Extracting in Situ Charge Carrier Diffusion Parameters in Perovskite Solar Cells with Light Modulated Techniques
Ontology highlight
ABSTRACT:
SUBMITTER: Bou A
PROVIDER: S-EPMC8576830 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:The charge carrier lifetime is an important parameter in solar cells as it defines, together with the mobility, the diffusion length of the charge carriers, thus directly determining the optimal active layer thickness of a device. Herein, we report on charge carrier lifetime values in bromine doped planar methylammonium lead iodide (MAPbI3) solar cells determined by transient photovoltage. The corresponding charge carrier density has been derived from charge carrier extraction. We found increased lifetime values in solar cells incorporating bromine compared to pure MAPbI3 by a factor of ~2.75 at an illumination intensity corresponding to 1 sun. In the bromine containing solar cells we additionally observe an anomalously high value of extracted charge, which we deduce to originate from mobile ions.
| S-EPMC5159823 | biostudies-literature
Project description:We have developed a new noninvasive optical method for monitoring charge carrier diffusion and mobility in semiconductor thin films in the direction perpendicular to the surface which is most relevant for devices. The method is based on standard transient absorption measurements carried out in reflectance and transmittance modes at wavelengths below the band gap where the transient response is mainly determined by the change in refractive index, which in turn depends on the distribution of photogenerated carriers across the film. This distribution is initially inhomogeneous because of absorption at the excitation wavelength and becomes uniform over time via diffusion. By modeling these phenomena we can determine the diffusion constant and respective mobility. Applying the method to a 500 nm thick triple cation FAMACs perovskite film revealed that homogeneous carrier distribution is established in few hundred picoseconds, which is consistent with mobility of 66 cm2?(V?s)-1.
| S-EPMC7076728 | biostudies-literature
Project description:Long-term stability is crucial for the future application of perovskite solar cells, a promising low-cost photovoltaic technology that has rapidly advanced in the recent years. Here, we designed a nanostructured carbon layer to suppress the diffusion of ions/molecules within perovskite solar cells, an important degradation process in the device. Furthermore, this nanocarbon layer benefited the diffusion of electron charge carriers to enable a high-energy conversion efficiency. Finally, the efficiency on a perovskite solar cell with an aperture area of 1.02?cm2, after a thermal aging test at 85?°C for over 500?h, or light soaking for 1,000?h, was stable of over 15% during the entire test. The present diffusion engineering of ions/molecules and photo generated charges paves a way to realizing long-term stable and highly efficient perovskite solar cells.
| S-EPMC5472713 | biostudies-other
Project description:Perovskite solar cells (PSCs) have been propelled into the limelight over the past decade due to the rapid-growing power conversion efficiency (PCE). However, the internal defects and the interfacial energy level mismatch are detrimental to the device performance and stability. In this study, it is demonstrated that a small amount of indium (In3+ ) ions in mixed cation and halide perovskites can effectively passivate the defects, improve the energy-level alignment, and reduce the exciton binding energy. Additionally, it is confirmed that In3+ ions can significantly elevate the initial carrier temperature, slow down the hot-carrier cooling rate, and reduce the heat loss before carrier extraction. The device with 1.5% of incorporated In3+ achieves a PCE of 22.4% with a negligible hysteresis, which is significantly higher than that of undoped PSCs (20.3%). In addition, the unencapsulated PSCs achieve long-term stability, which retain 85% of the original PCE after 3,000 h of aging in dry air. The obtained results demonstrate and promote the development of practical, highly efficient, and stable hot-carrier-enhanced PSCs.
| S-EPMC9008790 | biostudies-literature
Project description:Molecular passivation is a prominent approach for improving the performance and operation stability of halide perovskite solar cells (HPSCs). Herein, we reveal discernible effects of diammonium molecules with either an aryl or alkyl core onto Methylammonium-free perovskites. Piperazine dihydriodide (PZDI), characterized by an alkyl core-electron cloud-rich-NH terminal, proves effective in mitigating surface and bulk defects and modifying surface chemistry or interfacial energy band, ultimately leading to improved carrier extraction. Benefiting from superior PZDI passivation, the device achieves an impressive efficiency of 23.17% (area ~1 cm2) (low open circuit voltage deficit ~0.327 V) along with superior operational stability. We achieve a certified efficiency of ~21.47% (area ~1.024 cm2) for inverted HPSC. PZDI strengthens adhesion to the perovskite via -NH2I and Mulliken charge distribution. Device analysis corroborates that stronger bonding interaction attenuates the defect densities and suppresses ion migration. This work underscores the crucial role of bifunctional molecules with stronger surface adsorption in defect mitigation, setting the stage for the design of charge-regulated molecular passivation to enhance the performance and stability of HPSC.
