Electrodeposition of Cobalt Oxides on Carbon Nanotubes for Sensitive Bromhexine Sensing.
Ontology highlight
ABSTRACT:
SUBMITTER: Lisnund S
PROVIDER: S-EPMC9268198 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Fe/Ti-oxides-modified-carbon nanotubes CNTs nanocomposites were prepared and tested toward Co removal from solution under different operational conditions. The final performance of the nanocomposites for Co was highly dependent on the type and loaded amount of the oxides. The nanocomposites were characterized by standard methods and the results evidenced that the presence of CNTs hampers the growth of Fe3O4 and TiO2 particles and forming smaller nano-particles leading to better Co removal from solution. Analysis of isotherms at different temperatures indicated that Co retention was two-fold increased upon adding Ti-oxides up to 90.2%. All isotherms were fairly presented using Langmuir-Freundlich isotherm and most surfaces have high heterogeneity particularly after deposition of oxides. The combined influence of the factors was investigated by running a multivariate analysis. An empirical equation was generated by principal component analysis (PCA) for predicting Co retention assuming different relationships and the binary-interaction behavior between factors was the most dominant: Co retention (mg/g) = 5.12 + 1.25Conc + 1.47Temp - 1.38CNT% - 6.03Ti% - 5.03Fe% - 0.01Conc2 + 0.12Temp2 - 0.55CNT%2 - 1.53Ti%2 - 3.44Fe%2 + 0.17Conc × Temp + 0.07Conc × CNT% + 0.07Conc × Ti% + 0.10Conc × Fe% + 0.21Temp × CNT% + 0.10Temp × Ti% + 0.17Temp × Fe% - 1.67CNT% × Ti% - 1.45CNT% × Fe% - 4.11Ti% × Fe%. The most dominant factors on Co retention were temperature and concentration (positive linear correlation) and the positive interaction between temperature/concentration and temperature/CNTs mass. PCA indicated that the coefficient Temp × CNTs (+0.21) was higher than Temp × Ti% (+0.10). The negative coefficients of Ti/Fe with CNTs (1.45-4.11) indicated better Co retention at higher Ti/Fe loads and lower mass of CNTs. The results support that fact that incorporation of CNTs with Ti/Fe oxides may have a positive synergic impact on Co retention.
| S-EPMC8241930 | biostudies-literature
Project description:The poisoning of H2S sensing material based on the mixture of acid-treated carbon nanotubes, CuO and SnO2 was investigated by exposing the material to high doses of H2S (1% in volume) and following the changes spectroscopically. The presence of metal sulfides (CuS and SnS2), sulfates and thiols was confirmed on the surface of this material as the result of H2S poisoning. Further study revealed that leaving this material in air for extended period of time led to reoxidation of metal sulfides back to metal oxides. The formation of thiols and sulfates directly on carbon nanotubes is not reversible under these conditions; however, the extent of the overall surface reaction in this case is substantially lower than that for the composite material.
| S-EPMC5089814 | biostudies-literature
Project description:In this research, the synergistic antiviral effects of carbon nanotubes (CNTs) and metal oxides (MO) in the form of novel hybrid structures (MO-CNTs) are presented. Raw CNTs, Ni(OH)2, Fe2O3 and MnO2, as well as Ni(OH)2-CNT, Fe2O3-CNT and MnO2-CNT were explored in this study against Escherichia. coli MS2 bacteriophage, which was used as a virus surrogate. The nano particles were synthesized and characterized using field emission scanning electron microscopy (FESEM), energy-dispersive X-ray spectroscopy (EDS), transmission electron microscopy (TEM), particle size analysis, Fourier-transform infrared spectroscopy (FTIR) and X-ray diffraction (XRD). Kinetic parameters such as the LD50 (lethal dose to kill 50% of the population), T50 and T80 (time taken to kill 50% and 80% of the population), SGR (specific growth rate) and IRD (initial rate of deactivation of the population) were also studied to examine the antiviral efficacy of these nanomaterials. Among all the nanomaterials, Ni(OH)2-CNT was the most effective antiviral agent followed by Fe2O3-CNT, MnO2-CNT, raw CNTs, Ni(OH)2, Fe2O3 and MnO2. When comparing the metal oxide-CNTs to the raw CNTs, the average enhancement was 20.2%. The average antiviral activity enhancement of the MO-CNTs were between 50 and 54% higher than the MO itself. When compared to the raw CNTs, the average enhancement over all the MO-CNTs was 20.2%. The kinetic studies showed that the LD50 of Ni(OH)2-CNT was the lowest (16µg/mL), which implies that it was the most toxic of all the compounds studied. The LD50 of Ni(OH)2, Fe2O3 and MnO2 were 17.3×, 14.5× and 10.8× times greater than their corresponding hybrids with the CNTs. The synergistic mechanism involved the entrapment of phage viruses by the nano structured CNTs leading to structural damage along with toxicity to phage from the release of MO ions. The metal oxide-CNT nano hybrids developed in this project are promising candidates in applications such as antiviral coatings, nanocomposites, adsorbents and as components of personal protection gears.
