Reduction of the surface-tension-lowering ability of surfactant after exposure to hypochlorous acid.
Ontology highlight
ABSTRACT:
SUBMITTER: Merritt TA
PROVIDER: S-EPMC1134814 | biostudies-other | 1993 Oct
REPOSITORIES: biostudies-other
Similar Datasets
Project description:IntroductionE-cigarette (EC) and vaping use continue to remain popular amongst teenage and young adult populations, despite several reports of vaping associated lung injury. One of the first compounds that EC aerosols comes into contact within the lungs during a deep inhalation is pulmonary surfactant. Impairment of surfactant's critical surface tension reducing activity can contribute to lung dysfunction. Currently, information on how EC aerosols impacts pulmonary surfactant remains limited. We hypothesized that exposure to EC aerosol impairs the surface tension reducing ability of surfactant.MethodsBovine Lipid Extract Surfactant (BLES) was used as a model surfactant in a direct exposure syringe system. BLES (2ml) was placed in a syringe (30ml) attached to an EC. The generated aerosol was drawn into the syringe and then expelled, repeated 30 times. Biophysical analysis after exposure was completed using a constrained drop surfactometer (CDS).ResultsMinimum surface tensions increased significantly after exposure to the EC aerosol across 20 compression/expansion cycles. Mixing of non-aerosolized e-liquid did not result in significant changes. Variation in device used, addition of nicotine, or temperature of the aerosol had no additional effect. Two e-liquid flavours, menthol and red wedding, had further detrimental effects, resulting in significantly higher surface tension than the vehicle exposed BLES. Menthol exposed BLES has the highest minimum surface tensions across all 20 compression/expansion cycles. Alteration of surfactant properties through interaction with the produced aerosol was observed with a basic e-liquid vehicle, however additional compounds produced by added flavourings appeared to be able to increase inhibition.ConclusionEC aerosols alter surfactant function through increases in minimum surface tension. This impairment may contribute to lung dysfunction and susceptibility to further injury.
| S-EPMC9645651 | biostudies-literature
Project description:Surface tension influences the fraction of atmospheric particles that become cloud droplets. Although surfactants are an important component of aerosol mass, the surface tension of activating aerosol particles is still unresolved, with most climate models assuming activating particles have a surface tension equal to that of water. By studying picoliter droplet coalescence, we demonstrate that surfactants can significantly reduce the surface tension of finite-sized droplets below the value for water, consistent with recent field measurements. Significantly, this surface tension reduction is droplet size-dependent and does not correspond exactly to the macroscopic solution value. A fully independent monolayer partitioning model confirms the observed finite-size-dependent surface tension arises from the high surface-to-volume ratio in finite-sized droplets and enables predictions of aerosol hygroscopic growth. This model, constrained by the laboratory measurements, is consistent with a reduction in critical supersaturation for activation, potentially substantially increasing cloud droplet number concentration and modifying radiative cooling relative to current estimates assuming a water surface tension. The results highlight the need for improved constraints on the identities, properties, and concentrations of atmospheric aerosol surfactants in multiple environments and are broadly applicable to any discipline where finite volume effects are operative, such as studies of the competition between reaction rates within the bulk and at the surface of confined volumes and explorations of the influence of surfactants on dried particle morphology from spray driers.
| S-EPMC7165431 | biostudies-literature
Project description:PurposeTo examine the magnitude of bacterial load reduction on the surface of the periocular skin 20 minutes after application of a saline hygiene solution containing 0.01% pure hypochlorous acid (HOCl).MethodsMicrobiological specimens were collected immediately prior to applying the hygiene solution and again 20 minutes later. Total microbial colonies were counted and each unique colony morphology was processed to identify the bacterial species and to determine the susceptibility profile to 15 selected antibiotics.ResultsSpecimens were analyzed from the skin samples of 71 eyes from 36 patients. Prior to treatment, 194 unique bacterial isolates belonging to 33 different species were recovered. Twenty minutes after treatment, 138 unique bacterial isolates belonging to 26 different species were identified. Staphylococci accounted for 61% of all strains recovered and Staphylococcus epidermidis strains comprised 60% of the staphylococcal strains. No substantial differences in the distribution of Gram-positive, Gram-negative, or anaerobic species were noted before and after treatment. The quantitative data demonstrated a >99% reduction in the staphylococcal load on the surface of the skin 20 minutes following application of the hygiene solution. The total S. epidermidis colony-forming units were reduced by 99.5%. The HOCl hygiene solution removed staphylococcal isolates that were resistant to multiple antibiotics equally well as those isolates that were susceptible to antibiotics.ConclusionThe application of a saline hygiene solution preserved with pure HOCl acid reduced the bacterial load significantly without altering the diversity of bacterial species remaining on the skin under the lower eyelid.
