Permeability and Porosity Development during the Carbonization of Coals of Different Coking Pressures.
Ontology highlight
ABSTRACT:
SUBMITTER: Casal MD
PROVIDER: S-EPMC8480075 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:The adsorption of quinoline from wastewater by coking coal (AC-1), HCl-modified coking coal (AC-2), HNO3-modified coking coal (AC-3), HF-modified coking coal (AC-4), and H2SO4-modified coking coals (AC-5) was investigated in this paper. The effects of acid-modified concentration, modification time, and adsorption time versus quinoline removal rate were studied by batch experiments. The quinoline concentration was measured by UV spectrophotometry, the average pore size and specific surface area of coking coal before and after modification were characterized through static nitrogen adsorption, the mineral composition of coking coal was tested by X-ray diffraction, the surface functional groups were tested by Fourier transform infrared spectroscopy, and the surface topography was tested using a scanning electron microscope. The experimental results showed that the adsorption capacity of coking coals was the best when both the modification time was 120 min and the acid-modified concentration was 0.1 mol·L-1 and the quinoline removal rate reaches the highest when the adsorption time was 120 min. The specific surface area of AC-2 increased from 2.898 to 3.637 m2·g-1, and the removal rate of quinoline increased from 77.64 to 90.61%. Acids reacted with inorganic mineral impurities within coking coal such as hydrogen vanadium phosphate hydrate, which caused an increase in the specific surface area. A new peak appeared in the Fourier transform infrared spectroscopy pattern at the wavenumber 2300 cm-1. The surface of coking coal modified by acids was rougher than that of AC-1. The adsorption capacity of coking coal was improved after modification, and modified coking coals have the highest potential as low-cost adsorbents for quinoline removal.
| S-EPMC6906776 | biostudies-literature
Project description:The enrichment of coalbed methane (CBM) and the outburst of gas in a coal mine are closely related to the nanopore structure of coal. The evolutionary characteristics of 12 coal nanopore structures under different natural deformational mechanisms (brittle and ductile deformation) are studied using a scanning electron microscope (SEM) and low-temperature nitrogen adsorption. The results indicate that there are mainly submicropores (2~5 nm) and supermicropores (<2 nm) in ductile deformed coal and mesopores (10~100 nm) and micropores (5~10 nm) in brittle deformed coal. The cumulative pore volume (V) and surface area (S) in brittle deformed coal are smaller than those in ductile deformed coal which indicates more adsorption space for gas. The coal with the smaller pores exhibits a large surface area, and coal with the larger pores exhibits a large volume for a given pore volume. We also found that the relationship between S and V turns from a positive correlation to a negative correlation when S > 4 m(2)/g, with pore sizes <5 nm in ductile deformed coal. The nanopore structure (<100 nm) and its distribution could be affected by macromolecular structure in two ways. Interconversion will occur among the different size nanopores especially in ductile deformed coal.
| S-EPMC4121222 | biostudies-other
Project description:Microorganisms are the core drivers of coal biogeochemistry and are closely related to the formation of coalbed methane. However, it remains poorly understood about the network relationship and stability of microbial communities in coals with different ranks. In this study, a high-throughput sequencing data set was analyzed to understand the microbial co-occurrence network in coals with different ranks including anthracite, medium-volatile bituminous, and high-volatile bituminous. The results showed similar topological properties for the microbial networks among coals with different ranks, but a great difference was found in the microbial composition in different large modules among coals with different ranks, and these three networks had three, four, and four large modules with seven, nine, and nine phyla, respectively. Among these networks, a total of 46 keystone taxa were identified in large modules, and these keystone taxa were different in coals with different ranks. Bacteria dominated the keystone taxa in the microbial network, and these bacterial keystone taxa mainly belonged to phyla Actinobacteria, Bacteroidetes, Firmicutes, and Proteobacteria. Besides, the removal of the key microbial data could reduce the community stability of microbial communities in bituminous coals. A partial least-squares path model further showed that these bacterial keystone taxa indirectly affected methanogenic potential by maintaining the microbial community stability and bacterial diversity. In summary, these results showed that keystone taxa played an important role in determining the community diversity, maintaining the microbial community stability, and controlling the methanogenic potential, which is of great significance for understanding the microbial ecology and the geochemical cycle of coal seams.
