Dataset Information

Medially positioned plate in first metatarsophalangeal joint arthrodesis.

ABSTRACT:

Objective

The purpose of this study was to biomechanically compare the stability of first metatarsophalangeal (MTP1) joint arthrodesis with dorsally and medially positioned plates.

Methods

A physical model of the MTP1 joint consists of printed synthetic bones, a titanium locking plate and screws. In the experiments, samples with dorsally and medially positioned plates were subjected to loading of ground load character in a universal testing machine. Force-displacement relations and relative displacements of bones were recorded. The obtained results were used to validate the corresponding finite element models of the MTP1 joint. Nonlinear finite element simulations of the toe-off phase of gait were performed to determine the deformation and stress state in the MTP1 joint for two positions of the plate.

Results

In numerical simulations, the maximum displacement in the dorsal direction was noticed at the tip of the distal phalanx and was equal to 19.6 mm for the dorsal plate and 9.63 mm for the medial plate for a resultant force of 150 N. Lower relative bone displacements and smaller plastic deformation in the plate were observed in the model with the medial plate. Stress values were also smaller in the medially positioned plate and locking screws compared to fixation with the dorsal plate.

Conclusions

A medially positioned locking plate provides better stability of the MTP1 joint than a dorsally positioned plate due to greater vertical bending stiffness of the medial plate. Smaller relative bone displacements observed in fixation with the medial plate may be beneficial for the bone healing process. Moreover, lower stress values may decrease the risk of complications associated with hardware failure.

SUBMITTER: Witkowski W

PROVIDER: S-EPMC8635389 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Similar Datasets

Project description:BackgroundArthrodesis of the first metatarsophalangeal joint is the current treatment of choice for symptomatic advanced hallux rigidus and moderate-to-severe hallux valgus. There are different methods to perform arthrodesis, yet no consensus on the best approach. Therefore, this study aimed to determine the effects of preoperative and postoperative hallux valgus angle (HVA), joint preparation and fixation technique, and postoperative immobilization on the incidence of nonunion.MethodsA retrospective multicenter cohort study was performed that included 794 patients. Univariate and multiple logistic regression was conducted to determine associations between joint preparation, fixation techniques, postoperative immobilization, weightbearing, and pre- and postoperative HVA with nonunion.ResultsNonunion incidence was 15.2%, with 11.1% symptomatic and revised. Joint preparation using hand instruments (OR 3.75, CI 1.90-7.42) and convex/concave reamers (OR 2.80, CI 1.52-5.16) were associated with greater odds of a nonunion compared to planar cuts. Joint fixation with crossed screws was associated with greater odds of nonunion (OR 2.00, CI 1.11-3.42), as was greater preoperative HVA (OR 1.02, CI 1.00-1.03). However, the latter effect disappeared after inclusion of postoperative HVA in the model, with a small association identified between residual postoperative HVA and nonunion (OR 1.04, CI 1.01-1.08). Similarly, we found an association between odds of nonunion and higher body weight (OR 1.02, CI 1.01-1.04) but not of body mass index.ConclusionBased on our results, first metatarsophalangeal joint arthrodesis with planar cuts and fixation with a plate and interfragmentary screw is associated with the lowest odds of resulting in a nonunion. Higher body weight and greater preoperative HVA were associated with slight increase in rates of nonunion. It is crucial to properly correct the hallux valgus deformity during surgery.Level of evidenceLevel III, retrospective case control study.