Nanofiber template-induced preparation of ZnO nanocrystal and its application in photocatalysis
Ontology highlight
ABSTRACT:
SUBMITTER: Chen M
PROVIDER: S-EPMC8551286 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:A facile solution processing strategy has been developed for the formation of Ag-modified ZnO microneedles at various calcination temperatures such as 300, 500, and 700 °C (AZ3, AZ5, and AZ7 respectively). Due to the heavy doping of AgNO3, Ag+ ions have been incorporated in to the crystal lattice of ZnO in all the Ag-ZnO samples, which facilitated the formation of Ag-ZnO microneedle morphology with minimized defect states, and obviously, the plasmon peaks were observed due to Ag modification. These Ag-ZnO microneedle structures have been evaluated for their photocatalytic performance using methylene blue as model target contaminant and their activity was compared with the commercially available titania P25 photocatalyst. The photoactivity of all the Ag-ZnO microneedle structures was significantly higher than that of the commercially available P25 photocatalyst with the most active Ag-ZnO material having a photocatalytic activity ~ 1.4 times greater than that of P25 titania.
| S-EPMC7456407 | biostudies-literature
Project description:Molecularly imprinted polymers are versatile materials with wide application scope for the detection, capture and separation of specific compounds present in complex feed stocks. A major challenge associated with their preparation has been the need to sacrifice one mole equivalent of the template molecule to generate the complementary polymer cavities that selectively bind the target molecule. Moreover, template molecules can often be difficult to synthesise, expensive or lack stability. In this study, we describe a new approach, directed at the use of synthetic selectophores, chosen as readily prepared and low cost structural analogues with recognition groups in similar three-dimensional arrangements as found in the target molecule. To validate the approach, a comparative study of selectophores related to the polyphenolic compound (E)-resveratrol has been undertaken using traditional and green chemical synthetic approaches. These molecular mimic compounds were employed as polymer templates and also as binding analytes to interrogate the recognition sites associated with the molecularly imprinted polymers. Importantly, the study confirms that the use of selectophores has the potential to confer practical advantages, including access to more efficient methods for selection and preparation of suitable template molecules with a broader range of molecular diversity, as well as delivering imprinted polymers capable of recognizing the target compound and structurally related products.
| S-EPMC6332243 | biostudies-literature
Project description:In this work, the solar light-induced redox photoactivity of ZnO semiconductor material was used to prepare CuxO-ZnO composite catalysts at room temperature with a control of the chemical state of the copper oxide phase. Cu₂(I)O-ZnO and Cu(II)O-ZnO composite catalysts were prepared by using Cu(acac)₂ in tetrahydrofuran-water and Cu(NO₃)₂ in water as metallic precursor, respectively. Prior to the implementation of the photon-assisted synthesis method, the most efficient photoactive ZnO material was selected from among different ZnO materials prepared by the low temperature polyol and precipitation methods with carbonates and carbamates as precipitation agents. The photocatalytic degradation of the 4-chlorophenol compound in water under simulated solar light was taken as a model reaction. The ZnO support materials were characterized by X-ray diffraction (XRD), surface area and porosimetry measurements, thermogravimetric analysis (TGA), scanning electron microscopy (SEM) and transmission electron microscopy (TEM), and the synthesis method strongly influenced their photoactivity in terms of 4-chlorophenol degradation and of total organic carbon removal. The most photoactive ZnO material was prepared by precipitation with carbonates and calcined at 300 °C, benefitting from a high specific surface area and a small mean crystallite size for achieving a complete 4-chlorophenol mineralization within 70 min of reaction, with minimum Zn2+ released to the solution. Besides thermal catalysis applications, this work has opened a new route for the facile synthesis of Cu₂O-ZnO heterojunction photocatalysts that could take place under solar light of the heterojunction built between the p-type semi-conductor Cu₂O with direct visible light band gap and the ZnO semiconductor phase.
