Solid-State NMR and Raman Spectroscopic Investigation of Fluoride-Substituted Apatites Obtained in Various Thermal Conditions.
Ontology highlight
ABSTRACT:
SUBMITTER: Pajchel L
PROVIDER: S-EPMC8624616 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Solid-state (magic-angle spinning) NMR spectroscopy is a useful tool for obtaining structural information on bone organic and mineral components and synthetic model minerals at the atomic-level. Raman and 31P NMR spectral parameters were investigated in a series of synthetic B-type carbonated apatites (CAps). Inverse 31P NMR linewidth and inverse Raman PO43- ?1 bandwidth were both correlated with powder XRD c-axis crystallinity over the 0.3-10.3 wt% CO32- range investigated. Comparison with bone powder crystallinities showed agreement with values predicted by NMR and Raman calibration curves. Carbonate content was divided into two domains by the 31P NMR chemical shift frequency and the Raman phosphate ?1 band position. These parameters remain stable except for an abrupt transition at 6.5 wt% carbonate, a composition which corresponds to an average of one carbonate per unit cell. This near-binary distribution of spectroscopic properties was also found in AFM-measured particle sizes and Ca/P molar ratios by elemental analysis. We propose that this transition differentiates between two charge-balancing ion-loss mechanisms as measured by Ca/P ratios. These results define a criterion for spectroscopic characterization of B-type carbonate substitution in apatitic minerals.
| S-EPMC3835554 | biostudies-literature
Project description:A series of nanocrystalline calcium hydroxyapatites was prepared by dry milling and characterized using proton and 31P MAS NMR, TEM, and TGA methods. The samples contained stubby rod-shaped crystals, which length and width varied in the 130-30 and 95-20 nm ranges, respectively. It was confirmed that concentration of structural hydroxyl groups in nanocrystalline apatites decreases with the decreasing crystal size. In the series of the studied apatites, the decrease was from 86 to ca. 50 % in reference to stoichiometric apatite. Water was found in the surface hydrated layer and in the c-axis channels, in which compartments existed as adsorbed and structural, respectively. Molecules of the adsorbed water were capable of moving from the crystal surface into the lattice c-axis channels of apatite. This process introduced considerable structural disorder within and around those channels and reduced the content of the structural hydroxyl groups, particularly in the region underneath the apatite crystal surface.
| S-EPMC3751289 | biostudies-literature
Project description:Ionic liquid crystals (ILCs) present a new class of non-molecular soft materials with a unique combination of high ionic conductivity and anisotropy of physicochemical properties. Symmetrically-substituted long-chain imidazolium-based mesogenic ionic liquids exhibiting a smectic liquid crystalline phase were investigated by solid state NMR spectroscopy and computational methods. The aim of the study was to reveal the correlation between cation size and structure, local dynamics, and orientational order in the layered mesophase. The obtained experimental data are consistent with the model of a rod-shaped cation with the two chains aligned in opposite directions outward from the imidazolium core. The alignment of the core plane to the phase director and the restricted conformations of the chain segments were determined and compared to those in single-chain counterparts. The orientational order parameter S~0.5-0.6 of double-chain ionic liquid crystals is higher than that of corresponding single-chain analogues. This is compatible with the enhanced contribution of van der Waals forces to the stabilization of smectic layers. Increased orientational order for the material with Br- counterions, which exhibit a smaller ionic radius and higher ability to form hydrogen bonds as compared to that of BF4-, also indicated a non-negligible influence of electrostatic and hydrogen bonding interactions. The enhanced rod-shape character and higher orientational order of symmetrically-substituted ILCs can offer additional opportunities in the design of self-assembling non-molecular materials.
