Thermogravimetric analysis of the pyrolysis and combustion kinetics of surface dead combustibles in the Daxing'an Mountains.
Ontology highlight
ABSTRACT:
SUBMITTER: Shu Y
PROVIDER: S-EPMC8638970 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:In the present study, the pyrolysis behavior of Nigerian oil sands was investigated using thermogravimetric analysis. This was done with the aim of deriving kinetic models that can be relevant in the development of the natural resource. The effects of different heating rates (10, 20, and 30 °C/min) on oil sand pyrolysis were studied. The results of the study indicated that three regions comprising low-temperature oxidation, devolatilization, and high-temperature oxidation were obtained at all heating rates. The peak temperatures were observed to rise with an increasing heating rate, a phenomenon described as thermal hysteresis. Mineralogical analysis showed the presence of diffraction peaks corresponding to chlorite, quartz, aragonite, dolomite, calcite, and montmorillonite minerals and the notable absence of expandable clay minerals which are known to pose problems during tailing management and the aqueous bitumen extraction process. The kinetic analysis showed that the activation energy increased with the degree of conversion, with the highest activation energy of 14.682 kJ mol-1. The Coats-Redfern kinetic model gave the best model fit for oil sand pyrolysis.
| S-EPMC10034983 | biostudies-literature
Project description:In order to explore the influence of different chemical demineralizations on coal combustion characteristics and combustion kinetics, five coals subjected to different chemical demineralization processes were investigated via thermogravimetric analysis. The ash contents of clean coal was reduced to 0.1-1.55% after different chemical demineralizations. The ignition temperature of coal decreased by 12-69 °C, and the peak temperature decreased by 7-62 °C. The burnout temperature of clean coal increased by 63 °C after demineralization by NaOH. The adsorption of noncombustible NaOH into the porous structure of TaiXi-3 caused an increase in burnout temperature. Alkali-soluble minerals were proven to have a negative effect on the combustion performance of coal, while acid-soluble minerals had the opposite effect. The combustion kinetics of five kinds of coals at a heating rate of 10 °C/min was investigated. The activation energy of coal obviously changes before and after demineralization (58.39-91.39 kJ mol-1). The activation energy of clean coal is obviously lower than that of raw coal.
| S-EPMC9089369 | biostudies-literature
Project description:This paper presents the catalytic pyrolysis of a constant-composition mixture of zeolite β and polyethylene terephthalate (PET) polymer by thermogravimetric analysis (TGA) at different heating rates (2, 5, 10, and 20 K/min). The thermograms showed only one main reaction and shifted to higher temperatures with increasing heating rate. In addition, at constant heating rate, they moved to lower temperatures of pure PET pyrolysis when a catalyst was added. Four isoconversional models, namely, Kissinger–Akahira–Sunose (KAS), Friedman, Flynn–Wall–Qzawa (FWO), and Starink, were applied to obtain the activation energy (Ea). Values of Ea acquired by these models were very close to each other with average value of Ea = 154.0 kJ/mol, which was much lower than that for pure PET pyrolysis. The Coats–Redfern and Criado methods were employed to set the most convenient solid-state reaction mechanism. These methods revealed that the experimental data matched those obtained by different mechanisms depending on the heating rate. Values of Ea obtained by these two models were within the average values of 157 kJ/mol. An artificial neural network (ANN) was utilized to predict the remaining weight fraction using two input variables (temperature and heating rate). The results proved that ANN could predict the experimental value very efficiently (R2 > 0.999) even with new data.
| S-EPMC9824759 | biostudies-literature
Project description:The influence of particle size (0.3 and 5.0 mm) and heating rate (5, 10, and 20 °C min-1) on the kinetic parameters of pyrolysis of waste tire was studied by thermogravimetric analysis and mathematical modeling. Kinetic parameters were determined using the Friedman model, the Coats-Redfern model, and the ASTM E1641 standard based on Arrhenius linearization. In the Friedman model, the activation energy was between 40 and 117 kJ mol-1 for a particle size of 0.3 mm and between 23 and 119 kJ mol-1 for a particle size of 5.0 mm. In the Coats-Redfern model, the activation energy is in a range of 46 to 87 kJ mol-1 for a particle size of 0.3 mm and in a range of 43 to 124 kJ mol-1 for a particle size of 5.0 mm. Finally, in the ASTM E1641 standard, the activation energy calculated was between 56 and 60 kJ mol-1 for both particle sizes. This study was performed to obtain kinetic parameters from different mathematical methods, examining how the particle size and heating rate influence them.
| S-EPMC9118263 | biostudies-literature
Project description:Coal gangue has the shortcomings of low calorific value and refractory burnout, while polyvinyl chloride has the advantages of a long combustion process and high calorific value. In order to make up for these shortcomings of coal gangue, the possibility of a treatment method based on co-combustion of coal gangue with polyvinyl chloride, which can be centrally recovered from municipal solid waste, is proposed. In order to analyze the combustion effect of a mixture of these two substances, experimental samples were prepared by mixing these two substances in three different ratios, and they were tested by thermogravimetric analysis. The experimental results were compared, analyzed and evaluated. The effects of the proportion of polyvinyl chloride in the mixture on the temperature parameters, activation energy, and interaction during co-combustion were analyzed. In order to analyze the interaction during co-combustion of the two, a coupling analysis method for mixed combustion is presented, and the effectiveness of this method is verified by comparing with the correlation analysis results of co-combustion. The results show that co-combustion can mitigate the ignition difficulty and burnout of coal gangue. When the proportion of polyvinyl chloride in the mixture was increased from 20% to 80%, the maximum weightlessness rate of the first stage rapidly increased from 4.5%/min to 15.6%/min; however, that of the second stage slowly increased from 3.7%/min to 4.2%/min. A 20% proportion of polyvinyl chloride showed the most significant promotion of co-combustion, with a maximum coupling coefficient of 0.00318, which was 1.11 and 1.35 times greater than that of 50% and 80% proportions, respectively. Co-combustion can reduce the activation energy of coal gangue during the initial and end stages. Therefore, co-combustion is helpful to improve the problems of low calorific value and refractory burnout of coal gangue.
| S-EPMC6816570 | biostudies-literature
Project description:In general, the greater the number of directly linked nitrogen atoms in a molecule, the better its energetic performance, while the stability will be accordingly lower. But 1,1'-azobis-1,2,3-triazole (1) and 4,4'-azobis-1,2,4-triazole (2) show remarkable properties, such as high enthalpies of formation, high melting points, and relatively high stabilities. In order to rationalize this unexpected behavior of the two compounds, it is necessary to study their thermal decompositions and pyrolyses. Although a great deal of research has been focused on the synthesis and characterization of energetic materials with 1 and 2 as the backbone, a complete report on their fundamental thermodynamic parameters and thermal decomposition properties has not been published.Thermogravimetric-differential scanning calorimetry were used to obtain the thermal decomposition data of the title compounds. Kissinger and Ozawa-Doyle methods, the two selected non-isothermal methods, are presented for analysis of the solid-state kinetic data. Pyrolysis-gas chromatography/mass spectrometry was used to study the pyrolysis process of the title compounds.The DSC curves show that the thermal decompositions of 1 and 2 are at different heating rates involved a single exothermic process. The TG curves provide insight into the total weight losses from the compounds associated with this process. At different pyrolysis temperatures, the compositions and types of the pyrolysis products differ greatly and the pyrolysis reaction at 500 °C is more thorough than 400 °C.Apparent activation energies (E) and pre-exponential factors (lnA/s-1) are 291.4 kJ mol-1 and 75.53 for 1; 396.2 kJ mol-1 and 80.98 for 2 (Kissinger). The values of E are 284.5 kJ mol-1 for 1 and 386.1 kJ mol-1 for 2 (Ozawa-Doyle). The critical temperature of thermal explosion (T b ) is evaluated as 187.01 °C for 1 and 282.78 °C for 2. The title compounds were broken into small fragment ions under the pyrolysis conditions, which then might undergo a multitude of collisions and numerous other reactions, resulting in the formation of C2N2 (m/z 52), etc., before being analyzed by the GC/MS system.
| S-EPMC5833888 | biostudies-other
Project description:The pyrolysis characteristics of land biomass (corn stalks (Cs), pine sawdust (Ps)) and coastal zone biomass (Jerusalem artichoke stalks (JAs) and reed (Re)) were investigated based on thermogravimetric analysis (TGA) and products' analysis. The kinetic parameters were obtained by three isoconversional methods (Friedman, KAS, and FWO) and one model-fitting method (DAEM). The simultaneous effect of high temperature (700-900 °C) and high heating rate (1000 °C/s) on the pyrolysis product simulating the typical conditions of a fluidized bed gasifier was studied. TGA showed that high heating rates deepen the thermal cracking process of biomass. Compared with the land biomass, the initial decomposition temperature (T i ) of the coastal biomass is reduced significantly owing to its higher proportion of hemicellulose. These methods agree with the trends shown by the activation energy (E a) distribution calculated, with fluctuations between 160 and 350 kJ/mol. The mean value activation energies of Re and JAs were higher than those of Cs and Ps between 10% and 90% conversion. The DAEM model showed that Cs and JAs have a good linear relationship between ln A and E α during the main pyrolysis stage, while Ps and Re are relatively weaker. The kinetic compensation effect was evident for Cs and JAs during the main thermal cracking stage. Py-GC-MS results confirmed that phenols, hydrocarbons, PAHs, and oxygen heterocycle compounds were strongly present in the released volatile products. High-temperature fast pyrolysis of JAs produced a larger amount of PAH compounds than from Cs, Ps, and Re. A larger amount of hydrocarbons and phenols was generated from high-temperature fast pyrolysis of Ps. Some oxygen-containing volatiles are easily converted into aromatic products with higher stability under high temperature.
| S-EPMC8973058 | biostudies-literature
Project description:A novel approach involving thermo-gravimetricanalysis (TGA) for the quantification of citrate ions present on the surface of gold nanoparticles has been reported. TGA study was carried out on AuNPs in response to parameters such as concentration of tri-sodium citrate and pH of gold nanoparticles depicting that the number of citrate ion present on gold nanoparticles is highly pH dependent. In general, the citrate ions were observed to be higher in alkaline conditions contradicting earlier beliefs. These results also underline the significance of TGA as a novel tool for quantification of citrate molecules present on gold nanoparticle surface. Thus, the present approach not only provides with an insight into mechanistic details of gold nanoparticle synthesis but also opens the usage of TGA for understanding the nano range association of molecules.
| S-EPMC7237423 | biostudies-literature
Project description:BackgroundDuring the biomass-to-bio-oil conversion process, many studies focus on studying the association between biomass and bio-products using near-infrared spectra (NIR) and chemical analysis methods. However, the characterization of biomass pyrolysis behaviors using thermogravimetric analysis (TGA) with support vector machine (SVM) algorithm has not been reported. In this study, tobacco was chosen as the object for biomass, because the cigarette smoke (including water, tar, and gases) released by tobacco pyrolysis reactions decides the sensory quality, which is similar to biomass as a renewable resource through the pyrolysis process.ResultsSVM algorithm has been employed to automatically classify the planting area and growing position of tobacco leaves using thermogravimetric analysis data as the information source for the first time. Eighty-eight single-grade tobacco samples belonging to four grades and eight categories were split into the training, validation, and blind testing sets. Our model showed excellent performances in both the training and validation set as well as in the blind test, with accuracy over 91.67%. Throughout the whole dataset of 88 samples, our model not only provides precise results on the planting area of tobacco leave, but also accurately distinguishes the major grades among the upper, lower, and middle positions. The error only occurs in the classification of subgrades of the middle position.ConclusionsFrom the case study of tobacco, our results validated the feasibility of using TGA with SVM algorithm as an objective and fast method for auto-classification of tobacco planting area and growing position. In view of the high similarity between tobacco and other biomasses in the compositions and pyrolysis behaviors, this new protocol, which couples the TGA data with SVM algorithm, can potentially be extrapolated to the auto-classification of other biomass types.
| S-EPMC8077845 | biostudies-literature
Project description:This work presents the results of thermogravimetric analysis of decantoil. The microstructure of the extracted petroleum coke during the thermolysis of decantoil in an inert nitrogen atmosphere at 1000 °C was studied by scanning electron microscopy and interpreted as acicular. The model free kinetic approach based on Friedman's isoconversion method was used to calculate the kinetic characteristics of decantoil thermolysis-activation energy and pre-exponential factor. The individual hydrocarbon composition of decantoil was determined by gas chromatography mass spectrometry, which was used to determine the activation energy of evaporation of its fractions. The total energy spent on the chemical reactions of cracking and thermopolycondensation was determined when the degree of decantoil conversion was changed from 0.1 to 0.9.
| S-EPMC7676338 | biostudies-literature