Development of SSR Databases Available for Both NGS and Capillary Electrophoresis in Apple, Pear and Tea.
Ontology highlight
ABSTRACT:
SUBMITTER: Nishio S
PROVIDER: S-EPMC8703814 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Molecular identification and genetic analysis of cherry are necessary for solving the problem of synonyms and homonyms that occur in cherry production. In this study, capillary electrophoresis with fluorescent-labeled simple sequence repeat (SSR) primers was used to identify 63 cherry cultivars (varieties and rootstocks) planted in Shaanxi province, China. A total of 146 alleles were amplified by 10 SSR primer pairs, ranging from 10 to 20 per locus (mean: 14); among the SSR primer pairs, genotype number ranged from 12 to 26 (mean: 18). The mean values of gene diversity, heterozygosity, and polymorphism information content were 0.7549 (range 0.4011-0.8782), 0.5952 (range 0.3810-0.9683), and 0.7355 (range 0.3937-0.8697), respectively. An unweighted pair-group method with arithmetic average cluster analysis was used to separate the cherry cultivars. A model-based structure analysis separated the cultivars into three populations, which was consistent with the results of a phylogenic and principal component analysis. Based on Bayes' rule, the cultivars were further subdivided into seven populations. Some of the 63 cherry cultivars that are often confused in production were distinguished, and DNA fingerprinting of cherry cultivars was established. This research will significantly assist in the identification of cherry cultivars at the molecular level.
| S-EPMC5723578 | biostudies-other
Project description:BackgroundVirus-induced gene silencing (VIGS) is an effective technology for the analysis of gene functions in plants. Though there are many reports on virus vectors for VIGS in plants, no VIGS vectors available for Rosaceae fruit trees were reported so far. We present an effective VIGS system in apple, pear, and Japanese pear using Apple latent spherical virus (ALSV) vectors.ResultsInoculation of ALSV vectors carrying a partial sequence of endogenous genes from apple [ribulose-1, 5-bisphosphate carboxylase small subunit (rbcS), alpha subunit of chloroplast chaperonin (CPN60a), elongation factor 1 alpha (EF-1a), or actin] to the cotyledons of seeds by a particle bombardment induced highly uniform knock-down phenotypes of each gene on the true leaves of seedlings from 2~3 weeks after inoculation. These silencing phenotypes continued for several months. Northern blot and RT-PCR analyses of leaves infected with ALSV containing a fragment of rbcS gene showed that the levels of rbcS-mRNA drastically decreased in the infected apple and pear leaves, and, in reverse, rbcS-siRNAs were generated in the infected leaves. In addition, some of apple seedlings inoculated with ALSV vector carrying a partial sequence of a TERMINAL FLOWER 1 gene of apple (MdTFL1) showed precocious flowering which is expected as a knock-down phenotype of the silencing of MdTFL1 gene.ConclusionsThe ALSV-based VIGS system developed have provides a valuable new addition to the tool box for functional genomics in apple, pear, and Japanese pear.
| S-EPMC3123315 | biostudies-literature
Project description:The use of the novel CRISPR/Cas12a system is advantageous, as it expands the possibilities for genome editing (GE) applications due to its different features compared to the commonly used CRISPR/Cas9 system. In this work, the CRISPR/Cas12a system was applied for the first time to apple to investigate its general usability for GE applications. Efficient guide RNAs targeting different exons of the endogenous reporter gene MdPDS, whose disruption leads to the albino phenotype, were pre-selected by in vitro cleavage assays. A construct was transferred to apple encoding for a CRISPR/Cas12a system that simultaneously targets two loci in MdPDS. Using fluorescent PCR capillary electrophoresis and amplicon deep sequencing, all identified GE events of regenerated albino shoots were characterized as deletions. Large deletions between the two neighboring target sites were not observed. Furthermore, a chimeric composition of regenerates and shoots that exhibited multiple GE events was observed frequently. By comparing both analytical methods, it was shown that fluorescent PCR capillary gel electrophoresis is a sensitive high-throughput genotyping method that allows accurate predictions of the size and proportion of indel mutations for multiple loci simultaneously. Especially for species exhibiting high frequencies of chimerism, it can be recommended as a cost-effective method for efficient selection of homohistont GE lines.
