Mass Transfer from Ion-Sensing Component-Loaded Nanoemulsions into Ion-Selective Membranes: An Electrochemical Quartz Crystal Microbalance and Thin-Film Coulometry Study
Ontology highlight
ABSTRACT:
SUBMITTER:
PROVIDER: S-EPMC9936608 | biostudies-literature | 2022 Oct
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Microliter volumes are used in electrochemical detection and preconcentration of radionuclides to reduce the dose received by researchers and equipment. Unfortunately, there is a lack of analysis of radionuclides with coupled electrochemical techniques and microliter volume reactors. The goals of this work are 1) to develop a miniaturized micro-electrochemical quartz crystal microbalance (µeQCM) reactor for use in small volume (50-200 µL) electrogravimetric experiments and 2) to use this reactor to characterize the preconcentration of neptunium on carbon electrodes via electroprecipitation. We successfully deposited neptunium in the new µeQCM reactor and verified its operation. We found that preconcentration of neptunium on carbon coated electrodes was possible by chronoamperometry at -1.6 VAg/AgCl. The mass shift of the resulting precipitate was indicative of the amount of neptunium on the electrode, although the correlation between the mass increase and activity of the preconcentrated material was not linear. Neptunium precipitate reduced electron transfer to the solution as evidenced by the increase in charge transfer resistance compared to bare electrodes.
| S-EPMC7323927 | biostudies-literature
Project description:The immobilization of redox enzymes on electrodes enables the efficient and selective electrocatalysis of useful reactions such as the reversible interconversion of dihydrogen (H2) to protons (H+) and formate to carbon dioxide (CO2) with hydrogenase (H2ase) and formate dehydrogenase (FDH), respectively. However, their immobilization on electrodes to produce electroactive protein films for direct electron transfer (DET) at the protein-electrode interface is not well understood, and the reasons for their activity loss remain vague, limiting their performance often to hour timescales. Here, we report the immobilization of [NiFeSe]-H2ase and [W]-FDH from Desulfovibrio vulgaris Hildenborough on a range of charged and neutral self-assembled monolayer (SAM)-modified gold electrodes with varying hydrogen bond (H-bond) donor capabilities. The key factors dominating the activity and stability of the immobilized enzymes are determined using protein film voltammetry (PFV), chronoamperometry (CA), and electrochemical quartz crystal microbalance (E-QCM) analysis. Electrostatic and H-bonding interactions are resolved, with electrostatic interactions responsible for enzyme orientation while enzyme desorption is strongly limited when H-bonding is present at the enzyme-electrode interface. Conversely, enzyme stability is drastically reduced in the absence of H-bonding, and desorptive enzyme loss is confirmed as the main reason for activity decay by E-QCM during CA. This study provides insights into the possible reasons for the reduced activity of immobilized redox enzymes and the role of film loss, particularly H-bonding, in stabilizing bioelectrode performance, promoting avenues for future improvements in bioelectrocatalysis.
| S-EPMC9097293 | biostudies-literature
Project description:Various polycations and polyanions were sequentially adsorbed onto the gold electrode of a quartz crystal microbalance with dissipation monitoring. The study focused on determining the adsorption kinetics, viscoelastic properties, and electroresponsivity of polyelectrolyte layers. For the first time, it was demonstrated that the structure (compact or expanded) of the layers can be determined by electroresponsivity. Viscoelastic modeling alone did not provide a conclusive answer as to whether the layers were compact or expanded. The study was further enriched by streaming potential and contact angle measurements, where polyelectrolyte multilayers were formed on mica. It was found that successive adsorption of layers led to periodic inversion of the zeta potential. Systematic differences were observed between the different top layers, which were explained by intermixing between layers. The presence or absence of interpenetration, as determined by the measurements of streaming potential and contact angles, correlated well with electroresponsivity.
