Facilely Flexible Imprinted Hemispherical Cavity Array for Effective Plasmonic Coupling as SERS Substrate.
Ontology highlight
ABSTRACT:
SUBMITTER: Xu J
PROVIDER: S-EPMC8705896 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Surface-enhanced Raman scattering (SERS) is considered an efficient technique providing high sensitivity and fingerprint specificity for the detection of pesticide residues. Recent developments in SERS-based detection aim to create flexible plasmonic substrates that meet the requirements for non-destructive analysis of contaminants on curved surfaces by simply wrapping or wiping. Herein, we reported a flexible SERS substrate based on cellulose fiber (CF) modified with silver nanostructures (AgNS). A silver film was fabricated on the membrane surface with an in situ silver mirror reaction leading to the formation of a AgNS-CF substrate. Then, the substrate was decorated through in situ synthesis of raspberry-like silver nanostructures (rAgNS). The SERS performance of the prepared substrate was tested using 4-mercaptobenzoic acid (4-MBA) as a Raman probe and compared with that of the CF-based plasmonic substrates. The sensitivity of the rAgNS/AgNS-CF substrate was evaluated by determining the detection limit of 4-MBA and an analytical enhancement factor, which were 10 nM and ~107, respectively. Further, the proposed flexible rAgNS/AgNS-CF substrate was applied for SERS detection of malathion. The detection limit for malathion reached 0.15 mg/L, which meets the requirements about its maximum residue level in food. Thus, the characteristics of the rAgNS/AgNS-CF substrate demonstrate the potential of its application as a label-free and ready-to-use sensing platform for the SERS detection of trace hazardous substances.
| S-EPMC9963878 | biostudies-literature
Project description:We report on a quasi-three-dimensional (3D) plasmonic nanowell array with high structural uniformity for molecular detection. The quasi-3D plasmonic nanowell array was composed of periodic hexagonal Au nanowells whose surface is densely covered with gold nanoparticles (Au NPs), separated by an ultrathin dielectric interlayer. The uniform array of the Au nanowells was fabricated by nanoimprint lithography and deposition of Au thin film. A self-assembled monolayer (SAM) of perfluorodecanethiol (PFDT) was coated on the Au surface, on which Au was further deposited. Interestingly, the PFDT-coated Au nanowells were fully covered with Au NPs with an ultra-high density of 375 ?m-2 rather than a smooth film due to the anti-wetting property of the low-energy surface. The plasmonic nanogaps formed among the high-density Au NPs led to a strong near-field enhancement via coupled localized surface plasmon resonance and produced a uniform surface-enhanced Raman spectroscopy (SERS) response with a small relative standard deviation of 5.3%. Importantly, the highly uniform nanostructure, featured by the nanoimprint lithography and 3D growth of densely-packed Au NPs, minimizes the spatial variation of Raman intensity, potentially providing quantitative analysis. Moreover, analyte molecules were highly concentrated and selectively deposited in nanowells when a water droplet containing the analyte was evaporated on the plasmonic substrate. The analyte formed a relatively thick overcoat in the nanowells near the triple line due to the coffee-ring effects. Combining 3D plasmonic nanowell substrates with molecular enrichments, highly sensitive detection of lactic acid was demonstrated. Given its combination of high sensitivity and signal uniformity, the quasi-3D plasmonic nanowell substrate is expected to provide a superior molecular detection platform for biosensing applications.
| S-EPMC7279529 | biostudies-literature
Project description:Unique colorimetric optical properties of nanomaterials can effectively influence the light absorption or emission of molecules. Here, we design plasmonic substrate for surface-enhanced Raman scattering (SERS) by inducing three-dimensional (3D) hot spots on the sensing surface. The 3D hot spots are formed by the self-assembly of plasmonic nanoparticles (NPs) on a 3D plasmonic nanocup array structure. This 3D hot spot formation on the periodic nanocup arrays achieves much higher SERS enhancement factor than the 2D NP arrays, which have been conventionally sought SERS substrates. We also utilize the colorimetric properties of the nanocup arrays for an additional degree of SERS enhancement. Colorimetry, achieved by tunable plasmon resonance wavelength by controlling dielectric property on the nanocup array surface, eases the modulation of the plasmonic resonance condition without modifying the nanostructure design. By continuously monitoring the shifts of the plasmon resonance condition and its effect on the light absorption and emission of the nearby molecules, we verify that larger SERS enhancement is achieved when the plasmon resonance wavelength is matched with the Raman excitation wavelength. The ease of plasmon resonance tuning of this nanocup array-nanoparticle hybrid structure allows versatile SERS enhancement for a variety of different Raman measurement conditions.
