Adsorption of Mussel Protein on Polymer Antifouling Membranes: A Molecular Dynamics Study.
Ontology highlight
ABSTRACT:
SUBMITTER: Gao F
PROVIDER: S-EPMC8468479 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:We describe robustly anchored triblock copolymers that adopt loop conformations on surfaces and endow them with unprecedented lubricating and antifouling properties. The triblocks have two end blocks with catechol-anchoring groups and a looping poly(ethylene oxide) (PEO) midblock. The loops mediate strong steric repulsion between two mica surfaces. When sheared at constant speeds of ?2.5 ?m/s, the surfaces exhibit an extremely low friction coefficient of ?0.002-0.004 without any signs of damage up to pressures of ?2-3 MPa that are close to most biological bearing systems. Moreover, the polymer loops enhance inhibition of cell adhesion and proliferation compared to polymers in the random coil or brush conformations. These results demonstrate that strongly anchored polymer loops are effective for high lubrication and low cell adhesion and represent a promising candidate for the development of specialized high-performance biomedical coatings.
| S-EPMC4932843 | biostudies-literature
Project description:Two 6-ns simulations of the somatostatin analog sandostatin and a 1-palmityl-2-oleoyl-sn-glycero-3-phosphocholine (POPC) bilayer are presented. In the first simulation, the peptide was placed in a region of bulk water density and allowed to spontaneously move toward and bind to the bilayer surface. An attractive force between the peptide and bilayer drove the binding process, which was opposed by a significant frictional force caused by the solvent (water). During the approach of the peptide toward the bilayer the area of the interacting surface between the species was inversely proportional to the distance between them, supporting the application of such a relationship in continuum calculations of peptide-bilayer binding free energies. In the second simulation, the N-terminus of the surface-bound peptide was deprotonated. Consistent with experiment, this strengthened interactions between the peptide and the bilayer. Details of both peptide-bilayer complexes, including the orientation, percent buried surface area, and orientation of the lipid headgroups are in good agreement with those obtained from experiment. The location of the different side chains in the bilayer is in direct correlation with an interfacial hydrophobicity scale developed using model peptides. The aromatic side chains of the Phe and Trp residues all lie flat with respect to the bilayer surface in both complexes. Changes in lipid and water ordering due to peptide binding suggest a possible domination of lipophobic over hydrophobic effects, as proposed by other workers. Where appropriate, peptide and lipid properties in the bound states are compared with separate simulations of sandostatin and the bilayer in water, respectively, so as to monitor the response of the system to the binding process.
| S-EPMC1301258 | biostudies-other
Project description:Material systems that can be used to flexibly and precisely define the chemical nature and molecular arrangement of a surface would be invaluable for the control of complex biointerfacial interactions. For example, progress in antifouling polymer biointerfaces that prevent non-specific protein adsorption and cell attachment, which can significantly improve the performance of an array of biomedical and industrial applications, is hampered by a lack of chemical models to identify the molecular features conferring their properties. Poly(N-substituted glycine) "peptoids" are peptidomimetic polymers that can be conveniently synthesized with specific monomer sequences and chain lengths, and are presented as a versatile platform for investigating the molecular design of antifouling polymer brushes. Zwitterionic antifouling polymer brushes have captured significant recent attention, and a targeted library of zwitterionic peptoid brushes with a different charge densities, hydration, separations between charged groups, chain lengths, and grafted chain densities, is quantitatively evaluated for their antifouling properties through a range of protein adsorption and cell attachment assays. Specific zwitterionic brush designs were found to give rise to distinct but subtle differences in properties. The results also point to the dominant roles of the grafted chain density and chain length in determining the performance of antifouling polymer brushes.
| S-EPMC4497591 | biostudies-literature
Project description:The atomistic modeling of protein adsorption on surfaces is hampered by the different time scales of the simulation ([Formula: see text][Formula: see text]s) and experiment (up to hours), and the accordingly different 'final' adsorption conformations. We provide evidence that the method of accelerated molecular dynamics is an efficient tool to obtain equilibrated adsorption states. As a model system we study the adsorption of the protein BMP-2 on graphite in an explicit salt water environment. We demonstrate that due to the considerably improved sampling of conformational space, accelerated molecular dynamics allows to observe the complete unfolding and spreading of the protein on the hydrophobic graphite surface. This result is in agreement with the general finding of protein denaturation upon contact with hydrophobic surfaces.
| S-EPMC3670854 | biostudies-literature
Project description:Membranes composed of bipolar tetraether lipids have been studied by a series of 25-ns molecular dynamics simulations to understand the microscopic structure and dynamics as well as membrane area elasticity. By comparing macrocyclic and acyclic tetraether and diether archaeal lipids, the effect of tail linkage of the two phytanyl-chained lipids on the membrane properties is elucidated. Tetraether lipids show smaller molecular area and lateral mobility. For the latter, calculated diffusion coefficients are indeed one order-of-magnitude smaller than that of the diether lipid. These two tetraether membranes are alike in many physical properties except for membrane area elasticity. The macrocyclic tetraether membrane shows a higher elastic area expansion modulus than its acyclic counterpart by a factor of three. Free energy profiles of a water molecule crossing the membranes show no major difference in barrier height; however, a significant difference is observed near the membrane center due to the lack of the slip-plane in tetraether membranes.
