Dataset Information

Simulated and clinical aerosol spread in common periodontal aerosol-generating procedures.

ABSTRACT:

Objectives

This study evaluated particle spread associated with various common periodontal aerosol-generating procedures (AGPs) in simulated and clinical settings.

Materials and methods

A simulation study visualized the aerosols, droplets, and splatter spread with and without high-volume suction (HVS, 325 L/min) during common dental AGPs, namely ultrasonic scaling, air flow prophylaxis, and implant drilling after fluorescein dye was added to the water irrigant as a tracer. Each procedure was repeated 10 times. A complementary clinical study measured the spread of contaminated particles within the dental operatory and quantified airborne protein dispersion following 10 min of ultrasonic supragingival scaling of 19 participants during routine periodontal treatment.

Results

The simulation study data showed that air flow produced the highest amount of splatters and the ultrasonic scaler generated the most aerosol and droplet particles at 1.2 m away from the source. The use of HVS effectively reduced 37.5-96% of splatter generation for all three dental AGPs, as well as 82-93% of aerosol and droplet particles at 1.2 m for the ultrasonic scaler and air polisher. In the clinical study, higher protein levels above background levels following ultrasonic supragingival scaling were detected in fewer than 20% of patients, indicating minimal particle spread.

Conclusions

While three common periodontal AGPs produce aerosols and droplet particles up to at least 1.2 m from the source, the use of HVS is of significant benefit. Routine ultrasonic supragingival scaling produced few detectable traces of salivary protein at various sites throughout the 10-min dental operatory.

Clinical relevance

The likelihood of aerosol spread to distant sites during common periodontal AGPs is greatly reduced by high-volume suction. Clinically, limited evidence of protein contaminants was found following routine ultrasonic scaling, suggesting that the the majority of the contamination consisits of the irrigant rather than organic matter from the oral cavity.

SUBMITTER: Puljich A

PROVIDER: S-EPMC9113070 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Similar Datasets

Project description:BackgroundDuring medical procedures with the potential to produce aerosols such as bronchoscopy, intubation, or CPR, health-care workers (HCWs) may be exposed to infectious bioaerosols. This scenario is of particular concern when high consequence pathogens such as severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) are circulating. Thousands of HCWs have been infected with SARS-CoV-2. However, the determinants of aerosol generation during medical procedures and their relative risk to HCWs remain poorly characterized.Research questionThe goal of this study was to characterize aerosols produced during airway intubation by using an uninfected translational animal model and in human subjects undergoing elective aerosol-generating procedures. The study also determined the particle size distribution of generated particles.Study design and methodsAerosol generation was measured during highly controlled experimental (pig) intubations (N = 16) and elective bronchoscopies in uninfected patients (N = 49) using an optical particle counter. Recovery of normal respiratory flora was used as a surrogate for pathogen dispersion.ResultsThere was a small but significant (P = .03) decrease in 0.3 μm size particles during highly controlled pig intubations compared with baseline. The concentration of 1.0 μm and 5.0 μm aerosol particles did not significantly change, although oral bacteria were collected from the air. For elective patient bronchoscopies, there was a significant decrease in the generation of larger particles (1.0 μm and 5.0 μm) compared with baseline (P < .01); however, 18 of 39 (46%) patients showed increased aerosol production in 0.3 μm size particles, four of whom exhibited measurable increases.InterpretationAlthough the total amount of aerosols produced during intubation and bronchoscopy did not increase significantly relative to preprocedural levels, a small number of participants exhibited a measurable increase in submicron particle emission, meriting further research to delineate determinants of fine particle production during aerosol-generating procedures.