| S-EPMC5813092 | biostudies-literature
Project description:Stimuli-responsive surface-enhanced Raman scattering (SERS) nanoparticles have been developed by using colloidal gold nanocrystals and a class of thiolated block copolymers consisting of a pH-responsive polymer segment, an amphiphilic polyethylene glycol segment, and a lipoic acid anchoring group. The results demonstrate that SERS signals can be switched on and off by molecular conformations in response to pH. An important finding is that neutralized polymethacrylic acid (PMAA) molecules are able to interact with amphiphilic polyethylene glycol (PEG) chains, leading to highly compact and intermingled copolymer structures on the surface of nanoparticles. This type of molecular conformation change provides a new strategy for controlling plasmonic coupling and electromagnetic Raman enhancement and raises the possibility of using SERS nanoparticle tags for biomolecular binding and enzymatic cleavage studies.
| S-EPMC2703497 | biostudies-literature
Project description:Solar-to-steam (STS) generation based on plasmonic materials has attracted significant attention as a green method for producing fresh water. Herein, a simple in situ method is introduced to fabricate Au nanoparticles (AuNPs) on cellulose filter papers as dual-functional substrates for STS generation and surface-enhanced Raman spectroscopy (SERS) sensing. The substrates exhibit 90% of broadband solar absorption between 350 and 1800 nm and achieve an evaporation rate of 0.96 kg·m-2·h-1 under 1-sun illumination, room temperature of 20 °C, and relative humidity of 40%. The STS generation of the substrate is stable during 30 h continuous operation. Enriched SERS hotspots between AuNPs endow the substrates with the ability to detect chemical contamination in water with ppb limits of detection for rhodamine 6G dye and melamine. To demonstrate dual-functional properties, the contaminated water was analyzed with SERS and purified by STS. The purified water was then analyzed with SERS to confirm its purity. The developed substrate can be an improved and suitable candidate for fresh water production and qualification.
| S-EPMC10054297 | biostudies-literature
Project description:We numerically design and experimentally test a SERS-active substrate for enhancing the SERS signal of a single layer of graphene (SLG) in water. The SLG is placed on top of an array of silver-covered nanoholes in a polymer and is covered with water. Here we report a large enhancement of up to 2 × 105 in the SERS signal of the SLG on the patterned plasmonic nanostructure for a 532 nm excitation laser wavelength. We provide a detailed study of the light-graphene interactions by investigating the optical absorption in the SLG, the density of optical states at the location of the SLG, and the extraction efficiency of the SERS signal of the SLG. Our numerical calculations of both the excitation field and the emission rate enhancements support the experimental results. We find that the enhancement is due to the increase in the confinement of electromagnetic fields on the location of the SLG that results in enhanced light absorption in the graphene at the excitation wavelength. We also find that water droplets increase the density of optical radiative states at the location of the SLG, leading to enhanced spontaneous emission rate of graphene at its Raman emission wavelengths.
| S-EPMC5656589 | biostudies-literature
Project description:Early medical diagnostic in nanomedicine requires the implementation of innovative nanosensors with highly sensitive, selective, and reliable biomarker detection abilities. In this paper, a dual Localized Surface Plasmon Resonance - Surface Enhanced Raman Scattering (LSPR- SERS) immunosensor based on a flexible three-dimensional (3D) gold (Au) nanocups platform has been implemented for the first time to operate as a relevant "proof-of-concept" for the specific detection of antigen-antibody binding events, using the human IgG - anti-human IgG recognition interaction as a model. Specifically, polydimethylsilane (PDMS) elastomer mold coated with a thin Au film employed for pattern replication of hexagonally close-packed monolayer of polystyrene nanospheres configuration has been employed as plasmonic nanoplatform to convey both SERS and LSPR readout signals, exhibiting both well-defined LSPR response and enhanced 3D electromagnetic field. Synergistic LSPR and SERS sensing use the same reproducible and large-area plasmonic nanoplatform providing complimentary information not only on the presence of anti-human IgG (by LSPR) but also to identify its specific molecular signature by SERS. The development of such smart flexible healthcare nanosensor platforms holds promise for mass production, opening thereby the doors for the next generation of portable point-of-care devices.