| S-EPMC10824754 | biostudies-literature
Project description:CsPbBr3 quantum dots (QDs) are promising candidates for optoelectronic devices. The substitution of oleic acid (OA) and oleylamine (OLA) capping agents with a quaternary alkylammonium such as di-dodecyl dimethyl ammonium bromide (DDAB) has shown an increase in external quantum efficiency (EQE) from 0.19% (OA/OLA) to 13.4% (DDAB) in LED devices. The device performance significantly depends on both the diffusion length and the mobility of photoexcited charge carriers in QD solids. Therefore, we investigated the charge carrier transport dynamics in DDAB-capped CsPbBr3 QD solids by constructing a bi-sized QD mixture film. Charge carrier diffusion can be monitored by quantitatively varying the ratio between two sizes of QDs, which varies the mean free path of the carriers in each QD cluster. Excited-state dynamics of the QD solids obtained from ultrafast transient absorption spectroscopy reveals that the photogenerated electrons and holes are difficult to diffuse among small-sized QDs (4 nm) due to the strong quantum confinement. On the other hand, both photoinduced electrons and holes in large-sized QDs (10 nm) would diffuse toward the interface with the small-sized QDs, followed by a recombination process. Combining the carrier diffusion study with a Monte Carlo simulation on the QD assembly in the mixture films, we can calculate the diffusion lengths of charge carriers to be ∼239 ± 16 nm in 10 nm CsPbBr3 QDs and the mobility values of electrons and holes to be 2.1 (± 0.1) and 0.69 (± 0.03) cm2/V s, respectively. Both parameters indicate an efficient charge carrier transport in DDAB-capped QD films, which rationalized the perfect performance of their LED device application.
| S-EPMC8461607 | biostudies-literature
Project description:Double perovskites, comprising two different cations, are potential nontoxic alternatives to lead halide perovskites. Here, we characterized thin films and crystals of Cs2AgBiBr6 by time-resolved microwave conductance (TRMC), which probes formation and decay of mobile charges upon pulsed irradiation. Optical excitation of films results in the formation of charges with a yield times mobility product, ??? > 1 cm2/Vs. On excitation of millimeter-sized crystals, the TRMC signals show, apart from a fast decay, a long-lived tail. Interestingly, this tail is dominant when exciting close to the bandgap, implying the presence of mobile charges with microsecond lifetimes. From the temperature and intensity dependence of the TRMC signals, we deduce a shallow trap state density of around 1016/cm3 in the bulk of the crystal. Despite this high concentration, trap-assisted recombination of charges in the bulk appears to be slow, which is promising for photovoltaic applications.
| S-EPMC5846080 | biostudies-literature
Project description: Not available
| S-EPMC10672245 | biostudies-literature
Project description:It is a challenge to extract the energy sensitivity of charge carriers' transport and scattering from experimental data, although a theoretical estimation in which the existing scattering mechanism(s) are preliminarily assumed can be easily done. To tackle this problem, we have developed a method to experimentally determine the energy sensitivities, which can then serve as an important statistical measurement to further understand the collective behaviors of multi-carrier transport systems. This method is validated using a graphene system at different temperatures. Further, we demonstrate the application of this method to other two-dimensional (2D) materials as a guide for future experimental work on the optimization of materials performance for electronic components, Peltier coolers, thermoelectricity generators, thermocouples, thermopiles, electrical converters and other conductivity and/or Seebeck-effect-related sensors.
| S-EPMC6045660 | biostudies-literature
Project description:Besides further improvement in the power conversion efficiency (PCE) of perovskite solar cells (PSC), their long-term stability must also be ensured. Additives such as organic cations with halide counter anions are considered promising candidates to address this challenge, conferring both higher performance and increased stability to perovskite-based devices. Here, a stabilizing additive (N,N-dimethylmethyleneiminium chloride, [Dmmim]Cl) is identified, and its effect on charge carrier mobility and lifetime under thermal stress in triple cation perovskite (Cs0.05 MA0.05 FA0.90 PbI3 ) thin films is investigated. To explore the fundamental mechanisms limiting charge carrier mobility, temperature-dependent microwave conductivity measurements are performed. Different mobility behaviors across two temperature regions are revealed, following the power law Tm , indicating two different dominant scattering mechanisms. The low-temperature region is assigned to charge carrier scattering with polar optical phonons, while a strong decrease in mobility at high temperatures is due to dynamic disorder. The results obtained rationalize the improved stability of the [Dmmim]Cl-doped films and devices compared to the undoped reference samples, by limiting temperature-activated mobile ions and retarding degradation of the perovskite film.
| S-EPMC10700180 | biostudies-literature