Browse
Submit Data
Databases
API
Help

Dataset Information

16 Views

0 Connections

0 Citations

0 Reanalyses

0 Downloads

Omics score: 0

Sponge-like CoNi Catalysts Synthesized by Combustion of Reactive Solutions: Stability and Performance for CO₂ Hydrogenation.

ABSTRACT: Active and stable catalysts are essential for effective hydrogenation of gaseous CO₂ into valuable chemicals. This work focuses on the structural and catalytic features of single metals, i.e., Co and Ni, as well as bimetallic CoNi alloy catalysts synthesized via combustion of reactive sol-gels. Different characterization methods were used for studying the relationships between the structure, composition, and catalytic activity of the fabricated materials. All catalysts exhibited highly porous sponge-like microstructure. The outermost surfaces of the CoNi alloys were more saturated with Co, while a stoichiometric Co/Ni ratio was observed for the particle's bulk. Catalytic properties of the as-synthesized powders were studied in the CO₂ hydrogenation reaction at 300 °C for over 80 h of time on stream. All the catalysts demonstrated exceptional selectivity with respect to CH₄ formation. However, the combination of elemental Co and Ni in a single phase resulted in a synergistic effect in bulk alloy catalysts, with activity twofold to threefold that of single-metal catalysts. The activity and stability of the CoNi₃ catalyst were higher than those previously reported for Ni-based catalysts. The reasons for this behavior are discussed.

SUBMITTER: Evdokimenko N

PROVIDER: S-EPMC9329901 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Json Xml

Similar Datasets

Superior Stability of Au/SiO2 Compared to Au/TiO2 Catalysts for the Selective Hydrogenation of Butadiene.

Project description:Supported gold nanoparticles are highly selective catalysts for a range of both liquid-phase and gas-phase hydrogenation reactions. However, little is known about their stability during gas-phase catalysis and the influence of the support thereon. We report on the activity, selectivity, and stability of 2-4 nm Au nanoparticulate catalysts, supported on either TiO2 or SiO2, for the hydrogenation of 0.3% butadiene in the presence of 30% propene. Direct comparison of the stability of the Au catalysts was possible as they were prepared via the same method but on different supports. At full conversion of butadiene, only 0.1% of the propene was converted for both supported catalysts, demonstrating their high selectivity. The TiO2-supported catalysts showed a steady loss of activity, which was recovered by heating in air. We demonstrated that the deactivation was not caused by significant metal particle growth or strong metal-support interaction, but rather, it is related to the deposition of carbonaceous species under reaction conditions. In contrast, all the SiO2-supported catalysts were highly stable, with very limited formation of carbonaceous deposits. It shows that SiO2-supported catalysts, despite their 2-3 times lower initial activities, clearly outperform TiO2-supported catalysts within a day of run time.

| S-EPMC5601997 | biostudies-literature

Corrosion and transformation of solution combustion synthesized Co, Ni and CoNi nanoparticles in synthetic freshwater with and without natural organic matter.

Project description:Pure metallic Co, Ni, and their bimetallic compositions of Co3Ni, CoNi, and CoNi3 nanomaterials were prepared by solution combustion synthesis. Microstructure, phase composition, and crystalline structure of these nanoparticles (NPs) were characterized along with studies of their corrosion and dissolution properties in synthetic freshwater with and without natural organic matter (NOM). The nanomaterials consisted of aggregates of fine NPs (3-30 nm) of almost pure metallic and bimetallic crystal phases with a thin surface oxide covered by a thin carbon shell. The nanomaterials were characterized by BET surface areas ranging from ~ 1 to 8 m2/g for the Ni and Co NPs, to 22.93 m2/g, 14.86 m2/g, and 10.53 m2/g for the Co3Ni, CoNi, CoNi3 NPs, respectively. More Co and Ni were released from the bimetallic NPs compared with the pure metals although their corrosion current densities were lower. In contrast to findings for the pure metal NPs, the presence of NOM increased the release of Co and Ni from the bimetallic NPs in freshwater compared to freshwater only even though its presence reduced the corrosion rate (current density). It was shown that the properties of the bimetallic nanomaterials were influenced by multiple factors such as their composition, including carbon shell, type of surface oxides, and the entropy of mixing.

| S-EPMC8042015 | biostudies-literature

Synthesis of Ni/NiAlOx Catalysts for Hydrogenation Saturation of Phenanthrene.