| S-EPMC7404116 | biostudies-literature
Project description:Solid-state nuclear magnetic resonance (ssNMR) methods can probe the motions of membrane proteins in liposomes at the atomic level and propel the understanding of biomolecular processes for which static structures cannot provide a satisfactory description. In this work, we report our study on the fluoride channel Fluc-Ec1 in phospholipid bilayers based on ssNMR and molecular dynamics simulations. Previously unidentified fluoride binding sites in the aqueous vestibules were experimentally verified by 19F-detected ssNMR. One of the two fluoride binding sites in the polar track was identified as a water molecule by 1H-detected ssNMR. Meanwhile, a dynamic hotspot at loop 1 was observed by comparing the spectra of wild-type Fluc-Ec1 in variant buffer conditions or with its mutants. Therefore, we propose that fluoride conduction in the Fluc channel occurs via a "water-mediated knock-on" permeation mechanism and that loop 1 is a key molecular determinant for channel gating.
| S-EPMC10446490 | biostudies-literature
Project description:Bone infections are a key health challenge with dramatic consequences for affected patients. In dentistry, periodontitis is a medically compromised condition for efficient dental care and bone grafting, the success of which depends on whether the surgical site is infected or not. Present treatments involve antibiotics associated with massive bacterial resistance effects, urging for the development of alternative antibacterial strategies. In this work, we established a safe-by-design bone substitute approach by combining bone-like apatite to peroxide ions close to natural in vivo oxygenated species aimed at fighting pathogens. In parallel, bone-like apatites doped with Ag+ or co-doped Ag+/peroxide were also prepared for comparative purposes. The compounds were thoroughly characterized by chemical titrations, FTIR, XRD, SEM, and EDX analyses. All doped apatites demonstrated significant antibacterial properties toward four major pathogenic bacteria involved in periodontitis and bone infection, namely Porphyromonas gingivalis (P. gingivalis), Aggregatibacter actinomycetemcomitans (A. actinomycetemcomitans), Fusobacterium nucleatum (F. nucleatum), and S. aureus. By way of complementary tests to assess protein adsorption, osteoblast cell adhesion, viability and IC50 values, the samples were also shown to be highly biocompatible. In particular, peroxidated apatite was the safest material tested, with the lowest IC50 value toward osteoblast cells. We then demonstrated the possibility to associate such doped apatites with two biocompatible polymers, namely gelatin and poly(lactic-co-glycolic) acid PLGA, to prepare, respectively, composite 2D membranes and 3D scaffolds. The spatial distribution of the apatite particles and polymers was scrutinized by SEM and µCT analyses, and their relevance to the field of bone regeneration was underlined. Such bio-inspired antibacterial apatite compounds, whether pure or associated with (bio)polymers are thus promising candidates in dentistry and orthopedics while providing an alternative to antibiotherapy.
| S-EPMC9503752 | biostudies-literature
Project description:Estrogens are a group of steroid compounds found in the human body that are eventually discharged and ultimately end up in sewer effluents. Since these compounds can potentially affect the endocrine system its detection and quantification in sewer water is important. In this study, estrogens such as estrone (E1), estradiol (E2), estriol (E3), and ethynylestradiol (EE2) were discriminated and quantitated using Raman spectroscopy. Simulated Raman spectra were correlated with experimental data to identify unique marker peaks, which proved to be useful in differentiating each estrogen molecules. Among these marker peaks are Raman modes arising from hydroxyl groups of the estrogen molecules in the spectral region 3200-3700 cm-1. Other Raman modes unique to each of the estrogen samples were also identified, including peaks at 1722 cm-1 for E1 and 2109 cm-1 for EE2, which corresponds to their distinctive structures each containing a different set of functional groups. To quantify the components of estrogen mixtures, the intensities of each identifying Raman bands, at 581 cm-1 for E1, 546 cm-1 for E2, 762 cm-1 for E3 and 597 cm-1 for EE2, were compared and normalized against the intensity of a common peak at 783 cm-1. Quantitative analysis yielded most results within an acceptable 20% error.
