Design and synthesis of TiO2/C nanosheets with a directional cascade carrier transfer.
Ontology highlight
ABSTRACT:
SUBMITTER: Wu SM
PROVIDER: S-EPMC9214889 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Two-dimensional (2D) ternary materials recently generated interest in optoelectronics and energy-related applications, alongside their binary counterparts. To date, only a few naturally occurring layered 2D ternary materials have been explored. The plethora of benefits owed to reduced dimensionality prompted exploration of expanding non-layered ternary chalcogenides into the 2D realm. This work presents a templating method that uses 2D transition metal dichalcogenides as initiators to be converted into the corresponding ternary chalcogenide upon addition of copper, via a solution-phase synthesis, conducted in high boiling point solvents. The process starts with preparation of VSe2 nanosheets, which are next converted into Cu3VSe4 sulvanite nanosheets (NSs) which retain the 2D geometry while presenting an X-ray diffraction pattern identical with the one for the bulk Cu3VSe4. Both the scanning electron microscopy and transmission microscopy electron microscopy show the presence of quasi-2D morphology. Recent studies of the sulfur-containing sulvanite Cu3VS4 highlight the presence of an intermediate bandgap, associated with enhanced photovoltaic (PV) performance. The Cu3VSe4 nanosheets reported herein exhibit multiple UV-Vis absorption peaks, related to the intermediate bandgaps similar to Cu3VS4 and Cu3VSe4 nanocrystals. To test the potential of Cu3VSe4 NSs as an absorber for solar photovoltaic devices, Cu3VSe4 NSs thin-films deposited on FTO were subjected to photoelectrochemical testing, showing p-type behavior and stable photocurrents of up to ~ 0.036 mA/cm2. The photocurrent shows a ninefold increase in comparison to reported performance of Cu3VSe4 nanocrystals. This proves that quasi-2D sulvanite nanosheets are amenable to thin-film deposition and could show superior PV performance in comparison to nanocrystal thin-films. The obtained electrical impedance spectroscopy signal of the Cu3VSe4 NSs-FTO based electrochemical cell fits an equivalent circuit with the circuit elements of solution resistance (Rs), charge-transfer resistance (Rct), double-layer capacitance (Cdl), and Warburg impedance (W). The estimated charge transfer resistance value of 300 Ω cm2 obtained from the Nyquist plot provides an insight into the rate of charge transfer on the electrode/electrolyte interface.
| S-EPMC8097018 | biostudies-literature
Project description:TiO2 is well-known nanomaterials and mostly used as solid nanoparticles, and normal hollow spheres for photocatalysts or electrode materials. In this study, a novel self-templated method is presented to successfully fabricate high-surface-area ultrathin nanosheets constructed TiO2 hollow spheres through the solvothermal treatment of the titanate-silicone composite particles combined with calcination. The uniquely structured hollow spheres exhibit excellent rate capability and good cycle stability even at a high current density of ≈10 C for the anode material of Li-ion battery.
| S-EPMC5102664 | biostudies-literature
Project description:In this paper, TiO2/Ag2V4O11 nanoheterojunctions have been synthesized by hydrothermal methods, which show enhanced photocatalytic activity compared to TiO2 under visible light. Moreover, the TiO2/Ag2V4O11 nanoheterojunction with set molar ratio of 2:1, referred to as TA2, show the highest visible light photocatalytic activity, which could decompose about 100% RhB molecules within 80 min of irradiation with visible light. Specially, the time-resolved photoluminescence spectrum of TA2 demonstrates that the free exciton recombination occurs in approximately 1.7 ns, and the time scale for Shockley-Read-Hall recombination of photogenerated electrons and holes is prolonged to 6.84 ns. The prolonged timescale of TA2 compared to TiO2 and Ag2V4O11 can be attributed to the carrier separation between nanojunctions and the carrier capture by interfacial defects. Furthermore, the enhanced photocatalytic activity of TiO2/Ag2V4O11 nanoheterojunctions also benefits from the synergistic effect of the broadened absorption region, higher photocarrier generation, longer carrier lifetime, and quicker collection dynamics.