| S-EPMC6266916 | biostudies-literature
Project description:Ambient particulate matter less than 2.5 ?m (PM2.5) can substantially degrade the performance of cars by clogging the air intake filters. The application of nanofibers in air filter paper can achieve dramatic improvement of filtration efficiency with low resistance to air flow. Cellulose nanofibers have gained increasing attention because of their biodegradability and renewability. In this work, the cellulose nanofiber was prepared by Lyocell fiber nanofibrillation via a PFI-type refiner, and the influence of applying a cellulose nanofiber on filter paper was investigated. It was found that the cellulose nanofibers obtained under 1.00 N/mm and 40,000 revolutions were mainly macrofibrils of Lyocell fiber with average fiber diameter of 0.8 µm. For the filter papers with a different nanofiber fraction, both the pressure drop and fractional efficiency increased with the higher fraction of nanofibers. The results of the figure of merit demonstrated that for particles larger than 0.05 µm, the figure of merit increased substantially with a 5% nanofiber, but decreased when the nanofiber fraction reached 10% and higher. It was concluded that the optimal fraction of the cellulose nanofiber against PM2.5 was 5%. The results of the figure of merit were related to the inhomogeneous distribution of nanofibers in the fibrous structure. The discrepancy of the theoretical and measured pressure drop showed that a higher nanofiber fraction led to a higher degree of fiber inhomogeneity.
| S-EPMC6117698 | biostudies-literature
Project description:Bacterial conjunctivitis significantly impacts public health, including more than one-third of eye diseases reported worldwide. It is an infection caused by various aerobic and anaerobic bacteria and is highly contagious. Therefore, it has a high incidence of bacterial resistance to the antibiotics commonly used for treatment. Among the most recent antibiotics, besifloxacin is a fourth-generation fluoroquinolone antibiotic indicated exclusively for topical ophthalmic use. Due to its importance in treating bacterial conjunctivitis and its low solubility in water, limiting its efficacy, a nanotechnology-based drug delivery preparation was developed to overcome this hurdle. Besifloxacin nanocrystals were prepared by small-scale wet milling and response surface methodology, using Povacoat® as a stabilizer. The particle's average hydrodynamic diameter (Z-ave) was approximately 550 nm (17 times smaller than raw material), with a polydispersity index (PdI) of less than 0.2. The saturation solubility increased about two times compared to the raw material, making it possible to increase the dissolution rate of this drug substance, potentially improving its bioavailability and safety. The optimized preparation was stable under an accelerated stability study (90 days). The Z-ave, PZ, PdI, and content did not alter significantly during this period. Furthermore, the 0.6% m/m besifloxacin nanocrystals at the maximum dose and the Povacoat® stabilizer did not show toxicity in Galleria mellonella larvae. The innovative ophthalmic preparation minimum inhibitory concentration (MIC) was 0.0960 µg/mL and 1.60 µg/mL against Staphylococcus aureus and Pseudomonas aeruginosa, respectively, confirming in vitro efficacy. Therefore, besifloxacin nanocrystals revealed the potential for reduced dosing of the drug substance, with a minor occurrence of adverse effects and greater patient adherence to treatment.
| S-EPMC9609799 | biostudies-literature
Project description:Ce-doped ZnO (ZnO:Ce) nanorods have been prepared through a solvothermal method and the effects of Ce-doping on the structural, optical and electronic properties of ZnO rods were studied. ZnO:Ce rods were characterized by XRD, SEM, TEM, XPS, BET, DRS and Raman spectroscopy. 5% Ce-doped ZnO rods with an average length of 130 nm and a diameter of 23 nm exhibit the highest photocatalytic activity for the degradation of the Orange II dye under solar light irradiation. The high photocatalytic activity is ascribed to the substantially enhanced light absorption in the visible region, to the high surface area of ZnO:Ce rods and to the effective electron-hole pair separation originating from Ce doping. The influence of various experimental parameters like the pH, the presence of salts and of organic compounds was investigated and no marked detrimental effect on the photocatalytic activity was observed. Finally, recyclability experiments demonstrate that ZnO:Ce rods are a stable solar-light photocatalyst.