| S-EPMC6201238 | biostudies-literature
Project description:Cu(II)(phthalocyanine) (CuPc) is broadly utilized as an archetypal molecular semiconductor and is the most widely used blue printing pigment. CuPc crystallizes in six different forms; the chemical and physical properties are substantially modulated by its molecular packing among these polymorphs. Despite the growing importance of this system, spectroscopic identification of different polymorphs for CuPc has posed difficulties. This study presents the first example of spectroscopic distinction of alpha- and beta-forms of CuPc, the most widely used polymorphs, by solid-state NMR (SSNMR) and Raman spectroscopy. (13)C high-resolution SSNMR spectra of alpha- and beta-CuPc using very-fast magic angle spinning (VFMAS) at 20 kHz show that hyperfine shifts sensitively reflect polymorphs of CuPc. The experimental results were confirmed by ab initio chemical shift calculations. (13)C and (1)H SSNMR relaxation times of alpha- and beta-CuPc under VFMAS also showed marked differences, presumably because of the difference in electronic spin correlation times in the two forms. Raman spectroscopy also provided another reliable method of differentiation between the two polymorphs.
| S-EPMC2854081 | biostudies-literature
Project description:Objective:The aim of this study was to determine the concentration of fluoride ions present in various solvent solutions and compare it to the label amount of fluoride concentration. Material and methods:The gel containing amine fluoride and sodium fluoride was compared to gel containing sodium fluoride only. The solvents used in this study were distilled water, redistilled water, tap water, 0.9% sodium chloride solution and the artificial saliva. The amount of fluoride ion (F-) was determined by the use of fluoride ion-selective electrode. The ANOVA and the Post hoc Tukey's test were used. The significance level was ? = 5%. Results:The differences between F- ion release in various solvents were statistically significant (p < 0.05). The F- ion concentrations measured in both gels' redistilled water solutions were higher than the label concentration. There was a significant difference in fluoride ion release in sodium fluoride only gel solutions. Fluoride ion release was significantly different in combined fluoride gel solutions. Conclusions:Amine fluorides do not interact with other ions present in the solution, whereas F- ion release from sodium fluoride alters when other ions are dissolved in the same solution. Amine fluorides deliver F- ions for caries prevention more efficiently.
| S-EPMC7362733 | biostudies-literature
Project description:The application of dinaphthothienothiophene (DNTT) molecules, a novel organic semiconductor material, has recently increased due to its high charge carrier mobility and thermal stability. Since the structural properties of DNTT molecules, such as the molecular density distribution and molecular orientations, significantly affect their charge carrier mobility in organic field-effect transistors devices, investigating these properties would be important. Here, we report Raman spectroscopic studies on DNTT in a transistor device, which was further analyzed by the density functional theory. We also show a perspective of this technique for orientation analysis of DNTT molecules within a transistor device.
| S-EPMC6416593 | biostudies-literature
Project description:Carbonates are ubiquitous minerals carrying important information on aqueous environments where they precipitated on the Earth and space. While their ideal chemical formulae are denoted as simple as MCO3 or M1M2(CO3)2 (M: metal cations), natural carbonates generally form solid-solution series and their compositions deviate from the ideal formulae. Since their cation composition due to the substitution provides a sensitive indicator for chemical and thermodynamic environments of aqueous solutions where they precipitated, their composition analysis has been widely carried out from the environmental/geochemical/astrochemical aspects. However, in widely used back-scattered electron and energy dispersion X-Ray analyses, samples should be generally sliced and/or their surface be polished prior to the measurements. For analyzing rare samples with small sizes, such as ones sampled from deep-sea and/or meteorites and asteroids, a non-destructive method without any pretreatments has been strongly desired. Here, a novel analytical method for discriminating various carbonates with Raman micro-spectroscopy is demonstrated, showing that the biaxial plot of the peak frequencies of their lattice modes linearly moves upon partial substitution of the cations. The cation substitution leads to linear movement in the biaxial map, and the slopes of the movement were different for Mg2+-Fe2+ and Mn2+-Fe2+ substitutions. This finding suggests that the micro-Raman analysis would be a non-destructive analytical method for evaluating the relative amount of Mg2+, Fe2+, and Mn2+ in dolomite-ankerite-kutnohorite solid-solution series, as well as Mg2+/Fe2+ ratio for magnesite-breunnerite-siderite. It would be helpful for analyzing the present and past terrestrial and cosmochemical environments.
| S-EPMC9206923 | biostudies-literature