| S-EPMC11815823 | biostudies-literature
Project description:The increase in bacterial and viral resistance to current therapeutics has led to intensive research for new antibacterial and antiviral agents. Among these, aminoglycosides and their guanidino derivatives are potent candidates targeting specific RNA sequences. It is necessary that these substances can pass across mammalian membranes in order to reach their intracellular targets. This study investigated the effects of the aminoglycosides kanamycin A and neomycin B and their guanidino derivatives on mammalian mimetic membranes using a quartz crystal microbalance with dissipation monitoring (QCM-D). Lipid bilayers as membrane models were deposited onto gold coated quartz crystals and aminoglycosides added afterwards. Notably, the guanidino derivatives exhibited an initial stiffening of the membrane layer indicating a quick insertion of the planar guanidino groups into the membrane. The guanidino derivatives also reached their maximum binding to the membrane at lower concentrations than the native compounds. Therefore, these modified aminoglycosides are promising agents for the development of new antimicrobial treatments.
| S-EPMC6072410 | biostudies-literature
Project description:We probed electrochemical ion storage in single-walled carbon nanotubes (SWCNTs) of different diameters in two different organic electrolytes using electrochemical quartz crystal microbalance (EQCM) tracking. The measurements showed that charge storage probed by cyclic voltammetry did not deteriorate when steric effects seemed to hinder the accessibility of counter-ions into SWCNTs, and instead proceeded predominantly by co-ion desorption, as was shown by the decrease in the electrode mass probed by EQCM. The dominant mechanism correlated with the SWCNT diameter/ion size ratio; counter-ion adsorption dominated in the whole potential range when the diameter of SWCNTs was comparable to the size of the largest ion, whereas for larger diameters the charge increase coincided with a decrease in the electrode mass, indicating the dominance of co-ion desorption. The dominance of co-ion desorption was not observed in activated carbon, nor was it previously reported for other carbon materials, and is likely switched on because the carrier density of SWCNT increases with applied potential, and maintains the electrode capacity by co-ion desorption to overcome the steric hindrances to counter-ion adsorption.
| S-EPMC9041153 | biostudies-literature
Project description:Water existing within thin polyelectrolyte multilayer (PEM) films has significant influence on their physical, chemical, and thermal properties, having implications for applications including energy storage, smart coatings, and biomedical systems. Ionic strength, salt type, and terminating layer are known to influence PEM swelling. However, knowledge of water's microenvironment within a PEM, whether that water is affiliated with intrinsic or extrinsic ion pairs, remains lacking. Here, we examine the influence of both assembly and post-assembly conditions on the water-ion pair interactions of poly(styrene sulfonate)/poly(diallyldimethylammonium) (PSS/PDADMA) PEMs in NaCl and KBr. This is accomplished by developing a methodology in which quartz crystal microbalance with dissipation monitoring is applied to estimate the number of water molecules affiliated with an ion pair (i), as well as the hydration coefficient, πsalt H2O. PSS/PDADMA PEMs are assembled in varying ionic strengths of either NaCl and KBr and then exposed post-assembly to increasing ionic strengths of matching salt type. A linear relationship between the total amount of water per intrinsic ion pair and the post-assembly salt concentration was obtained at post-assembly salt concentrations >0.5 M, yielding estimates for both i and πsalt H2O. We observe higher values of i and πsalt H2O in KBr-assembled PEMs due to KBr being more effective in doping the assembly because of KBr's more chaotropic nature as compared to NaCl. Lastly, when PSS is the terminating layer, i decreases in value due to PSS's hydrophobic nature. Classical and ab initio molecular dynamics provide a microstructural view as to how NaCl and KBr interact with individual polyelectrolytes and the involved water shells. Put together, this study provides further insight into the understanding of existing water microenvironments in PEMs and the effects of both assembly and post-assembly conditions.