| S-EPMC5082445 | biostudies-literature
Project description:ZnO nanorods (NRs) decorated with Ni nanoparticles were synthesized using a template-free electrochemical deposition in an ultra-dilute aqueous electrolyte and a subsequent galvanic reaction. The electrochemical properties of the ZnO NRs as an anode material for rechargeable Li-ion batteries were evaluated for different binder morphologies (film and close-packed spherical particles) of polyvinylidene fluoride (PVDF). Results showed that the close-packed spherical PVDF simultaneously improved electrochemical capacity and cyclability because the free-volume between the spherical PVDF helped to accommodate the volume change in the anode caused by the Li ions discharge and charge processes. Furthermore, the Ni nanoparticles decorated on the surface of ZnO NRs enhanced the electrical conductivity of the ZnO NR anode, which enabled faster electronic and ionic transport at the interface between the electrolyte and the electrode, resulting in improved electrochemical capacity. The free-volume formed by the close-packed spherical PVDF, and the decoration of metal nanoparticles are expected to provide insight on the simultaneous improvement of electrochemical capacity and cyclability in other metal oxide anode nanostructures.
| S-EPMC6563756 | biostudies-literature
Project description:As a green and preferred technology for energy crisis and environmental issues, continuous research on photocatalysis and gas sensing has come forth at an explosive rate. Thus far, promising synthetic methods have enabled various designs and preparations of semiconductor-based nanostructure which have shown superior activity. This review summarized various synthetic routines toward carbon sphere template derived hollow nanostructures and their successful attempts in synthesize doping, solid solution, heterostructure, and surface modified nanostructures for heterogeneous photocatalysis and gas sensing. Moreover, the challenges and future prospects are briefly discussed. It is eagerly anticipated that this review may broaden the view and in-depth understanding of carbon sphere template derived hollow nanostructures while expected to have further progresses in heterogeneous photocatalysis, gas sensing and other related fields which will make great contributions to their application.
| S-EPMC7075306 | biostudies-literature
Project description:It is very interesting that magic electron affection promotes growth of nanocrystals due to nanoscale characteristics of electronic de Broglie wave which produces resonance to transfer energy to atoms. In our experiment, it was observed that silicon nanocrystals rapidly grow with irradiation of electron beam on amorphous silicon film prepared by pulsed laser deposition (PLD), and silicon nanocrystals almost occur in sphere shape on smaller nanocrystals with less irradiation time of electron beam. In the process, it was investigated that condensed structures of silicon nanocrystals are changed with different impurity atoms in silicon film, in which localized states emission was observed. Through electron beam irradiation for 15 min on amorphous Si film doped with oxygen impurity atoms by PLD process, enhanced photoluminescence emission peaks are observed in visible light. And electroluminescence emission is manipulated into the optical communication window on the bigger Si-Yb-Er nanocrystals after irradiation of electron beam for 30 min.
| S-EPMC4408977 | biostudies-literature
Project description:Spread of antibiotic resistant bacteria through water, is a threat to global public health. Here, we report Fe-doped ZnO nanoparticles (Fe/ZnO NPs) based solar-photocatalytic disinfection (PCD) of multidrug resistant Escherichia coli (MDR E. coli). Fe/ZnO NPs were synthesized by chemical precipitation technique, and when used as photocatalyst for disinfection, proved to be more effective (time for complete disinfection = 90 min) than ZnO (150 min) and TiO2 (180 min). Lipid peroxidation and potassium (K+) ion leakage studies indicated compromisation of bacterial cell membrane and electron microscopy and live-dead staining confirmed the detrimental effects on membrane integrity. Investigations indicated that H2O2 was the key species involved in solar-PCD of MDR E. coli by Fe/ZnO NPs. X-ray diffraction and atomic absorption spectroscopy studies showed that the Fe/ZnO NPs system remained stable during the photocatalytic process. The Fe/ZnO NPs based solar-PCD process proved successful in the disinfection of MDR E. coli in real water samples collected from river, pond and municipal tap. The Fe/ZnO NPs catalyst made from low cost materials and with high efficacy under solar light may have potential for real world applications, to help reduce the spread of resistant bacteria.
| S-EPMC5427922 | biostudies-literature