Project description:The saturation of octahydrophenanthrene was the rate-determining step in the hydrogenation process from phenanthrene to perhydrophenanthrene, which was due to the steric hindrance and competitive adsorption of octahydrophenanthrene. In this work, a series of Ni/NiAlOx catalysts with a uniform electron-deficient state of Ni derived from the nickel aluminate structure was synthesized to overcome the disadvantage of noble catalyst and the traditional sulfided catalysts in the saturation hydrogenation process of phenanthrene. Results showed that the catalyst calcinated at 650°C possessed more Ni2+ (∼98%) occupying octahedral sites and exhibited the highest robs (1.53 × 10-3 mol kg-1 s-1) and TOF (14.64 × 10-3 s-1) for phenanthrene hydrogenation. Furthermore, its ability to overcome steric hindrance and promote the rate-determining step was proven by octahydrophenanthrene hydrogenation. Comparing the evolution of hydrogenation activity with the change in the electronic structure of surface Ni sites, it was shown that the increase of metallic electron deficiency hindered the π-back bonding between surface Ni and aromatic rings, which was unfavorable for aromatic adsorption. As a result, the phenanthrene hydrogenation saturation performance can be enhanced by stabilizing the electron-deficient state of surface Ni on an optimal degree.

| S-EPMC8531806 | biostudies-literature

Supported binary CuO x -Pt catalysts with high activity and thermal stability for the combustion of NH3 as a carbon-free energy source.

Project description:Recently, NH3 has been thought to be a renewable and carbon-free energy source. The use of NH3 fuel, however, is hindered by its high ignition temperature and N2O/NO production. To overcome these issues, in this study, the combustion of NH3 over copper oxide (CuO x ) and platinum (Pt) catalysts supported on aluminium silicates (3Al2O3·2SiO2), aluminium oxides (Al2O3), and silicon oxides (SiO2) were compared. To achieve high catalytic activity for the combustion of NH3 and high selectivity for N2 (or low selectively for N2O/NO), conditions for the preparation of impregnated binary catalysts were optimised. With respect to the binary catalysts, sequentially impregnated CuO x /Pt/Al2O3 exhibited relatively higher activity, N2 selectivity, and thermal stability. From XRD and XAFS analyses, CuO x and Pt in CuO x /Pt/Al2O3 were present as CuAl2O4 and metallic Pt, respectively. Given that the combustion activity was closely associated with the Pt nanoparticle size, which was estimated from the Scherrer equation and the pulsed CO technique, highly dispersed Pt nanoparticles were crucial for the low-temperature light-off of NH3. For single and binary catalysts, although NH (imide) deformation modes as a key species for N2O production were detected by in situ FTIR spectral analysis, the band intensity of CuO x /Pt/Al2O3 was less than those of CuO x /Al2O3 and Pt/Al2O3. Therefore, CuO x /Pt/Al2O3 exhibits high selectivity for N2 in NH3 combustion.

| S-EPMC9091973 | biostudies-literature

Structural Evolution of Ga-Cu Model Catalysts for CO2 Hydrogenation Reactions.

Project description:We studied the initial stages of Ga interaction with the Cu(001) surface and environment-induced surface transformations in an attempt to elucidate the surface chemistry of the Cu-Ga catalysts recently proposed for CO2 hydrogenation to methanol. The results show that Ga readily intermixes with Cu upon deposition in vacuum. However, even traces of oxygen in the gas ambient cause Ga oxidation and the formation of two-dimensional ("monolayer") Ga oxide islands uniformly covering the Cu surface. The surface morphology and the oxidized state of Ga remain in H2 as well as in a CO2 + H2 reaction mixture at elevated pressures and temperatures (0.2 mbar, 700 K). The results indicate that the Ga-doped Cu surface under reaction conditions exposes a variety of structures including GaO x /Cu interfacial sites, which must be taken into account for elucidating the reaction mechanism.

| S-EPMC7830109 | biostudies-literature

Nanostructure of nickel-promoted indium oxide catalysts drives selectivity in CO2 hydrogenation.

Project description:Metal promotion in heterogeneous catalysis requires nanoscale-precision architectures to attain maximized and durable benefits. Herein, we unravel the complex interplay between nanostructure and product selectivity of nickel-promoted In2O3 in CO2 hydrogenation to methanol through in-depth characterization, theoretical simulations, and kinetic analyses. Up to 10 wt.% nickel, InNi3 patches are formed on the oxide surface, which cannot activate CO2 but boost methanol production supplying neutral hydrogen species. Since protons and hydrides generated on In2O3 drive methanol synthesis rather than the reverse water-gas shift but radicals foster both reactions, nickel-lean catalysts featuring nanometric alloy layers provide a favorable balance between charged and neutral hydrogen species. For nickel contents >10 wt.%, extended InNi3 structures favor CO production and metallic nickel additionally present produces some methane. This study marks a step ahead towards green methanol synthesis and uncovers chemistry aspects of nickel that shall spark inspiration for other catalytic applications.

| S-EPMC8010022 | biostudies-literature

Copper-Based Catalysts for Selective Hydrogenation of Acetylene Derived from Cu(OH)2.

