A First Assessment of Carbon Nanotubes Grown on Oil-Well Cement via Chemical Vapor Deposition.
Ontology highlight
ABSTRACT:
SUBMITTER: Lavagna L
PROVIDER: S-EPMC9317604 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Nickel-encapsulated nitrogen-doped carbon nanotubes (Ni-TiO2-NCNTs) are synthesized via chemical vapor deposition by thermal decomposition of acetylene with acetonitrile vapor at 700 °C on the Ni-TiO2 matrix. TiO2 is used as a dispersant medium for Ni nanoparticles, which assists in higher CNT growth at high temperatures. A reference catalyst is made by following the similar procedure without acetonitrile vapor, which is called a Ni-TiO2-CNT. Acid treatment of these two catalysts dissolved Ni on the surface of CNTs-NCNTs, producing catalysts with enhanced surface area and defects. The transmission electron microscopy-energy-dispersive X-ray spectra analysis of acid-treated version of the catalysts confirmed the presence of encapsulated Ni. Oxygen reduction reaction (ORR) activity of these catalysts was analyzed in 0.1 N KOH solution. Among these, the acid-treated Ni-TiO2-NCNT exhibited highest ORR onset potential of 0.88 V versus reversible hydrogen electrode and a current density of 3.7 mA cm-2 at 170 μg cm-2 of catalyst loading. The stability of the acid-treated Ni-TiO2-NCNT is proved by cyclic voltammetry and chronoamperometry measurements which are done for 800 cycles and 100 h, respectively. Primarily N doping of CNTs is the reason behind the improved ORR activity.
| S-EPMC6644947 | biostudies-literature
Project description:Graphene transistors are of considerable interest for radio frequency (rf) applications. In general, transistors with large transconductance and drain current saturation are desirable for rf performance, which is however nontrivial to achieve in graphene transistors. Here we report high-performance top-gated graphene transistors based on chemical vapor deposition (CVD) grown graphene with large transconductance and drain current saturation. The graphene transistors were fabricated with evaporated high dielectric constant material (HfO(2)) as the top-gate dielectrics. Length scaling studies of the transistors with channel length from 5.6 ?m to 100 nm show that complete current saturation can be achieved in 5.6 ?m devices and the saturation characteristics degrade as the channel length shrinks down to the 100-300 nm regime. The drain current saturation was primarily attributed to drain bias induced shift of the Dirac points. With the selective deposition of HfO(2) gate dielectrics, we have further demonstrated a simple scheme to realize a 300 nm channel length graphene transistors with self-aligned source-drain electrodes to achieve the highest transconductance of 250 ?S/?m reported in CVD graphene to date.
| S-EPMC3236244 | biostudies-literature
Project description:Radial junction solar cells with vertically aligned wire arrays have been widely studied to improve the power conversion efficiency. In this work, we report the first Ge nanopillar solar cell. Nanopillar arrays are selectively patterned on p-type Ge (100) substrates using nanosphere lithography and deep reactive ion etching processes. Nanoscale radial and planar junctions are realized by an n-type Ge emitter layer which is epitaxially grown by MOCVD using isobutylgermane. In situ epitaxial surface passivation is employed using an InGaP layer to avoid high surface recombination rates and Fermi level pinning. High quality n-ohmic contact is realized by protecting the top contact area during the nanopillar patterning. The short circuit current density and the power conversion efficiency of the Ge nanopillar solar cell are demonstrated to be improved up to 18 and 30%, respectively, compared to those of the Ge solar cell with a planar surface.
| S-EPMC5314339 | biostudies-literature
Project description:The stronger photoluminescence (PL) in chemical vapor deposition (CVD) grown monolayer MoS2 has been attributed to its high crystal quality compared with that in mechanically exfoliated (ME) crystal, which is contrary to the cognition that the ME crystal usually have better crystal quality than that of CVD grown one and it is expected with a better optical quality. In this report, the reason of abnormally strong PL spectra in CVD grown monolayer crystal is systematically investigated by studying the in-situ opto-electrical exploration at various environments for both of CVD and ME samples. High resolution transmission electron microscopy is used to investigate their crystal qualities. The stronger PL in CVD grown crystal is due to the high p-doping effect of adsorbates induced rebalance of exciton/trion emission. The first principle calculations are carried out to explore the interaction between adsorbates in ambient and defects sites in MoS2, which is consistent to the experimental phenomenon and further confirm our proposed mechanisms.
