Electrochemical oxidation of ferricyanide.
Ontology highlight
ABSTRACT:
SUBMITTER: Cheah MH
PROVIDER: S-EPMC8629995 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Stopped-flow kinetics were made of the reaction between ascorbate-reduced Pseudomonas cytochrome oxidase and potassium ferricyanide under both N2 and CO atmospheres. Under N2 three kinetic processes were observed, two being dependent on ferricyanide concentration, with second-order rate constants of 9.6 X 10(4)M-1.s-1 and 1.5 X 10(4)M-1.s-1, whereas the other was concentration-independent, with a first-order rate constant of 0.17 +/- 0.03s-1. Measurements of their kinetic difference spectra have allowed the fastest and second-fastest phases of the reaction to be assigned to direct bimolecular reactions of ferricyanide with the haem c and haem d, moieties of the enzyme respectively. Under CO, the second-order rate constant for the reaction of the haem c was, at 1.3 X 10(5)M-1.s-1, slightly enhanced over the rate in a N2 atmosphere, but the reaction velocity of the haem d1 component was greatly decreased, being apparently limited to that of the rates of CO dissociation from the molecule (0.15s-1 and 0.03s-1). The results are compared with those obtained during a previous study of the reaction of reduced Pseudomonas cytochrome oxidase with oxidized azurin.
| S-EPMC1185823 | biostudies-other
Project description:Potassium ferricyanide (PF), routinely employed for the oxidation of sterically-hindered hydroxylamines to nitroxides, is considered to be chemically inert towards the latter. In the present study, we report on an unexpected oxidative fragmentation of the imidazolidine nitroxides containing hydrogen atom in the 4-position of the heterocycle (HIMD) by PF resulting in the loss of the EPR signal. The mechanistic EPR, spectrophotometric, electrochemical and HPLC-MS studies support the assumption that the HIMD fragmentation is facilitated by the proton abstraction from the 4-position of the oxoammonium cation formed as a result of the initial one-electron HIMD oxidation. Increase in steric hindrance around the radical fragment by introducing ethyl substituents decreased the rate of ascorbate-induced HIMD reduction by more than 20 times, but did not affect the rate of ferricyanide-induced HIMD oxidation. This preferential sensitivity of HIMDs to oxidative processes has been used to detect peroxyl radicals in the presence of high concentration of the reducing agent, ascorbate. HIMD-based EPR probes capable to discriminate oxidative and reductive processes might find application in biomedicine and related fields for monitoring the oxidative stress and reactive radical species in biological systems.
| S-EPMC3971654 | biostudies-literature
Project description:Recently, it has been great efforts to synthesize an efficient water-oxidizing catalyst. However, to find the true catalyst in the harsh conditions of the water-oxidation reaction is an open area in science. Herein, we showed that corrosion of some simple manganese salts, MnCO3, MnWO4, Mn3(PO4)2?·?3H2O, and Mn(VO3)2?·?xH2O, under the water-electrolysis conditions at pH?=?6.3, gives an amorphous manganese oxide. This conversion was studied with X-ray absorption spectroscopy (XAS), as well as, scanning electron microscopy (SEM), Energy-dispersive X-ray spectroscopy (EDXS), transmission electron microscopy (TEM), X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), spectroelectrochemistry and electrochemistry methods. When using as a water-oxidizing catalyst, such results are important to display that long-term water oxidation can change the nature of the manganese salts.
| S-EPMC6533286 | biostudies-literature
Project description:Fully inactivating SARS-CoV-2, the virus causing coronavirus disease 2019, is of key importance for interrupting virus transmission but is currently performed by using biologically or environmentally hazardous disinfectants. Herein, we report an eco-friendly and efficient electrochemical strategy for inactivating the SARS-CoV-2 using in-situ formed nickel oxide hydroxide as anode catalyst and sodium carbonate as electrolyte. At a voltage of 5 V, the SARS-CoV-2 viruses can be rapidly inactivated with disinfection efficiency reaching 95% in only 30 s and 99.99% in 5 min. Mass spectrometry analysis and theoretical calculations indicate that the reactive oxygen species generated on the anode can oxidize the peptide chains and induce cleavage of the peptide backbone of the receptor binding domain of the SARS-CoV-2 spike glycoprotein, and thereby disables the virus. This strategy provides a sustainable and highly efficient approach for the disinfection of the SARS-CoV-2 viruliferous aerosols and wastewater.