| S-EPMC5402722 | biostudies-literature
Project description:The article summarizes the results of our research on the behavior of ions at uncharged fluid interfaces, with a focus on moderately to highly concentrated aqueous electrolytes. The ion-specific properties of such interfaces have been analyzed. The ion-specificity series are different for water|air and water|oil; different for surface tension σ, surface Δχ potential and electrolyte adsorption, and they change with concentration. A methodology has been developed that allows to disentangle the multiple factors controlling the ion order. The direct ion-surface interactions are not always the most significant factor behind the observed ion sequences: indirect effects stemming from conjugate bulk properties are often more important. For example, the order of the surface tension with the nature of the anion (σKOH > σKCl > σKNO3 for potassium salts) is often the result of bulk nonideality and follows the order of the bulk activity coefficients (γKOH > γKCl > γKNO3) rather than that of a specific ion-surface interaction potential. The surface Δχ potential of aqueous solutions is, in many cases, insensitive to the ion distribution in the electric double layer but reflects the orientation of water at the surface, through the ion-specific dielectric permittivity ε of the solution. Even the sign of Δχ is often the result of the decrement of ε in the presence of electrolyte. A whole new level of complexity appears when the ions interact with an uncharged surfactant monolayer. A method has been developed to measure the electrolyte adsorption isotherms on monolayers of varying area per surfactant molecule via a combination of experiments-compression isotherms and surface pressure of equilibrium spread monolayers. The obtained isotherms demonstrate that the ions exhibit a maximum in their adsorption on monolayers of intermediate density. The maximum is explained with the interplay between ion-surfactant complexation, volume exclusion and osmotic effects.
| S-EPMC11340029 | biostudies-literature
Project description:In the acute respiratory distress syndrome (ARDS), alveolar surface tension, T, may be elevated. Elevated T should increase ventilation-induced lung injury. Exogenous surfactant therapy, intended to lower T, has not reduced mortality. Sulforhodamine B (SRB) might, alternatively, be used to lower T. We test whether substances suspected of elevating T in ARDS raise T in the lungs and test the abilities of exogenous surfactant and SRB to reduce T. In isolated rat lungs, we micropuncture a surface alveolus and instill a solution of a purported T-raising substance: control saline, cell debris, secretory phospholipase A2 (sPLA2), acid, or mucins. We test each substance alone; with albumin, to model proteinaceous edema liquid; with albumin and exogenous surfactant; and with albumin and SRB. We determine T in situ in the lungs by combining servo-nulling pressure measurement with confocal microscopy and applying the Laplace relation. With control saline, albumin does not alter T, additional surfactant raises T, and additional SRB lowers T. The experimental substances, without or with albumin, raise T. Excepting under aspiration conditions, addition of surfactant or SRB lowers T. Exogenous surfactant activity is concentration and ventilation dependent. Sulforhodamine B, which could be delivered intravascularly, holds promise as an alternative therapeutic.NEW & NOTEWORTHY In the acute respiratory distress syndrome (ARDS), lowering surface tension, T, should reduce ventilation injury yet exogenous surfactant has not reduced mortality. We show with direct T determination in isolated lungs that substances suggested to elevate T in ARDS indeed raise T, and exogenous surfactant reduces T. Further, we extend our previous finding that sulforhodamine B (SRB) reduces T below normal in healthy lungs and show that SRB, too, reduces T under ARDS conditions.
| S-EPMC7792849 | biostudies-literature
Project description:Monomolecular films at an air/water interface coexist at the equilibrium spreading tension (γ(e)) with the bulk phase from which they form. For individual phospholipids, γ(e) is single-valued, and separates conditions at which hydrated vesicles adsorb from tensions at which overcompressed monolayers collapse. With pulmonary surfactant, isotherms show that monolayers compressed on the surface of bubbles coexist with the three-dimensional collapsed phase over a range of surface tensions. γ(e) therefore represents a range rather than a single value of surface tension. Between the upper and lower ends of this range, rates of collapse for spread and adsorbed films decrease substantially. Changes during adsorption across this narrow region of coexistence between the two- and three-dimensional structures at least partially explain how alveolar films of pulmonary surfactant become resistant to collapse.