| S-EPMC7711476 | biostudies-literature
Project description:Two-dimensional (2D) anatase titanium dioxide (TiO2) is expected to exhibit different properties as compared to anatase nanocrystallites, due to its highly reactive exposed facets. However, access to 2D anatase TiO2 is limited by the non-layered nature of the bulk crystal, which does not allow use of top-down chemical exfoliation. Large efforts have been dedicated to the growth of 2D anatase TiO2 with high reactive facets by bottom-up approaches, which relies on the use of harmful chemical reagents. Here, we demonstrate a novel fluorine-free strategy based on topochemical conversion of 2D 1T-TiS2 for the production of single crystalline 2D anatase TiO2, exposing the {001} facet on the top and bottom and {100} at the sides of the nanosheet. The exposure of these faces, with no additional defects or doping, gives rise to a significant activity enhancement in the hydrogen evolution reaction, as compared to commercially available Degussa P25 TiO2 nanoparticles. Because of the strong potential of TiO2 in many energy-based applications, our topochemical approach offers a low cost, green and mass scalable route for production of highly crystalline anatase TiO2 with well controlled and highly reactive exposed facets.
| S-EPMC9255669 | biostudies-literature
Project description:Overall photocatalytic water splitting is one of the most sought after processes for sustainable solar-to-chemical energy conversion. The efficiency of this process strongly depends on charge carrier recombination and interaction with surface adsorbates at different time scales. Here, we investigated how hydration of TiO2 P25 affects dynamics of photogenerated electrons at the millisecond to minute time scale characteristic for chemical reactions. We used rapid scan diffuse-reflectance infrared Fourier transform spectroscopy (DRIFTS). The decay of photogenerated electron absorption was substantially slower in the presence of associated water. For hydrated samples, the charge carrier recombination rates followed an Arrhenius-type behavior in the temperature range of 273-423 K; these became temperature-independent when the material was dehydrated at temperatures above 423 K or cooled below 273 K. A DFT+U analysis revealed that hydrogen bonding with adsorbed water stabilizes surface-trapped holes at anatase TiO2(101) facet and lowers the barriers for hole migration. Hence, hole mobility should be higher in the hydrated material than in the dehydrated system. This demonstrates that adsorbed associated water can efficiently stabilize photogenerated charge carriers in nanocrystalline TiO2 and suppress their recombination at the time scale up to minutes.
| S-EPMC5388900 | biostudies-literature
Project description:Layered NbS2, a member of group-V transition metal dichalcogenides, was synthesized via a colloidal synthesis method and employed as a negative material for a supercapacitor. The morphologies of NbS2 can be tuned from ultrathin nanosheets to hierarchical structures through dynamics controls based on growth mechanisms. Electrochemical energy storage measurements present that the ultrathin NbS2 electrode exhibits the highest rate capability due to having the largest electrochemical surface area and its efficient ion diffusion. Meanwhile, the hierarchical NbS2 shows the highest specific capacitance at low current densities for small charge transfer resistance, displays 221.4 F g-1 at 1 A g-1 and 117.1 F g-1 at 10 A g-1, and cycling stability with 78.9% of the initial specific capacitance after 10,000 cycles. The aggregate or stacking of nanosheets can be suppressed effectively by constructing hierarchical structure NbS2 nanosheets.
| S-EPMC7154151 | biostudies-literature
Project description:Understanding the interface of plasmonic nanostructures is essential for improving the performance of photocatalysts. Surface defects in semiconductors modify the dynamics of charge carriers, which are not well understood yet. Here, we take advantage of scanning photoelectrochemical microscopy (SPECM) as a fast and effective tool for detecting the impact of surface defects on the photoactivity of plasmonic hybrid nanostructures. We evidenced a significant photoactivity activation of TiO2 ultrathin films under visible light upon mild reduction treatment. Through Au nanoparticle (NP) arrays deposited on different reduced TiO2 films, the plasmonic photoactivity mapping revealed the effect of interfacial defects on hot charge carriers, which quenched the plasmonic activity by (i) increasing the recombination rate between hot charge carriers and (ii) leaking electrons (injected and generated in TiO2) into the Au NPs. Our results show that the catalyst's photoactivity depends on the concentration of surface defects and the population distribution of Au NPs. The present study unlocks the fast and simple detection of the surface engineering effect on the photocatalytic activity of plasmonic semiconductor systems.