| S-EPMC7832140 | biostudies-literature
Project description:The electrocatalytic N2 oxidation reaction (NOR) using renewable electricity is a promising alternative to the industrial synthesis of nitrate from NH3 oxidation. However, breaking the triple bond in the nitrogen molecule is one of the most essential challenges in chemistry. In this work, we use density functional theory simulations to investigate the plausible reaction mechanisms of electrocatalytic NOR and its competition with oxygen evolution reaction (OER) at the atomic scale. We focus on the electrochemical conversion of inert N2 to active *NO during NOR. We propose formation of *N2O from *N2 and *O as the rate-determining step (RDS). Following the RDS, a microkinetic model is utilized to study the rate of NOR on metal oxides. Our results demonstrate that a lower activation energy is obtained when a catalyst binds *O weakly. We show that the reaction is extremely challenging but also that design strategies have been suggested to promote electrochemical NOR.
| S-EPMC9531249 | biostudies-literature
Project description:Energy storage systems are crucial in the deployment of renewable energies. As one of the most promising solutions, redox flow batteries (RFBs) are still hindered for practical applications by low energy density, high cost, and environmental concerns. To breakthrough the fundamental solubility limit that restricts boosting energy density of the cell, we here demonstrate a new RFB system employing polysulfide and high concentrated ferricyanide (up to 1.6 M) species as reactants. The RFB cell exhibits high cell performances with capacity retention of 96.9% after 1,500 cycles and low reactant cost of $32.47/kWh. Moreover, neutral aqueous electrolytes are environmentally benign and cost-effective. A cell stack is assembled and exhibits low capacity fade rate of 0.021% per cycle over 642 charging-discharging steps (spans 60 days). This neutral polysulfide/ferricyanide RFB technology with high safety, long-duration, low cost, and feasibility of scale-up is an innovative design for storing massive energy.
| S-EPMC8497995 | biostudies-literature
Project description:The gold π-acid activation under electrochemical conditions is achieved. While EAO allows easy access to gold(III) intermediates over alternative chemical oxidation under mild conditions, the reported examples so far are limited to coupling reactions due to the rapid AuIII reductive elimination. Using aryl hydrazine-HOTf salt as precursors, the π-activation reaction mode was realized through oxidation relay. Both alkene and alkyne di-functionalization were achieved with excellent functional group compatibility and regioselectivity, which extended the versatility and utility of electrochemical gold redox chemistry for future applications.
| S-EPMC10719393 | biostudies-literature
Project description:In this work, the degradation of hydroxychloroquine (HCQ) drug in aqueous solution by electrochemical advanced oxidation processes including electrochemical oxidation (EO) using boron doped diamond (BDD) and its combination with UV irradiation (photo-assisted electrochemical oxidation, PEO) and sonication (sono-assisted electrochemical oxidation, SEO) was investigated. EO using BDD anode achieved the complete depletion of HCQ from aqueous solutions in regardless of HCQ concentration, current density, and initial pH value. The decay of HCQ was more rapid than total organic carbon (TOC) indicating that the degradation of HCQ by EO using BDD anode involves successive steps leading to the formation of organic intermediates that end to mineralize. Furthermore, the results demonstrated the release chloride (Cl-) ions at the first stages of HCQ degradation. In addition, the organic nitrogen was converted mainly into NO3 - and NH4 + and small amounts of volatile nitrogen species (NH3 and NOx). Chromatography analysis confirmed the formation of 7-chloro-4-quinolinamine (CQLA), oxamic and oxalic acids as intermediates of HCQ degradation by EO using BDD anode. The combination of EO with UV irradiation or sonication enhances the kinetics and the efficacy of HCQ oxidation. PEO requires the lowest energy consumption (EC) of 63 kWh/m3 showing its cost-effectiveness. PEO has the potential to be an excellent alternative method for the treatment of wastewaters contaminated with HCQ drug and its derivatives.
| S-EPMC7363609 | biostudies-literature
Project description:The dehydrogenative aryl C-H/N-H cross-coupling is a powerful synthetic methodology to install nitrogen functionalities into aromatic compounds. Herein, we report an electrochemical oxidation induced intermolecular cross-coupling between aromatics and sulfonimides with high regioselectivity through N-radical addition pathway under external-oxidant-free and catalyst-free conditions. A wide variety of arenes, heteroarenes, alkenes and sulfonimides are applicable scaffolds in this transformation. In addition, aryl sulfonamides or amines (aniline derivatives) can be obtained through different deprotection process. The cyclic voltammetry mechanistic study indicates that the N-centered imidyl radicals are generated via proton-coupled electron transfer event jointly mediated by tetrabutylammonium acetate and anode oxidation process.
| S-EPMC6884519 | biostudies-literature
Project description:N-N-linked dimeric indole alkaloids represent an unexplored class of natural products for which chemical synthesis has no practical solution. To meet this challenge, an electrochemical oxidative dimerization method was developed, which was applied as the pivotal step of the first total synthesis of dixiamycin B. This method is also general for N-N dimerization of substituted carbazoles and β-carbolines, providing entry into seldom explored chemical space.
| S-EPMC4004216 | biostudies-literature