| S-EPMC9569974 | biostudies-literature
Project description:The properties of multi-wall carbon nanotubes decorated with iridium oxide nanoparticles (IrOx-MWCNTs) are studied to detect harmful gases such as nitrogen dioxide and ammonia. IrOx nanoparticles were synthetized using a two-step method, based on a hydrolysis and acid condensation growth mechanism. The metal oxide nanoparticles obtained were employed for decorating the sidewalls of carbon nanotubes. Iridium-oxide nanoparticle decorated carbon nanotube material showed higher and more stable responses towards NH₃ and NO₂ than bare carbon nanotubes under different experimental conditions, establishing the optimal operating temperatures and estimating the limits of detection and quantification. Furthermore, the nanomaterials employed were studied using different morphological and compositional characterization techniques and a gas sensing mechanism is proposed.
| S-EPMC6339137 | biostudies-literature
Project description:Polymer composites with electrically conductive inclusions are intensively developed for microwave shielding applications, where lightweight and elastic coatings are necessary. In this paper, dielectric properties of hybrid polyethylene composites containing cobalt nanoparticles and multi-wall carbon nanotubes (MWCNT) were investigated in the wide frequency range of 20-40 GHz for electromagnetic shielding applications. The percolation threshold in the hybrid system is close to 6.95 wt% MWCNT and 0.56 Co wt%. Cobalt nanoparticles (up to highest investigated concentration 4.8 wt%) had no impact on the percolation threshold, and for the fixed total concentration of fillers, the complex dielectric permittivity is higher for composites with bigger MWCNT concentrations. Moreover, the microwave complex dielectric permittivity of composites with high concentration of fillers is quite high (for composites with 13.4 wt% MWCNT and 1.1 wt% Co ε' ≈ ε″ ≈ 20 at 30 GHz, it corresponds to microwave absorption 50% of 1 mm thickness plate); therefore, these composites are suitable for electromagnetic shielding applications.
| S-EPMC8912063 | biostudies-literature
Project description:Carbon nanotubes (CNTs) have shown great potential as sensing component in the electrochemical field effect transistor and optical sensors, because of their extraordinary one-dimensional electronic structure, thermal conductivity, and tunable and stable near-infrared emission. However, the insolubility of CNTs due to strong van der Waals interactions limits their use in the field of nanotechnology. In this study, we demonstrate that noncovalent ultrathin gold nanowires functionalized multiwalled carbon nanotube (GNW-CNT) hybrid sensing agents show highly efficient and selective immune molecular sensing in electrochemical and near-infrared photoacoustic imaging methods. A detection limit of 0.01 ng/mL for the alpha-fetoprotein (AFP) antigen with high selectivity is shown. The extraordinary optical absorption, thermal, and electric conductivity of hybrid GNW-CNTs presented in this study could be an effective tactic to integrate imaging, sensing, and treatment functionalities.