| S-EPMC8619667 | biostudies-literature
Project description:A capillary zone electrophoresis-laser-induced fluorescence detection (CZE-LIF) method was developed for the simultaneous analysis of disaccharides derived from heparan sulfate, chondroitin sulfate/dermatan sulfate, hyaluronan, and keratan sulfate. Glycosaminoglycans (GAGs) were first depolymerized with the mixture of GAG lyases (heparinase I, II, III and chondroitinase ABC and chondroitinase AC II) and GAG endohydrolase (keratinase II) and the resulting disaccharides were derivatized by reductive amination with 2-aminoacridone. Nineteen fluorescently labeled disaccharides were separated using 50 mM phosphate buffer (pH 3.3) under reversed polarity at 25 kV. Using these conditions, all the disaccharides examined were baseline separated in less then 25 min. This CZE-LIF method gave good reproducibility for both migration time (?1.03% for intraday and ?4.4% for interday) and the peak area values (?5.6% for intra- and ?8.69% for interday). This CZE-LIF method was used for profiling and quantification of GAG derivative disaccharides in bovine cornea. The results show that the current CZE-LIF method offers fast, simple, sensitive, reproducible determination of disaccharides derived from total GAGs in a single run.
| S-EPMC4097815 | biostudies-literature
Project description:In capillary electrophoresis, sample ions migrate along a microcapillary filled with a background electrolyte under the influence of an applied electric field. If the sample concentration is sufficiently high, the electrical conductivity in the sample zone could differ significantly from the background. Under such conditions, the local migration velocity of sample ions becomes concentration-dependent, resulting in a nonlinear wave that exhibits shocklike features. If the nonlinearity is weak, the sample concentration profile, under certain simplifying assumptions, can be shown to obey Burgers' equation [Ghosal and Chen, Bull. Math. Biol. 72, 2047 (2010)], which has an exact analytical solution for arbitrary initial condition. In this paper, we use a numerical method to study the problem in the more general case where the sample concentration is not small in comparison to the concentration of background ions. In the case of low concentrations, the numerical results agree with the weakly nonlinear theory presented earlier, but at high concentrations, the wave evolves in a way that is qualitatively different.
| S-EPMC3458716 | biostudies-literature
Project description:Early stages of insulin aggregation, which involve the transient formation of oligomeric aggregates, are an important aspect in the progression of Type II diabetes and in the quality control of pharmaceutical insulin production. This study is the first to utilize capillary electrophoresis (CE) with ultraviolet (UV) detection to monitor insulin oligomer formation at pH 8.0 and physiological ionic strength. The lag time to formation of the first detected species in the aggregation process was evaluated by UV-CE and thioflavin T (ThT) binding for salt concentrations from 100 mM to 250 mM. UV-CE had a significantly shorter (5-8 h) lag time than ThT binding (15-19 h). In addition, the lag time to detection of the first aggregated species via UV-CE was unaffected by salt concentration, while a trend toward an increased lag time with increased salt concentration was observed with ThT binding. This result indicates that solution ionic strength impacts early stages of aggregation and ?-sheet aggregate formation differently. To observe whether CE may be applied for the analysis of biological samples containing low insulin concentrations, the limit of detection using UV and laser induced fluorescence (LIF) detection modes was determined. The limit of detection using LIF-CE, 48.4 pM, was lower than the physiological insulin concentration, verifying the utility of this technique for monitoring biological samples. LIF-CE was subsequently used to analyze the time course for fluorescein isothiocyanate (FITC)-labeled insulin oligomer formation. This study is the first to report that the FITC label prevented incorporation of insulin into oligomers, cautioning against the use of this fluorescent label as a tag for following early stages of insulin aggregation.
| S-EPMC3257135 | biostudies-literature
Project description:Compared to conventional bench-top instruments, microfluidic devices possess advantageous characteristics including great portability potential, reduced analysis time (minutes), and relatively inexpensive production, putting them on the forefront of modern analytical chemistry. Fabrication of these devices, however, often involves polymeric materials with less-than-ideal surface properties, specific instrumentation, and cumbersome fabrication procedures. In order to overcome such drawbacks, a new hybrid platform is proposed. The platform is centered on the use of 5 interconnecting microfluidic components that serve as the injector or reservoirs. These plastic units are interconnected using standard capillary tubing, enabling in-channel detection by a wide variety of standard techniques, including capacitively-coupled contactless conductivity detection (C4D). Due to the minimum impact on the separation efficiency, the plastic microfluidic components used for the experiments discussed herein were fabricated using an inexpensive engraving tool and standard Plexiglas. The presented approach (named 52-platform) offers a previously unseen versatility: enabling the assembly of the platform within minutes using capillary tubing that differs in length, diameter, or material. The advantages of the proposed design are demonstrated by performing the analysis of inorganic cations by capillary electrophoresis on soil samples from the Atacama Desert.