| S-EPMC9435036 | biostudies-literature
Project description:Application of low-cost carbon black from lignin highly depends on the materials properties, which might by determined by raw material and processing conditions. Four different technical lignins were subjected to thermostabilization followed by stepwise heat treatment up to a temperature of 2000 °C in order to obtain micro-sized carbon particles. The development of the pore structure, graphitization and inner surfaces were investigated by X-ray scattering complemented by scanning electron microscopy and FTIR spectroscopy. Lignosulfonate-based carbons exhibit a complex pore structure with nanopores and mesopores that evolve by heat treatment. Organosolv, kraft and soda lignin-based samples exhibit distinct pores growing steadily with heat treatment temperature. All carbons exhibit increasing pore size of about 0.5-2 nm and increasing inner surface, with a strong increase between 1200 °C and 1600 °C. The chemistry and bonding nature shifts from basic organic material towards pure graphite. The crystallite size was found to increase with the increasing degree of graphitization. Heat treatment of just 1600 °C might be sufficient for many applications, allowing to reduce production energy while maintaining materials properties.
| S-EPMC8038752 | biostudies-literature
Project description:Current vector control programs are largely dependent on pyrethroids, which are the most commonly used and only insecticides recommended by the World Health Organization for insecticide-treated nets (ITNs). However, the rapid spread of pyrethroid resistance worldwide compromises the effectiveness of control programs and threatens public health. Since few new insecticide classes for vector control are anticipated, limiting the development of resistance is crucial for prolonging efficacy of pyrethroids. In this study, we exposed a field-collected population of Culex pipiens pallens to different insecticide selection intensities to dynamically monitor the development of resistance. Moreover, we detected kdr mutations and three detoxification enzyme activities in order to explore the evolutionary mechanism of pyrethroid resistance. Our results revealed that the level of pyrethroid resistance was proportional to the insecticide selection pressure. The kdr and metabolic resistance both contributed to pyrethroid resistance in the Cx. pipiens pallens populations, but they had different roles under different selection pressures. We have provided important evidence for better understanding of the development and mechanisms of pyrethroid resistance which may guide future insecticide use and vector management in order to avoid or delay resistance.
| S-EPMC4537097 | biostudies-literature
Project description:This paper presents the results of comprehensive cement paste porosity and gas permeability tests. The tests conducted concerned ordinary Portland cement (OPC) cement pastes with varying water-cement ratios ranging from 0.3 to 0.6. The tests were conducted after the curing of cement paste for 90 days and two years under laboratory conditions. Open porosity was determined using three methods: helium pycnometry, mercury intrusion porosimetry, and water saturation. Permeability was determined using a modified RILEM-Cembureau method. The results obtained demonstrated that permeability does not change significantly over time despite the observed material shifts in open porosity characteristics caused both by further progress in hydration and by the carbonation process that occurs. The results of the tests conducted also permitted the quantitative determination of the impact of the water-cement ratio, age, and the progress of carbonation on open porosity measured using different methods and also on the gas permeability of the pastes.