| S-EPMC5711928 | biostudies-literature
Project description:Graphene has been considered as an excellent channel
| S-EPMC9330160 | biostudies-literature
Project description:High-quality WS2 film with the single domain size up to 400 ?m was grown on Si/SiO2 wafer by atmospheric pressure chemical vapor deposition. The effects of some important fabrication parameters on the controlled growth of WS2 film have been investigated in detail, including the choice of precursors, tube pressure, growing temperature, holding time, the amount of sulfur powder, and gas flow rate. By optimizing the growth conditions at one atmospheric pressure, we obtained tungsten disulfide single domains with an average size over 100 ?m. Raman spectra, atomic force microscopy, and transmission electron microscopy provided direct evidence that the WS2 film had an atomic layer thickness and a single-domain hexagonal structure with a high crystal quality. And the photoluminescence spectra indicated that the tungsten disulfide films showed an evident layer-number-dependent fluorescence efficiency, depending on their energy band structure. Our study provides an important experimental basis for large-area, controllable preparation of atom-thick tungsten disulfide thin film and can also expedite the development of scalable high-performance optoelectronic devices based on WS2 film.
| S-EPMC5626679 | biostudies-literature
Project description:Humidity sensing is fundamental in some applications, as humidity can be a strong interferent in the detection of analytes under environmental conditions. Ideally, materials sensitive or insensitive towards humidity are strongly needed for the sensors used in the first or second case, respectively. We present here the sensing properties of multi-layered graphene (MLG) upon exposure to different levels of relative humidity. We synthesize MLG by chemical vapor deposition, as shown by Raman spectroscopy, Atomic Force Microscopy (AFM) and Scanning Electron Microscopy (SEM). Through an MLG-based resistor, we show that MLG is scarcely sensitive to humidity in the range 30%-70%, determining current variations in the range of 0.005%/%relative humidity (RH) well below the variation induced by other analytes. These findings, due to the morphological properties of MLG, suggest that defective MLG is the ideal sensing material to implement in gas sensors operating both at room temperature and humid conditions.
| S-EPMC7313702 | biostudies-literature
Project description:Over the past decades, graphene has attracted much attention from the scientific community due to its broad applications in the optoelectronics industries [1]. Owing to graphene's high transmission and high electrical conductivity, diverse functional materials/graphene hybridized heterostructures and interfaces are under extensive investigation to satisfy the increasing interest in the need for bendable, flexible and high performance optoelectronic devices [2]. Due to the good atomic lattice structure of graphene, varying heterostructures have been formed by depositing different functional materials directly on graphene [3], [4], [5]. We fabricated a vertical photovoltaic type G/PbS/Ti device by making use of the Ti/PbS Schottky junction and discussed the photocurrent transient characteristics. Lead sulfide (PbS) was deposited directly on large area CVD (Chemical vapor deposition) graphene by CBD (Chemical bath deposition). Temperature dependent photocurrent spectra of our G/PbS/Ti photovoltaic devices were measured by a Fourier transformed infrared (FTIR) set-up. In this paper, we present the experimental procedures and the raw experimental data for the direct chemical deposition of PbS on CVD-graphene for high performance photovoltaic infrared photo-detectors. The manuscript is already available [6].
| S-EPMC7494446 | biostudies-literature
Project description:Growth of transition metal dichalcogenide (TMD) monolayers is of interest due to their unique electrical and optical properties. Films in the 2H and 1T phases have been widely studied but monolayers of some 1T'-TMDs are predicted to be large-gap quantum spin Hall insulators, suitable for innovative transistor structures that can be switched via a topological phase transition rather than conventional carrier depletion [ Qian et al. Science 2014 , 346 , 1344 - 1347 ]. Here we detail a reproducible method for chemical vapor deposition of monolayer, single-crystal flakes of 1T'-MoTe2. Atomic force microscopy, Raman spectroscopy, X-ray photoelectron spectroscopy, and transmission electron microscopy confirm the composition and structure of MoTe2 flakes. Variable temperature magnetotransport shows weak antilocalization at low temperatures, an effect seen in topological insulators and evidence of strong spin-orbit coupling. Our approach provides a pathway to systematic investigation of monolayer, single-crystal 1T'-MoTe2 and implementation in next-generation nanoelectronic devices.
| S-EPMC5893939 | biostudies-literature
Project description:Combining MoS2 monolayers to form multilayers allows to access new functionalities. Deterministic assembly of large area van der Waals structures requires concrete indicators of successful interlayer coupling in bilayers grown by chemical vapor deposition. In this work, we examine the correlation between the stacking order and the interlayer coupling of valence states in both as-grown MoS2 homobilayer samples and in artificially stacked bilayers from monolayers, all grown by chemical vapor deposition. We show that hole delocalization over the bilayer is only allowed in 2H stacking and results in strong interlayer exciton absorption and also in a larger A-B exciton separation as compared to 3R bilayers. Comparing 2H and 3R reflectivity spectra allows to extract an interlayer coupling energy of about t⊥ = 49 meV. Beyond DFT calculations including excitonic effects confirm signatures of efficient interlayer coupling for 2H stacking in agreement with our experiments.
| S-EPMC7220905 | biostudies-literature