Dataset Information

Effects of short-term environmental stresses on the onset of cannabinoid production in young immature flowers of industrial hemp (Cannabis sativa L.).

ABSTRACT:

Backgrounds

Cannabis sativa L. produces at least 120 cannabinoids. Although genetic variation is the main factor in cannabinoid production, the effects of short-term environmental stresses in the early flowering stage remains largely unknown.

Methods

To investigate the effects of short-term environmental stresses on the onset of cannabinoid production in young immature flowers, a hemp variety, Green-Thunder (5-8% CBD/mg of dry weight), was treated with mechanical damage, insect herbivory, extreme heat, or drought stress for 5-7 days during the first 2 weeks of flowering. Three hemp tissues, including flowers, leaves, and stems, were collected from hemp grown under these stress conditions at multiple time points during the first 2 weeks after transition to the short photoperiod and analyzed using high pressure liquid chromatography to quantify phytocannabinoids including cannabigerolic acid (CBGA), cannabigerol (CBG), cannabidiolic acid (CBDA), cannabidiol (CBD), Δ-tetrahydrocannabinolic acid (THCA), Δ-tetrahydrocannabinol (THC), and cannabinol (CBN).

Results

The 5 days of mechanical wounding did not affect the production of any of the cannabinoids during the initial stage of flowering. However, after 5 days of herbivore treatment, there was a significant difference in concentration between day 1 and day 6 of CBGA (control: 308 μg/g; treatment - 24 μg/g), CBG (control: 69 μg/g; treatment: 52 μg/g), and CBD (control: 755 μg/g; treatment: 194 μg/g) between the control and treatment plants. The 7 days of heat treatment at 45-50 ^oC significantly reduced the production of CBGA during this observed window (control: 206 μg/g; treatment: 182 μg/g) and CBG (control: 21 μg/g; treatment: - 112 μg/g). Notably, the largest change was observed after 7 days of drought stress, when plants showed a 40% greater accumulation of CBG (control: 336 μg/g; treatment: 622 μg/g), and a significant decrease (70-80%) in CBD (control: 1182 μg/g; treatment: 297 μg/g) and THC amounts (control: 3927 μg/g; treatment: 580 μg/g).

Conclusions

Although this observation is limited in the early flowering stage, the common field stresses are adequate to induce changes in the cannabinoid profiles, particularly drought stress being the most impactful stress for hemp flower initiation with the altering the cannabinoid production by decreasing CBD and THC accumulation while increasing CBG by 40%.

SUBMITTER: Park SH

PROVIDER: S-EPMC8725245 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Similar Datasets

Project description:Five essential oil hemp (Cannabis sativa L.) cultivars (Cherry Blossom, Cherry Blossom (Tuan), Berry Blossom, Cherry Wine, and Cherry Blossom × Trump) were treated with six fertigation treatments to quantify the effects of synthetic fertilizer rates and irrigation electrical conductivity on plant growth, biomass accumulation, and cannabinoid profiles. Irrigation water was injected with a commercial 20-20-20 fertilizer at rates of 0, 50, 150, 300, 450, and 600 ppm nitrogen equating to 0.33 (control), 0.54, 0.96, 1.59, 2.22, and 2.85 dS m-1, respectively. Plants were grown under artificial lighting (18 hr) to maintain vegetative growth for eight weeks, followed by an eight-week flowering period. High linear relationship between chlorophyll concentrations and SPAD-502 measurements validated the utilization of SPAD meters to rapidly identify nutrient deficiency in essential oil hemp. Cultivars expressed significant variation in plant height and cannabinoid profiles (% dry mass), in concurrence with limited biomass and cannabinoid (g per plant) yield variation. Cherry Blossom was the best performing cultivar and Cherry Wine was the least productive. Variation in plant growth, biomass, and cannabinoid concentrations were affected to a greater extent by fertilizer rates. Optimal fertilizer rates were observed at 50 ppm N, while increased fertilizer rates significantly reduced plant growth, biomass accumulation, and cannabinoid concentrations. Increased fertilizer rates (> 300 ppm N) resulted in compliant THC levels (< 0.3%), although when coupled with biomass reductions resulted in minimal cannabinoid yields. Additionally, CBD concentration demonstrated higher sensitivity to increased fertilizer rates (> 300 ppm N) compared to THC and CBG (> 450 ppm N). The results of this study can serve as a guide when using fertigation methods on essential oil hemp cultivars; although results may differ with cultivar selection, environmental conditions, and management practices.

Project description:BackgroundCannabis sativa (hemp) is a source of various biologically active compounds, for instance, cannabinoids, terpenes and phenolic compounds, which exhibit antibacterial, antifungal, anti-inflammatory and anticancer properties. With the purpose of expanding the auxiliary application of C. sativa in the field of bio-nanotechnology, we explored the plant for green and efficient synthesis of gold nanoparticles (AuNPs) and silver nanoparticles (AgNPs).Methods and resultsThe nanoparticles were synthesized by utilizing an aqueous extract of C. sativa stem separated into two different fractions (cortex and core [xylem part]) without any additional reducing, stabilizing and capping agents. In the synthesis of AuNPs using the cortex enriched in bast fibers, fiber-AuNPs (F-AuNPs) were achieved. When using the core part of the stem, which is enriched with phenolic compounds such as alkaloids and cannabinoids, core-AuNPs (C-AuNPs) and core-AgNPs (C-AgNPs) were formed. Synthesized nanoparticles were character-ized by UV-visible analysis, transmission electron microscopy, atomic force microscopy, dynamic light scattering, Fourier transform infrared, and matrix-assisted laser desorption/ionization time-of-flight. In addition, the stable nature of nanoparticles has been shown by thermogravimetric analysis and inductively coupled plasma mass spectrometry (ICP-MS). Finally, the AgNPs were explored for the inhibition of Pseudomonas aeruginosa and Escherichia coli biofilms.ConclusionThe synthesized nanoparticles were crystalline with an average diameter between 12 and 18 nm for F-AuNPs and C-AuNPs and in the range of 20-40 nm for C-AgNPs. ICP-MS analysis revealed concentrations of synthesized nanoparticles as 0.7, 4.5 and 3.6 mg/mL for F-AuNPs, C-AuNPs and C-AgNPs, respectively. Fourier transform infrared spectroscopy revealed the presence of flavonoids, cannabinoids, terpenes and phenols on the nanoparticle surface, which could be responsible for reducing the salts to nanoparticles and further stabilizing them. In addition, the stable nature of synthesized nanoparticles has been shown by thermogravimetric analysis and ICP-MS. Finally, the AgNPs were explored for the inhibition of P. aeruginosa and E. coli biofilms. The nanoparticles exhibited minimum inhibitory concentration values of 6.25 and 5 µg/mL and minimum bactericidal concentration values of 12.5 and 25 µg/mL against P. aeruginosa and E. coli, respectively.