| S-EPMC10441571 | biostudies-literature
Project description:Being an optical semiconductor, tin disulfide (SnS2) attracts increasing interest in the fields of heterogeneous photocatalysis and photovoltaics. However, support from a graphene sheet in the form of a nanocomposite is expected to increase the stability and effectiveness of a SnS2 material in potential applications. We report here novel nanocomposites of graphene-oxide-stacked hexagonal-shaped pristine SnS2 nanodiscs (NDs of two different sizes) and nanosheets synthesized using an in situ one-pot hydrothermal synthesis process and the application of the nanocomposite as an efficient heterogeneous photocatalyst. The as-synthesized morphology-oriented nanoparticles and nanocomposites were comprehensively characterized, and finally, excellent photocatalytic activity of reduced graphene oxide/SnS2 nanocomposites under visible-light irradiation was analyzed using UV-vis spectroscopy, high-performance liquid chromatography, and gas chromatography. While precisely manipulating the nanocomposite formation, we observed efficient visible-light-driven photocatalytic application of graphene-stacked SnS2 NDs in the quantitative synthesis of aniline (99.9% yield, absolute selectivity) from nitrobenzene (>99.9% conversion), in the reduction of toxic Cr(VI) to nontoxic Cr(III), and in the degradation of mutagenic organic dyes. A possible synergetic electrical and chemical coupling leads to effective carrier separation in the semiconductor and charge transport in the nanocomposite, which finally gives rise to efficient tandem photocatalysis reactions.
| S-EPMC6640736 | biostudies-literature
Project description:The activity of Fischer-Tropsch synthesis (FTS) on metal-based nanocatalysts can be greatly promoted by the support of reducible oxides, while the role of support remains elusive. Herein, by varying the reduction condition to regulate the TiOx overlayer on Ru nanocatalysts, the reactivity of Ru/TiO2 nanocatalysts can be differentially modulated. The activity in FTS shows a volcano-like trend with increasing reduction temperature from 200 to 600?°C. Such a variation of activity is characterized to be related to the activation of CO on the TiOx overlayer at Ru/TiO2 interfaces. Further theoretical calculations suggest that the formation of reduced TiOx occurs facilely on the Ru surface, and it involves in the catalytic mechanism of FTS to facilitate the CO bond cleavage kinetically. This study provides a deep insight on the mechanism of TiOx overlayer in FTS, and offers an effective approach to tuning catalytic reactivity of metal nanocatalysts on reducible oxides.
| S-EPMC7314765 | biostudies-literature
Project description:We report on the synthesis and characterization of six novel 2,2'-bithiophene-based organic compounds (3a-c and 5a-c) that are designed to serve as co-sensitizers for dye-sensitized solar cells (DSSCs) based on TiO2. The compounds are linked to various donor and acceptor groups, and we confirm their chemical structures through spectral analyses. Our focus is on enhancing the performance of metal based N3, and the compounds were designed to operate at the nanoscale. We performed absorption and fluorescence emission measurements in dimethylformamide (DMF), where one of our compounds 5a exhibited the longest maximum absorption and maximum emission wavelengths, indicating the significant impact of the para methoxy group as a strong electron-donating group. Our dyes 5a + N3 (η = 7.42%) and 5c + N3 (η = 6.57%) outperformed N3 (η = 6.16%) alone, where the values of short current density (JSC) and open circuit voltage (VOC) for these two systems also improved. We also investigated the charge transfer resistance at the TiO2/dye/electrolyte interface using electrochemical impedance spectroscopy (EIS), which is important in the context of nanotechnology. According to the Nyquist plot, the 5a + N3 cocktail exhibited the lowest recombination rate, resulting in the highest VOC. Our theoretical calculations based on density functional theory (DFT) are also in agreement with the experimental process. These findings suggest that our compounds have great potential as efficient DSSC co-sensitizers. This study provides valuable insights into the design and synthesis of new organic compounds for use as co-sensitizers in DSSCs based on TiO2 and highlights the potential of these compounds for use in efficient solar energy conversion.
| S-EPMC10449855 | biostudies-literature