutes become primary targets for biocrust Caudovirales phages, consistent with the classical "kill-the-winner" hypothesis.IMPORTANCE This work forms part of an overarching research theme studying the effects of a changing climate on biological soil crust (biocrust) in the Southwestern United States. To our knowledge, this study was the first to characterize bacteriophages in biocrust and offers a view into the ecology of phages in response to a laboratory wetting experiment. The phages identified here represent lineages of Caudovirales, and we found that the dynamics of their interactions with their Firmicutes hosts explain the collapse of a bacterial bloom that was induced by wetting. Moreover, we show that phages carried host-altering metabolic genes and found evidence of proviral infection and CRISPR-Cas repeats within host genomes. Our results suggest that phages exert controls on population density by lysing dominant bacterial hosts and that they further impact biocrust by acquiring host genes for sporulation. Future research should explore how dominant these phages are in other biocrust communities and quantify how much the control and lysis of blooming populations contributes to nutrient cycling in biocrusts.
| S-EPMC6918073 | biostudies-literature