Dataset Information

A Reference Database of Standardised Continuous Lumbar Intervertebral Motion Analysis for Conducting Patient-Specific Comparisons.

ABSTRACT: Lumbar instability has long been thought of as the failure of lumbar vertebrae to maintain their normal patterns of displacement. However, it is unknown what these patterns consist of. Research using quantitative fluoroscopy (QF) has shown that continuous lumbar intervertebral patterns of rotational displacement can be reliably measured during standing flexion and return motion using standardised protocols and can be used to assess patients with suspected lumbar spine motion disorders. However, normative values are needed to make individualised comparisons. One hundred and thirty-one healthy asymptomatic participants were recruited and performed guided flexion and return motion by following the rotating arm of an upright motion frame. Fluoroscopic image acquisition at 15fps was performed and individual intervertebral levels from L2-3 to L5-S1 were tracked and analysed during separate outward flexion and return phases. Results were presented as proportional intervertebral motion representing these phases using continuous means and 95%CIs, followed by verification of the differences between levels using Statistical Parametric Mapping (SPM). A secondary analysis of 8 control participants matched to 8 patients with chronic, non-specific low back pain (CNSLBP) was performed for comparison. One hundred and twenty-seven asymptomatic participants' data were analysed. Their ages ranged from 18 to 70 years (mean 38.6) with mean body mass index 23.8 kg/m² 48.8% were female. Both the flexion and return phases for each level evidenced continuous change in mean proportional motion share, with narrow confidence intervals, highly significant differences and discrete motion paths between levels as confirmed by SPM. Patients in the secondary analysis evidenced significantly less L5-S1 motion than controls (p < 0.05). A reference database of spinal displacement patterns during lumbar (L2-S1) intersegmental flexion and return motion using a standardised motion protocol using fluoroscopy is presented. Spinal displacement patterns in asymptomatic individuals were found to be distinctive and consistent for each intervertebral level, and to continuously change during bending and return. This database may be used to allow continuous intervertebral kinematics to drive dynamic models of joint and muscular forces as well as reference values against which to make patient-specific comparisons in suspected cases of lumbar spine motion disorders.

SUBMITTER: Breen A

PROVIDER: S-EPMC8503612 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Similar Datasets

Project description:BACKGROUND:Physiological motion of the lumbar spine is a subject of interest for musculoskeletal health care professionals, as abnormal motion is believed to be related to lumbar conditions and complaints. Many researchers have described ranges of motion for the lumbar spine, but only a few have mentioned specific motion patterns of each individual segment during flexion and extension. These motion patterns mostly comprise the sequence of segmental initiation in sagittal rotation. However, an adequate definition of physiological motion of the lumbar spine is still lacking. The reason for this is the reporting of different ranges of motion and sequences of segmental initiation in previous studies. Furthermore, due to insufficient fields of view, none of these papers have reported on maximum flexion and extension motion patterns of L1 to S1. In the lower cervical spine, a consistent pattern of segmental contributions was recently described. In order to understand physiological motion of the lumbar spine, it is necessary to systematically study motion patterns, including the sequence of segmental contribution, of vertebrae L1 to S1 in healthy individuals during maximum flexion and extension. OBJECTIVE:This study aims to define the lumbar spines' physiological motion pattern of vertebrae L1, L2, L3, L4, L5, and S1 by determining the sequence of segmental contribution and the sequence of segmental initiation of motion in sagittal rotation of each vertebra during maximum flexion and extension. The secondary endpoint will be exploring the possibility of analyzing the intervertebral horizontal and vertical translation of each vertebra during maximum flexion and extension. METHODS:Cinematographic recordings will be performed in 11 healthy male participants, aged 18-25 years, without a history of spine problems. Cinematographic flexion and extension recordings will be made at two time points with a minimum 2-week interval in between. RESULTS:The study has been approved by the local institutional medical ethical committee (Medical Research Ethics Committee of Zuyderland and Zuyd University of applied sciences) on September 24, 2018. Inclusion of participants will be completed in 2020. CONCLUSIONS:If successful, these physiological motion patterns can be compared with motion patterns of patients with lumbar conditions before or after surgery. Ultimately, researchers may be able to determine differences in biomechanics that can potentially be linked to physical complaints like low back pain. TRIAL REGISTRATION:ClinicalTrials.gov NCT03737227; https://clinicaltrials.gov/ct2/show/NCT03737227. INTERNATIONAL REGISTERED REPORT IDENTIFIER (IRRID):DERR1-10.2196/14741.

Project description:BackgroundEnsuring fair comparisons of cancer survival statistics across population groups requires careful consideration of differential competing mortality due to other causes, and adjusting for imbalances over groups in other prognostic covariates (e.g. age). This has typically been achieved using comparisons of age-standardised net survival, with age standardisation addressing covariate imbalance, and the net estimates removing differences in competing mortality from other causes. However, these estimates lack ease of interpretability. In this paper, we motivate an alternative non-parametric approach that uses a common rate of other cause mortality across groups to give reference-adjusted estimates of the all-cause and cause-specific crude probability of death in contrast to solely reporting net survival estimates.MethodsWe develop the methodology for a non-parametric equivalent of standardised and reference adjusted crude probabilities of death, building on the estimation of non-parametric crude probabilities of death. We illustrate the approach using regional comparisons of survival following a diagnosis of rectal cancer for men in England. We standardise to the covariate distribution and other cause mortality of England as a whole to offer comparability, but with close approximation to the observed all-cause region-specific mortality.ResultsThe approach gives comparable estimates to observed crude probabilities of death, but allows direct comparison across population groups with different covariate profiles and competing mortality patterns. In our illustrative example, we show that regional variations in survival following a diagnosis of rectal cancer persist even after accounting for the variation in deprivation, age at diagnosis and other cause mortality.ConclusionsThe methodological approach of using standardised and reference adjusted metrics offers an appealing approach for future cancer survival comparison studies and routinely published cancer statistics. Our non-parametric estimation approach through the use of weighting offers the ability to estimate comparable survival estimates without the need for statistical modelling.

Dataset Information

A Reference Database of Standardised Continuous Lumbar Intervertebral Motion Analysis for Conducting Patient-Specific Comparisons.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets