Thermodynamic Properties of the First-Generation Hybrid Dendrimer with "Carbosilane Core/Phenylene Shell" Structure.
Ontology highlight
ABSTRACT:
SUBMITTER: Sologubov SS
PROVIDER: S-EPMC8700160 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Epitaxial growth of a protective semiconductor shell on a colloidal quantum dot (QD) core is the key strategy for achieving high fluorescence quantum efficiency and essential stability for optoelectronic applications and biotagging with emissive QDs. Herein we investigate the effect of shell growth rate on the structure and optical properties in blue-emitting ZnSe/ZnS QDs with narrow emission line width. Tuning the precursor reactivity modifies the growth mode of ZnS shells on ZnSe cores transforming from kinetic (fast) to thermodynamic (slow) growth regimes. In the thermodynamic growth regime, enhanced fluorescence quantum yields and reduced on-off blinking are achieved. This high performance is ascribed to the effective avoidance of traps at the interface between the core and the shell, which are detrimental to the emission properties. Our study points to a general strategy to obtain high-quality core/shell QDs with enhanced optical properties through controlled reactivity yielding shell growth in the thermodynamic limit.
| S-EPMC7467768 | biostudies-literature
Project description:Development of highly efficient nanowire-based photovoltaic devices requires an accurate modeling of light scattering from interfaces and optical carrier generation inside the cell. A comprehensive study of optical absorption and carrier generation enables us to tap the full potential of nanowire arrays (NWAs). In this study, we have done a systematic study to optimize the core-shell structure of vertically aligned silicon nanowire (Si NW) arrays coated with PTB7:PC71BM by means of finite difference time domain optical simulations to maximize the photon absorption. Initially, the core thickness of hybrid Si NWs has been optimized for the most efficient light absorption. The further improvement of light absorption has been studied by varying the coating thickness of low-band gap organic polymer PTB7:PC71BM on Si NWAs. A delineative analysis shows that NWs with a 150 nm thick silicon core and 60 nm thick coating of PTB7:PC71BM exhibit broad band absorption and the optimum ideal current density of about 34.95 mA/cm2, which are larger than those of their planar counterpart with the same amount of absorbing material and also better than those previously reported for NWs. The basic principle and the physical process taking place during absorption and current generation have been also discussed. The optimization of the hybrid heterojunction Si NW arrays and understanding of their optical characteristics may contribute to the development of economical and highly efficient hybrid solar cells.
| S-EPMC6641530 | biostudies-literature
Project description:Benzocyclobutene-modified silsesquioxane (BCB-POSS) and divinyl tetramethyl disiloxane-bisbenzocyclobutene (DVS-BCB) prepolymer were introduced into the containing benzocyclobutene (BCB) unit matrix resin P(4-MB-co-1-MP) polymerized from 1-methyl-1-(4-benzocyclobutenyl) silacyclobutane (4-MSCBBCB) and 1-methyl-1-phenylsilacyclobutane (1-MPSCB), respectively. The low dielectric constant (low-k) siloxane/carbosilane hybrid benzocyclobutene resin composites, P(4-MB-co-1-MP)/BCB-POSS and P(4-MB-co-1-MP)/DVS-BCB, were prepared. The curing processes of the composites were assessed via Fourier-transform infrared spectroscopy (FTIR) and differential scanning calorimetry (DSC). The effects on dielectric properties and heat resistance of those composites with different proportion of BCB-POSS and DVS-BCB were investigated using an impedance analyzer and thermogravimetric analyzer (TGA), respectively. The thermal curing of composites could be carried out by ring-opening polymerization (ROP) of the BCB four-member rings of BCB-POSS or DVS-BCB and those of P(4-MB-co-1-MP). With increasing the proportion of BCB-POSS to 30%, the 5% weight loss temperature (T5%) of P(4-MB-co-1-MP)/BCB-POSS composites was raised visibly, whereas the dielectric constant (k) was decreased owing to the introduction of nanopores into POSS. For P(4-MB-co-1-MP)/DVS-BCB composites, the T5% and k were slightly raised with increasing the proportion of DVS-BCB. The above results indicated that the BCB-POSS showed advantages over conventional fillers to simultaneously improve thermostability and decrease k.
| S-EPMC8585461 | biostudies-literature
Project description:Well-defined nanocomposite structures have received significant attention due to their superior combinatorial properties. Rational tuning of the core and shell of the nanostructure(s) can offer potent antibacterial activity. Such advanced core-shell nanocomposite methodologies allow not only the incorporation of antibacterial agents on the shell but also provide its stability and nurture antibacterial activity. Herein, antibiotic zinc oxide-curcumin (ZnO-Cum) core-shell nanoparticles for antibacterial application were synthesised. The ZnO-Cum core-shell nanoparticles were prepared by curcumin nanolayer deposition on zinc oxide nanoparticles via a sonication process. The resulting ZnO-Cum core-shell nanoparticles were spiracle in shape with a ∼45 nm ZnO core and ∼12 nm curcumin shell layer size, respectively, determined by transmission electron microscopy. X-ray diffraction analysis confirmed the formation of a core-shell crystal structure. Additionally, UV-DRS and ATR-FTIR spectral analysis support the existence of ZnO and curcumin in a core-shell nanocomposite. The antibacterial activities of nanoparticles developed were studied against Staphylococcus aureus and Streptococcus pneumoniae and Escherichia coli and Shigella dysenteriae bacterial stains using the diffusion method. A greater inhibition of the growth of Gram positive and negative bacteria was noticed upon treatment with core-shell ZnO and curcumin nanoparticles than the commercial antibiotic amoxicillin which indicates their antibacterial property. The findings of this study provide evidence that the zinc oxide-curcumin core-shell nanoparticles may be highly promising for antibacterial and biomedical applications.
| S-EPMC6472438 | biostudies-literature
Project description:In recent years, various kinds of ZnO-based core@shell nanomaterials have been paid much attention due to their widespread applications in the fields of physics, chemistry and energy conversion. In this work, the electronic and optical properties of a new type of ZnO-based one-dimensional core@shell nanostructure, which is composed of inner ZnO nanowire and outer carbon nanotube (CNT), is calculated based on the first-principles density functional theory (DFT). Calculation results suggest that the ZnO nanowire encapsulated in (9, 9)-CNT is the most stable structure from the view of formation energy. The interaction between the inner ZnO nanowire and the outer (9, 9) CNT belongs to a weak van der Waals type. The complex structure is found to possess metallicity for the outer (9, 9) CNT and maintain the wide band gap nature for the inner ZnO nanowire. Under the different external strains, the charge redistribution between inner ZnO nanowire and outer CNT caused by electron tunneling leads to the shift of Dirac point and the band narrowing of inner ZnO nanowire. The inner ZnO nanowire only has light absorption in the UV region, which is consistent with its optical property originating from its wide bandgap nature.
| S-EPMC6194084 | biostudies-literature
Project description:Core/shell pigments allow for the combination of the active anti-corrosion effect of the shell and the barrier effect of the core. This makes it possible to obtain anti-corrosion pigments, with a high-protective effect and low toxicity. Thus, the need for a comprehensive study of the properties of these pigments grows more urgent, before their application to paints and varnishes. The hiding power of core/shell pigments comes close to the one of pure polyaniline (PANi), when the PANi content in the pigment reaches 50 wt.%, with sulfuric and phosphoric acids used as dopants. This paper, also, shows that the blackness value of core/shell pigments with 10 wt.% PANi is around 35 and constant; for pure PANi, their blackness value is 40. When PANi content is 5 wt.%, kaolin-based pigment shows the lowest blackness, which happens due to a generally higher whiteness of kaolin. However, when the PANi content surpasses 10 wt.%, there seems to be no influence on the blackness of the core/shell pigments. The core/shell pigment with a 20 wt.% PANi is, optically, identical to a black-iron-oxide pigment. An increase in the PANi content of the core/shell pigment leads to an increase in the oil absorption of the samples. It was found that the dispersion process would be the most energy efficient for core/shell pigments, containing kaolin and talc as a core.
| S-EPMC9144958 | biostudies-literature
Project description:We report a high-performance chemiresistive sensor for detection of volatile organic compound (VOC) vapors based on core-shell hybridized nanostructures of Fe3O4 magnetic nanoparticles (MNPs) and poly(3,4-ethylenedioxythiophene) (PEDOT)-conducting polymers. The MNPs were prepared using microwave-assisted synthesis in the presence of polymerized ionic liquids (PILs), which were used as a linker to couple the MNP and PEDOT. The resulting PEDOT-PIL-modified Fe3O4 hybrids were then explored as a sensing channel material for a chemiresistive sensor to detect VOC vapors. The PEDOT-PIL-modified Fe3O4 sensor exhibited a tunable response, with high sensitivity (down to a concentration of 1 ppm) and low noise level, to VOCs; these VOCs include acetone vapor, which is present in the exhaled breath of potential lung cancer patients. The present sensor, based on the hybrid nanostructured sensing materials, exhibited a 38.8% higher sensitivity and an 11% lower noise level than its PEDOT-PIL-only counterpart. This approach of embedding MNPs in conducting polymers could lead to the development of new electronic noses, which have significant potential for the use in the early diagnosis of lung cancer via the detection of VOC biomarkers.
| S-EPMC4559249 | biostudies-literature
Project description:The UNAIDS objective for 2020 was 500,000 new HIV-1 infections per year; however, the latest annual reported data confirmed 1.7 million new HIV-1 infections in that year. Those data evidences the need for new prevention strategies and prophylactic treatments. This prevention crisis occurred in spite of the knowledge and availability of efficient prevention strategies. The G2-S16 is a microbicidal polyanionic carbosilane dendrimer currently being tested for topical vaginal application, which has been shown to be efficient in the prevention of HIV-1 infection. However, safety tests were lacked. For this purpose, we injected intravenously G2-S16 dendrimer to CD1 mice, thereby analyzing the hemogram, blood biochemical markers of systemic damage, accumulation in the organs and organ-tissue damage in heart, spleen, kidney, liver and brain. This work shows that even if the G2-S16 dendrimer penetrates the epithelial tissue, it does not cause vaginal irritation or tissue damage. Moreover, the i.v. injection of the G2-S16 dendrimer did not cause a damaging effect on the studied organs and it did not modify the hemogram or the biochemical plasma markers. In conclusion, the G2-S16 dendrimer has a very good safety profile, indicating that this molecule can be a very safe and efficient vaginal microbicide.
| S-EPMC8910216 | biostudies-literature
Project description:Hybrid materials of electrically conducting polymers and inorganic semiconductors form an exciting class of functional materials. To fully exploit the potential synergies of the hybrid formation, however, sophisticated synthetic methods are required that allow for the fine-tuning of the nanoscale structure of the organic/inorganic interface. Here we present the photocatalytic deposition of a conducting polymer (polyaniline) on the surface of silicon carbide (SiC) nanoparticles. The polymerization is facilitated on the SiC surface, via the oxidation of the monomer molecules by ultraviolet-visible (UV-vis) light irradiation through the photogenerated holes. The synthesized core-shell nanostructures were characterized by UV-vis, Raman, and Fourier Transformed Infrared (FT-IR) Spectroscopy, thermogravimetric analysis, transmission and scanning electron microscopy, and electrochemical methods. It was found that the composition of the hybrids can be varied by simply changing the irradiation time. In addition, we proved the crucial importance of the irradiation wavelength in forming conductive polyaniline, instead of its overoxidized, insulating counterpart. Overall, we conclude that photocatalytic deposition is a promising and versatile approach for the synthesis of conducting polymers with controlled properties on semiconductor surfaces. The presented findings may trigger further studies using photocatalysis as a synthetic strategy to obtain nanoscale hybrid architectures of different semiconductors.
| S-EPMC5456665 | biostudies-other
Project description:Core-only InAs nanowires (NWs) remain of continuing interest for application in modern optical and electrical devices. In this paper, we utilize the II-VI semiconductor CdSe as a shell for III-V InAs NWs to protect the electron transport channel in the InAs core from surface effects. This unique material configuration offers both a small lattice mismatch between InAs and CdSe and a pronounced electronic confinement in the core with type-I band alignment at the interface between both materials. Under optimized growth conditions, a smooth interface between the core and shell is obtained. Atom probe tomography (APT) measurements confirm substantial diffusion of In into the shell, forming a remote n-type doping of CdSe. Moreover, field-effect transistors (FETs) are fabricated, and the electron transport characteristics in these devices is investigated. Finally, band structure simulations are performed and confirm the presence of an electron transport channel in the InAs core that, at higher gate voltages, extends into the CdSe shell region. These results provide a promising basis toward the application of hybrid III-V/II-VI core/shell nanowires in modern electronics.
| S-EPMC10910494 | biostudies-literature