Diffraction Methods for Qualitative and Quantitative Texture Analysis of Ferroelectric Ceramics.
Ontology highlight
ABSTRACT:
SUBMITTER: Fancher CM
PROVIDER: S-EPMC8510197 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:The most common scientific analysis of archaeological ceramics aims to determine the raw material source and/or production technology. Scientists and archaeologists widely use XRF-based techniques as a tool in a provenance study. After conducting XRF analysis, the results are often analyzed using multivariate analysis in addition to interpretation and conclusions. Various multivariate techniques have already been applied in archaeological ceramics provenance studies to reveal different raw material sources, identify imported pieces, or determine different production recipes. This study aims to evaluate the results of multivariate analysis in the provenance study of ceramics that belong to three cultures that settled in the same area during various prehistoric periods. Portable energy-dispersive X-ray fluorescence spectrometry (pEDXRF) was used to determine the elemental composition of the ceramic material. The ceramic material was prepared in two different ways. The ceramic body material was ground into powder, homogenized, and then pressed into tablets. After that, the same fragments are polished in suitable places. Quantitative and qualitative analyses were performed on the tablets and polished pieces. The results were subjected to both unsupervised and supervised multivariate analysis. Based on the results, it was concluded that qualitative analysis of the well-prepared shards' surface using EDXRF spectrometry could be utilized in provenance studies, even when the ceramic assemblages were made of similar raw materials.
| S-EPMC11313242 | biostudies-literature
Project description:Grain size effects on the physical properties of polycrystalline ferroelectrics have been extensively studied for decades; however there are still major controversies regarding the dependence of the piezoelectric and ferroelectric properties on the grain size. Dense BaTiO3 ceramics with different grain sizes were fabricated by either conventional sintering or spark plasma sintering using micro- and nano-sized powders. The results show that the grain size effect on the dielectric permittivity is nearly independent of the sintering method and starting powder used. A peak in the permittivity is observed in all the ceramics with a grain size near 1??m and can be attributed to a maximum domain wall density and mobility. The piezoelectric coefficient d33 and remnant polarization Pr show diverse grain size effects depending on the particle size of the starting powder and sintering temperature. This suggests that besides domain wall density, other factors such as back fields and point defects, which influence the domain wall mobility, could be responsible for the different grain size dependence observed in the dielectric and piezoelectric/ferroelectric properties. In cases where point defects are not the dominant contributor, the piezoelectric constant d33 and the remnant polarization Pr increase with increasing grain size.
| S-EPMC4423446 | biostudies-literature
Project description:Domain engineering in ferroelectrics endows flexibility for different functional applications. Whereas the domain engineering strategy for single crystals and thin films is diverse, there is only a limited number of strategies for bulk ceramics. Here, a domain engineering strategy for achieving a compact domain architecture with increased domain-wall density in (K,Na)NbO3 (KNN)-based ferroelectric ceramics via mesoscopic chemical inhomogeneity (MCI) is developed. The MCI-induced interfaces can effectively hinder domain continuity and modify the domain configuration. Besides, the MCI effect also results in diffused phase transitions, which is beneficial for achieving enhanced thermal stability. Modulation of chemical inhomogeneity demonstrates great potential for engineering desirable domain configuration and properties in ferroelectric ceramics. Additionally, the MCI can be easily controlled by regulating the processing condition during solid-state synthesis, which is advantageous to industrial production.