| S-EPMC9374166 | biostudies-literature
Project description:The facile real-time monitoring of methyl content in fermented beverages is of fundamental significance in the alcohol and restaurant industry, since as little as 4 mL of methanol entering the blood may cause intoxication or blindness. So far, the practical applicability of available methanol sensors, including the piezoresonance analogs, is somewhat limited to laboratory use due to the complexity and bulkiness of the measuring equipment involving multistep procedures. This article introduces a hydrophobic metal-phenolic film-coated quartz crystal microbalance (MPF-QCM) as a novel streamlined detector of methanol in alcoholic drinks. Unlike other QCM-based alcohol sensors, our device operates under saturated vapor pressure conditions, permitting rapid detection of methyl fractions up to seven times below the tolerable levels in spirits (e.g., whisky) while effectively suppressing the cross-sensitivity to interfering chemical compounds such as water, petroleum ether or ammonium hydroxide. Furthermore, the good surface adhesion of metal-phenolic complexes endows the MPF-QCM with superior long-term stability, contributing to the repeatable and reversible physical sorption of the target analytes. These features, combined with the lack of mass flow controllers, valves and connecting pipes delivering the gas mixture, outline the likelihood for future design of a portable MPF-QCM prototype suitable to point-of-use analysis in drinking establishments.
| S-EPMC10302850 | biostudies-literature
Project description:This work addresses a key challenge of tailoring the ion selectivity of a thin-film composite nanofiltration membrane to a specific application, such as water softening, without altering the water permeability. We modified the active surface of a commercial NF270 membrane by molecular layer deposition (MLD) of ethylene glycol-Al (EG-alucone). With increasing deposition cycles, we found that the MLD precursors first infiltrated and deposited in the active layer of NF270, then inflated the active layer, and finally deposited on the surface as a distinct EG-alucone layer. The deposition process changed the morphology of the membrane active layer and decreased the overall density of its fixed negative charge by embedding the positively charged EG-alucone. Filtration experiments revealed that these modifications affected the ion separation properties of the membrane without significantly hindering the water permeability. Specifically, the permeation of Na+ increased relative to that of Mg2+, as indicated by the permselectivity of Na+ salts over Mg2+ salts. The changes in permselectivities with an increasing number of MLD cycles were rationalized using the dielectric, steric, and electrostatic ion exclusion mechanisms, which are related to the membrane material, pore size, and fixed charge, respectively. These relations open a path for the rational design of nanofiltration membranes with tailored selectivity by tuning the properties of the MLD layer. Filtration results of natural brackish groundwater using the MLD modified membranes agreed with the single salt experiments. As a result, water hardness was 26% lower for the permeate obtained using the MLD-modified membranes, which were found stable even during a 24 h filtration run. These results highlight the practical potential of this approach in enhancing water softening efficiency.
| S-EPMC7735666 | biostudies-literature
Project description:In this work, the interaction between a sessile droplet's contact angle and a quartz crystal microbalance (QCM) is elucidated. We differentiate the QCM's frequency response to changes in the droplet contact area from variations in the dynamic contact angle. This is done by developing a computational model that couples the electrical and mechanical analysis of the quartz substrate with the visco-acoustic behavior of the sessile droplet. From our analysis, we conclude that changes in the contact angle have an effect on the frequency response of the QCM when the droplet height is on the order of the viscous decay length or smaller. On the other hand, changes in the interfacial contact area of the sessile droplets have a significant impact on the frequency response of the QCM regardless of the droplet size.
| S-EPMC6872598 | biostudies-literature
Project description:Both the short- and long-term electron-transfer processes of electrode-respiring Geobacter sulfurreducens biofilms are demonstrated by using an electrochemical quartz crystal microbalance (QCM). The QCM monitors the frequency shift from the initial resonant frequency (background) in real time, while the current increases, because of biofilm growth. In the short term, the frequency shift is linear with respect to current for the biofilm. In long-term biofilm growth up to the exponential phase, a second linear region of frequency shift with respect to current is observed. In addition to the frequency shift response at constant polarization, the frequency shift response is coupled to cyclic voltammetry experiments. During cyclic voltammetry, a reproducible, negative increase in frequency shift is observed at oxidizing potentials. The results suggest that a QCM can be used in applications in which it is useful to find the most efficient current producer.
| S-EPMC4964883 | biostudies-literature