| S-EPMC3622270 | biostudies-literature
Project description:An assay was developed for phosphofructokinase-1 (PFK-1) using capillary electrophoresis (CE). In the glycolytic pathway, this enzyme catalyzes the rate-limiting step from fructose-6-phosphate and magnesium-bound adenosine triphosphate (Mg-ATP) to fructose-1,6-bisphosphate and magnesium-bound adenosine diphosphate (Mg-ADP). This enzyme has recently become a research target because of the importance of glycolysis in cancer and obesity. The CE assay for PFK-1 is based on the separation and detection by ultraviolet (UV) absorbance at 260 nm of Mg-ATP and Mg-ADP. The separation was enhanced by the addition of Mg²? to the separation buffer. Inhibition studies of PFK-1 by aurintricarboxylic acid and palmitoyl coenzyme A were also performed. An IC?? value was determined for aurintricarboxylic acid, and this value matched values in the literature obtained using coupled spectrophotometric assays. This assay for PFK-1 directly monitors the enzyme-catalyzed reaction, and the CE separation reduces the potential of spectral interference by inhibitors.
| S-EPMC3943981 | biostudies-literature
Project description:BackgroundIn order to isolate an individual's genotype from a sample of biological material, most laboratories use PCR and Capillary Electrophoresis (CE) to construct a genetic profile based on polymorphic loci known as Short Tandem Repeats (STRs). The resulting profile consists of CE signal which contains information about the length and number of STR units amplified. For samples collected from the environment, interpretation of the signal can be challenging given that information regarding the quality and quantity of the DNA is often limited. The signal can be further compounded by the presence of noise and PCR artifacts such as stutter which can mask or mimic biological alleles. Because manual interpretation methods cannot comprehensively account for such nuances, it would be valuable to develop a signal model that can effectively characterize the various components of STR signal independent of a priori knowledge of the quantity or quality of DNA.ResultsFirst, we seek to mathematically characterize the quality of the profile by measuring changes in the signal with respect to amplicon size. Next, we examine the noise, allele, and stutter components of the signal and develop distinct models for each. Using cross-validation and model selection, we identify a model that can be effectively utilized for downstream interpretation. Finally, we show an implementation of the model in NOCIt, a software system that calculates the a posteriori probability distribution on the number of contributors.ConclusionThe model was selected using a large, diverse set of DNA samples obtained from 144 different laboratory conditions; with DNA amounts ranging from a single copy of DNA to hundreds of copies, and the quality of the profiles ranging from pristine to highly degraded. Implemented in NOCIt, the model enables a probabilisitc approach to estimating the number of contributors to complex, environmental samples.
| S-EPMC6886162 | biostudies-literature
Project description:Genotyping, as applied to linkage mapping, human identification, or mapping of genetic traits, mandates electrophoretic separation systems that enable a user to identify alleles with high precision to obtain a correct genotype. For 2-bp microsatellites or short tandem repeats (STRs), standard deviations of +/-0.3 nucleotide are required to ensure with 99.7% probability the identity or dissimilarity of tested alleles. A complete system, consisting of commercially available laser-induced fluorescence capillary electrophoresis (ABI PRISM 310) and performance optimized polymer 4 (POP-4), was evaluated for microsatellite separations. POP-4 is a low viscosity polymer for use in uncoated fused microbore silica capillaries. It separates DNA fragments that differ in size by 1 nucleotide up to 250 nucleotides and that differ in size by 2 nucleotides for fragments up to at least 350 nucleotides in length in about 30 min. The presence of denaturants and, more importantly, operation at 60 degrees C was mandatory for high-precision and high-resolution sizing operation. Reproducible separation performance was achieved in excess of 100 injections per capillary with resulting standard deviations in the range of 0.04 to 0.17 nucleotide. Comparative sizing of known CEPH (Centre d'Etudes du Polymorphisme Humaine) samples performed at 22 independent test sites showed the usefulness of the system for genotyping with standard deviations of 0.24 nucleotide, or better.
| S-EPMC310688 | biostudies-literature