| S-EPMC9189658 | biostudies-literature
Project description:The electric and nonvolatile control of the spin texture in semiconductors would represent a fundamental step toward novel electronic devices combining memory and computing functionalities. Recently, GeTe has been theoretically proposed as the father compound of a new class of materials, namely ferroelectric Rashba semiconductors. They display bulk bands with giant Rashba-like splitting due to the inversion symmetry breaking arising from the ferroelectric polarization, thus allowing for the ferroelectric control of the spin. Here, we provide the experimental demonstration of the correlation between ferroelectricity and spin texture. A surface-engineering strategy is used to set two opposite predefined uniform ferroelectric polarizations, inward and outward, as monitored by piezoresponse force microscopy. Spin and angular resolved photoemission experiments show that these GeTe(111) surfaces display opposite sense of circulation of spin in bulk Rashba bands. Furthermore, we demonstrate the crafting of nonvolatile ferroelectric patterns in GeTe films at the nanoscale by using the conductive tip of an atomic force microscope. Based on the intimate link between ferroelectric polarization and spin in GeTe, ferroelectric patterning paves the way to the investigation of devices with engineered spin configurations.
| S-EPMC6994063 | biostudies-literature
Project description:The figure-of-merits of ferroelectrics for transducer applications are their electromechanical coupling factor and the operable temperature range. Relaxor-PbTiO3 ferroelectric crystals show a much improved electromechanical coupling factor k33 (88~93%) compared to their ceramic counterparts (65~78%) by taking advantage of the strong anisotropy of crystals. However, only a few relaxor-PbTiO3 systems, for example Pb(In1/2Nb1/2)O3-Pb(Mg1/3Nb2/3)O3-PbTiO3, can be grown into single crystals, whose operable temperature range is limited by their rhombohedral-tetragonal phase transition temperatures (Trt: 60~120 °C). Here, we develop a templated grain-growth approach to fabricate <001>-textured Pb(In1/2Nb1/2)O3-Pb(Sc1/2Nb1/2)O3-PbTiO3 (PIN-PSN-PT) ceramics that contain a large amount of the refractory component Sc2O3, which has the ability to increase the Trt of the system. The high k33 of 85~89% and the greatly increased Trt of 160~200 °C are simultaneously achieved in the textured PIN-PSN-PT ceramics. The above merits will make textured PIN-PSN-PT ceramics an alternative to single crystals, benefiting the development of numerous advanced piezoelectric devices.
| S-EPMC7977148 | biostudies-literature
Project description:With an ever increasing dependence on electrical energy for powering modern equipment and electronics, research is focused on the development of efficient methods for the generation, storage and distribution of electrical power. In this regard, the development of suitable dielectric based solid-state capacitors will play a key role in revolutionizing modern day electronic and electrical devices. Among the popular dielectric materials, anti-ferroelectrics (AFE) display evidence of being a strong contender for future ceramic capacitors. AFE materials possess low dielectric loss, low coercive field, low remnant polarization, high energy density, high material efficiency, and fast discharge rates; all of these characteristics makes AFE materials a lucrative research direction. However, despite the evident advantages, there have only been limited attempts to develop this area. This article attempts to provide a focus to this area by presenting a timely review on the topic, on the relevant scientific advancements that have been made with respect to utilization and development of anti-ferroelectric materials for electric energy storage applications. The article begins with a general introduction discussing the need for high energy density capacitors, the present solutions being used to address this problem, and a brief discussion of various advantages of anti-ferroelectric materials for high energy storage applications. This is followed by a general description of anti-ferroelectricity and important anti-ferroelectric materials. The remainder of the paper is divided into two subsections, the first of which presents various physical routes for enhancing the energy storage density while the latter section describes chemical routes for enhanced storage density. This is followed by conclusions and future prospects and challenges which need to be addressed in this particular field.