| S-EPMC4896737 | biostudies-literature
Project description:Noroviruses (NVs) are the most frequent cause of outbreaks of gastroenteritis in common settings, with surface-mediated transfer via contact with fecally contaminated surfaces implicated in exposure. NVs are environmentally stable and persistent and have a low infectious dose. Several disinfectants have been evaluated for efficacy to control viruses on surfaces, but the toxicity and potential damage to treated materials limits their applicability. Sterilox hypochlorous acid (HOCl) solution (HAS) has shown broad-spectrum antimicrobial activity while being suitable for general use. The objectives of this study were to evaluate the efficacy of HAS to reduce NV both in aqueous suspensions and on inanimate carriers. HOCl was further tested as a fog to decontaminate large spaces. HOCl effectiveness was evaluated using nonculturable human NV measured by reverse transcriptase PCR (RT-PCR) and two surrogate viruses, coliphage MS2 and murine NV, that were detected by both infectivity and RT-PCR. Exposing virus-contaminated carriers of ceramic tile (porous) and stainless steel (nonporous) to 20 to 200 ppm of HOCl solution resulted in > or = 99.9% (> or = 3 log10) reductions of both infectivity and RNA titers of tested viruses within 10 min of exposure time. HOCl fogged in a confined space reduced the infectivity and RNA titers of NV, murine NV, and MS2 on these carriers by at least 99.9% (3 log10), regardless of carrier location and orientation. We conclude that HOCl solution as a liquid or fog is likely to be effective in disinfecting common settings to reduce NV exposures and thereby control virus spread via fomites.
| S-EPMC1932820 | biostudies-literature
Project description:Exposure of human red blood cells to low doses of hypochlorous acid (HOCl) resulted in the loss of intracellular GSH. Oxidation occurred less than 2 min after the addition of HOCl, and required approx. 2.5 mol of HOCl per mol of GSH lost. Loss of GSH preceded oxidation of membrane thiols, the formation of chloramines and haemoglobin oxidation. The susceptibility of intracellular GSH to oxidation by HOCl was two-thirds that of GSH in cell lysates. These results indicate that HOCl can penetrate the red cell membrane, which provides little barrier protection for cytoplasmic components, and that GSH oxidation by HOCl may be a highly selective process. Virtually all of the GSH lost was converted into GSSG. If glucose was added to the medium, most of the GSH oxidized by low doses of HOCl was rapidly regenerated. At higher doses, recovery was less efficient. However, when HOCl was added as a slow infusion rather than in a single bolus, there was increased recovery at higher doses. This indicates that in metabolically active cells regeneration is rapid and GSH may protect cell components from damage by HOCl. HOCl-induced lysis was only slightly delayed by adding glucose to the medium, indicating that lytic injury is not ameliorated by GSH.
| S-EPMC1136744 | biostudies-other
Project description:The proliferation of computer-aided design and additive manufacturing enables on-demand fabrication of complex, three-dimensional structures. However, combining the versatility of cell-laden hydrogels within the 3D printing process remains a challenge. Herein, we describe a facile and versatile method that integrates polymer networks (including hydrogels) with 3D-printed mechanical supports to fabricate multicomponent (bio)materials. The approach exploits surface tension to coat fenestrated surfaces with suspended liquid films that can be transformed into solid films. The operating parameters for the process are determined using a physical model, and complex geometric structures are successfully fabricated. We engineer, by tailoring the window geometry, scaffolds with anisotropic mechanical properties that compress longitudinally (~30% strain) without damaging the hydrogel coating. Finally, the process is amenable to high cell density encapsulation and co-culture. Viability (>95%) was maintained 28 days after encapsulation. This general approach can generate biocompatible, macroscale devices with structural integrity and anisotropic mechanical properties.
| S-EPMC5864961 | biostudies-literature
Project description:We have studied homogeneous cavitation in liquid nitrogen and normal liquid helium. We monitor the fluid content in a large number of independent mesopores with an ink-bottle shape, either when the fluid in the pores is quenched to a constant pressure or submitted to a pressure decreasing at a controlled rate. For both fluids, we show that, close enough to their critical point, the cavitation pressure threshold is in good agreement with the Classical Nucleation Theory (CNT). In contrast, at lower temperatures, deviations are observed, consistent with a reduction of the surface tension for bubbles smaller than two nanometers in radius. For nitrogen, we could accurately measure the nucleation rate as a function of the liquid pressure down to the triple point, where the critical bubble radius is about one nanometer. We find that CNT still holds, provided that the curvature dependence of the surface tension is taken into account. Furthermore, we evaluate the first- and second-order corrections in curvature, which are in reasonable agreement with recent calculations for a Lennard-Jones fluid.
| S-EPMC10104516 | biostudies-literature