| S-EPMC6337504 | biostudies-literature
Project description:Subsurface sandstone deposits represent globally ubiquitous reservoirs which can potentially provide the characteristics necessary for the effective geological storage of CO2. Geological carbon storage is widely agreed to be a key asset in tackling anthropogenic emissions and climate change to reach a sustainable 'net zero', despite the present financial challenges associated with it. Therefore, improved understanding of the characteristics of the materials in which we plan to store many gigatons of CO2 is critical. Developing cheaper characterisation techniques is therefore crucial to support the global push for net zero. In this work we use digital analysis of 3D microscale X-ray images of a range of sandstone samples to constrain the porosity-permeability relationship and the upper percolation threshold; the point at which near full pore structure connectivity is achieved. This is one of the most significant controls on the viability of carbon storage as a practical solution to achieving net zero. We find that the upper percolation threshold in sandstone occurs at ca. 14% total porosity whilst the relationship between porosity ([Formula: see text]) and permeability ([Formula: see text]) can be defined as [Formula: see text]. The investigation of the upper percolation threshold may allow a target criterion to be designated when assessing potential carbon storage reservoirs, whilst investigation of the porosity-permeability relationship allows for a greater understanding of the fluid flow regimes in the subsurface. By using a digital technique to assess carbon storage reservoir potentiality we show that initial characterisation of reservoirs can be carried out rapidly and relatively economically, prior to further full reservoir characterisation studies. This approach is also non-destructive, allowing samples to be reused and multiple analytical phases performed on the same materials.
| S-EPMC9253316 | biostudies-literature
Project description:This study aimed to compare intraocular pressures (IOP) using different tonometers, Goldmann applanation (IOPGAT), non-contact (IOPNCT), and rebound (IOPRBT), and to assess the effects of aging and central corneal thickness (CCT) on the measurements. The IOPGAT, IOPNCT, IOPRBT, mean patient age (65.1 ± 16.2 years), and CCT (521.7 ± 39.2 µm) were collected retrospectively from 1054 eyes. The differences among IOPs were compared by the paired t-test. Possible correlations between devices, age, and CCT were assessed by linear regression analyses. The effects of age and CCT on the IOP reading were assessed by mixed-effects regression models. The IOPGAT values were 2.4 and 1.4 mmHg higher than IOPNCT and IOPRBT, respectively; the IOPNCT was 1.0 mmHg lower than IOPRBT (p < 0.0001 for all comparisons). The IOPs measured by each tonometer were highly correlated with each other (r = 0.81-0.90, t = 45.2-65.5). The linear regression analyses showed that age was negatively correlated with IOPNCT (r = -0.12, t = -4.0) and IOPRBT (r = -0.14, t = -4.5) but not IOPGAT (r = 0.00, t = -0.2); the CCT was positively correlated with IOPGAT (r = 0.13, t = 4.3), IOPNCT (r = 0.29, t = 9.8), and IOPRBT (r = 0.22, t = 7.2). The mixed-effect regression models showed significant negative correlations between age and IOPNCT (t = -2.6) and IOPRBT (t = -3.4), no correlation between age and IOPGAT (t = 0.2), and a significant positive correlation between CCT and the tonometers (t = 3.4-7.3). No differences between IOPGAT and IOPRBT were seen at the age of 38.8 years. CCT affects IOPs from all tonometers; age affects IOPNCT and IOPRBT in different degrees. IOPRBT tended to be higher than IOPGAT in young subjects, but this stabilized in middle age and became higher in older subjects.
| S-EPMC8471438 | biostudies-literature
Project description:Mechanical response, deformation behaviour and permeability evolution of surrounding rock under unloading conditions are of significant importance in rock engineering activities. In this research, triaxial experiments of sandstone subjected to different initial confining pressures and unloading rates under fixed axial stress were conducted. The results showed that sandstones experienced shear dilatancy before failure. However, the dilatancy factor did not decrease with increasing confining pressure, i.e. the dilatancy behaviour was not suppressed, which contradicted the phenomenon under increasing axial stress. The crack density also increased with increasing initial confining pressure. Furthermore, the normalized permeability was positively correlated with unloading rates. The sandstone permeability was closely related to the shear dilatancy behaviour. In the accelerated dilatancy stage, the relationship between normalized permeability and volumetric strain was linear at low unloading rates and nonlinear at high unloading rates. The linear/nonlinear relationship between them can directly affect the temporality of respective mutation, so as to guide the prevention of geological disasters at different excavations rates.
| S-EPMC7890488 | biostudies-literature