| S-EPMC5458845 | biostudies-other
Project description:Assessing the pattern of nuclear chromatin is essential for pathological investigations. However, the interpretation of nuclear pattern is subjective. In this study, we performed the texture analysis of nuclear chromatin in breast cancer samples to determine the nuclear pleomorphism score thereof. We used three different algorithms for extracting high-level texture features: the gray-level co-occurrence matrix (GLCM), gray-level run length matrix (GLRLM), and gray-level size zone matrix (GLSZM). Using these algorithms, 12 GLCM, 11 GLRLM, and 16 GLSZM features were extracted from three scores of breast carcinoma (Scores 1-3). Classification accuracy was assessed using the support vector machine (SVM) and k-nearest neighbor (KNN) classification models. Three features of GLCM, 11 of GLRLM, and 12 of GLSZM were consistent across the three nuclear pleomorphism scores of breast cancer. Comparing Scores 1 and 3, the GLSZM feature large zone high gray-level emphasis showed the largest difference among breast cancer nuclear scores among all features of the three algorithms. The SVM and KNN classifiers showed favorable results for all three algorithms. A multiclass classification was performed to compare and distinguish between the scores of breast cancer. Texture features of nuclear chromatin can provide useful information for nuclear scoring. However, further validation of the correlations of histopathologic features, and standardization of the texture analysis process, are required to achieve better classification results. © 2021 The Authors. Cytometry Part A published by Wiley Periodicals LLC on behalf of International Society for Advancement of Cytometry.
| S-EPMC8359278 | biostudies-literature
Project description:Congenital heart defects (CHD) are the most common type of birth defect in humans, affecting up to 1% of all live births. However, the underlying causes for CHD are still poorly understood. The developing mouse constitutes a valuable model for the study of CHD, because cardiac developmental programs between mice and humans are highly conserved. The protocol describes in detail how to produce mouse embryos of the desired gestational stage, methods to isolate and preserve the heart for downstream processing, quantitative methods to identify common types of CHD by histology (e.g., ventricular septal defects, atrial septal defects, patent ductus arteriosus), and quantitative histomorphometry methods to measure common muscular compaction phenotypes. These methods articulate all the steps involved in sample preparation, collection, and analysis, allowing scientists to correctly and reproducibly measure CHD.
| S-EPMC7577828 | biostudies-literature
Project description:Both relaxor ferroelectric and antiferroelectric materials can individually demonstrate large electrocaloric effects (ECE). However, in order to further enhance the ECE it is crucial to find a material system, which can exhibit simultaneously both relaxor ferroelectric and antiferroelectric properties, or easily convert from one into another in terms of the compositional tailoring. Here we report on a system, in which the structure can readily change from antiferroelectric into relaxor ferroelectric and vice versa. To this end relaxor ferroelectric Pb0.89La0.11(Zr0.7Ti0.3)0.9725O3 and antiferroelectric Pb0.93La0.07(Zr0.82Ti0.18)0.9825O3 ceramics were designed near the antiferroelectric-ferroelectric phase boundary line in the La2O3-PbZrO3-PbTiO3 phase diagram. Conventional solid state reaction processing was used to prepare the two compositions. The ECE properties were deduced from Maxwell relations and Landau-Ginzburg-Devonshire (LGD) phenomenological theory, respectively, and also directly controlled by a computer and measured by thermometry. Large electrocaloric efficiencies were obtained and comparable with the results calculated via the phenomenological theory. Results show great potential in achieving large cooling power as refrigerants.
| S-EPMC5366905 | biostudies-literature
Project description:Texture analysis is a subject of intensive focus in research due to its significant role in the field of image processing. However, few studies focus on colored texture analysis and even fewer use information theory concepts. Entropy measures have been proven competent for gray scale images. However, to the best of our knowledge, there are no well-established entropy methods that deal with colored images yet. Therefore, we propose the recent colored bidimensional fuzzy entropy measure, FuzEnC2D, and introduce its new multi-channel approaches, FuzEnV2D and FuzEnM2D, for the analysis of colored images. We investigate their sensitivity to parameters and ability to identify images with different irregularity degrees, and therefore different textures. Moreover, we study their behavior with colored Brodatz images in different color spaces. After verifying the results with test images, we employ the three methods for analyzing dermoscopic images of malignant melanoma and benign melanocytic nevi. FuzEnC2D, FuzEnV2D, and FuzEnM2D illustrate a good differentiation ability between the two-similar in appearance-pigmented skin lesions. The results outperform those of a well-known texture analysis measure. Our work provides the first entropy measure studying colored images using both single and multi-channel approaches.
| S-EPMC9223301 | biostudies-literature