| S-EPMC1366815 | biostudies-other
Project description:A multiscale molecular dynamics simulation study has been carried out in order to provide in-depth information on the adsorption of hemoglobin, myoglobin, and trypsin over citrate-capped AuNPs of 15 nm diameter. In particular, determinants for single proteins adsorption and simultaneous adsorption of the three types of proteins considered have been studied by Coarse-Grained and Meso-Scale molecular simulations, respectively. The results, discussed in the light of the controversial experimental data reported in the current experimental literature, have provided a detailed description of the (i) recognition process, (ii) number of proteins involved in the early stages of corona formation, (iii) protein competition for AuNP adsorption, (iv) interaction modalities between AuNP and protein binding sites, and (v) protein structural preservation and alteration.
| S-EPMC6678212 | biostudies-literature
Project description:We investigate nanoparticle (NP) dispersion, polymer conformations, entanglements and dynamics in ionic nanocomposites. To this end, we study nanocomposite systems with various spherical NP loadings, three different molecular weights, two different Bjerrum lengths, and two types of charge-sequenced polymers by means of molecular dynamics simulations. NP dispersion can be achieved in either oligomeric or entangled polymeric matrices due to the presence of electrostatic interactions. We show that the overall conformations of ionic oligomer chains, as characterized by their radii of gyration, are affected by the presence and the amount of charged NPs, while the dimensions of charged entangled polymers remain unperturbed. Both the dynamical behavior of polymers and NPs, and the lifetime and amount of temporary crosslinks, are found to depend on the ratio between the Bjerrum length and characteristic distance between charged monomers. Polymer-polymer entanglements start to decrease beyond a certain NP loading. The dynamics of ionic NPs and polymers is very different compared with their non-ionic counterparts. Specifically, ionic NP dynamics is getting enhanced in entangled matrices and also accelerates with the increase of NP loading.
| S-EPMC7694256 | biostudies-literature
Project description:Spontaneous membrane-translocating peptides (SMTPs) have recently been shown to directly penetrate cell membranes. Adsorption of a SMTP, and some engineered extensions, at model silica surfaces is studied herein using fully atomistic molecular dynamics simulations in order to assess their potential to construct novel drug delivery systems. The simulations are designed to reproduce the electric fields above single, siloxide-rich charged surfaces, and the trajectories indicate that the main driving force for adsorption is electrostatic. An increase in the salt concentration slows down but does not prevent adsorption of the SMTP to the surface; it also does not result in peptide desorption, suggesting additional binding via hydrophobic forces. The results are used to design extensions to the peptide sequence which we find enhance adsorption but do not affect the adsorbed conformation. We also investigate the effect of surface hydroxylation on the peptide adsorption. In all cases, the final adsorbed conformations are with the peptide flattened to the surface with arginine residues, which are key to the peptide's function, anchoring it to the surface so that they are not exposed to solution. This conformation could impact their role in membrane translocation and thus has important implications for the design of future drug delivery vehicles.
| S-EPMC3871889 | biostudies-other
Project description:The stability of the film poly(n-butyl methacrylate) (PnBMA) with different tacticities, prepared on silicon oxide and exposed to aqueous phosphate-buffered saline with different concentrations of bovine serum albumin (CBSA between 0 and 4.5 mg/mL), was examined at temperatures close to the physiological limit (between 4 and 37 °C) with optical microscopy, contact angle measurements, atomic force microscopy, and time-of-flight secondary ion mass spectrometry. For PBS solutions with CBSA = 0, the stability of atactic PnBMA and dewetting of isotactic PnBMA was observed, caused by the interplay between the stabilizing long-range dispersion forces and the destabilizing short-range polar interactions. Analogous considerations of excess free energy cannot explain the retardation of dewetting observed for isotactic PnBMA in PBS solutions with higher CBSA. Instead, formation of a BSA overlayer, adsorbed preferentially but not exclusively to uncovered SiOx regions, is evidenced and postulated to hinder polymer dewetting. Polymer dewetting and protein patterning are obtained in one step, suggesting a simple approach to fabricate biomaterials with micropatterned proteins.
| S-EPMC7584358 | biostudies-literature
Project description:We describe a new antifouling surface coating, based on aggregation of a short amphiphilic four-armed PEG-dopamine polymer into particles and on surface binding by catechol chemistry. An unbroken and smooth polymeric coating layer with an average thickness of approximately 4 ?m was formed on top of titanium oxide surfaces by a single step reaction. Coatings conferred excellent resistance to protein adhesion. Cell attachment was completely prevented for at least eight weeks, although the membranes themselves did not appear to be intrinsically cytotoxic. When linear PEG or four-armed PEG of higher molecular weight were used, the resulting coatings were inferior in thickness and in preventing protein adhesion. This coating method has potential applicability for biomedical devices susceptible to fouling after implantation.
| S-EPMC3775852 | biostudies-literature