| S-EPMC3946550 | biostudies-literature
Project description:Near-field scanning optical microscopes are widely used in imaging of subwavelength features in various material systems and nanostructures. For a variety of applications, polarization-sensitive near-field probes can provide valuable information on the nature and symmetry of the imaged nanoparticles and emitters. Conventional near-field optical microscopy lacks in-plane polarization sensitivity. Here, we use aligned single-wall carbon nanotubes as polarization-sensitive molecular scale probes to image the transverse near-field components of an optical Hertzian dipole antenna. Because of the Raman "antenna effect" in carbon nanotubes, only the near-field components along the nanotube axis are detected. These findings demonstrate that aligned carbon nanotubes can be used as polarization-sensitive near-field detectors.
| S-EPMC2636739 | biostudies-literature
Project description:A series of gold (Au) nanostructures, having different morphologies, were fabricated for amperometric selective detection of carbon monoxide (CO), a biologically important signaling molecule. Au layers were electrodeposited from a precursor solution of 7 mM HAuCl4 with a constant deposition charge (0.04 C) at various deposition potentials. The obtained Au nanostructures became rougher and spikier as the deposition potential lowered from 0.45 V to 0.05 V (vs. Ag/AgCl). As prepared Au layers showed different hydrophobicity: The sharper morphology, the greater hydrophobicity. The Au deposit formed at 0.05 V had the sharpest shape and the greatest surface hydrophobicity. The sensitivity of an Au deposit for amperometric CO sensing was enhanced as the Au surface exhibits higher hydrophobicity. In fact, CO selectivity over common electroactive biological interferents (L-ascorbic acid, 4-acetamidophenol, 4-aminobutyric acid and nitrite) was improved eminently once the Au deposit became more hydrophobic. The most hydrophobic Au was also confirmed to sense CO exclusively without responding to nitric oxide, another similar gas signaling molecule, in contrast to a hydrophobic platinum (Pt) counterpart. This study presents a feasible strategy to enhance the sensitivity and selectivity for amperometric CO sensing via the fine control of Au electrode nanostructures.
| S-EPMC8468895 | biostudies-literature
Project description:Carbon-based nanomaterials including carbon nanotubes (CNTs) have been shown to trigger inflammation. However, how these materials are 'sensed' by immune cells is not known. Here we compared the effects of two carbon-based nanomaterials, single-walled CNTs (SWCNTs) and graphene oxide (GO), on primary human monocyte-derived macrophages. Genome-wide transcriptomics assessment was performed at sub-cytotoxic doses. Pathway analysis of the microarray data revealed pronounced effects on chemokine-encoding genes in macrophages exposed to SWCNTs, but not in response to GO, and these results were validated by multiplex array-based cytokine and chemokine profiling. Conditioned medium from SWCNT-exposed cells acted as a chemoattractant for dendritic cells. Chemokine secretion was reduced upon inhibition of NF-?B, as predicted by upstream regulator analysis of the transcriptomics data, and Toll-like receptors (TLRs) and their adaptor molecule, MyD88 were shown to be important for CCL5 secretion. Moreover, a specific role for TLR2/4 was confirmed by using reporter cell lines. Computational studies to elucidate how SWCNTs may interact with TLR4 in the absence of a protein corona suggested that binding is guided mainly by hydrophobic interactions. Taken together, these results imply that CNTs may be 'sensed' as pathogens by immune cells.
| S-EPMC5773626 | biostudies-literature
Project description:Controlling chirality in growth of single-walled carbon nanotubes (SWNTs) is important for exploiting their practical applications. For long it has been conceptually conceived that the structural control of SWNTs is potentially achievable by fabricating nanoparticle catalysts with proper structures on crystalline substrates via epitaxial growth techniques. Here, we have accomplished epitaxial formation of monometallic Co nanoparticles with well-defined crystal structure, and its use as a catalyst in the selective growth of SWNTs. Dynamics of Co nanoparticles formation and SWNT growth inside an atomic-resolution environmental transmission electron microscope at a low CO pressure was recorded. We achieved highly preferential growth of semiconducting SWNTs (~90%) with an exceptionally large population of (6, 5) tubes (53%) in an ambient CO atmosphere. Particularly, we also demonstrated high enrichment in (7, 6) and (9, 4) at a low growth temperature. These findings open new perspectives both for structural control of SWNTs and for elucidating the growth mechanisms.
| S-EPMC3597999 | biostudies-literature