| S-EPMC5660151 | biostudies-literature
Project description:Surface-enhanced Raman optical activity (SEROA) has been extensively investigated due to its ability to directly probe stereochemistry and molecular structure. However, most works have focused on the Raman optical activity (ROA) effect arising from the chirality of the molecules on isotropic surfaces. Here, we propose a strategy for achieving a similar effect: i.e., a surface-enhanced Raman polarization rotation effect arising from the coupling of optically inactive molecules with the chiral plasmonic response of metasurfaces. This effect is due to the optically active response of metallic nanostructures and their interaction with molecules, which could extend the ROA potential to inactive molecules and be used to enhance the sensibility performances of surface-enhanced Raman spectroscopy. More importantly, this technique does not suffer from the heating issue present in traditional plasmonic-enhanced ROA techniques, as it does not rely on the chirality of the molecules.
| S-EPMC10103303 | biostudies-literature
Project description:A compact quasi-hemispherical-pattern antenna, two linear wide-angle scanning arrays, and a planar wide-angle scanning array are proposed. To increase the field-of-view scanning range of arrays, a compact low-profile antenna with a quasi-hemispherical pattern is introduced firstly. When the ground is infinite, the proposed antenna has a quasi-hemispherical pattern, i.e., an approximately uniform radiation in the upper half space. Afterward, two linear arrays arranged along the length and width of the proposed antenna's radiation patch are presented. The main beams of the two arrays with 16 active elements can scan from less than -75° to more than +75°. When the linear array element number is 128, the maximum scanning angle can reach 86°. At last, a planar array with 16?×?16 active elements is proposed. In two special planes, xz plane and yz plane, the main beams of the planar array can scan from less than -77° to more than +77° with a gain fluctuation less than 5?dB and a maximum side lobe level (SLL) less than -10?dB. An excellent wide-angle-scanning performance both in linear and planar arrays can be obtained using the proposed method.
| S-EPMC5457415 | biostudies-literature
Project description:Fabricating polymer solar cells (PSCs) on flexible polymer substrates, instead of on hard glass, is attractive for implementing the advantage and uniqueness of the PSCs represented by mechanically rollable and light-weight natures. However, simultaneously achieving reliable robustness and high-power conversion efficiency (PCE) in such flexible PSCs is still technically challenging due to poor light harvesting of thin photoactive polymers. In this work, we report a facile, effective strategy for improving the light-harvesting performance of flexible PSCs without sacrificing rollability. Very high transparent (93.67% in 400-800 nm) and low sheet resistance (~10 ? sq-1) ZnO/Ag(O)/ZnO electrodes were implemented as the flexible substrates. In systematically comparison with ZnO/Ag/ZnO electrodes, small amount of oxygen induced continuous metallic films with lower thickness, which resulted in higher transmittance and lower sheet resistance. To increase the light absorption of thin active layer (maintain the high rollability of active layer), a unique platform simultaneously utilizing both a transparent electrode configuration based on an ultrathin oxygen-doped Ag, Ag(O), and film and plasmonic Ag@SiO2 nanoparticles were designed for fully leveraging the advantages of duel microresonant cavity and plasmonic effects to enhance light absorbance in photoactive polymers. A combination of the ZnO/Ag(O)/ZnO electrode and Ag@SiO2 nanoparticles significantly increased the short-current density of PSCs to 17.98 mA cm-2 with enhancing the photoluminescence of PTB7-Th film. The flexible PSC using the optimized configuration provided an average PCE of 8.04% for flexible PSCs, which was increased by 36.27% compared to that of the PSC merely using a conventional transparent indium tin oxide electrode.
| S-EPMC7279274 | biostudies-literature