Project description:Replacing precious metals with cheap metals in catalysts is a topic of interest in both industry and academia but challenging. Here, a selective hydrogenation catalyst was prepared by thermal treatment of Cu(OH)2 nanowires with acetylene-containing gas at 120 °C followed by hydrogen reduction at 150 °C. The characterization by means of transmission electron microscopy observation, X-ray diffraction, and X-ray photoelectron spectroscopy revealed that two crystallites were present in the resultant catalyst. One of the crystal phases was metal Cu, whereas the other crystal phase was ascribed to an interstitial copper carbide (Cu x C) phase. The reduction of freshly prepared copper (II) acetylide (CuC2) at 150 °C also afforded the formation of Cu and Cu x C crystallites, indicating that CuC2 was the precursor or an intermediate in the formation of Cu x C. The prepared catalysts consisting of Cu and Cu x C exhibited a considerably high hydrogenation activity at low temperatures in the selective hydrogenation of acetylene in the ethylene stream. In the presence of a large excess of ethylene, acetylene was completely converted at 110 °C and atmospheric pressure with an ethane selectivity of <15%, and the conversion and selectivity were constant in a 260 h run.

| S-EPMC7860242 | biostudies-literature

Iron catalyzed CO2 hydrogenation to formate enhanced by Lewis acid co-catalysts.

Project description:A family of iron(ii) carbonyl hydride complexes supported by either a bifunctional PNP ligand containing a secondary amine, or a PNP ligand with a tertiary amine that prevents metal-ligand cooperativity, were found to promote the catalytic hydrogenation of CO2 to formate in the presence of Brønsted base. In both cases a remarkable enhancement in catalytic activity was observed upon the addition of Lewis acid (LA) co-catalysts. For the secondary amine supported system, turnover numbers of approximately 9000 for formate production were achieved, while for catalysts supported by the tertiary amine ligand, nearly 60 000 turnovers were observed; the highest activity reported for an earth abundant catalyst to date. The LA co-catalysts raise the turnover number by more than an order of magnitude in each case. In the secondary amine system, mechanistic investigations implicated the LA in disrupting an intramolecular hydrogen bond between the PNP ligand N-H moiety and the carbonyl oxygen of a formate ligand in the catalytic resting state. This destabilization of the iron-bound formate accelerates product extrusion, the rate-limiting step in catalysis. In systems supported by ligands with the tertiary amine, it was demonstrated that the LA enhancement originates from cation assisted substitution of formate for dihydrogen during the slow step in catalysis.

| S-EPMC5707511 | biostudies-literature

Silica accelerates the selective hydrogenation of CO2 to methanol on cobalt catalysts.

Project description:The reaction pathways on supported catalysts can be tuned by optimizing the catalyst structures, which helps the development of efficient catalysts. Such design is particularly desired for CO2 hydrogenation, which is characterized by complex pathways and multiple products. Here, we report an investigation of supported cobalt, which is known for its hydrocarbon production and ability to turn into a selective catalyst for methanol synthesis in CO2 hydrogenation which exhibits good activity and stability. The crucial technique is to use the silica, acting as a support and ligand, to modify the cobalt species via Co‒O‒SiOn linkages, which favor the reactivity of spectroscopically identified *CH3O intermediates, that more readily undergo hydrogenation to methanol than the C‒O dissociation associated with hydrocarbon formation. Cobalt catalysts in this class offer appealing opportunities for optimizing selectivity in CO2 hydrogenation and producing high-grade methanol. By identifying this function of silica, we provide support for rationally controlling these reaction pathways.

| S-EPMC7042257 | biostudies-literature

Unraveling surface structures of gallium promoted transition metal catalysts in CO2 hydrogenation.

Project description:Gallium-containing alloys have recently been reported to hydrogenate CO2 to methanol at ambient pressures. However, a full understanding of the Ga-promoted catalysts is still missing due to the lack of information about the surface structures formed under reaction conditions. Here, we employed near ambient pressure scanning tunneling microscopy and x-ray photoelectron spectroscopy to monitor the evolution of well-defined Cu-Ga surfaces during CO2 hydrogenation. We show the formation of two-dimensional Ga(III) oxide islands embedded into the Cu surface in the reaction atmosphere. The islands are a few atomic layers in thickness and considerably differ from bulk Ga2O3 polymorphs. Such a complex structure, which could not be determined with conventional characterization methods on powder catalysts, should be used for elucidating the reaction mechanism on the Ga-promoted metal catalysts.

| S-EPMC10397205 | biostudies-literature